• Energy Research
• US close
• DE close
• Chinese Academy of Sciences close

Abstract A high-flux solar simulator is essential for evaluating solar thermal components under controlled and adjustable flux input conditions. This study presents a newly built high-flux solar simulator composed of 19 individual units. Each unit includes a xenon short-arc lamp (each consuming up to 6 kW electricity power) coupled with a truncated ellipsoidal reflector, a cooling blower, and a power module. The power module yields a current in the range of 50–160 A. The number of lamps in use is flexible, which allows for a wide range of radiation flux (10%–100%) on the focal plane. The radiation power, peak value, flux distribution on the circular target plane, and conversion efficiency are evaluated based on a flux mapping method. The results indicate that the proposed solar simulator is capable of achieving thermal power of 23.3 kW, peak flux in excess of 1.78 MW/m2, a stagnation temperature exceeding 2360 °C, and average irradiance of 773.4 kW/m2 on the focal plane (diameter of 260 mm). The electro-thermal conversion efficiency of the simulator is 35.7%. A ray-tracing method was employed, and the simulation results were found to be in good agreement with those in the experiments. An experimental test of a volumetric ceramic receiver was conducted, and the results indicate the availability and applicability of the high-flux solar simulator when carrying out studies about solar receivers.

Abstract The absorption refrigeration system driven by low grade heat sources, especially the waste heat sources, becomes more and more attractive in recent decades. However, most traditional absorption systems cannot achieve a high utilization rate of the waste heat with limited heat capacity. These systems are usually designed to obtain heat in the generator, which means that the waste heat sources cannot be utilized to the temperature lower than the generator temperature. This paper proposed a new structure heated by heat conduction oil in the generator and electric heating rings around the stripping section. This structure can simulate the temperature-distributed heat sources when the electric heating rings work. It can also simulate a traditional generator when the electric heating rings do not work. Influences of different heat distributions are analyzed in detail in this paper. The results show that the heat sources utilization rate will increase with the increase of the heat in the stripping section, while the coefficient of performance will be negatively affected by the increasing heat in the stripping section. By optimizing the heating structure, the coefficient of performance can be similar to that of a traditional system when the heat is just added in the middle and lower part of stripping section. The optimum utilization rate of heat sources in this test model can reach 1.8 times to that of a traditional system. Under this heating model, the lowest temperature required in the heating section is 82 °C when the heat conduction oil inlet temperature is 169 °C. It is much lower than the temperature inside the generator, which is 137.3 °C.

Xuanwei City (formerly known as Xuanwei County) locates in the northeastern of Yunnan Province and is rich in coal, iron, copper and other mines, especially the smoky (bituminous) coal. Unfortunately, the lung cancer morbidity and mortality rates in this region are among China's highest, with a clear upward trend from the mid-1970s to mid-2000s. In 2004-2005, the crude death rate of lung cancer was 91.3 per 100,000 in the whole Xuanwei City, while that for Laibin Town in this city was 241.14 per 100,000. The epidemiologic distribution (clustering patterns by population, time, and space) of lung cancer in Xuanwei has some special features, e.g., high incidence in rural areas, high incidence in females, and an early age peak in lung cancer deaths. The main factor that associates with a high rate of lung cancer incidence was found to be indoor air pollution caused by the indoor burning of smoky coal. To a certain extent, genetic defects are also associated with the high incidence of lung cancer in Xuanwei. Taken together, lung cancer in this smoky coal combustion region is a unique model for environmental factor-related human cancer, and the current studies indicate that abandoning the use of smoky coal is the key to diminish lung cancer morbidity and mortality.

AbstractChina is under pressure to improve its agricultural productivity to keep up with the demands of a growing population with increasingly resource‐intensive diets. This productivity improvement must occur against a backdrop of carbon intensity reduction targets, and a highly fragmented, nutrient‐inefficient farming system. Moreover, the Chinese government increasingly recognizes the need to rationalize the management of the 800 million tonnes of agricultural crop straw that China produces each year, up to 40% of which is burned in‐field as a waste. Biochar produced from these residues and applied to land could contribute to China's agricultural productivity, resource use efficiency and carbon reduction goals. However competing uses for China's straw residues are rapidly emerging, particularly from bioenergy generation. Therefore it is important to understand the relative economic viability and carbon abatement potential of directing agricultural residues to biochar rather than bioenergy. Using cost‐benefit analysis (CBA) and life‐cycle analysis (LCA), this paper therefore compares the economic viability and carbon abatement potential of biochar production via pyrolysis, with that of bioenergy production via briquetting and gasification. Straw reincorporation and in‐field straw burning are used as baseline scenarios. We find that briquetting straw for heat energy is the most cost‐effective carbon abatement technology, requiring a subsidy of $7 MgCO2e−1 abated. However China's current bioelectricity subsidy scheme makes gasification (NPV $12.6 million) more financially attractive for investors than both briquetting (NPV $7.34 million), and pyrolysis ($−1.84 million). The direct carbon abatement potential of pyrolysis (1.06 MgCO2e per odt straw) is also lower than that of briquetting (1.35 MgCO2e per odt straw) and gasification (1.16 MgCO2e per odt straw). However indirect carbon abatement processes arising from biochar application could significantly improve the carbon abatement potential of the pyrolysis scenario. Likewise, increasing the agronomic value of biochar is essential for the pyrolysis scenario to compete as an economically viable, cost‐effective mitigation technology.

