• Energy Research
• Closed Access close
• Embargo close
• Renewable Energy close

Abstract In this work, energy analysis is carried out to account for inputs and outputs of energy and GHG emissions associated with the biodiesel production system. Jojoba oil is obtained by cultivation of the jojoba plant, harvesting of seeds followed by extraction of oil, which is then converted to biodiesel by the process of transesterification. Energy efficiency is expressed in terms of the net energy balance (NEB) and the net energy ratio (NER). The use of the byproducts (husk, cake or meal, waste residues and glycerin) are also included as a part of the system boundary. The results show that the NEB and NER values are calculated at 46724.1 MJ/ha (28.9 MJ/L biodiesel produced) and 2.16, respectively. At the same time, the total amount of GHG emissions are estimated at 2.28 kg-CO2eq/L biodiesel produced (66.0 g CO2eq/MJ biodiesel produced). Nevertheless, if manure is used as fertilizer for jojoba plant cultivation, the primary energy input will fall by 9.52% (to 22.49 MJ/L of biodiesel).

Abstract This paper investigates the performance of a variable ratio gearbox (VRG) used in a small fixed-speed wind turbine with active blades. The major components of the VRG-enabled drivetrain are an automatic-manual gearbox and squirrel cage induction generator that connects directly to the grid. The simplicity of this system may be appealing for applications when cost and reliability are of concern. It is an alternative to variable speed systems, which necessitate a modified generator and power conditioning equipment. During partial load operation the VRG provides a discrete set of rotor speeds. This allows the controller to track the wind speed and to achieve a greater efficiency. This study suggests three VRG ratios are sufficient to improve performance when used with active blades. A case study is presented where the performance is simulated using three different wind data sets. The study suggests that the VRG can improve production between 7 and 8.5% in low wind areas. The design procedure also illustrates a technique for finding the lowest and highest gear ratios needed for VRG design. These ratios allow the system to achieve the lowest cut-in and rated speeds. The approach also has useful implications for the design of a continuously variable transmission.

Abstract This paper describes a model of the 2020 Irish electricity system which was developed and solved in a mixed integer programming, unit commitment and economic dispatch tool called PLEXOS ® . The model includes all generators on the island of Ireland, a simplified representation of the neighbouring British system including proposed wind capacity and interconnectors between the two systems. The level of wind curtailment is determined under varying levels of three influencing factors. The first factor is the amount of offshore wind, the second is the allowed limit of system non-synchronous penetration (SNSP) and the third is inclusion or exclusion of transmission constraints. A binding constraint, resulting from the 2020 EU renewable energy targets, is that 37% of generation comes from wind. When the SNSP limit was increased from 60% to 75% there was a reduction in wind curtailment from 14% to 7%, with a further reduction when the proportion of wind capacity installed offshore was increased. Wind curtailment in the range of SNSP limit of 70–100% is influenced primarily by the inclusion of transmission constraints. Large changes in the dispatch of conventional generators were also evident due to the imposition of SNSP limits and transmission constraints.

The Severn Estuary has the world's second largest tide range and a barrage across the estuary, located just seawards of Cardiff in Wales and Weston in the South West England, has been proposed for over half a century, with the objective of extracting large amounts of tidal energy. A Severn Barrage, as previously proposed by the Severn Tidal Power Group (STPG), would be the largest renewable energy project for tidal power generation in the world, if built as proposed, and would generate approximately 5% of the UK's electricity needs. However, concerns have been raised over the environmental impacts of such a barrage, including potential increase in flood risk, loss of intertidal habitats etc. In addressing the challenges of maximizing the energy output and minimizing the environmental impacts of such a barrage, this research study has focused on using a Continental Shelf model, based on the modified Environmental Fluid Dynamics Code (EFDC) with a barrage operation module (EFDC_B), to investigate both the far and near field hydrodynamic impacts of a barrage for different operating scenarios. Three scenarios have been considered to simulate the Severn Barrage, operating via two-way generation and using different combinations of turbines and sluices. The first scenario consisted of 216 turbines and 166 sluices installed along the barrage; the second consisted of 382 turbines with no sluices; and the third consisted of 764 turbines and no sluices. The specification of the sluice gates and turbines are the same for all scenarios. The model results indicate that the third scenario has the best mitigating effects for the far-field and near-field flood risks caused by a barrage and produces the most similar results of minimum water depth and maximum velocity distributions to those obtained from simulating the natural conditions of the estuary, i.e. the current conditions. The results also show that the flow patterns around the barrage are closest to those for the existing natural conditions with minimal slight changes in the estuary. Thus, the results clearly indicate that the environmental impacts of a Severn Barrage can be minimized if the barrage is operated for two-way generation and under the third scenario. Although it appears that the energy output for the third scenario is less than that obtained for the other two scenarios, if very low head (VLH) turbines are used, then the third scenario could generate more energy as more turbines could be cited along the barrage structure. Therefore, the study shows that a Severn Barrage, operating in two-way generation and with 764 turbines (ideally VLH turbines), would be the best option to meet the needs of maximizing the energy output, but having a minimal impact on environmental changes in the estuary and far-field.

Abstract The price effect of the rising share of renewable electricity, which is called ‘merit-order-effect’, leads to noticeable changes in the German power industry and debates about the electricity market design. This paper estimates the merit-order-effect induced by variable renewable energy in the German-Austrian electricity sector with a multivariate regression model. The research focus lies on the impact of the estimated effects on the marketability of variable renewable electricity generation. The results show a systematic decline of the average market revenues for wind and photovoltaic plants in the period from January 2011 to December 2013. Current market data shows a continuation of this trend into 2016. According to the German long term goals for the use of renewables, wind and solar power will play a crucial role in the future electricity generation mix. If investments in these technologies will be profitable without any regulatory remuneration mechanisms in addition to the market revenues, depends on the further cost degression and the development of the merit-order-effect.