• Energy Research
• US close
• PK close

The Sulphurdale Geothermal Field is located in Beaver County Utah, within the boundaries of the Cove Fort--Sulphurdale Known Geothermal Resource Area (KGRA). During the past year, three wells drilled in Section 7, T-26-S, R-6-W, have produced dry steam from a fractured volcanic formation located at a depth of about 1100 feet. Two of these three wells are currently prepared to supply steam to a power plant, and one well has been plugged and abandoned. ThermaSource, Inc. was retained by Mother Earth Industries, the operator of the field, to conduct well tests and render an opinion as to the nature of the geothermal reserves and assess the commercial potential of these reserves. Because of the limited area that has been explored to date, there can be no assurance that the reserves estimate will prove accurate. Project economics are based on parameters believed to be accurate, but there is no assurance that such cash flow projections will be realized.

Providing access to on-demand energy at the global scale is a grand challenge of our time. The fabrication of solar cells from nanocrystal inks comprising earth abundant elements represents a scalable and sustainable photovoltaic technology with the potential to meet the global demand for electricity. Solar cells with Cu2ZnSn(S,Se)4 (CZTSSe) absorber layers are of particular interest due to the high absorption coefficient of CZTSSe, its band gap in the ideal range for efficient photovoltaic power conversion, and the relative abundance of its constituent elements in the earth’s crust. Despite the promise of this material system, CZTSSe solar cell efficiencies reported throughout literature have failed to exceed 12.6%, principally due to the low open-circuit voltage (VOC) achieved in these devices compared to the absorber band gap. The work presented herein primarily aims to address the low VOC problem. First, the fundamental cause for such low VOC’s is investigated. Interparticle compositional inhomogeneities identified in the synthesized CZTS nanocrystals and their effect on the absorber layer formation and device performance are characterized. Real-time energy-dispersive x-ray diffraction (EDXRD) elucidates the role of these inhomogeneities in the mechanism by which a film of CZTS nanocrystals converts into a dense absorber layer comprising micron-sized CZTSSe grains upon annealing in a selenium atmosphere (selenization). Additionally, a direct correlation between the nanocrystal inhomogeneities and the VOC in completed devices is observed. Detailed characterization of CZTSSe solar cells identifies electrical potential fluctuations in the CZTSSe absorber – due to spatial composition variations not unlike those observed in the nanocrystals – as a primary V OC inhibitor. Additional causes for low VOC’s in CZTSSe solar cells proposed in the literature involve recombination at the interface between the CZTSSe absorber and: (1) the n-type, CdS buffer layer, or (2) the Mo back contact, and work is presented to ...

Dynamic loading of transformers is the term used when the loading capacity is calculated using an appropriate thermal model while taking into account the load magnitude, load shape, thermal limits and external cooling conditions. For transformer dynamic loading, the aim is to estimate the transformer's maximum dynamic loading capacity without violating the hottest-spot temperature (HST) and top-oil temperature (TOT) thermal limits. These two temperatures are proxy measures of insulation temperature, which can be used to estimate the loss of service life. The accuracy of the TOT and HST predictions is dependent on many things, central to which is the accuracy of the thermal model. This paper introduces metrics that can be used to differentiate between reliable and unreliable transformer thermal models. The two models discussed in this paper for HST and TOT are the non-linear IEEE model and the model developed by the authors using linear regression methods.

Consumer interest in food products, including fresh vegetables, with health promoting properties is rising. In fresh vegetables, these properties include vitamins, minerals, dietary fiber, and secondary compounds, which collectively impart a large portion of the dietary, nutritional or health value associated with vegetable intake. Many, including farmers, aim to increase the health-promoting properties of fresh vegetables on the whole but they face at least three obstacles. First, describing crop composition in terms of its nutrition-based impact on human health is complex and there are few, if any, accepted processes and associated metrics for assessing and managing vegetable composition on-farm, at the origin of supply. Second, data suggest that primary and secondary metabolism can be 'in conflict' when establishing the abundance versus composition of a crop. Third, fresh vegetable farmers are rarely compensated for the phytochemical composition of their product. The development and implementation of a fresh vegetable 'nutritional yield' index could be instrumental in overcoming these obstacles. Nutritional yield is a function of crop biomass and tissue levels of health-related metabolites, including bioavailable antioxidant potential. Data from a multi-factor study of leaf lettuce primary and secondary metabolism and the literature suggest that antioxidant yield is sensitive to genetic and environmental production factors, and that changes in crop production and valuation will be required for fresh vegetable production systems to become more focused and purposeful instruments of public health.

