• Energy Research
• Closed Access close
• Restricted close
• Embargo close
• IT close
• FR close
• NL close

The unpredictable nature of wind energy makes its integration to the electric grid highly challenging. However, these challenges can be addressed by incorporating storage devices (batteries) in the system. We perform an overall assessment of a single domestic power system with a wind turbine supported by an energy storage device. The aim is to investigate the best operation mode of the storage device such that the occurrence of large power spills can be minimized. For estimating the small probability of large power spills, we use the splitting technique for rare-event simulations. An appropriate Importance Function for splitting is formulated such that it reduces the work-load of the probability estimator as compared to the conventional Crude Monte Carlo probability estimator. Simulation results show that the ramp constraints imposed on the charging/discharging rate of the storage device plays a pivotal role in mitigating large power spills. It is observed that by employing a new charging strategy for the storage device large power spills can be minimized further. There exists a trade-off between reducing the large power spills versus reducing the average power spills.

Abstract The elemental dissolution of Cu-Zn alloys was investigated as a function of Zn content ranging from 0 to 45 wt%. Atomic emission spectroelectrochemistry (AESEC) was utilized to directly monitor Cu2+ and Zn2+ release and oxide growth as function of time during potentiodynamic experiments. It was determined that Cu dissolution undergoes a simultaneous mechanism of Cu2O formation and Cu2+ release. The addition of Zn in Cu-Zn alloy does not measurably change the dissolution mechanism of Cu2+ and the rate of aqueous Cu2+ was only dependent on the potential. Zn dissolution was however blocked by the formation of a Cu(0) film which shifted the Zn dissolution in the anodic direction.

The crucial role evaluation can play in the co-development of project design and its implementation will be addressed through the analysis of a case study, the Green Communities (GC) project, funded by the Italian Ministry of Environment within the EU Interregional Operational Program (2007-2013) "Renewable Energy and Energy Efficiency". The project's broader goals included an attempt to trigger a change in Italian local development strategies, especially for mountain and inland areas, which would be tailored to the real needs of communities, and based on a sustainable exploitation and management of the territorial assets. The goal was not achieved, and this paper addresses the issues of how GC could have been more effective in fostering a vision of change, and which design adaptations and evaluation procedures would have allowed the project to better cope with the unexpected consequences and resistances it encountered. The conclusions drawn are that projects should be conceived, designed and carried out as dynamic systems, inclusive of a dynamic and engaged evaluation enabling the generation of feedbacks loops, iteratively interpreting the narratives and dynamics unfolding within the project, and actively monitoring the potential of various relationships among project participants for generating positive social change.

Abstract Economically harvesting energy from a microbial fuel cell (MFC), increasing its electrical power production, and developing its role as a practical energy supply, needs a low-cost and high-performance design of the MFC compartments. According to this strategy, a novel monolithic membrane electrode assembly (MEA) was fabricated and evaluated as an air–cathode in a single-chamber MFC (SCMFC). The MEA was made of bacterial cellulose (BC), conductive multi-walled carbon nanotubes (CNT), and nano-zycosil (NZ). BC, as a nano-celluloses with oxygen barrier property, can maintain anaerobic conditions for the anode compartment. Binder-less CNT coating on BC avoids costly binders such as poly-tetra fluoro ethylene (PTFE) and Nafion and decreases the MEA charge transfer resistance. NZ, as a very cheap modifier, not only prevents the anolyte leakage but also provides more MEA’s active sites for the oxygen reduction reaction (ORR). The electrochemical performance of the MEA was compared to a PTFE- based gas diffusion electrode (GDE) in the SCMFC. The MEA cell provided a pulse power density of 1790 mW/m2, roughly twice as high as the pulse power density of GDE (920 mW/m2). SCMFC’s internal resistance decreased from 1.84 KΩ (with GDE) to 0.8 KΩ (with MEA). Also, the cell’s columbic efficiency increased from 4.2% (with GDE) to11.7% (with MEA). Additionally, the capacitance of the MEA (65 mF) was much higher than the value for GDE (0.73 mF). Thus, the MEA compared to the GDE showed higher performance in the SCMFC for electricity generation and wastewater treatment at a lower cost.

