• Energy Research
• other engineering and technologies close
• 6. Clean water close
• CN close
• ES close
• IT close

Environment-friendly treatment of sewage sludge has become tremendously important. Conversion of sewage sludge into energy products by environment-friendly conversion process, with its energy recovery and environmental benefits, is being paid significant attention. Direct liquefaction of sewage sludge into bio-oils with supercritical water (SCW) was therefore put forward in this study, as de-water usually requiring intensive energy input is not necessary in this direct liquefaction. Supercritical water may act as a strong solvent and also a reactant, as well as catalyst promoting reaction process. Experiments were carried out in a self designed high-pressure reaction system with varying operating conditions. Through orthogonal experiments, it was found that temperature and residence time dominated on bio-oil yield compared with other operating parameters. Temperature from 350 to 500°C and reaction residence time of 0, 30, 60min were accordingly investigated in details, respectively. Under supercritical conversion, the maximum bio-oil yield could achieve 39.73%, which was performed at 375°C and 0min reaction residence time. Meanwhile, function of supercritical water was concluded. Fuel property analysis showed the potential of bio-oil application as crude fuel.

To find an appropriate method for sulfate-rich wastewater containing ethanol and acetate with COD/sulfate ratio of 1, a UASB reactor was operated for more than 180 days. The influences of HRT (hydraulic retention time) and OLR (organic loading rate) on organics and sulfate removal, gas production, and electrons utilization were investigated. The sludge activity and microorganism composition were also determined. The results indicated that this system removed more than 80% of COD and 30% of sulfate with HRT above 6h and OLR below 12.3 gCOD/L d. Further HRT decrease caused volatile fatty acids accumulation and performance deterioration. Except at HRT of 2h, COD and electron flow were mostly utilized by methane-producing archaea (MPA), and methane yield remained in the range of 0.18-0.24 LCH4/gCOD. Methane was mainly generated by Methanosaeta concilii GP6 with acetate as substrate, whereas sulfate was mainly reduced by incomplete-oxidizing Desulfovibrio species with ethanol as substrate.

Abstract The 2013/2017 Nankai Trough (Japan) and 2017 Shenhu Area (China) offshore methane hydrate production tests showed the world the possibility and feasibility of the oceanic methane hydrate production by depressurization. However, the relatively low gas production rate still remained as one of the critical bottlenecks for the economical utilization. This study chose the Nankai Trough as a target area, and aimed at the gas recovery enhancement from the methane hydrate reservoir using vertical wells. A traditional single-vertical-well system and a new dual-vertical-well system were proposed, and special production strategies of the aggressive depressurization and permeability improvement were applied to these two systems for the effectiveness verification. Based on the 15-year simulation results, it was found that the middle low-permeability silt-dominated layers in the reservoir held the key to the gas recovery enhancement, and for the single-vertical-well system, the permeability improvement in this sublayer seemed more reliable and feasible than the aggressive depressurization. On the other hand, the dual-vertical-well system significantly exceeded the single-vertical-well system due to the synergistic effect of the two wellbores, and could raise the average gas production rate (9.5 × 103 m3/day) by one order of magnitude (to 7.9 × 104 m3/day). Moreover, if this new system was combined with the aggressive depressurization, the average gas production rate could be further raised by one order of magnitude (to 3.4 × 105 m3/day).

In order to enhance the efficiency and benefits of the sludge anaerobic digestion process, K2FeO4 was added to a sludge anaerobic digestion system, and its effects on the system were comprehensively investigated. Results showed that sludge anaerobic digestion was greatly improved by adding 500 mg/L K2FeO4. Biogas and methane productions were increased by 26.6 and 28.4%, respectively. Sludge reduction, protein removal, and the conversion efficiency of dissolved organics were all improved. The mechanism revealed that the disintegration of sludge flocs, enhancement of protease activity, and decrease of soluble sulfide toxicity on microorganisms contributed to biogas production and sludge reduction. Biogas quality was improved, benefitting from the decreasing H2S content in biogas; as additionally, the cost of biogas desulfuration was reduced. In the biogas slurry treatment, the PO43--P concentrations were decreased by 39%, which also reduced the cost of the dephosphorization processes at certain extent.

The U.S. Environmental Protection Agency’s (EPA) Superfund—the Comprehensive Environmental Response, Compensation, and Liability Act (CERCLA) database—has collected and built an open-source database based on nearly 2000 US soil remediation cases since 1980, providing detailed information and references for researchers worldwide to carry out remediation work. However, the cases were relatively independent to each other, so the whole database lacks systematicness and instructiveness to some extent. In this study, the basic features of all 144 soil remediation projects in four major oil-producing states (California, Texas, Oklahoma and Alaska) were extracted from the CERCLA database and the correlations among the pollutant species, pollutant site characteristics and selection of remediation methods were analyzed using traditional and machine learning techniques. The Decision Tree Classifier was selected as the machine learning model. The results showed that the growth of new contaminated sites has slowed down in recent years; physical remediation was the most commonly used method, and the probability of its application is more than 80%. The presence of benzene, toluene, ethylbenzene and xylene (BTEX) substances and the geographical location of the site were the two most influential factors in the choice of remediation method for a specific site; the maximum weights of these two features reaches 0.304 and 0.288.

