• Energy Research
• other engineering and technologies close
• 6. Clean water close
• ES close
• NL close

[EN]A systematic approach is developed for the conceptual optimal design of biomethane production via carbon capture. A hybrid heuristic-mathematical procedure is proposed to determine the optimal technology and operating conditions. The heuristic step consists of a literature-based screening of the available technologies. After the prescreening stage, the technologies selected are amine absorption, pressure swing adsorption (PSA), and membrane separation. The mathematical stage is composed of two steps. First, different alternatives for each technology are modeled based on first principles and rules of thumb. These models are used to select the optimal configuration for each process considered. Second, a superstructure model for biomethane production is developed integrating the pre-selected upgrading technologies to select the optimal process, as well as to determine the optimal operating conditions. Four waste sources are analyzed: cattle manure, swine manure, municipal food waste, and sludge. The results suggest that the best amine is diethanolamine (DEA), the best membrane material is the polyimide, and the suggested zeolite is 13X among the ones studied. Finally, among the three technologies, the overall results show that carbon capture using a PSA system using zeolite 13X results in lower production and investment costs, but very close to the use of membranes. The results indicate that food waste shows the lowest production cost for biomethane 0.36 €/Nm3, due to the largest organic matter content, whereas the investment costs are 67 M€, considering a biogas production rate of 0.035 kg of biomethane per kg of waste and the processing of 311 kt/yr of food waste. Credits or incentives are still needed for biomethane to be competitive with fossil natural gas. Junta de Castilla y León y USAL

AbstractSulfate reduction in salt‐rich wastewaters using unadapted granular sludge was investigated in 0.9 L UASB reactors (pH 7.0 ± 0.2; hydraulic retention time from 8–14 h) fed with acetate, propionate, or ethanol at organic loading rates up to 10 gCOD.L−1.day−1 and in excess sulfate (COD/SO of 0.5). High‐rate sulfate reduction rates (up to 3.7 gSO42‐.L−1.day−1) were achieved at salinities exceeding 50 gNaCl.L−1 and 1 gMgCl2.L−1. Sulfate reduction proceeded at a salinity of up to 70 gNaCl.L−1 and 1 gMgCl2.L−1 (corresponding to a conductivity of about 85–90 mS.cm−1), although at lower rates compared to a conductivity of 60–70 mS.cm−1. Ethanol as well as propionate were suitable substrates for sulfate reduction, with acetate and sulfide as the end products. The successful high‐rate treatment was due to the proliferation of a halotolerant incomplete oxidizing SRB population present in the unadapted inoculum sludge. Bioaugmentation of this sludge with the acetate oxidizing halotolerant SRB Desulfobacter halotolerans was unsuccessful, as the strain washed out from the UASB reactor without colonizing the UASB granules. © 2004 Wiley Periodicals, Inc.

Although recent research has demonstrated that waste orange peel (WOP) is a potentially valuable resource that can be transformed into high value products, heat generation, biomethanisation and composting might be considered the most feasible alternatives in terms of yield. This study revealed that WOP can be successfully valorised through combustion. However, a previous drying step, which generates hazardous wastewater, is required and harmful NOx are emitted with the flue gases. In contrast, a high yield of renewable methane (280LSTPCH4/kg added COD, chemical oxygen demand) and an organic amendment can be obtained through the thermophilic biomethanisation of WOP following the removal of valuable essential oils from the peel. Co-composting of WOP combined at different proportions (17-83%) with the organic fraction of municipal solid waste (OFMSW) was also demonstrated to be suitable. Moreover, a 37% reduction in odour generation was observed in co-composting of WOP compared to single composting of OFMSW.

In membrane bioreactors applied to wastewater treatment, fouling is typically a complex function of sludge characteristics. A pilot-scale tertiary submerged membrane bioreactor (tMBR) was continuously operated for over 200 days to assess the effect of biomass physiological state and environmental stress on process performance. Sludge characteristics were evaluated in terms of suspended solid concentration (MLSS and MLVSS), apparent viscosity, bioflocculation state, filterability, bioactivity, biopolymeric clusters (BPCs) and soluble microbial products. During the initial period of the tMBR start-up, when MLSS was below 3000 mg/L, the biomass was found to be very sensitive to environmental stress by sudden oxygen increase or organic shock loading, resulting in temporary biomass deflocculation and BPC release, and consequently, severe induced membrane fouling. However, at higher MLSS values, low stable biomass growth (0.04 ± 0.002 kg MLVSS/kg COD) was measured, regardless of organic overloading shocks or feeding failures. This period was also characterised by low bioactivity, BPC content and membrane fouling. Statistical analysis showed that BPCs have an important role when compared with other sludge properties as indicators of its fouling potential.

