• Energy Research
• Closed Access close
• 6. Clean water close
• AU close
• GB close

Among various bioreactors examined in anaerobic digestion and dark fermentation, UASB bioreactor has shown to be a promising alternative. However, mass transfer resistance and biomass washout have been the issues that reported as draw backs of the granular system in the literature. Another problem associated with such a system is its long start-up period as a result of biomass washout and long microbial granulation stage. In this paper, the results obtained from an UASFF bioreactor in methane (AD process) and hydrogen (DF process) production from POME, are presented to assess mass transfer of substrate into the granules and also study the role of internal packing used in the middle part of reactor in the process stability. The value of effectiveness factor, η, for AD and DF processes were calculated to be 0.96 and 0.94, respectively, indicating that there was no mass transfer resistance due to internal and/or external factors. The results showed that the packing material could retain biomass in the reactor and had outstanding contribution in the granulation enhancement. Its role as a supplementing treatment stage was more significant at low HRTs and up-flow velocities.

The operation of centrifugal pumps can generate instabilities and pressure pulsations that may be detrimental to the integrity and performance of the pump. In the present study a numerical investigation of the time variation of pressure within a complete centrifugal pump was undertaken. A range of parameters and three flow rates were investigated and the pulsations were extracted at 15 different locations covering important pump regions. The transient flow results compared reasonably with experimental data obtained in a limited experimental survey and clearly indicated the pump locations experiencing the largest pulsation levels. It was also noted that monitoring pulsations at the top dead centre of the pump volute casing would provide a better indication of internal pump pulsations than monitoring at the discharge.

A field study was conducted on two texturally different soils to determine the influences of biosolids application on selected soil chemical properties and carbon dioxide fluxes. Two sites, located in Manildra (clay loam) and Grenfell (sandy loam), in Australia, were treated at a single level of 70 Mg ha-1 biosolids. Soil samples were analyzed for SOC fractions, including total organic carbon (TOC), labile, and non-labile carbon contents. The natural abundances of soil δ13C and δ15N were measured as isotopic tracers to fingerprint carbon derived from biosolids. An automated soil respirometer was used to measure in-situ diurnal CO2 fluxes, soil moisture, and temperature. Application of biosolids increased the surface (0-15 cm) soil TOC by > 45% at both sites, which was attributed to the direct contribution from residual carbon in the biosolids and also from the increased biomass production. At both sites application of biosolids increased the non-labile carbon fraction that is stable against microbial decomposition, which indicated the soil carbon sequestration potential of biosolids. Soils amended with biosolids showed depleted δ13C, and enriched δ15N indicating the accumulation of biosolids residual carbon in soils. The in-situ respirometer data demonstrated enhanced CO2 fluxes at the sites treated with biosolids, indicating limited carbon sequestration potential. However, addition of biosolids on both the clay loam and sandy loam soils found to be effective in building SOC than reducing it. Soil temperature and CO2 fluxes, indicating that temperature was more important for microbial degradation of carbon in biosolids than soil moisture.

Much of New South Wales and southern Queensland suffered from extreme drought from 2017 to 2019. This study models drought and bushfires impacts using VU‐TERM, a multi‐regional, dynamic CGE model. Prolonged drought pushed national real GDP to 0.7 per cent or more below base in 2018–2019 and 2019–2020. NSW’s real GDP fell relative to forecast by 1.1 per cent or $6.9 billion in 2018–2019 and 1.6 per cent or $10.2 billion in 2019–2020. These impacts reflect a severe diminution of farm output, given that agriculture accounts for around 1.6 per cent of NSW’s income. Bushfires exacerbated 2019–2020 losses. We assume that there is a full recovery in seasonal conditions in 2020. However, prolonged drought and bushfire destruction deplete farm capital through depressed investment and diminished herd numbers. Consequently, the income earning capacity of farms in recovery remains below that of a no drought base. The net present value of the national welfare loss is $63 billion, split between $53 billion in losses from drought and $10 billion from bushfires. The latter excludes any valuation of human lives lost, flora, fauna or forestry destruction. In the longer term, adaptation and policy responses will need to reflect the expectation of increased frequency of adverse climatic events.

Use of a pilot-scale fixed-film bioreactor was investigated for remediation of bromate contamination within groundwater. Bromate reduction with stoichiometric production of bromide was observed, providing supporting evidence for complete reduction of bromate with no production of stable intermediates. Reduction of 87-90% bromate from an influent concentration of 1.1 mg L(-1) was observed with retention times of 40-80 h. Lower retention times led to decreases in bromate reduction capability, with 11.5% removal at a 10 h retention time. Nitrate reduction of 76-99% from a 30.7 mg L(-1) as NO(3)(-) influent was observed at retention times of 10-80 h, although an increase in nitrite production to 2.7 mg L(-1) occurred with a 10 h retention time. Backwashing was not required, with the large plastic packing media able to accommodate biomass accumulation without decreases in operational efficiency. This study has provided proof of concept and demonstrated the potential of biological bromate reduction by fixed-film processes for remediation of a bromate contaminated groundwater source.

