• Energy Research
• Closed Access close
• Restricted close
• natural sciences close
• 11. Sustainability close
• 3. Good health close
• 1. No poverty close

Interfacial resistance at electrode‐high Li+ conductive solid electrolytes must be reduced well to develop high‐power all‐solid‐state batteries using oxide‐based solid electrolytes (Ox‐SSBs). Herein, crystalline electrode films of LiCoO2 (LCO) are formed on a high Li+ conductive crystalline‐glass solid electrolyte sheet, Li1.3Al0.3Ti2(PO4)3 (LATP) (σ25 °C = 1 × 10−4 S cm−1), at room temperature by aerosol deposition (AD), and the effects of the annealing temperature on the interfacial resistivities (Rint) at the LCO/LATP are investigated. The Rint visibly increases by annealing over 500 °C with the growth of Co3O4 as a reactant. In contrast, Rint is reduced to ≈100 Ω cm2 by low‐temperature annealing at 250–350 °C due to superior contact through the structural rearrangement of an artificial metastable interface formed by the AD. These results are applied to bulk‐type Ox‐SSB, Li/Li7La3Zr2O12(LLZ)/LCO–LATP, and our best Ox‐SSB delivers a discharge capacity of 100 mA cm−2 at 100 °C.

Bioplastics are alternatives of conventional petroleum-based plastics. Bioplastics are polymers processed from renewable sources and are biodegradable. This study aims at conducting an environmental impact assessment of the bioprocessing of agricultural wastes into bioplastics compared to petro-plastics using an LCA approach. Bioplastics were produced from potato peels in laboratory. In a biochemical reaction under heating, starch was extracted from peels and glycerin, vinegar and water were added with a range of different ratios, which resulted in producing different samples of bio-based plastics. Nevertheless, the environmental impact of the bioplastics production process was evaluated and compared to petro-plastics. A life cycle analysis of bioplastics produced in laboratory and petro-plastics was conducted. The results are presented in the form of global warming potential, and other environmental impacts including acidification potential, eutrophication potential, freshwater ecotoxicity potential, human toxicity potential, and ozone layer depletion of producing bioplastics are compared to petro-plastics. The results show that the greenhouse gases (GHG) emissions, through the different experiments to produce bioplastics, range between 0.354 and 0.623 kg CO2 eq. per kg bioplastic compared to 2.37 kg CO2 eq. per kg polypropylene as a petro-plastic. The results also showed that there are no significant potential effects for the bioplastics produced from potato peels on different environmental impacts in comparison with poly-β-hydroxybutyric acid and polypropylene. Thus, the bioplastics produced from agricultural wastes can be manufactured in industrial scale to reduce the dependence on petroleum-based plastics. This in turn will mitigate GHG emissions and reduce the negative environmental impacts on climate change.

This review presents recent advancements in high-voltage rechargeable aqueous batteries employing water-in-salt and modified water-in-salt electrolytes.

Trace elements can have profound adverse effects on the health of people burning coal in homes or living near coal deposits, coal mines, and coal-burning power plants. Trace elements such as arsenic emitted from coal-burning power plants in Europe and Asia have been shown to cause severe health problems. Perhaps the most widespread health problems are caused by domestic coal combustion in developing countries where millions of people suffer from fluorosis and thousands from arsenism. Better knowledge of coal quality characteristics may help to reduce some of these health problems. For example, information on concentrations and distributions of potentially toxic elements in coal may help delineate areas of a coal deposit to be avoided. Information on the modes of occurrence of these elements and the textural relations of the minerals in coal may help to predict the behavior of the potentially toxic trace metals during coal cleaning, combustion, weathering, and leaching.

In the last thirty years of the twentieth century we saw a resurrection of the writings of Matlhus. In their new guise we are told that instead of war, pestilence and famine, the earth has decreasing biodiversity, loss of species, loss of natural resources and water shortages, to name but a few, to look forward too. Population growth today, as it was two hundred years ago, is portrayed as Public Enemy number one. There is little doubt that the Neo-Malthusian argument has made an impact on policy, indeed, probably moreso than did its namesake. The newly clad argument shares much with its namesake, not least, its significant faults. The argument is two hundred years old, and the inaccuracies share that age. Malthus' predictions never reigned true because he made the fundamental error of not taking account of technical progress, or the ability of human ingenuity to adapt to change. This paper looks at the evolution of both sides of the population argument, and argues that this year's World Summit in Johannesburg should not fall foul to the dangerous generalisations invoked by the Neo-Malthusian school of thought. This paper is an attempt to lay the blame for environmental degradation not on the increasing population of the Third World, but on the consumption patterns and lifestyles of the First World. Affluence consumes energy and produces waste at a far higher rate than poverty. In looking at the environmental debate only an integrated approach, and not one that is concerned solely with ‘demonising’ population growth, can result in success.

