• Energy Research
• Closed Access close
• 7. Clean energy close
• 11. Sustainability close
• 15. Life on land close
• PT close
• AO close

This paper explores how market and regulatory factors affect stakeholders' investments in smart grid projects in Europe. Distribution System Operators (DSOs), universities, and technology manufacturers are leading investors, with a cumulative 2286 M€ financed since 2002. Statistical tests were conducted on these groups' investments in smart grid projects in the EU-28, Norway, and Switzerland from 2008-2015, to evaluate the influence of the following factors on investment: the level of distribution sector concentration, the regulatory mechanism in place, and the existence of innovation stimulus mechanisms. The level of distribution sector concentration did not significantly influence investments by these three groups. Market-minded stakeholders, such as DSOs and technology manufacturers, invested more in countries that employed hybrid, incentive, or innovation-stimulus mechanisms; meanwhile, collaborative knowledge-seeking institutions, such as universities, were not swayed by these factors. Taking these findings into consideration will help policy makers design adequate incentives for stakeholders.

Abstract Lighting simulation is a useful instrument in predicting lighting conditions in buildings. Modelers can use several matrix methods according to the buildings’ characteristics and the objectives of the analysis. However, it is unknown which methods are the most appropriate for lighting analysis of heritage buildings. The Joanina Library located in the University of Coimbra – a World Heritage building – was used to compare different matrix methods (2PH, 3PH, and 5PH) under several solar models (BRL, DISC, Perez, and Reindl) using Radiance-based simulations. On-site measurements (indoor and outdoor) were used to calculate each method’s accuracy under different solar models. The combination of the 2PH method with the DISC solar model presented the highest accuracy with an average MBEr and RMSEr of 2.8 % and 43.6 %, respectively. Therefore, the 2PH method was the best choice for the case study, even though the 3PH method may also be considered, especially for parametric studies of improving measures.

It is shown that due to power take-off losses, optimal control provides maximum energy absorption, but not maximum energy production. A new reactive control criterion in the frequency-domain is deduced assuming constant power take-off efficiency, respectively, in the power feeding and power absorption parts of the wave cycle. If applied in the time-domain, this criterion requires the incident wave to be predicted some time into the future. Whilst the OWC type of Wave Energy Converters (WEC) is presented in the paper, the extension to WECs of the floating body type is also considered. Illustrative numerical results for a two-dimensional OWC of simple geometry are presented, which include the performance of this device in three wave spectra with increasing demands of active control for improved energy production. Linear hydrodynamic theory is considered throughout the paper.

Abstract This paper addresses the importance of the probabilistic analysis in determining the wave energy potential to support the design of electrical generators for wave energy conversion. The irregular activity of ocean waves induces variable frequencies and amplitudes of operation for point absorbers electrical generators, which may lead to the construction of inefficient electrical machines. Applying probabilistic models to describe the ocean wave's behavior allows the determination of the values most likely to be sampled for ocean-state parameters. Knowing these values, the most expected ocean wave potential can be determined and a proper device design can be performed. This work also refers to the importance of using the joint probability models instead of the marginal ones. Seven locations at the Portuguese coast are evaluated in order to determine their wave energy resource potential.

Abstract Despite the significant growth in the number of published life-cycle assessments of biofuels, important aspects have not captured sufficient attention, namely soil carbon emissions from land use change (LUC) and uncertainty analysis. The main goal of this article is to evaluate the implications of different LUC scenarios and uncertainty in the life-cycle energy renewability efficiency and GHG (greenhouse gases) intensity of wheat-based bioethanol replacing gasoline. A comprehensive assessment of different LUC scenarios (grassland or cropland converted to wheat cultivation) and agricultural practices is conducted, which results in different carbon stock change values. The types of uncertainty addressed include parameter uncertainty (propagated into LC (life-cycle) results using Monte-Carlo simulation) and uncertainty concerning how bioethanol co-product credits are accounted for. Results show that GHG emissions have considerably higher uncertainty than energy efficiency values, mainly due to soil carbon emissions from direct LUC and N2O release from cultivated soil. Moreover, LUC dominates the GHG intensity of bioethanol. Very different GHG emissions are calculated depending on the LUC scenario considered. Conversion of full- or low-tillage croplands to wheat cultivation results in bioethanol GHG emissions lower than gasoline emissions, whereas conversion of grassland does not contribute to bioethanol GHG savings over gasoline in the short- to mid-term.

