• Energy Research
• Open Access close
• Open Source close
• 6. Clean water close
• 2. Zero hunger close
• SA close

The environmental control and management of municipal solid waste (MSW) dumping sites is considered one of the sensitive challenges faced by executive municipalities. This is especially true in Makkah due to the gradual increase in urban population and visitors, with an overall MSW generation of about one million tons per year. Consequently, the geo-environmental evaluation of the Kaakia dumping site shed light on the potential environmental threats, in terms of ambient air quality levels and meteorological parameters, in addition to geophysical inspection. An air quality survey discussed the major trends of ambient air pollutants (SO2, NO2, CO, O3, CH4, and PM10) downwind from the Kaakia dumping site. It indicated the presence of a significant increase in sporadic plumes of Methane concentration. The maximum hourly averages ranged between 22.9–26.6 µg/m3 for SO2, 44.4–64.0 µg/m3 for NO2, 0.86–1.38 mg/m3 for CO, 150.2–158.8 µg/m3 for O3, 5.09–5.9 ppm for CH4, and 955–994 µg/m3 for PM10. The ground penetrating radar (GPR) geophysical survey indicated the subsurface sequence of three geological layers, as confirmed by nearby bores of the investigated site: (1) a surface layer formed of alluvial sediments of sand, which were 2.5–3.1 m thick; (2) a second layer represented by sand and gravel, with a thickness of 4.6–6.5 m; and (3) a third layer equivalent to saturated alluvial sediments mixed with rock fragments that extended to a depth of 13 m. The signals of the GPR were attenuated at the base of the conducted profiles due to the percolation of generated leachate to the subsurface sequence and contaminated groundwater aquifer.

This study aimed to realize Sustainable Development Goals (SDGs), i.e., no poverty, zero hunger, and sustainable cities and communities through the implementation of an intelligent cattle-monitoring system to enhance dairy production. Livestock industries in developing countries lack the technology that can directly impact meat and dairy products, where human resources are a major factor. This study proposed a novel, cost-effective, smart dairy-monitoring system by implementing intelligent wireless sensor nodes, the Internet of Things (IoT), and a Node-Micro controller Unit (Node-MCU). The proposed system comprises three modules, including an intelligent environmental parameter regularization system, a cow collar (equipped with a temperature sensor, a GPS module to locate the animal, and a stethoscope to update the heart rate), and an automatic water-filling unit for drinking water. Furthermore, a novel IoT-based front end has been developed to take data from prescribed modules and maintain a separate database for further analysis. The presented Wireless Sensor Nodes (WSNs) can intelligently determine the case of any instability in environmental parameters. Moreover, the cow collar is designed to obtain precise values of the temperature, heart rate, and accurate location of the animal. Additionally, auto-notification to the concerned party is a valuable addition developed in the cow collar design. It employed a plug-and-play design to provide ease in implementation. Moreover, automation reduces human intervention, hence labor costs are decreased when a farm has hundreds of animals. The proposed system also increases the production of dairy and meat products by improving animal health via the regularization of the environment and automated food and watering. The current study represents a comprehensive comparative analysis of the proposed implementation with the existing systems that validate the novelty of this work. This implementation can be further stretched for other applications, i.e., smart monitoring of zoo animals and poultry.

Saffron, also known as “the golden spice”, is one of the most expensive crops in the world. The expensiveness of saffron comes from its rarity, the tedious harvesting process, and its nutritional and medicinal value. Different countries of the world are making great economic growth due to saffron export. In India, it is cultivated mostly in regions of Kashmir owing to its climate and soil composition. The economic value generated by saffron export can be increased manyfold by studying the agronomical factors of saffron and developing a model for artificial cultivation of saffron in any season and anywhere by monitoring and controlling the conditions of its growth. This paper presents a detailed study of all the agronomical variables of saffron that have a direct or indirect impact on its growth. It was found that, out of all the agronomical variables, the important ones having an impact on growth include corm size, temperature, water availability, and minerals. It was also observed that the use of IoT for the sustainable cultivation of saffron in smart cities has been discussed only by very few research papers. An IoT-based framework has also been proposed, which can be used for controlling and monitoring all the important growth parameters of saffron for its cultivation.