The global energy demand is growing substantially. Clean and secure energy supply is a must for our civilization's sustainable development. Solar and wind energy is growing fast and can contribute significantly to meet the goals set by many countries to reduce greenhouse gas emissions. A deep and wide investigation of the environmental impact of solar and wind energy is important before any solar or wind plants' construction is made. In this study, the literature is reviewed to summarize the environmental impact of solar and wind energy systems in terms of the following factors; land use, water consumption, impact on biodiversity, visual and noise effects, health issues, and impact on micro climate. Although the benefits of solar and wind energy are obvious and great, negative perception of these technologies can inhibit their wide penetration in some regions. This review paper includes a critical and an inclusive analysis of solar and wind energy’s environmental impact and may serve as an important tool to conduct a proper environmental impact assessment. This critical analysis may serve also as a tool for developers, policy, and decision-when planning future solar and wind farms.

Abstract Pyrolysis is currently being considered as an alternative method of treating sewage sludge. It yields residual oils and gases, which can be used as fuels, and a solid which can either be burned or physically activated with air or CO 2 . The aim of this work was to study the influence of different pyrolysis conditions (e.g. temperature and heating rate) on the reactivity in air and in CO 2 of carbonaceous materials obtained from these types of residues. An anaerobic sewage sludge produced in a Spanish urban waste water treatment plant, containing 5 wt.% moisture after air-drying, was pyrolyzed in an electrical laboratory furnace under different pyrolysis conditions. Non-isothermal reactivities (up to 1100°C) in air and in CO 2 of the carbonaceous materials obtained after pyrolysis were performed in a thermobalance. The TG and DTG curves obtained from these experiments are discussed.

Chalcocite (Cu2S) has the fastest kinetics of dissolution of Cu in chlorinated media of all copper sulfide minerals. Chalcocite has been identified as having economic interest due to its abundance, although the water necessary for its dissolution is scarce in many regions. In this work, the replacement of fresh water by sea water or by reject brine with high chloride content from desalination plants is analyzed. Additionally, the effect of adding MnO2 from available manganese nodules in vast quantities at the bottom of the sea is studied. Reject brine shows better results than sea water, and the addition of MnO2 to the brine significantly increases the kinetics of chalcocite dissolution in a short time. H2SO4 concentration is found to be irrelevant when working at high concentrations of chloride and MnO2. The best results, 71% Cu extractions in 48 h, are obtained for reject brine, 100 mg of MnO2 per 200 g of mineral and H2SO4 0.5 mol/L. The results are expected to contribute to a sustainable process of dissolution of chalcocite by using the reject brine from desalination plants.

Anaerobic digestion is a commercial reality for several kinds of waste. Nonetheless, anaerobic digestion of single substrates presents some drawbacks linked to substrate characteristics. Anaerobic co-digestion, the simultaneous digestion of two or more substrates, is a feasible option to overcome the drawbacks of mono-digestion and to improve plants economic feasibility. At present, since 50% of the publication has been published in the last two years, anaerobic co-digestion can be considered the most relevant topic within anaerobic digestion research. The aim of this paper is to present a review of the achievements and perspectives of anaerobic co-digestion within the period 2010-2013, which represents a continuation of the previous review made by the authors [3]. In the present review, the publications have been classified as for the main substrate, i.e., animal manures, sewage sludge and biowaste. Animal manures stand as the most reported substrate, agro-industrial waste and the organic fraction of the municipal solid waste being the most reported co-substrate. Special emphasis has been made to the effect of the co-digestion over digestate quality, since land application seems to be the best option for digestate recycling. Traditionally, anaerobic co-digestion between sewage sludge and the organic fraction of the municipal solid waste has been the most reported co-digestion mixture. However, between 2010 and 2013 the publications dealing with fats, oils and greases and algae as sludge co-substrate have increased. This is because both co-substrates can be obtained at the same wastewater treatment plant. In contrast, biowaste as a main substrate has not been as studied as manures or sewage sludge. Finally, three interdisciplinary sections have been written for addressing novelty aspects in anaerobic co-digestion, i.e., pre-treatments, microbial dynamics and modeling. However, much effort needs to be done in these later aspects to better understand and predict anaerobic co-digestion.