• Energy Research
• Open Access close
• Restricted close
• GB close
• ES close
• CA close

Sustainable electricity generation is one of the major current challenges for our society. In this context, the evolution of nanomaterials and nanotechnologies has enabled the fabrication of microscopic devices to produce clean energy from a great variety of renewable sources. To expand the possibilities of energy generation, we have designed and fabricated bioinorganic generators capable to produce electricity by conversion of chemical energy from renewable fuel sources. Unlike traditional generators, the systems described herein produce mechanical energy through enzyme-driven gas production which generates vibration and pressure that are thus converted into electricity by the action of a piezoelectric component properly integrated into the device. Our generators are able to produce an electric ernergy from different renewable sources like glucose, ethanol, and amino acids, attaining energy outputs around 250 nJ cm–2 and reaching maximum open-circuit voltages of up to 1 V. In addition, the produced energy can be easily regulated by adjusting both enzyme and fuel concentration which can tune the electrical output according to the application. The systems described herein propose a new concept for self-sufficient energy harvesting that bridges biocatalysis and piezoelectricity, where the energy production is based on the piezoelectric effect triggered by enzymatic action rather than on the enzyme-driven electron transfer that governs biofuel cells. Although the electric output is too low yet to be considered an alternative for energy production, this technology opens the door to power small devices. We envision the utilization of this technology in such remote locations where mechanical energy is lacking but there are chemical energy reservoirs. We would like to acknowledge Marie-Curie Actions (NANOBIENER project), IKERBASQUE foundation for funding F.L.-G., and the support of COST Action CM1303 Systems Biocatalysis. We also acknowledge HERGAR foundation for the funding. Peer reviewed

Abstract This paper uses research-quality, ground measurements of irradiance and temperature that are accurate to ±2% to estimate the electric energy yield of fixed solar modules for utility-scale solar power plants at 18 sites in Saudi Arabia. The calculation is performed for a range of tilt and azimuth angles and the orientation that gives the optimum annual energy yield is determined. A detailed analysis is presented for Riyadh including the impact of non-optimal tilt and azimuth angles on annual energy yield. It is also found that energy yield in March and October are higher than in April and September, due to milder operating temperatures of the modules. A similar optimization of tilt and azimuth is performed each month separately. Adjusting the orientation each month increases energy yield by 4.01% compared to the annual optimum, but requires considerable labour cost. Further analysis shows that an increase in energy yield of 3.63% can be obtained by adjusting the orientation at five selected times during the year, thus significantly reducing the labour requirement. The optimal orientation and corresponding energy yield for all 18 sites is combined with a site suitability analysis taking into account climate, topography and proximity to roads, transmission lines and protected areas. Six sites are selected as having high suitability and high energy yield: Albaha, Arar, Hail, Riyadh, Tabuk and Taif. For these cities the optimal tilt is only slightly higher than the latitude, however the optimum azimuth is from 20° to 53° west of south due to an asymmetrical daily irradiance profile.

Este trabajo se centra en el modelado mediante TRNSYS de una bomba de calor geotérmica agua-agua que utiliza CO2 como refrigerante para producir agua caliente sanitaria (ACS), para posteriormente hacer un estudio comparativo con una instalación solar. Dicha instalación se encuentra disponible en el laboratorio de Calor y Frío del ELDI. Los objetivos principales del trabajo son: - Estudiar y entender el funcionamiento de la bomba de calor y de todos sus componentes. - Conocer las ventajas que presente el CO2 como refrigerante. - Búsqueda de información acerca de los sistemas de captación de energía geotérmica. - Modelar los componentes que constituyen una bomba de calor geotérmica. - Programar los modelos seleccionados mediante el compilador FORTRAN. - Simulación de la bomba de calor en TRNSYS a partir de los componentes programados que la forman. - Realizar un estudio comparativo con un sistema solar convencional a base de colectores solares. ; Escuela Técnica Superior de Ingeniería Industrial ; Universidad Politécnica de Cartagena

