• Energy Research
• Restricted close
• Open Source close
• 13. Climate action close
• 11. Sustainability close
• 12. Responsible consumption close

Alternative fuels and energy vectors are becoming increasingly important in terms of technical, geopolitical, economic, and environmental aspects. In particular, gaseous fuels and vectors, such as fossil or synthetic natural gas (NG) blended with hydrogen, commonly help provide optimal strategies to reduce global and toxic emissions of internal combustion engines, owing to their adaptability, anti-knock capacity, lower toxicity of pollutants, reduced CO2 emissions, and costeffectiveness. However, diesel engines still represent the reference category among internal combustion engines in terms of maximum thermodynamic efficiency. The possibility offered by dual-fuel (DF) systems to combine the efficiency and performance of diesel engines with the environmental advantages of gaseous fuels has been the subject of extensive investigations. However, the simple replacement of diesel fuel with gaseous fuel does not allow for optimising the engine performance, owing to the high percentage of unburned gaseous fuel, which compromises the potential reduction of CO2; therefore, more complex combustion strategies should be realised. In this study, with the aim of improving the DF combustion process, an experimental investigation was performed to analyse low-temperature combustion (LTC), using NG and two enriched hydrogen-compressed NG blends as primary fuels. The LTC mode was activated by means of a very early advanced pilot injection and carried out in two close steps. The double pilot injection was used to control the energy release rate in the first combustion stage, thereby minimizing the increase of the rate of pressure and allowing the extension of the operation range under LTC. The experimental activity was also focused on analysing the particle emissions, as it is well known that these emissions, together with those of nitrogen oxide, constitute the main pollutants resulting from diesel fuel combustion. The results demonstrated the potential to reduce the unburned fuel, NOx, and particle emissions simultaneously, while maintaining equivalent CO2 emissions to a diesel-only engine. Both the timing and pressure of the pilot injection proved to be critical parameters for optimising the emissions and performance

Landfill gas (LFG) tends to escape from the landfill surface even when LFG collecting systems are installed. Since LFG leaks are generally a noticeable percentage of the total production of LFG, the optimisation of the collection system is a fundamental step for both energy recovery and environmental impact mitigation. In this work, we suggest to take into account the results of direct measurements of gas fluxes at the air-cover interface to achieve this goal.During the last 5 years (2004-2009), 11 soil gas emission surveys have been carried out at the Municipal Solid Waste landfill of Legoli (Peccioli municipality, Pisa Province, Italy) by means of the accumulation chamber method. Direct and simultaneous measurements of CH(4) and CO(2) fluxes from the landfill cover (about 140,000 m(2)) have been performed to estimate the total output of both gases discharged into the atmosphere. Three different data processing have been applied and compared: Arithmetic mean of raw data (AMRD), sequential Gaussian conditional simulations (SGCS) and turning bands conditional simulations (TBCS). The total amount of LFG (captured and not captured) obtained from processing of direct measurements has been compared with the corresponding outcomes of three different numerical models (LandGEM, IPCC waste model and GasSim).Measured fluxes vary from undetectable values (<0.05 mol m(-2) day(-1) for CH(4) and <0.02 mol m(-2) day(-1) for CO(2)) to 246 mol m(-2) day(-1) for CH(4) and 275 mol m(-2) day(-1) for CO(2). The specific CH(4) and CO(2) fluxes (flux per surface unit) vary from 1.8 to 7.9 mol m(-2) day(-1) and from 2.4 to 7.8 mol m(-2) day(-1), respectively.The three different estimation methodologies (AMRD, SGCS and TBCS) used to evaluate the total output of diffused CO(2) and CH(4) fluxes from soil provide similar estimations, whereas there are some mismatches between these results and those of numerical LFG production models. Isoflux maps show a non-uniform spatial distribution, with high-flux zones not always corresponding with high-temperature areas shown by thermographic images.The average value estimated over the 5-year period for the Legoli landfill is 245 mol min(-1) for CH(4) and 379 mol min(-1) for CO(2), whereas the volume percentage of CH(4) in the total gas discharged into the atmosphere varies from 29% to 51%, with a mean value of 39%. The estimated yearly emissions from the landfill cover is about 1.29 x 10(8) mol annum(-1) (2,100 t year(-1)) of CH(4) and 1.99 x 10(8) mol annum(-1) (8,800 t year(-1)) of CO(2). Considering that the CH(4) global warming potential is 63 times greater than that of CO(2) (20 a time horizon, Lashof and Ahuja 1990), the emission of methane corresponds to 130,000 t annum(-1) of CO(2).The importance of these studies is to provide data for the worldwide inventory of CH(4) and CO(2) emissions from landfills, with the ultimate aim of determining the contribution of waste disposal to global warming. This kind of studies could be extended to other gas species, like the volatile organic compounds.

