• Energy Research
• Closed Access close
• Restricted close
• Embargo close
• 13. Climate action close
• 12. Responsible consumption close
• 6. Clean water close

This paper presents experimental results of the impact of CO(2) co-feed on a gasification/pyrolysis process for various feedstocks (biomass, coal, and municipal solid waste (MSW)). Various feedstocks were thermo-gravimetrically characterized under various atmospheric conditions and heating rates. A substantial amount of char burn out was identified in the presence of CO(2) via a series of thermo-gravimetric analysis tests, which enabled high conversion of final mass (approximately 99%) to be achieved. The impact of CO(2) co-feed on the volatilization regime during the pyrolysis/gasification process was not apparent at a heating rate of 10-40 degrees C min(-1). However, the impact of CO(2) on the volatilization regime at a fast heating rate (950 degrees C min(-1)) was substantial. For example, significant enhancement in the generation of CO, by a factor of approximately 2, was observed in the presence of CO(2). The generation of major chemical species, such as CH(4) and C(2)H(4), were enhanced, but this was not as apparent as in the case with CO. In addition, introducing CO(2) to the pyrolysis/gasification process enabled the amount of condensable liquid hydrocarbons, such as tar (approximately 30-40%) to be significantly reduced in the presence of CO(2), in that injecting CO(2) into the pyrolysis/gasification process expedites cracking the volatilized chemical species. Experimental work confirmed that biomass and MSW could be feasible and desirable feedstocks for the pyrolysis/gasification process as these feedstocks can be easily treated compared to coal. To extend this understanding to a more practical level, various feedstocks were tested in a tubular reactor and drop tube reactor under various experimental conditions.

We have studied the response of the efficiency and short-circuit current of an array of silicon solar cells to changes in intensity of solar radiation under tropical atmospheric conditions. The investigation was carried out simultaneously at two different geographical locations in Nigeria: Enugu (6.20°N, 7.30°E) and Port Harcourt (4.43°N, 7.10°E) (Port Harcourt is located very close to the sea, while Enugu is far away from the sea). Data collected from the two locations clearly reveal that the mean optimum efficiency is not constant, but decreases exponentially as the intensity of solar radiation increases. The short-circuit current, on the other hand, increases non-linearly with intensity of solar radiation and approaches some constant maximum value under very high insolation. The change in efficiency is above 70% as the intensity of solar radiation changes from 100 to 800 W m−2. An empirical equation, relating the mean optimum efficiency to intensity of solar radiation, and an empirical equation, relating the mean short-circuit current to intensity of solar radiation, have been proposed. No previous similar work is available for comparison, but our results are consistent with the well-established fact that under cloudy conditions (and thereafter low insolation), short-wavelength radiation becomes predominant.

It's a slow death, but bolts still slay rainforest trees.

Abstract The high temperature coolant of nuclear power plants (NPPs) has been investigated for the hydrogen production, which could be a major role of a green energy promotion. An accident of the high temperature gas cooled reactor (HTGR) is modeled for the stabilized hydrogen production using nuclear energy. For the clean energy resource pursuit in preventing the climate change, the hydrogen is one of very attractive energy sources. The non-operational data could be produced by the fuzzy set theory which is one of non-linear complex algorithms. So, the result can show the possibility of the event happening instead of the exact solutions. The random numbers are generated for membership numbers of the fuzzy function. The event manipulation is done by new membership numbers for the propagations. The final result is 1.0 in 8 times during 100 months. So, the frequency is 0.08, or 8% of successful long-term cooling by conduction.

In recent years, marine auxiliary diesel engine has been widely used to produce electricity in the large ocean-going ship. One of the main technical challenges for ocean-going ship is to reduce pollutant emissions from marine auxiliary diesel engine and to meet the criteria of disposal on ships pollutants of IMO (International Maritime Organization). Different technical changes have been introduced in marine auxiliary diesel engine to apply clean fuels to reduce pollutant emissions. The ultralow sulfur light fuel will be applied in diesel engine for emission reductions in China. This study is aimed to investigate the impact of fuel (ultralow sulfur light fuel) on the combustion characteristic, NOx and green house gas emissions in a marine auxiliary diesel engine, under the 50%-90% engine speeds and the 25%-100% engine torques. The experimental results show that, in the marine auxiliary diesel engine, the cylinder pressure and peak heat release rate increase slightly with the increase of engine torques, while the ignition advances and combustion duration become longer. With the increases of the engine speed and torque, the fuel consumption decreases significantly, while the temperature of the exhaust manifold increases. The NOx emissions increase significantly with the increases of the engine speed and torque. The NO emission increases with the increases of the engine speed and torque, while the NO2 emission decreases. Meanwhile, the ratio of NO2 and NO is about 1:1 when the diesel engine operated in the low speed and load, while the ratio increases significantly with the increases of engine speed and torque, due to the increase of the cylinder temperature in the diffusive combustion mode. Moreover, the CO2 emission increases with the increases of engine speed and torque by the use of ultralow sulfur light fuel.