This study evaluated the efficacy of enzyme induced calcite precipitation (EICP) in restricting the mobility of heavy metals in soils. EICP is an environmentally friendly method that has wide ranging applications in the sustainable development of civil infrastructure. The study examined the desorption of three heavy metals from treated and untreated soils using ethylene diamine tetra-acetic acid (EDTA) and citric acid (C6H8O7) extractants under harsh conditions. Two natural soils spiked with cadmium (Cd), nickel (Ni), and lead (Pb) were studied in this research. The soils were treated with three types of enzyme solutions (ESs) to achieve EICP. A combination of urea of one molarity (M), 0.67 M calcium chloride, and urease enzyme (3 g/L) was mixed in deionized (DI) water to prepare enzyme solution 1 (ES1); non-fat milk powder (4 g/L) was added to ES1 to prepare enzyme solution 2 (ES2); and 0.37 M urea, 0.25 M calcium chloride, 0.85 g/L urease enzyme, and 4 g/L non-fat milk powder were mixed in DI water to prepare enzyme solution 3 (ES3). Ni, Cd, and Pb were added with load ratios of 50 and 100 mg/kg to both untreated and treated soils to study the effect of EICP on desorption rates of the heavy metals from soil. Desorption studies were performed after a curing period of 40 days. The curing period started after the soil samples were spiked with heavy metals. Soils treated with ESs were spiked with heavy metals after a curing period of 21 days and then further cured for 40 days. The amount of CaCO3 precipitated in the soil by the ESs was quantified using a gravimetric acid digestion test, which related the desorption of heavy metals to the amount of precipitated CaCO3. The order of desorption was as follows: Cd > Ni > Pb. It was observed that the average maximum removal efficiency of the untreated soil samples (irrespective of the load ratio and contaminants) was approximately 48% when extracted by EDTA and 46% when extracted by citric acid. The soil samples treated with ES2 exhibited average maximum removal efficiencies of 19% and 10% when extracted by EDTA and citric acid, respectively. It was observed that ES2 precipitated a maximum amount of calcium carbonate (CaCO3) when compared to ES1 and ES3 and retained the maximum amount of heavy metals in the soil by forming a CaCO3 shield on the heavy metals, thus decreasing their mobility. An approximate improvement of 30% in the retention of heavy metal ions was observed in soils treated with ESs when compared to untreated soil samples. Therefore, the study suggests that ESs can be an effective alternative in the remediation of soils contaminated with heavy metal ions.

Today, the global food security is one of the most pressing issues for humanity, and, according to Food and Agriculture Organisation (FAO), the increasing demand for food is likely to grow by 70% until 2050. In this current condition and future scenario, the agricultural production is a critical factor for global food security and for facing the food security challenge, with specific reference to many African countries, where a large quantities of rice are imported from other continents. According to FAO, to face the Africa’s inability to reach self-sufficiency in rice, it is urgent “to redress to stem the trend of over-reliance on imports and to satisfy the increasing demand for rice in areas where the potential of local production resources is exploited at very low levels” The present study was undertaken to design a new method for land evaluation based on soil quality indicators and remote sensing data, to assess and map soil suitability for rice crop. Results from the investigations, performed in some areas in the northern part of the Nile Delta, were compared with the most common approaches, two parametric (the square root, Storie methods) and two qualitative (ALES and MicrioLEIS) methods. From the qualitative point of view, the results showed that: (i) all the models provided partly similar outputs related to the soil quality assessments, so that the distinction using the crop productivity played an important role, and (ii) outputs from the soil suitability models were consistent with both the satellite Sentinel-2 Normalize Difference Vegetation Indices (NDVI) during the crop growth and the yield production. From the quantitative point of view, the comparison of the results from the diverse approaches well fit each other, and the model, herein proposed, provided the highest performance. As a whole, a significant increasing in R2 values was provided by the model herein proposed, with R2 equal to 0.92, followed by MicroLES, Storie, ALES and Root as R2 with value equal to 0.87, 0.86, 0.84 and 0.84, respectively, with increasing percentage in R2 equal to 5%, 6% and 8%, respectively. Furthermore, the proposed model illustrated that around (i) 44.44% of the total soils of the study area are highly suitable, (ii) 44% are moderately suitable, and (iii) approximately 11.56% are unsuitable for rice due to their adverse physical and chemical soil properties. The approach herein presented can be promptly re-applied in arid region and the quantitative results obtained can be used by decision makers and regional governments.