The drought prone North-West Bangladesh is vulnerable to the impacts of climate change, particularly because of less water availability in the dry period and high water requirement for crop production. Improved understanding of recent changes in crop water demand in the dry season is important for the water resources management in the region. A study was carried out to determine the potential impacts of recent climate change during last three decades on trends of water requirements of Boro rice. The reference crop evapotranspiration (ETo), potential crop water requirement (∑ETC), effective rainfall during the crop growing period (ER), potential irrigation requirement for crop evapotranspiration (∑ETC − ER) and net irrigation requirement of Boro rice were estimated using observed daily climate data in the CropWat model for the period of 1980 to 2013 for four North-West districts. Significant decreasing trends of ETo were observed in most of the dry months due to increasing relative humidity and decreasing wind-speed and sun-shine hours. The results showed decreasing trends of potential crop water requirement, i.e. the total crop evapotranspiration (∑ETC), of Boro rice due to decreasing reference crop evapotranspiration and shorter crop growing periods. The variations in trends of potential irrigation requirement for crop evapotranspiration (∑ETC − ER) found among different districts, are mainly linked to variations in trends of changes in effective rainfall. The net irrigation requirement of Boro rice has decreased, by 11% during the last three decades at an average rate of −4.4 mm year−1, instead of decreasing effective rainfall, mainly because of high rate of decrease of crop evapotranspiration (−5.9 mm year−1). Results indicate that a warming climate does not always result in higher agricultural water use and that climate change can also result in reduced water demands because of changes in humidity, wind-speed and sun-shine hours.

MILD combustion is a very attractive technology in energy production from diluted gas deriving from bio or thermochemical degradation of biomass for its intrinsic features. An effective use of such a technology for diluted fuel needs a thorough analysis of ignition and oxidation behavior to highlight the potential effects of the different fuel components on the basis of temperature and diluent/oxygen/fuel mixture composition. In this work ignition and oxidation of a model gas surrogating the gaseous fraction of biomass pyrolysis products containing C1-C2 species, CO and CO2 were experimentally and numerically studied in a wide range of temperature and overall composition in presence of large amount of CO2 or H2O. Experimental results showed that such species significantly alter the evolution of the ignition process in dependence on temperature range and mixture composition. Several kinetic models were tested to simulate experimental results. Significant discrepancies occur especially in case of steam dilution. Numerical analyses suggest that such diluents mainly act as third body species at low temperatures, conditioning both radicals production pathways and the relative weight of C1 oxidation/recombination routes, while strongly interact with the H2/O2 high temperature branching mechanisms at high temperatures. Further analyses are mandatory to improve the model ability to reduce the discrepancy between numerical and experimental data obtained in non standard conditions.

Clean combustion technologies, based on reactant dilution, have shown very peculiar and innovative characteristics. Reduction of light and noise emission and uniformity of temperature and composition distribution inside the combustion chamber, related to an extension of the reaction zone, make these processes very promising in several technological fields. Analysis of combustion in very diluted conditions is needed for a general understanding of these processes, which remain unknown from many aspects. The study is also useful for the identification of practical constraints which define the most suitable reactor configurations and working parameters for process reliability. The present work deals with a theoretical analysis of methane oxidation in diluted conditions using one of the detailed kinetic schemes available in the literature. A well-stirred reactor (WSR) configuration has been considered as a first attempt of process schematization. This choice is consistent with the experimental characterization of the flameless combustion processes. The influence of residence time, C/O ratio, and inlet temperature on the steady state was studied for an oxygen molar fraction (0.05), chosen as representative of flameless combustion processes. It has been pointed out that only rich conditions (C/O ? 0.25) are possible for WSR creation, because they allow partial methane conversion. Three kinetic regimes, related to different temperature ranges, have been identified on the basis of product distribution analysis. Both the oxidation and pyrolitic regimes, occurring respectively in low- and high-temperature ranges, are the most interesting working conditions for diluted combustion. The former, leading to CO and H2O as main reaction products, is suitable for reburning technology. The latter, which corresponds to large production of CO and H2, has been shown to be a reasonable explanation of flameless combustion. Advantages and potentials of this innovative process are analyzed, taking into account the kinetic pathway followed in the different working conditions.

With the concept of climate services rapidly climbing research and research-funding agendas worldwide, the time is ripe for a debate about the objectives, scope and content of such services.

The transition to a low carbon future is starting to affect landscapes around the world. In order for this landscape transformation to be sustainable, renewable energy technologies should not cause critical trade-offs between the provision of energy and that of other ecosystem services such as food production. This literature review advances the body of knowledge on sustainable energy transition with special focus on ecosystem services-based approaches and methods. Two key issues emerge from this review: only one sixth of the published applications on the relation between renewable energy and landscape make use of the ecosystem service framework. Secondly, the applications that do address ecosystem services for landscape planning and design lack efficient methods and spatial reference systems that accommodate both cultural and regulating ecosystem services. Future research efforts should be directed to further advancing the spatial reference systems, the use of participatory mapping and landscape visualizations tools for cultural ecosystem services and the elaboration of landscape design principles.

Since 2007, a range of new modeling approaches and tools have been developed for sustainability impact assessment (SIA), but a lack of universal acceptance of SIA tools in applied policy making is observed. The current article gives an overview of experiences from several European and international projects, critically reviews the selected SIA tools and then discusses a number of reasons for the observed disconnect of the tools with the potential users. Largely based on the experiences of the presented SIA tools focusing land use policy advice, a decision tree is designed, which may facilitate an adequate, region and developmental phase specific selection of tool-box components for the development of SIA tools in future. Elements to ensure end-user participation are also integrated in the decision tree in order to increase the likelihood of the tool in applied land use policy advice. In addition, the Challenges in SIA tool development and use are further discussed.