Abstract Stable aqueous TiO2 nanofluids with different particle (agglomerate) sizes and concentrations are formulated and measured for their static thermal conductivity and rheological behaviour. The nanofluids are then measured for their heat transfer and flow behaviour upon flowing upward through a vertical pipe in both the laminar and turbulent flow regimes. Addition of nanoparticles into the base liquid enhances the thermal conduction and the enhancement increases with increasing particle concentration and decreasing particle (agglomerate) size. Rheological measurements show that the shear viscosity of nanofluids decreases first with increasing shear rate (the shear thinning behaviour), and then approaches a constant at a shear rate greater than ∼100 s−1. The constant viscosity increases with increasing particle (agglomerate) size and particle concentration. Given the flow Reynolds number and particle size, the convective heat transfer coefficient increases with nanoparticle concentration in both the laminar and turbulent flow regimes and the effect of particle concentration seems to be more considerable in the turbulent flow regime. Given the particle concentration and flow Reynolds number, the convective heat transfer coefficient does not seem to be sensitive to the average particle size under the conditions of this work. The results also show that the pressure drop of the nanofluid flows is very close to that of the base liquid flows for a given Reynolds number.

A pot experiment was undertaken to investigate the effects of Cd and Cu mixtures to growth and nutrients (sugar, carotene or vitamin C) of carrot and pakchoi under greenhouse cultivation condition. The study included: (a) physical-chemical properties of soil and soil animals in response to Cd and Cu stress; (b) bioaccumulation of heavy metals, length, biomass, contents of sugar and carotene (vitamin C) of carrot and pakchoi; (c) estimation the effects of Cd and Cu mixtures by multivariate regression analysis. The results implied that heavy metals impacted negative influence on soil animals' abundance. The metals contents in plants increased obviously with Cd and Cu contamination in soil. The biomass production and nutrients declined with Cd and Cu contents increasing. Cd (20 mg kg-1) treatment caused maximum reduction of sugar content (45.29%) in carrot root; maximum reduction in carotene content (75.73%) in carrot, 75.1% sugar content reduction and 70.58% vitamin C content reduction in pakchoi shoots were observed with addition of Cd (20 mg kg-1) and Cu (400 mg kg-1) mixture. The results of multivariate regression analysis indicated that combination of Cd and Cu exerts negative effects to both carrot and pakchoi, and both growth and nutrients were negatively correlated with metals concentrations. It is concluded that the Cd and Cu mixtures caused toxic damage to vegetable plants as Cd and Cu gradient concentrations increased.

A Bayesian network model was developed to assess the combined influence of nutrient conditions and climate on the occurrence of cyanobacterial blooms within lakes of diverse hydrology and nutrient supply. Physicochemical, biological, and meteorological observations were collated from 20 lakes located at different latitudes and characterized by a range of sizes and trophic states. Using these data, we built a Bayesian network to (1) analyze the sensitivity of cyanobacterial bloom development to different environmental factors and (2) determine the probability that cyanobacterial blooms would occur. Blooms were classified in three categories of hazard (low, moderate, and high) based on cell abundances. The most important factors determining cyanobacterial bloom occurrence were water temperature, nutrient availability, and the ratio of mixing depth to euphotic depth. The probability of cyanobacterial blooms was evaluated under different combinations of total phosphorus and water temperature. The Bayesian network was then applied to quantify the probability of blooms under a future climate warming scenario. The probability of the “high hazardous” category of cyanobacterial blooms increased 5% in response to either an increase in water temperature of 0.8°C (initial water temperature above 24°C) or an increase in total phosphorus from 0.01 mg/L to 0.02 mg/L. Mesotrophic lakes were particularly vulnerable to warming. Reducing nutrient concentrations counteracts the increased cyanobacterial risk associated with higher temperatures.

Gynura divaricata (L.) DC and G. bicolor DC are used as secret recipes to treat diabetes mellitus in some parts of China. Pharmacological tests were performed to prove the anti-hyperglycemic effect of these two plants of genus Gynura Cass. in this study. Both water and 95% ethanol extracts of fresh G. divaricata had significant effects on lowering blood glucose level in normal mice, in which the dose of 0.4 g (crude drug)/kg of 95% ethanol extract was more effective than 50 mg/kg glyburide. The ethyl acetate and n-butanol extracts of dried G. divaricata had significant effects on lowering blood glucose level in normal and alloxan diabetic mice too. Both ethyl acetate and n-butanol extracts of dried G. bicolor showed very significant effect on lowering blood glucose level to normal and alloxan-diabetic mice, and the dose 4.0 g (crude drug)/kg had a more hypoglycemic effect than 50 mg/kg glyburide in normal mice.