• Energy Research
• 2016-2025close
• 7. Clean energy close
• 13. Climate action close
• 8. Economic growth close
• Tsinghua University close

Abstract Predicting and optimizing radiative thermal properties have been acknowledged as an efficient way to improve thermal insulation performance of fibrous materials with high porosity. Based on experimental investigation of infrared spectral of ultrafine fibrous insulations with diameters of 520–650 nm, a method of calculating radiative thermal properties was presented by combining Rosseland equation, Mie scattering theory, Beer’s law and Subtractive Kramers–Kronig (SKK) relation. To ensure the calculation correct the uniqueness analysis was performed for Poly(vinylidene fluoride) (PVDF) fibers, which indicated the valid fiber diameter was less than 1.06 μm. The calculated thermal radiative conductivities by using the method agreed well with the measured data. The effect of fiber diameter on the thermal properties of the fibrous insulations was also investigated to minimize the radiative thermal conductivity. The results indicated that the minimized radiative thermal conductivities by regulating fiber diameters could be approximately 25% smaller than those for experimental fiber diameters. The method of predicting and minimizing radiative thermal conductivities of fibrous insulations demonstrated in this paper could be of great advantage to thermal engineering applications aiming to reducing heat loss and saving energy.

Flexible butyl interconnection segments are synthetically incorporated into an electronically conductive poly(pyrene methacrylate) homopolymer and its copolymer. The insertion of butyl segment makes the pyrene polymer more flexible, and can better accommodate deformation. This new class of flexible and conductive polymers can be used as a polymer binder and adhesive to facilitate the electrochemical performance of a silicon/graphene composite anode material for lithium ion battery application. They act like a “spring” to maintain the electrode mechanical and electrical integrity. High mass loading and high areal capacity, which are critical design requirements of high energy batteries, have been achieved in the electrodes composed of the novel binders and silicon/graphene composite material. A remarkable area capacity of over 5 mAh/cm2 and volumetric capacity of over 1700 Ah/L have been reached at a high current rate of 333 mA/g.

Test systems are important tools and benchmark for power system research. Currently, there is a lack of standard test systems for modern transmission expansion planning (TEP) research, especially under high variable renewable energy (VRE) penetrations. This paper describes a 38-bus test system named the HRP-38 system dedicated to TEP. “HRP” stands for high renewable penetration. The objective of establishing such a system is to provide a consistent platform for different TEP methods to be tested and compared. The test system considers high VRE penetration of more than 30% energy share, which will be an important feature in many power systems in the future. Both AC and DC candidate lines are given to provide sufficient transmission planning alternatives. The complexity of the test system is well balanced considering calculation tractability and the ability to test the performance of the TEP planning model. The network topology, generation mix, and load characteristics are described in detail. Year-round time series of VRE (wind power and PV) output and load curves for each bus are provided to facilitate a detailed evaluation of the transmission grid configuration under high VRE penetration. Finally, three benchmark results with different optimization targets are provided for the HRP-38 system.

This study aims to explore the application of fractional order chaotic system (FOCS), based on the T-S fuzzy model, in the design of secure communication (SC) and this SC system’s role in the construction of efficiency evaluation system for dispatching operation of energy saving and power generation under a low carbon economy (LCE). First, the definition of fractional order differential equations and the stability theory of FOCS are discussed. T-S fuzzy control is introduced to analyse the stability of FOCS. Then, based on the adaptive synchronisation theory, the combined FOCS is designed for SC, and the performance of the system constructed here is analysed in a MATLAB environment. Next, an evaluation index system of the dispatching operation effect of energy saving and power generation under LCE is constructed. The confidential communication system constructed here is used to transmit the index data. The particle swarm optimisation (PSO) algorithm is then used to optimise the back propagation neural network (BPNN) model. The BPNN algorithm based on PSO (PSO-BPNN) is obtained, and the evaluation model is constructed. After training this model, it is applied to the evaluation of the dispatching operation effect for energy saving and power generation in 10 provinces in China. The simulation results show that the FOCS based on the T-S fuzzy model can acquire the criterion of system stability. Furthermore, the constructed SC system can effectively undertake the secure transmission of square and sine waves. The performance of the PSO-BPNN model seems to be better than other algorithms. After analysing the data on energy saving and power generation from 10 provinces in China using this model, the comprehensive evaluation value of province 5 is found to be the highest and good (0.802), while that of province 4 is the lowest and general (0.600). Summarising, the FOCS based on T-S fuzzy model constructed here is applied to the design of SC. This can improve the confidentiality of data transmission and reduce the transmission error. Moreover, the BPNN evaluation model based on PSO can effectively achieve the evaluation of the dispatching operation effect of energy saving and power generation under LCE.

