• Energy Research
• Open Access close
• Closed Access close
• Open Source close
• Embargo close
• 6. Clean water close
• 2. Zero hunger close
• SA close

The environmental control and management of municipal solid waste (MSW) dumping sites is considered one of the sensitive challenges faced by executive municipalities. This is especially true in Makkah due to the gradual increase in urban population and visitors, with an overall MSW generation of about one million tons per year. Consequently, the geo-environmental evaluation of the Kaakia dumping site shed light on the potential environmental threats, in terms of ambient air quality levels and meteorological parameters, in addition to geophysical inspection. An air quality survey discussed the major trends of ambient air pollutants (SO2, NO2, CO, O3, CH4, and PM10) downwind from the Kaakia dumping site. It indicated the presence of a significant increase in sporadic plumes of Methane concentration. The maximum hourly averages ranged between 22.9–26.6 µg/m3 for SO2, 44.4–64.0 µg/m3 for NO2, 0.86–1.38 mg/m3 for CO, 150.2–158.8 µg/m3 for O3, 5.09–5.9 ppm for CH4, and 955–994 µg/m3 for PM10. The ground penetrating radar (GPR) geophysical survey indicated the subsurface sequence of three geological layers, as confirmed by nearby bores of the investigated site: (1) a surface layer formed of alluvial sediments of sand, which were 2.5–3.1 m thick; (2) a second layer represented by sand and gravel, with a thickness of 4.6–6.5 m; and (3) a third layer equivalent to saturated alluvial sediments mixed with rock fragments that extended to a depth of 13 m. The signals of the GPR were attenuated at the base of the conducted profiles due to the percolation of generated leachate to the subsurface sequence and contaminated groundwater aquifer.

Abstract This study presents and evaluates the feasibility of a novel hybridization of modified Kalina cycle, reverse osmosis desalination, and low-temperature water electrolysis utilizing geothermal energy to yield power, distilled water, and hydrogen, respectively. The scientific impact of the current work has been improved considering the features of Sabalan flash-binary geothermal wells in Iran as a real model through a case study. In addition to designing a novel setup, the smart use of multi-heat recovery technique, modifying the base cycle, and utilizing a part of generated distilled water to produce hydrogen by the electrolyzer are the other structural originalities, distinguishing the current work from the previous studies. The suggested system is scrutinized via a parametric study and optimized based on a genetic algorithm. The parametric study demonstrated that the highest sensitivity of varying the performance criteria of the whole system is attributed to the change in flash tank pressure. Moreover, the multi-objective optimization led to achieving the exergy efficiency and trigeneration gain output ratio as 51.3% and 1.7 for the system, respectively. Furthermore, the system was able to produce 4795 kW of power, 5.3 kg/h of hydrogen, and 19.9 kg/s of distilled water.

This study aimed to realize Sustainable Development Goals (SDGs), i.e., no poverty, zero hunger, and sustainable cities and communities through the implementation of an intelligent cattle-monitoring system to enhance dairy production. Livestock industries in developing countries lack the technology that can directly impact meat and dairy products, where human resources are a major factor. This study proposed a novel, cost-effective, smart dairy-monitoring system by implementing intelligent wireless sensor nodes, the Internet of Things (IoT), and a Node-Micro controller Unit (Node-MCU). The proposed system comprises three modules, including an intelligent environmental parameter regularization system, a cow collar (equipped with a temperature sensor, a GPS module to locate the animal, and a stethoscope to update the heart rate), and an automatic water-filling unit for drinking water. Furthermore, a novel IoT-based front end has been developed to take data from prescribed modules and maintain a separate database for further analysis. The presented Wireless Sensor Nodes (WSNs) can intelligently determine the case of any instability in environmental parameters. Moreover, the cow collar is designed to obtain precise values of the temperature, heart rate, and accurate location of the animal. Additionally, auto-notification to the concerned party is a valuable addition developed in the cow collar design. It employed a plug-and-play design to provide ease in implementation. Moreover, automation reduces human intervention, hence labor costs are decreased when a farm has hundreds of animals. The proposed system also increases the production of dairy and meat products by improving animal health via the regularization of the environment and automated food and watering. The current study represents a comprehensive comparative analysis of the proposed implementation with the existing systems that validate the novelty of this work. This implementation can be further stretched for other applications, i.e., smart monitoring of zoo animals and poultry.