Abstract In AP1000 plant, the Automatic Depressurization System (ADS) 1–3 stages operate to discharge the high-temperature and high-pressure steam from the Reactor Coolant System (RCS) primary side to the large heat sink tank In-containment Refueling Water Storage Tank (IRWST) in accidental conditions. The key equipment’s specific shape and arrangement lead to the complicate flow and heat transfer characteristics in IRWST. In the present work, an overall scaled IRWST&ADS sparger experiment has been built up. The thermocouples matrix, flowmeters, pressure transmitters, heat flux sensors, Particle Image Velocimetry (PIV) technique, and high speed camera are employed for the measurements of the key thermal and flow parameters. The local steam jets condensation phenomena as well as the overall flow and thermal behavior are investigated. The experimental results indicate that the thermal stratification phenomenon is obvious in IRWST. The criteria of Richardson Number and Stratification Number are utilized to predict and evaluate the thermal stratification extent, respectively. An improved ADS arrangement design is further proposed to reduce the thermal stratification. Moreover, the multi-holes lumped “steam condensation column” is modeled with characteristic parameters, then the steam condensation heat transfer coefficient range in chugging condensation process is estimated. The experimental results provide practical engineering application reference for the effective operation of the passive safety system in AP1000 plant.

Response of aquatic organisms to eutrophication have been well reported, while less studies are available for the recovery of eutrophic lakes following a reduction in the external loading, especially for systems where nitrogen is reduced but the phosphorus concentration is maintained high due to internal loading. Diatoms are nitrate (NO3-N) opportunists but can also use ammonium (NH4-N). They may, therefore, be more sensitive to nitrogen reduction than other algae that typically prefer NH4-N. We document the variations of nutrients and diatoms in subtropical, eutrophic Lake Taihu over 28 yr during which a reduction of the external loading resulted from lake management. According to the results of change point analysis, data on environmental variables were divided into two periods (P1: 1992-2006; P2: 2007-2019) with two different seasons (WS: Winter-Spring; SA: Summer-Autumn), respectively. Compared with P1-WS, the concentration of NH4-N decreased significantly whereas NO3-N showed no significant change in P2-WS. In contrast, NH4-N concentrations were low and showed no significant changes in P1-SA and P2-SA and NO3-N decreased significantly in the latter period. Accordingly, NO3-N: NH4-N mass ratios in P1-SA and P2-WS were all significantly higher than those in P2-SA and P1-WS, respectively. The biomass of WS diatom increased significantly and the timing of the peak biomass shifted from P1-SA to P2-WS since 2007. The SEM analysis showed that NO3-N was retained as a statistically significant predictor for diatom biomass in P1-SA and significant effects of windspeed, zooplankton and NH4-N on diatom biomass in P2-WS. Windspeed and zooplankton have further changed the biomass of diatoms in the case of declining inorganic nitrogen. We conclude that the magnitude of vernal suppression or stimulation of diatom assemblages has increased, concomitant with the variations of NH4-N and NO3-N: NH4-N mass ratios. Diatoms response to NH4-N or NO3-N is apparently changing in response to water temperature in this eutrophic shallow lake. Thus, parallel reductions in external nitrogen loading, along with variations in dominant inorganic nitrogen, will stimulate the growth of diatom and therefore increase the total biomass of phytoplankton in still high internal phosphorus loading, which is should be regarded as a good sign of restoration measures.

Ammonia increases buffer capacity of methanogenic medium in mesophilic anaerobic reactor thus increasing the stability of anaerobic digestion process. Optimal ammonia concentration ensures sufficient buffer capacity while not inhibiting the process. It was found out in this paper that this optimum depends on the quality of anaerobic sludge under investigation. The optimal concentrations for methanogens were 2.1, 2.6 and 3.1 g/L of ammonia nitrogen in dependence on inoculum origin. High ammonia nitrogen concentration (4.0 g/L) inhibited methane production, while low ammonia nitrogen concentration (0.5 g/L) caused low methane yield, loss of biomass (as VSS) and loss of the aceticlastic methanogenic activity. It was found out that negative effect of low ammonia nitrogen concentration on biomass is caused not only by low buffer capacity but also by insufficiency of nitrogen as nutrient. It was also found out that anaerobic sludge with higher ammonia nitrogen concentration (4.2 g/L) tolerates even concentration of volatile fatty acids (160 mmol/L) which causes inhibition of the process with low ammonia nitrogen concentration (0.2 g/L).

Abstract Dolomite, a naturally occurring Ca-based sorbent, shows superior recycling stability in carbonation/calcination cycles for CO2 capture. However, the separation between Ca and Mg in sorbent during recycling weakens the resistance for sintering from MgO, leading to a drastic reduction in the CO2 carrying activity (spent sorbent). This paper presents a novel method for the reactivation of spent dolomite sorbents. Notable activity recovery is achieved by ball milling of the spent sorbent with H2O and dry ice. Powder X-ray diffraction (XRD) results confirm the transformation from oxide (CaO/MgO) to carbonate (CaCO3/CaMg(CO3)2), so that the segregated Ca and Mg in spent sorbent are re-mixed at the atomic level, which is mainly responsible for this effective reactivation. Water plays an irreplaceable role in this process by providing a liquid environment to accelerate the diffusion of the reactants and ionic reactions. In addition, thermogravimetric analysis was carried out on a series of samples with different ball-milling times to determine the suitable reactivation conditions for CO2 capture.