Abstract Agricultural practice is facing multiple challenges under volatile commodity markets, inevitable climate change, mounting pest pressure and various other environment-related constraints. The objective of this research is to present a dynamic optimization model of crop rotations and farm management and show its suitability for economic analysis over a 30 year time period. In this model, we include management practices such as fertilization, fungicide treatment and liming, and apply it in a region in Southwestern Finland. Results show that (i) growing pest pressure favours the cultivation of wheat-oats and wheat-oilseeds combinations, while (ii) market prices largely determine the crops in the rotation plan and the specific management practices adopted. The flexibility of our model can also be utilized in evaluating the value of other management options such as new cultivars under different projections of future climate and market conditions.

Abstract This article focuses on the results obtained by the enforcement of a original greenhouse gas emissions policy, issued in recent years in several municipalities in Northern Italy. The Municipality of Reggio Emilia was one of the firsts in Italy to develop and adopt a voluntary building energy-consumption certification method called Ecoabita, aiming to promote energy efficiency in buildings over its jurisdiction. Several reasons make this project innovative: first, the certification method has been processed through and verified by a quality international agency, secondly the procedure is assisting financial-incentive policies both on mandatory (European Directive 2002/91/CE) and voluntary basis (Municipality Protocol Ecoabita), finally it allows to obtain eligible credits for avoided emissions that can be negotiated on the CO2 exchange market. With specific reference to Reggio Emilia case, acknowledged the amount of actions, that are normally scheduled in the municipality throughout a year, it has been evaluated the benefit, in terms of environmental improvement, descended from the protocol, also projecting their trend in future years up to 2020 as well, demonstrating the scheduled interventions are fundamental in sought of the achievement of the Kyoto and Copenhagen commitments. The entire procedure has been developed in accordance to the parameters given by UNFCCC for these kinds of analyses and has been recently confirmed to be one of the most accurate international accounting procedure by a survey developed by the scientific committee of the European Project LIFE-LAKS.

This paper presents an experimental study of indoor thermal environment near a full-scale glass facade with different types of shading devices under varying climatic conditions in winter. Interior glazing and shading temperature, operative temperature and radiant temperature asymmetry were measured for facade sections with roller shades and venetian blinds at different positions. Interior glass surface temperatures can be high during sunny days with low outdoor temperature. Shading systems significantly improved operative temperature and radiant temperature asymmetry during cold sunny days, depending on their properties and tilt angle. During cloudy days the impact was smaller, however the shading layers could still decrease the amount of heat loss through the facade. A transient building thermal model, which also calculates indoor environmental indices under the presence of solar radiation, was developed and compared with the experimental measurements. Part II of this paper uses this validated model with a transient, two-node thermal comfort model (including transmitted solar radiation) for assessment of indoor environmental conditions with different building envelope and shading properties, facade location and orientation.

The delayed harvest system for grass crops in which the harvest of the previous year's crop is undertaken after it has over-wintered in the field significantly improves the fuel quality for both combustion and gasification. The critical elements that cause fouling and corrosion problems in boilers are alkali and chlorine which are released during combustion. The concentrations of these are reduced by a factor of 2 to 6 by using the delayed harvest system rather than harvesting in the end of the growing season. The loss of some leaf material and leaching of alkali also contributes to an increase in the ash fusion temperature from 1070°C to 1400°C. This work is part of a project in progress involving 14 different field trials distributed all over Sweden. Results are presented demonstrating that ash content is influenced by the type of soil. The most extreme variations are between reed canary grass grown on high clay content soils and those produced on very humic soils, with ash contents of 10.1% and 2.2%, respectively.