Saffron, also known as “the golden spice”, is one of the most expensive crops in the world. The expensiveness of saffron comes from its rarity, the tedious harvesting process, and its nutritional and medicinal value. Different countries of the world are making great economic growth due to saffron export. In India, it is cultivated mostly in regions of Kashmir owing to its climate and soil composition. The economic value generated by saffron export can be increased manyfold by studying the agronomical factors of saffron and developing a model for artificial cultivation of saffron in any season and anywhere by monitoring and controlling the conditions of its growth. This paper presents a detailed study of all the agronomical variables of saffron that have a direct or indirect impact on its growth. It was found that, out of all the agronomical variables, the important ones having an impact on growth include corm size, temperature, water availability, and minerals. It was also observed that the use of IoT for the sustainable cultivation of saffron in smart cities has been discussed only by very few research papers. An IoT-based framework has also been proposed, which can be used for controlling and monitoring all the important growth parameters of saffron for its cultivation.

This study evaluated the efficacy of enzyme induced calcite precipitation (EICP) in restricting the mobility of heavy metals in soils. EICP is an environmentally friendly method that has wide ranging applications in the sustainable development of civil infrastructure. The study examined the desorption of three heavy metals from treated and untreated soils using ethylene diamine tetra-acetic acid (EDTA) and citric acid (C6H8O7) extractants under harsh conditions. Two natural soils spiked with cadmium (Cd), nickel (Ni), and lead (Pb) were studied in this research. The soils were treated with three types of enzyme solutions (ESs) to achieve EICP. A combination of urea of one molarity (M), 0.67 M calcium chloride, and urease enzyme (3 g/L) was mixed in deionized (DI) water to prepare enzyme solution 1 (ES1); non-fat milk powder (4 g/L) was added to ES1 to prepare enzyme solution 2 (ES2); and 0.37 M urea, 0.25 M calcium chloride, 0.85 g/L urease enzyme, and 4 g/L non-fat milk powder were mixed in DI water to prepare enzyme solution 3 (ES3). Ni, Cd, and Pb were added with load ratios of 50 and 100 mg/kg to both untreated and treated soils to study the effect of EICP on desorption rates of the heavy metals from soil. Desorption studies were performed after a curing period of 40 days. The curing period started after the soil samples were spiked with heavy metals. Soils treated with ESs were spiked with heavy metals after a curing period of 21 days and then further cured for 40 days. The amount of CaCO3 precipitated in the soil by the ESs was quantified using a gravimetric acid digestion test, which related the desorption of heavy metals to the amount of precipitated CaCO3. The order of desorption was as follows: Cd > Ni > Pb. It was observed that the average maximum removal efficiency of the untreated soil samples (irrespective of the load ratio and contaminants) was approximately 48% when extracted by EDTA and 46% when extracted by citric acid. The soil samples treated with ES2 exhibited average maximum removal efficiencies of 19% and 10% when extracted by EDTA and citric acid, respectively. It was observed that ES2 precipitated a maximum amount of calcium carbonate (CaCO3) when compared to ES1 and ES3 and retained the maximum amount of heavy metals in the soil by forming a CaCO3 shield on the heavy metals, thus decreasing their mobility. An approximate improvement of 30% in the retention of heavy metal ions was observed in soils treated with ESs when compared to untreated soil samples. Therefore, the study suggests that ESs can be an effective alternative in the remediation of soils contaminated with heavy metal ions.