With the increasing global nutritional bar market, developing and formulating innovative high-energy and protein bars to compensate for nutrients using date fruits is beneficial for health-conscious individuals. The current research was undertaken to study the composition and physicochemical characteristics of innovative high-energy and high-protein bars using two combinations of Sukkari dates or fruit mixtures as a base. Fifty percent of either Sukkari date paste or dried fruit mixture (25% raisin, 12.5% fig, and 12.5% apricot) combined with other different ingredients was used to produce a date-based bar (DBB) or fruit-based bar (FBB). Proximate composition, sugar content, amino and fatty acid profiles, minerals and vitamins, phytochemicals, antioxidant activity, and visual color parameters of the DBB and the FBB were determined and statistically compared. Proximate analysis revealed higher moisture and fat content in the FBB than the DBB, while ash and crude fiber were higher in the DBB than the FBB. The protein content in the DBB and the FBB was not statistically different. Both prepared bars exuded around 376–378 kcal 100 g−1 fresh weight. Sugar profile analysis of the DBB and the FBB showed dependable changes based on date or fruit content. Fructose, glucose, and maltose contents were higher in the FBB than in the DBB, while sucrose content was higher in the DBB than in the FBB. The DBB showed significantly higher content in Ca, Cu, Fe, Zn, Mn, and Se and significantly lower content in Mg, K, and Na than the FBB, with no variation in phosphorus content. The DBB and the FBB contained both essential (EAA) and non-essential (NEAA) amino acids. The DBB scored higher Lysine, Methionine, Histidine, Threonine, Phenylalanine, Isoleucine, and Cystine contents than the FBB, while the FBB scored only higher Leucine and Valine contents than the DBB. Seventeen saturated fatty acids were identified in the DBB and the FBB, with Palmitic acid (C16:0) as the predominant fatty acid. Oleic acid (C18:1n9c) was predominant among seven determined monounsaturated fatty acids. Linoleic fatty acid (C18:2n6c) was predominant among eight identified polyunsaturated fatty acids. In addition, α-Linolenic (C18:3n3) was detected in a considerable amount. However, in both the DBB and the FBB, the content and distribution of fatty acids were not remarkably changed. Regarding phytochemicals and bioactive compounds, the FBB was significantly higher in total phenolic content (TPC), total flavonoids (TF), and total flavonols (TFL) contents and scavenging activity against DPPH and ABTS free radicals than the DBB. The DBB and the FBB showed positive a* values, indicating a reddish color. The b* values were 27.81 and 28.54 for the DBB and the FBB, respectively. The DBB is affected by the lower L* value and higher browning index (BI) to make its color brownish. Sensory evaluation data showed that panelists significantly preferred the DBB over the FBB. In conclusion, processing and comparing these bars indicated that using Sukkari dates is a nutrient-dense, convenient, economical, and better sugar alternative that helps combat the calorie content. Thus, scaling up the use of dates instead of fruits in producing high-energy and protein bars commercially is highly recommended.

Recent years have seen a rise in the frequency and severity of extreme rainstorm events, which have caused widespread damage and death in numerous cities. The manufacture and use of storm drainage materials result in numerous environmental concerns in the construction industry. Green materials for storm drainage networks are environmentally friendly compared to their traditional counterparts. Identifying and assessing sustainability criteria for green materials for storm drain networks has been challenging. This study aims to determine the critical criteria for selecting green materials for storm drainage networks using a stationary analysis approach. To this end, a questionnaire survey was administered to Egyptian storm engineers to assess their importance based on a selection criteria 29 green materials. From the results obtained, “Operation and maintenance cost” and “Use of local material” were seen to be the “stationary materials”. The obtained findings in this research pave the way for the Egyptian storm industry towards becoming environmentally friendly, which will in turn improve the functioning mechanism of sewer networks.

Agro-wastes, such as crop residues, leaf litter, and sawdust, are major contributors to global greenhouse gas emissions, and consequently a major concern for climate change. Nowadays, mushroom cultivation has appeared as an emerging agribusiness that helps in the sustainable management of agro-wastes. However, partial utilization of agro-wastes by mushrooms results in the generation of a significant quantity of spent mushroom substrates (SMS) that have continued to become an environmental problem. In particular, Shiitake (Lentinula edodes Berk.) mushrooms can be grown on different types of agro-wastes and also generate a considerable amount of SMS. Therefore, this study investigates the biotransformation of SMS obtained after Shiitake mushroom cultivation into biogas and attendant utilization of slurry digestate (SD) in tomato (Solanum lycopersicum L.) crop fertilization. Biogas production experiments were conducted anaerobically using four treatments of SMS, i.e., 0% (control), 25, 50, and 75% inoculated with a proportional amount of cow dung (CD) as inoculum. The results on biogas production revealed that SMS 50% treatment yielded the highest biogas volume (8834 mL or 11.93 mL/g of organic carbon) and methane contents (61%) along with maximum reduction of physicochemical and proximate parameters of slurry. Furthermore, the biogas digestate from 50% treatment further helped to increase the seed germination (93.25%), seedling length (9.2 cm), seedling root length (4.19 cm), plant height (53.10 cm), chlorophyll content (3.38 mg/g), total yield (1.86 kg/plant), flavonoids (5.06 mg/g), phenolics (2.78 mg/g), and tannin (3.40 mg/g) contents of tomato significantly (p < 0.05) in the 10% loading rate. The findings of this study suggest sustainable upcycling of SMS inspired by a circular economy approach through synergistic production of bioenergy and secondary fruit crops, which could potentially contribute to minimize the carbon footprints of the mushroom production sector.