AbstractWarming of freshwaters as a result of climate change is expected to have complex interactions with the toxicity of contaminants to aquatic organisms. The present study evaluated the effects of temperature on the acute toxicity of endosulfan, chlorpyrifos, and phenol to 3 warm water species of fish—silver perch, rainbowfish, and western carp gudgeon—and 1 cold water species, rainbow trout. Endosulfan was more toxic to silver perch at 30 °C and 35 °C than at 15 °C, 20 °C and 25 °C during short exposures of 24 h, but at 96 h, temperature had no effect on toxicity. Toxicity to rainbow trout increased with increasing temperature, whereas warm water species exhibited maximum toxicity at around 30 °C, decreasing again toward 35 °C. Chlorpyrifos became more toxic to all species with increasing temperature. Phenol toxicity to all species decreased at low to intermediate temperatures; but as temperatures increased further toward the upper thermal limit, phenol became more toxic. Increasing toxicity in the upper thermal range of cold water species may contribute to upstream range contraction in rivers with high toxicant loads. In contrast, warm water species may not exhibit a range shift within rivers as a result of interactions between temperature and toxicity. Catchment management to offset global warming at local scales may present opportunities to mitigate increased toxicity of contaminants to fish. Environ Toxicol Chem 2015;34:1809–1817. © 2015 SETAC

In this work we assess the pathways for environmental improvement by the coal utilization industry for power generation in Australia. In terms of resources, our findings show that coal is a long term resource of concern as coal reserves are likely to last for the next 500 years or more. However, our analysis indicates that evaporation losses of water in power generation will approach 1000 Gl (gigalitres) per year, equivalent to a consumption of half of the Australian residential population. As Australia is the second driest continent on earth, water consumption by power generators is a resource of immediate concern with regards to sustainability. We also show that coal will continue to play a major role in energy generation in Australia and, hence, there is a need to employ new technologies that can minimize environmental impacts. The major technologies to reduce impacts to air, water and soils are addressed. Of major interest, there is a major potential for developing sequestration processes in Australia, in particular by enhanced coal bed methane (ECBM) recovery at the Bowen Basin, South Sydney Basin and Gunnedah Basin. Having said that, CO2 capture technologies require further development to support any sequestration processes in order to comply with the Kyoto Protocol. Current power generation cycles are thermodynamic limited, with 35-40% efficiencies. To move to a high efficiency cycle, it is required to change technologies of which integrated gasification combined cycle plus fuel cell is the most promising, with efficiencies expected to reach 60-65%. However, risks of moving towards an unproven technology means that power generators are likely to continue to use pulverized fuel technologies, aiming at incremental efficiency improvements (business as usual). As a big picture pathway, power generators are likely to play an increasing role in regional development; in particular EcoParks and reclaiming saline water for treatment as pressures to access fresh water supplies will significantly increase.

The deposition of ash - combustion residues - on superheaters and heat exchanger surfaces reduce their efficiency; this phenomenon was investigated for a large-scale waste-to-energy incineration facility. Over a period of six months, ash samples were collected from the plant, which included the bottom ash and deposits from the superheater, as well as flyash from the convective heat exchanger, the economiser and fabric filters. These were analysed for particle size, unburned carbon, elemental composition and surface morphology. Element partitioning was evident in the different combustion residues, as volatile metals, such as cadmium, antimony and arsenic, were found to be depleted in the bottom ash by the high combustion temperatures (1000+°C) and concentrated/enriched in the fabric filter ash (transferred by evaporation). Non-volatile elements by contrast were distributed equally in all locations (transported by particle entrainment). The heat exchanger deposits and fabric filter ash had elevated levels of alkali metals. 82% of flyash particles from the fabric filter were in the submicron range.

Two chickpea genotypes viz. Bhakar-2011 (desi) and Noor-2013 (kabuli) were sown in soil filled pots supplied with low (0.3 mg kg-1) and high (3 mg kg-1 soil) zinc (Zn) under control (70% water holding capacity and 25/20 °C day/night temperature), drought (35% water holding capacity) and heat (35/30 °C day/night temperature) stresses. Drought and heat stresses reduced rate of photosynthesis, photosystem II efficiency, plant growth and Zn uptake in chickpea. Low Zn supply exacerbated adverse effects of drought and heat stresses in chickpea, and caused reduction in plant biomass, carbon assimilation, antioxidant activity, impeded Zn uptake and enhanced oxidative damage. However, adequate Zn supply ameliorated adverse effect of drought and heat stresses in both chickpea types. The improvements were more in desi than kabuli type. Adequate Zn nutrition is crucial to augment growth of chickpea plants under high temperature and arid climatic conditions.