Flue gas desulfurization (FGD) and selective catalytic reduction (SCR) technologies have been widely used to control the emissions of sulphur dioxide (SO2) and nitrogen oxides (NOX) from coal-fired power plants (CFPPs). Field measurements of emission characteristics of four conventional CFPPs indicated a significant increase in particulate ionic species, increasing PM2.5 emission with FGD and SCR installations. The mean concentrations of PM2.5 from all CFPPs tested were 3.79 ± 1.37 mg/m3 and 5.02 ± 1.73 mg/m3 at the FGD inlet and outlet, respectively, and the corresponding contributions of ionic species were 19.1 ± 7.7% and 38.2 ± 7.8%, respectively. The FGD was found to enhance the conversion of NH3 slip from the SCR to NH4+ in the PM2.5, together with the conversion of SO2 to SO42-, and increased the primary NH4+ and SO42- aerosol emissions by approximately 18.9 and 4.2 times, respectively. This adverse effect should be considered when updating the emission inventory of CFPPs and should draw the attention of policy-makers for future air pollution control.

Based on the observation monthly climatic data collected from 2766 weather observation stations on global during the period from 1981 to 2010, and the climatic scenarios data of SSP1_2.6、SSP1_4.5 and SSP1_8.5 scenarios released by CMIP6, the mean annual biotemperature, average total annual precipitation and potential evapotranspiration ratio on spatial resolution of 0.1º× 0.1º were respectively obtained by operating a high accuracy and speed method of surfacing modeling (HASM) (Yue, 2010, Yue et al., 2016) during all the four periods from 2020 to 2050 per decade. The method for surface modelling of land cover scenarios (SMLCS) has been developed to simulate the scenarios of land cover in Eurasia （Fan et al., 2019, 2020, 2021）. Finally, the scenario dataset of land cover under scenario SSP1_2.6、SSP1_4.5 and SSP1_8.5 were simulated by the SMLCS method from 2020 to 2050. 采用1981-2010年全球2766个气象观测站的观测月气候数据，以及CMIP6发布的SSP1_2.6、SSP1_4.5和SSP1_8.5情景的气候情景数据。通过运行高精度面建模方法（HASM）(Yue, 2010, Yue et al., 2016)，分别获得2020-2050年间每10年的空间分辨率为0.1º×0.1º的平均生物温度数据、多年平均年降水和潜在蒸散比率数据。采用自主研发的土地覆被情景曲面建模（SMLCS）方法（Fan et al., 2019, 2020, 2021），实现了SSP1_2.6、SSP1_4.5和SSP1_8.5情景的2020-2050年间每10年的全球土地覆被变化情景模拟。

Including solar power geneartion from 2018 to 2019 at a 3kW rooftop pv plant in the university of macau, with a resolation of 30 s, and the public weather report of Macau with a resolution of 1 hour.

The greatest sustainability challenge facing humanity today is the greenhouse gas emissions and the global climate change with fossil fuels led by coal, natural gas and oil contributing 61.3% of global electricity generation in the year 2020. The cumulative effect of the Stockholm, Rio, and Johannesburg conferences identified sustainable energy development (SED) as a very important factor in the sustainable global development. This study reviews energy transition strategies and proposes a roadmap for sustainable energy transition for sustainable electricity generation and supply in line with commitments of the Paris Agreement aimed at reducing greenhouse gas emissions and limiting the rise in global average temperature to 1.5°C above the preindustrial level. The sustainable transition strategies typically consist of three major technological changes namely, energy savings on the demand side, generation efficiency at production level and fossil fuel substitution by various renewable energy sources and low carbon nuclear. For the transition remain technically and economically feasible and beneficial, policy initiatives are necessary to steer the global electricity transition towards a sustainable energy and electricity system. Large-scale renewable energy adoption should include measures to improve efficiency of existing nonrenewable sources which still have an important cost reduction and stabilization role. A resilient grid with advanced energy storage for storage and absorption of variable renewables should also be part of the transition strategies. From this study, it was noted that whereas sustainable development has social, economic, and environmental pillars, energy sustainability is best analysed by five-dimensional approach consisting of environmental, economic, social, technical, and institutional/political sustainability to determine resource sustainability. The energy transition requires new technology for maximum use of the abundant but intermittent renewable sources a sustainable mix with limited nonrenewable sources optimized to minimize cost and environmental impact but maintained quality, stability, and flexibility of an electricity supply system. Technologies needed for the transition are those that use conventional mitigation, negative emissions technologies which capture and sequester carbon emissions and finally technologies which alter the global atmospheric radiative energy budget to stabilize and reduce global average temperature. A sustainable electricity system needs facilitating technology, policy, strategies and infrastructure like smart grids, and models with an appropriate mix of both renewable and low carbon energy sources.