One of the most popular off‐site wastewater treatment plants used in the tropics is the waste stabilization pond (WSP). Although it has several advantages, its use in urban areas is limited because of its large land area requirement. Hence, this research is aimed at investigating if a solar‐enhanced WSP (SEWSP) can increase treatment efficiency and consequently reduce the land area requirement. The SEWSPs of varying sizes, made of a metallic tank with inlet and outlet valves and a solar reflector, were constructed to increase the incident sunlight intensity. Wastewater samples collected from the inlet and outlet of the SEWSPs were examined for physio‐chemical and biological characteristics for a period of 2 months. The parameters examined were total suspended solids, dissolved oxygen, 5‐day biochemical oxygen demand (BOD 5), chemical oxygen demand (COD), coliform, and Escherichia coli. The efficiencies of the SEWSPs, with respect to these parameters, fluctuated with temperature variation, with the shallowest SEWSP giving the highest treatment efficiency. The research revealed that the cost of treating wastewater using SEWSPs was approximately 2 times lower than the conventional WSP for the same treatment efficiencies.

This paper examines potential changes in solid waste policies for the reduction in GHG for the country of Brazil and one of its major states and cities, Rio de Janeiro, from 2005 to 2030. To examine these policy options, trends in solid waste quantities and associated GHG emissions are derived. Three alternative policy scenarios are evaluated in terms of effectiveness, technology, and economics and conclusions posited regarding optimal strategies for Brazil to implement. These scenarios are been building on the guidelines for national inventories of GHG emissions (IPCC, 2006) and adapted to Brazilian states and municipalities' boundaries. Based on the results, it is possible to say that the potential revenue from products of solid waste management is more than sufficient to transform the current scenario in this country into one of financial and environmental gains, where the negative impacts of climate change have created a huge opportunity to expand infrastructure for waste management.

In developing an algal treatment system, selenium (Se) removal efficiency by Chlorella vulgaris was evaluated under various conditions such as Se concentration, algal density, temperature and pH. A maximum removal efficiency plateau of ∼90% was observed between 1000-3000 μg Se/L while the tolerance of Se toxicity was found at 6000 μg Se/L. C. vulgaris of 0.75 g DW/L showed the highest removal efficiency (84%), and volatilization was dominant below 1.37 g DW/L. Se volatilization was two times higher at 25 °C than at 20 °C in the first 24 h. Moreover, the highest removal efficiency (77%) was obtained at pH 8.0, compared to 66.5% at pH 6.5 and 40% at pH 10.0. To prevent ecotoxicity, Se laden algae were further burned to ashes or filtered out by Anodonta woodiana. After burning, biomass Se was reduced by 99%, with organo-Se entirely converted into inorganic Se, lowering Se bioavailability. A. woodiana removed 54% of Se in 24 h, leading to Se bioaccumulation in soft tissues, which may serve as dietary Se supplements for human health. Our results suggest the cleanup of Se-contaminated water from either agricultural runoff or industrial discharge could be achieved using an algal treatment system with minimum potential ecotoxicity.

Indoor air pollution in developing countries is a public health problem deserving of urgent attention. The aim of this study was to assess indoor second‐hand smoke (SHS) exposure via PM2.5 (fine particles with diameter ≤ 2.5 μm) level measurements in several public venues in Kuwait. The PM2.5 mean, median, and interquartile range (IQR) values for nonsmoking areas were; respectively, 28, 24, 32 μg/m3 while the corresponding values for smoking areas were 274, 222, 288 μg/m3 in the absence of water pipe usage and 1434, 1001, 964 μg/m3 in the presence of water pipes, respectively. Differences among the three tested venues (nonsmoking, smoking with and without water pipes) were statistically significant (F = 330.7, P < 0.001). The air quality index (AQI) results showed that nonsmoking areas were mostly classified as either “Good” or “Moderate” whereas the classification in smoking areas varied between “Moderate” to “Hazardous.” Adverse health outcomes from exposure to PM2.5 were also evaluated. The estimated lifetime lung cancer and cardiopulmonary risks in nonsmoking area were 4 × 10−3 and 3 × 10−3, respectively. In smoking areas, the risks were more than sixfold and 30‐fold increases of cancer and cardiopulmonary relative to nonsmoking areas without and with water pipes, respectively. In smoking venues, the relative ratio values were 1.26 and 1.16 with no water pipe and 1.86 and 1.51 when water pipe usage was observed, for lung cancer and cardiopulmonary mortality, respectively. These values reveal that people, especially the young and elderly, occupying or visiting these venues are susceptible to lung cancer and cardiopulmonary mortality. © 2018 American Institute of Chemical Engineers Environ Prog, 38:e13096, 2019