Background:  Acute and chronic ethanol exposure produces profound impairments in motor functioning. Individuals with lower sensitivity to the acute motor impairing effects of ethanol have an increased risk of developing alcohol dependence and abuse, and infants with subtle delays in motor coordination development may have an increased risk for subsequently developing alcoholism. Thus, understanding the mechanism by which ethanol disrupts motor functioning is very important.Methods:  Parasagittal slices of the cerebellar vermis (250 μM thick) were prepared from P17 to 20 Sprague–Dawley rats. Whole‐cell recordings of Purkinje cells were obtained with an Axopatch 200B amplifier. Parallel fiber‐Purkinje cell synaptic currents were sampled at 1 kHz and digitized at 10 kHz, and synaptic long‐term depression (LTD) was observed in either external or internal application of ethanol for comparison.Results:  We determined whether ethanol acutely affects parallel fiber LTD using whole‐cell patch‐clamp recordings from Purkinje cells. Application of ethanol both externally (50 mM) and internally (17 and 10 mM) significantly suppressed mGluR‐mediate slow currents. Short‐term external ethanol exposure (50 but not 17 mM) during tetanus blocked mGluR‐dependent parallel fiber LTD. Furthermore, internal 17 and 10 mM ethanol completely inhibited this LTD.Conclusions:  The results of the current study demonstrate that ethanol acutely suppresses parallel fiber LTD and may influence the mGluR‐mediated slow current intracellularly. This study, plus previous evidence by Carta and colleagues (2006) and Belmeguenai and colleagues (2008), suggests significant actions of ethanol on mGluR‐mediated currents and its dependent plasticity in brain.

AbstractA new approach for the replacement of heart valves consists of obtaining an acellular matrix from animal aortic valves that performs mechanically, is nonantigenic, and is free from calcification and fibroblast proliferation. Novel biochemical treatments must be developed for this purpose. In this work, we focus on the characterization of collagen in acellular bovine cardiovascular tissues, fresh or glutaraldehyde treated, and stored in different solutions [phosphate‐buffered saline (PBS), ethanol, octanol, and glutaraldehyde], to determine whether the resulting fibrous material is structurally preserved. The preservation of the triple helical structure of collagen is checked by differential scanning calorimetry (DSC), which is a well suited technique to analyze thermal transitions in proteins, such as denaturation. To get insight into the molecular dynamics of collagen in the nanometric range, we used thermally stimulated currents, a dielectric technique running at low frequency, that measure the dipolar reorientations in proteins submitted to a static electrical field. The combined use of these two techniques allowed us to evaluate the physical structure and conformation of collagen after the different chemical treatments. We have found that the glutaraldehyde treatment followed by octanol storage preserves the triple helical conformation of the polypeptidic chains of collagen, contrary to the ethanol and PBS storage that induce drastic changes in the thermal and dielectric behavior of the protein. Moreover, this particular chemical treatment stabilizes the collagen structure (shift toward high temperature of the collagen denaturation and stiffening of the chains by a cross‐linking action) when compared to the control sample, and so could provide interesting fibrous material for the conception of bioprosthetic heart valve. © 2002 Wiley Periodicals, Inc., J Biomed Mater Res 64A: 330–338, 2003

Abstract This article focuses on the results obtained by the enforcement of a original greenhouse gas emissions policy, issued in recent years in several municipalities in Northern Italy. The Municipality of Reggio Emilia was one of the firsts in Italy to develop and adopt a voluntary building energy-consumption certification method called Ecoabita, aiming to promote energy efficiency in buildings over its jurisdiction. Several reasons make this project innovative: first, the certification method has been processed through and verified by a quality international agency, secondly the procedure is assisting financial-incentive policies both on mandatory (European Directive 2002/91/CE) and voluntary basis (Municipality Protocol Ecoabita), finally it allows to obtain eligible credits for avoided emissions that can be negotiated on the CO2 exchange market. With specific reference to Reggio Emilia case, acknowledged the amount of actions, that are normally scheduled in the municipality throughout a year, it has been evaluated the benefit, in terms of environmental improvement, descended from the protocol, also projecting their trend in future years up to 2020 as well, demonstrating the scheduled interventions are fundamental in sought of the achievement of the Kyoto and Copenhagen commitments. The entire procedure has been developed in accordance to the parameters given by UNFCCC for these kinds of analyses and has been recently confirmed to be one of the most accurate international accounting procedure by a survey developed by the scientific committee of the European Project LIFE-LAKS.

The experimental study is conducted to investigate the public opinion on how immigration leads to overpopulation and in turn might damage the sustainable development and environmental protection.