The delivery of precipitation through large and small scale precipitation features plays a key role in the hydrological cycle. Therefore, it is important to understand how the organization of precipitation will change as the earth warms. The organization of precipitation can be characterized into either widespread, mesoscale precipitation features (MPF) or short-lived, isolated precipitation features (IPF). The Weather Research and Forecasting (WRF) model was used to simulate precipitation features at a 3 km resolution during the 17-22 June 2010 period in the Southeast US under present and future climate conditions. In this methodology, the model is first run in present climate mode and then rerun with an adjusted initial state that adds projected temperature anomalies for the 2090s based on Representative Concentration Pathways (RCPs) 4.5 and 8.5 from the Coupled Model Intercomparison Project Phase 5 (CMIP5) in the IPCC Fifth Assessment Report (AR5). In the future climate simulations, small changes in precipitation occurred under RCP4.5 warming, but many significant changes were noted under RCP8.5 warming. Domain-averaged precipitation increased in the future climate simulations, with the largest changes over the ocean relative to the continent. In the future climates, IPF grew larger in length and eventually coalesced into MPF, reducing the total number of IPF and increasing the number of MPF. IPF and MPF also extended deeper into the troposphere and produced more precipitation overall.

Abstract For 118 million residential housing units in the U.S., there is currently a gap between the potential energy savings that can be achieved through the use of existing energy efficiency technologies, and the actual level of energy savings realized, particularly for the 37% of housing units that are considered residential rental properties. Additional quantifiable benefits are needed beyond energy savings to help further motivate residential property owners to invest in energy efficiency upgrades. This research focuses on assessing the adoption of energy efficient upgrades in U.S. residential housing and the impact on rental prices. Ten U.S. cities are chosen for analysis; these cities vary in size across multiple climate zones, and represent a diverse set of housing market conditions. Data was collected for over 159,000 rental property listings, their characteristics, and their energy efficiency measures listed in rental housing postings across each city. Following an extensive data quality control process, over thirty different types energy efficient features were identified. The level of adoption was determined for each city, ranging from 5.3% to 21.6%. Efficient lighting and appliances were among the most common, with many features doubling as energy efficient and other desirable aesthetic or comfort improvements. Then using propensity score matching and conditional mean comparison methods, the relative impact on rent charged in each city was calculated, which ranged from a 6% to 14.1% increase in rent for properties with energy efficient features, demonstrating a positive economic impact of these features, particularly for property owners. This was further subdivided into five types of energy efficiency upgrade and three housing types. Single family homes generally demanded higher premiums with energy efficient features, however there was not a consistent pattern across the types of efficient upgrades. The results of this work demonstrate that investment in energy efficient technologies has quantifiable benefits for rental property owners in the U.S. beyond just energy savings. This methodology and results can also be used in other cities and by property owners, utility companies, or others, ultimately encouraging further investment and positive economic impact in residential energy efficiency and in turn improving energy and resource conservation in the building sector.

Abstract The Seed-and-Blanket (SB it is few percent higher than that of the 2-stage PWR-ABR system. Approximately 7% of the thorium fed to the blanket is converted into energy, which makes the thorium fuel utilization approximately 12 times the utilization of natural uranium in PWRs. A comprehensive fuel cycle evaluation performed with the methodology developed by the recent U.S Department of Energy’s Nuclear Fuel Cycle Evaluation and Screening campaign concludes that the PWR-S&B system has similar fuel cycle performance characteristics as the PWR-ABR system. The S&B concept may potentially feature improved economics and resource utilization relative to the ABR.

Abstract Climate change has been repeatedly linked to phenological shifts in many taxa, but the factors that drive variation in phenological sensitivity remain unclear. For example, relatively little is known about phenological responses in areas that have not exhibited a consistent warming trend, making it difficult to project phenological responses in response to future climate scenarios for these regions. We used an extensive community science dataset to examine changes in the adult flight onset dates of 38 butterfly species with interannual variation in spring temperatures in the Piedmont region of North Carolina, a region that did not experience a significant overall warming trend in the second half of the 20th century. We also explored whether voltinism, overwintering stage, and mean adult flight onset dates explain interspecific variation in phenological sensitivity to spring temperature. We found that 12 out of 38 species exhibited a significant advance in adult flight onset dates with higher spring temperatures. In comparison, none of the 38 species exhibited a significant advance with year. There was a significant interaction between mean onset flight date and voltinism, such that late-emerging, multivoltine species tended to be the most sensitive to spring temperature changes. We did not observe a significant correlation between phenological sensitivity and the overwintering stage. These results suggest that butterfly arrival dates may shift as temperatures are projected to rise in the southeastern United States, with late-emerging, multivoltine species potentially exhibiting the greatest shifts in adult flight onset dates.