Abstract This paper presents a new methodology for impact assessment—SIAM (Spatial Impact Assessment Methodology)—which is based on the assumption that the importance of environmental impacts is dependent, among other things, on the spatial distribution of the effects and of the affected environment. The information generated by the use of Geographical Information Systems (GIS) in impact identification and prediction stages of Environmental Impact Assessment (EIA) is used in the assessment of impact significance by the computation of a set of impact indices. For each environmental component (e.g., air pollution, water resources, biological resources), impact indices are calculated based on the spatial distribution of impacts. A case study of impact evaluation of a proposed highway in Central Portugal illustrates the application of the methodology and shows its capabilities to be adapted to the particular characteristics of a given EIA problem.

Thermal management is a particularly difficult challenge to the miniaturization of electronic components because it requires high performance cooling systems capable of removing large heat loads at fast rates in order to keep the operating temperature low and controlled. To meet this challenge, the Intermittent Spray Cooling (ISC) concept has been suggested as a promising technology which uses a proper match between the frequency and duration of consecutive injection cycles to control heat transfer. This concept also depends on: the atomization strategy; a homogeneous dispersion of droplets impinging on the hot surface; and the quantitative control of the liquid deposited, avoiding excessive secondary atomization or pre-impingement-evaporation. In this work, the use of liquid atomization by multiple jets impact, also referred as multijet atomization, is the subject of a thermal-fluid assessment using heat transfer correlations previously derived for intermittent sprays. Simultaneous measurements of droplet size and velocity are provided as input for the correlations and the analysis explores the influence of the number of impinging jets on the heat removal pattern and magnitude. Emphasis is put on the promising applicability of multijet atomization for promoting an intelligent use of energy in the thermal management of electronic devices.

Abstract Wave energy extraction in coastal regions may be an excellent alternative due to the increase in global demand for renewable energy. The viability study of this extraction depends on the evaluation of the wave energy potential that is higher in regions located in high latitudes. Therefore, this study shows evaluation and characterization of wave energy in the south of Brazil. Numerical simulations were carried out by the Mike 21 SW spectral model which was calibrated and validated in the region measurement campaigns. Annual, seasonal and monthly means and the temporal variability of the wave energy potential in a 10-year wave hindcast were analyzed offshore and nearshore. Annual mean fluxes in three points nearshore had similar values; the highest one was 6.7 kW/m, while the wave energy flux offshore was 22.3 kW/m. The refraction and the bottom friction dissipation were responsible for the wave attenuation from offshore to nearshore and, consequently, for the decrease in wave energy. The annual, seasonal and monthly variabilities of wave energy fluxes were moderate offshore and high nearshore. A directional analysis showed that the dominant wave directions were S and NE offshore whereas they were SSE and E nearshore.

Metal accumulation by Juncus maritimus and the effect this plant might have on the physico-chemical composition of sediments, from Douro river estuary (NW Portugal), were investigated through one year of plant's life. The contents of Al, Cd, Cr, Cu, Fe, Mn, Ni, Pb and Zn were determined (by atomic absorption spectrophotometry) in sediments, rhizosediments (those among plant roots and rhizomes) and different tissues of J. maritimus. Two estuarine sites with different characteristics were studied, one a sandy sediment with relatively low organic matter content, the other a muddy site. The role of the plant seemed to be markedly dependent on the sediment composition. At the sandy site, significant variations throughout the year (a decrease from winter to summer and an increase in autumn) either in rhizosediment and sediment or in J. maritimus roots were only observed in Cd and Cu levels. These variations were the same in both compartments, probably caused by tidal water movements and the activity of the plant. At the muddy site, variations throughout the year were observed for all studied elements but Pb. Changes in the Cd and Zn contents of roots were opposite to those in the rhizosediment (uptake of Cd and Zn by J. maritimus roots in summer may have caused a decrease in rhizosediment levels). Fe and Mn showed similar patterns of variation in both roots and rhizosediment (contents significantly increasing in summer). Higher contents of Fe and Mn in roots in summer could be related to changes in mass, higher availability of the elements, or accumulation at the surface of the root in (hydr)oxides forms. For the remaining elements no significant correlations between rhizosediment and roots variations were observed, indicating that their uptake and release by roots were not based on single exchanges with the sediment. J. maritimus showed capacity to accumulate Cu, Zn and particularly Cd, thus appearing to be useful for the phytostabilization of these metals.