Antibiotics are one of the emerging pollutants that have drawn increased attention in recent years. In this study simultaneous production of electricity and bioremediation of sulfadiazine from the wastewater using microbial fuel cells (MFCs) and open circuit system were analyzed. LC-MS analysis revealed decreased sulfadiazine concentration in open circuit system and closed MFC chamber. In MFCs, 12.6 ± 1.3% removal efficiency of sulfadiazine was reached after 30 h and it improved 89.2 ± 2.1% after 100 h. The initial sulfadiazine concentration influenced on antibiotic removal in MFCs and antibiotic removal was increased up to 350 μg/L. At higher antibiotic concentration, reduced microbial activity results depleted antibiotic degradation. MFCs degraded sulfadiazine (350 μg/L) completely within 80 h of treatment. The maximum COD removal (91.9 ± 2.3%) was obtained in MFCs chamber and it was about 60.8 ± 2.7% in the open circuit chamber. The initial total phosphorus content of the wastewater fed with reactor was 1350 mg/L and it reduced considerably after treatment in MFCs system (89.9 ± 2.8%). Total microbial population was 4.5 × 105 CFU/mL after one day of treatment and it declined after five days due to the depletion of nutrients in the wastewater. In MFC electricity generation reached maximum within 60 h of treatment (1.28 ± 0.1 V). The electrogenic strain Bacillus subtilis EL06 was characterized from the MFC and sulfadiazine tolerance was analyzed. These findings demonstrated that MFCs are useful for the simultaneous bioremediation of wastewater and electricity generation.

Today, the global food security is one of the most pressing issues for humanity, and, according to Food and Agriculture Organisation (FAO), the increasing demand for food is likely to grow by 70% until 2050. In this current condition and future scenario, the agricultural production is a critical factor for global food security and for facing the food security challenge, with specific reference to many African countries, where a large quantities of rice are imported from other continents. According to FAO, to face the Africa’s inability to reach self-sufficiency in rice, it is urgent “to redress to stem the trend of over-reliance on imports and to satisfy the increasing demand for rice in areas where the potential of local production resources is exploited at very low levels” The present study was undertaken to design a new method for land evaluation based on soil quality indicators and remote sensing data, to assess and map soil suitability for rice crop. Results from the investigations, performed in some areas in the northern part of the Nile Delta, were compared with the most common approaches, two parametric (the square root, Storie methods) and two qualitative (ALES and MicrioLEIS) methods. From the qualitative point of view, the results showed that: (i) all the models provided partly similar outputs related to the soil quality assessments, so that the distinction using the crop productivity played an important role, and (ii) outputs from the soil suitability models were consistent with both the satellite Sentinel-2 Normalize Difference Vegetation Indices (NDVI) during the crop growth and the yield production. From the quantitative point of view, the comparison of the results from the diverse approaches well fit each other, and the model, herein proposed, provided the highest performance. As a whole, a significant increasing in R2 values was provided by the model herein proposed, with R2 equal to 0.92, followed by MicroLES, Storie, ALES and Root as R2 with value equal to 0.87, 0.86, 0.84 and 0.84, respectively, with increasing percentage in R2 equal to 5%, 6% and 8%, respectively. Furthermore, the proposed model illustrated that around (i) 44.44% of the total soils of the study area are highly suitable, (ii) 44% are moderately suitable, and (iii) approximately 11.56% are unsuitable for rice due to their adverse physical and chemical soil properties. The approach herein presented can be promptly re-applied in arid region and the quantitative results obtained can be used by decision makers and regional governments.

Nowadays, healthcare activities generate a significant amount of hazardous materials. One way to manage this problem without causing any pollution is to use the pyrolysis process. The objective of this experimental study is to examine the feasibility of pyrolysis technology to convert the medical waste to syngas and liquid fuel. The medical waste was dried, and then heat treated at $350 ^{\circ}\mathrm{C}$ for 120 minutes. The produced liquid fuel had a density of 0.7775 g/ml, calorific value of 46.6 MJ/kg, and flashpoint of $30 ^{\circ}\mathrm{C}$, properties similar to diesel fuel. Moreover, the resulting syngas consist of HC, CO, and CO2, which may be employed in combustion applications. Furthermore, this study proved that the pyrolysis process can be considered as an alternative solution for solving energy and medical waste issues.