Abstract. Flooding in the Amazon basin is frequently attributed to modes of large-scale climate variability, but little attention is paid to how these modes influence the timing and duration of floods despite their importance to early warning systems and the significant impacts that these flood characteristics can have on communities. In this study, river discharge data from the Global Flood Awareness System (GloFAS 2.1) and observed data at 58 gauging stations are used to examine whether positive or negative phases of several Pacific and Atlantic indices significantly alter the characteristics of river flows throughout the Amazon basin (1979–2015). Results show significant changes in both flood magnitude and duration, particularly in the north-eastern Amazon for negative El Niño–Southern Oscillation (ENSO) phases when the sea surface temperature (SST) anomaly is positioned in the central tropical Pacific. This response is not identified for the eastern Pacific index, highlighting how the response can differ between ENSO types. Although flood magnitude and duration were found to be highly correlated, the impacts of large-scale climate variability on these characteristics are non-linear; some increases in annual flood maxima coincide with decreases in flood duration. The impact of flood timing, however, does not follow any notable pattern for all indices analysed. Finally, observed and simulated changes are found to be much more highly correlated for negative ENSO phases compared to the positive phase, meaning that GloFAS struggles to accurately simulate the differences in flood characteristics between El Niño and neutral years. These results have important implications for both the social and physical sectors working towards the improvement of early warning action systems for floods.

The objective of this work is to valorise the discharges (rejections) of the Boukhedra iron ore mine (east of Algeria) as raw materials for the elaboration of the cement raw. The study concerns the development of different types of low impact environmental belite cements whose raw are exclusively mine rejections. The use of a low CaO / SiO2 ratio and the combination of quick cooling of clinker with adequate NaF and LiF mineralization in association with CaSO4, has led to the production of belite cement with high hydraulic reactivity comparable to that of ordinary Portland cements. The used mineralization plays also a positive role in improving performance in terms of firing of the raw, by lowering the clinker process temperatures of these cements, thus, enabling an additional gain in terms of environmental impact and energy consumption. This mineralization and the low LSF of these cements allows obtaining them at low burning temperatures 1150 °C and 1100 °C for the cement with 2%LiF. This is 350 °C lower to ordinary Portland cement. The addition of CaSO4, NaF and LiF to the clinkers makes the improvement of its clinkering possible. The effect of LiF seems to be the most significant followed by NaF and finally, CaSO4

The energy considered as waste heat in industrial furnaces owing to inefficiencies represents a substantial opportunity for recovery by means of thermal energy storage (TES) implementation. Although conventional systems based on sensible heat are used extensively, these systems involve technical limitations. Latent heat storage based on phase change materials (PCMs) results in a promising alternative for storing and recovering waste heat. Within this scope, the proposed PCM-TES allows for demonstrating its implementation feasibility in energy-intensive industries at high temperature range. The stored energy is meant to preheat the air temperature entering the furnace by using a PCM whose melting point is 885 °C. In this sense, a heat transfer model simulation is established to determine an appropriate design based on mass and energy conservation equations. The thermal performance is analysed for the melting and solidification processes, the phase transition and its influence on heat transference. Moreover, the temperature profile is illustrated for the PCM and combustion air stream. The obtained results prove the achievability of very high temperature levels (from 700 to 865 °C) in the combustion air preheating in a ceramic furnace; so corroborating an energy and environmental efficiency enhancement, compared to the initial condition presenting an air outlet at 650 °C.

At the 1972 Stockholm Conference, participating States expressed concern about the extent and consequences of air pollution, laying the groundwork for international legal cooperation to address it. The Action Plan for the Human Environment included the need to promote scientific observation of the atmosphere, and the principles set out in the Stockholm Declaration served, as in other areas of environmental international law, to articulate the response to the threats identified. Since that meeting, the evolution of international legal protection of the atmosphere has been marked by the implementation of three international regimes. The European regime on transboundary air pollution, inaugurated in 1979, was the first model of international cooperation in this field, and influenced subsequent developments in the regimes on ozone layer protection and climate change. Taking into account the foundational impetus that the Stockholm Conference provided for the development of these regimes, this paper analyses the evolution of international legal protection of the atmosphere in the fifty years since the Conference was held