• Energy Research
• 6. Clean water close
• CN close
• GB close
• Bioresource Technology close

The microbial electrolysis desalination and chemical-production cell (MEDCC) is a device to desalinate seawater, and produce acid and alkali. The objective of this study was to enhance the desalination and chemical-production performance of the MEDCC using two types of stack structure. Experiments were conducted with different membrane spacings, numbers of desalination chambers and applied voltages. Results showed that the stack construction in the MEDCC enhanced the desalination and chemical-production rates. The maximal desalination rate of 0.58 ± 0.02 mmol/h, which was 43% higher than that in the MEDCC, was achieved in the four-desalination-chamber MEDCC with the AEM-CEM stack structure and the membrane spacing of 1.5mm. The maximal acid- and alkali-production rates of 0.079 ± 0.006 and 0.13 ± 0.02 mmol/h, which were 46% and 8% higher than that in the MEDCC, respectively, were achieved in the two-desalination-chamber MEDCC with the BPM-AEM-CEM stack structure and the membrane spacing of 3mm.

This study focused on the effects of plant compositions on removal rates of pollutants in microcosms through investigating rhizosphere microbial populations, photosynthetic efficiency and growth characteristics. Mixed-culture groups improved the removal efficiency of TN and TP significantly but exhibited lower COD removal rates. Total plant biomasses were improved as the species richness increased, but the N/P content in the plants was mainly affected by the type of species. The mixed-culture groups showed lower photosynthesis rates and oxygen supply generated from roots under high irradiation. Microbial communities of the cultured groups in the rhizosphere exhibited significant differences. According to principal component analysis (PCA), the fungi were the typical microbes of SPA, SPAB, and SPABC, resulted in improvement in nutrient accumulation. These results demonstrated that a mixed culture strategy can represent the overyielding of biomass, promote the photo-protection mechanism, and will further increase the removal rates of pollutants in a constructed wetland.

Influence of different pretreated sludge for electricity generation in microbial fuel cells (MFCs) was investigated in this study. Pre-treatment has shown significant improvement in MFC electricity productivity especially from microwave treated sludge. Higher COD reduction in the MFC has been revealed from microwave treated sludge with 55% for total and 85% for soluble COD, respectively. Nonetheless, longer ozonation treatment did not give additional advantage compared to the raw sludge. On the other hand, samples from anodes were analyzed using the 16S rRNA gene-based pyrosequencing technique for microbial community analysis. There was substantial difference in community compositions among MFCs fed with different pretreated sludge. Bacteroidetes was the abundant bacterial phylum dominated in anodes of higher productivity MFCs. These results demonstrate that using waste sludge as the substrate in MFCs could achieve both sludge reduction and electricity generation, and proper pre-treatment of sludge could improve the overall process performance.

Antibiotics removal and ARGs control in microbial fuel cell (MFC) has received extensive attention. In particular, the critical role of bioelectrochemical characteristics deserves further study. Bioelectrochemical characteristics significantly affected sulfamethoxazole (SMX) removal and ARGs fate, in which the current intensity played a more critical role than anode potential. High-concentration SMX (2 mg/L and 10 mg/L) facilitated the anode potential tend to be close, and thus, the strengthening effect of current on the system was highlighted. However, the SMX degradation pathway under different bioelectrochemical characteristics was not affected. Furthermore, the higher current intensity was preferable to antibiotic removal, but unfavorable for ARGs control might be due to the oxidative stress on microorganisms. Low-concentration SMX (0.5 mg/L) contributed to improving higher electricity generation because of Geobacter enrichement. This study suggested that appropriate bioelectrochemical characteristics regulation in MFCs was essential in removing antibiotics and controlling ARGs.

In this work, neutral lipids (NLs) extraction capacity and selectivity of six solvents were firstly compared. In addition, an eco-friendly solvent combination of ethyl acetate and ethanol (EA/E) was proposed and tested for lipid extraction from Chlorella sp. cultivated in outdoor raceway ponds and effect of extraction variables on lipid yield were intensively studied. Results indicated that lipid extraction yield was increased with solvent to biomass ratio but did not vary significantly when the value exceeded 20:1. Lipid yield was found to be strongly dependent on extraction temperature and time. Finally, fatty acid profiles of lipid were determined and results indicated that the major components were octadecanoic acid, palmitic acid, linoleic acid and linolenic acid, demonstrating that the lipid extracted from the Chlorella sp. cultivated in outdoor raceway ponds by EA/E was suitable feedstock for biodiesel production.

Microbial electrolysis cell (MECs) were investigated as a promising technology to manage waste activated sludge (WAS) reduction and bio-methane generation. The effect of WAS concentration on the MECs performance was discussed. At the optimal concentration of 15gCOD/L, maximum methane yield of MECs fed with alkaline pretreated WAS (A-WAS) were achieved with the value of 77.13±2.52LCH4/kg-COD on Day 3, which had been improved by 1.5-fold compared with MECs fed with raw WAS (R-WAS), while that was negligible in open circuit controls. Efficient sludge reduction was also obtained in terms of TCOD, total protein, TSS and VSS removal. Pyrosequencing revealed the dominance of exoelectrogen Geobacter and hydrogen-producing bacteria Petrimonas in MECs fed with WAS. Methanocorpusculum with the capacity of methane generation using CO2 and H2 also showed overwhelming dominance (96.01%). The large proportions of Petrimonas and Methanocorpusculum indicated the occurrence of hydrogenotrophic methanogenesis in our methane-producing MECs.

In order to relieve the suppression problems of methanogenesis with microorganisms surrounded by undegraded lipids in food waste, hydrothermal alkali pretreatment was utilized to degrade lipids for promoted methane production through the co-production process of hydrogen with methane. GC-MS results demonstrated that oleic acids and hexadecanoic acids derived from degraded glycerol trioleate increased (from 43.29% to 58.22%, and from 1.06% to 8.25%, respectively) when the pretreatment temperature was increased from 160 °C to 220 °C. SEM, TEM and FTIR analyses showed that the pre-treatment at 220 °C effectively degraded 87.56% of glycerol trioleate and drastically relieved the covering of methanogens by non-degraded lipids. The methane yield and the production peak rate of glycerol trioleate also increased (from 636.85 to 877.47 mL CH4/g-total volatile solid (VS), and from 32.60 to 51.22 mL CH4/g-VS/d, respectively), which led to an increased energy conversion efficiency from 48.05% to 66.21% through the co-production of hydrogen with methane.

Air-cathode microbial fuel cells (MFCs), obtained by inoculating with an aerobic activated sludge, were activated over a one month period, at pH 10.0, to obtain alkaline MFCs. The alkaline MFCs produced stable power of 118mWm(-2) and a maximum power density of 213mWm(-2) at pH 10.0, using glucose as substrate. The performance of the MFCs was enhanced to produce a stable power of 140mWm(-2) and a maximum power density of 235mWm(-2) by increasing pH to 11.0. This is the highest pH for stably operating MFCs reported in the literature. Power production was found to be suppressed at higher pH (12.0) and lower pH (9.0). Microbial analysis indicated that Firmicutes phylum was largely enriched in the anodic biofilms (88%), within which Eremococcus genus was the dominant group (47%). It is the first time that Eremococcus genus was described in bio-electrochemical systems.