• Energy Research
• Open Access close
• 7. Clean energy close
• 12. Responsible consumption close
• Energy close

The hydraulic balance of heating network is considered as a pre-condition for the implementation of low temperature district heating (LTDH). Its imbalance result into high energy consumption and heat-losses in the network. In this study, a novel hydraulic model is presented which investigates hydraulic imbalance in the LTDH network, using real weather and hourly monitored operational heating data from an existing boiler based building. Analysis of delta t in space-heating system shows that the delta t is maximum when the outside air temperature is lowest and it decreases with increase in outside air temperature. Furthermore, the hydraulic imbalance is analysed for four different control scenarios with the aim to find an optimum scenario with minimum pumping power, energy consumption and heat-losses in the LTDH network. Results show that the hydraulic imbalance is due to the absence of flow-limiters and balancing valves on the return pipe and thermostatic radiator valves (TRVs) alone are unable to maintain hydraulic balance in the space-heating system of buildings. Moreover, the control scenario with variable flow-rate and fixed supply water temperature from the sub-station is found to be optimum. Compared to the constant flow-rate scenario, the pumping power, energy consumption and heat-losses in the LTDH network are reduced by approximately 2%, 63% and 14%, respectively.

Abstract This work aims to predict the general performances of a pilot parabolic trough collector during transient periods. To do so, a one-dimensional thermal model has been developed. It has been validated with experimental results from two different experimental setups, in steady-state conditions, with a transmitted power maximum error of 3.4%. Since the model only predicts the collector's thermal behavior, the parabolic trough collector has been first optically qualified. Then, optical efficiencies were used as input for the model. Experimental results were obtained in steady-state conditions and compared to the model. Then, experimental and numerical results were compared during two period of time with varying inlet conditions (i.e. dynamic condition tests): the first one with stable conditions, and the other one with harsh conditions. The developed model showed a good capability of predicting the thermal behavior of the parabolic trough collector with unstable environment (DNI, mass flow, inlet temperature), with a 9.6% relative standard error in the worst case. As a conclusion, while previous studies only focused on steady-state conditions, it has been showed that this kind of model can be used to precisely predict the dynamic behavior of large power plants.

This paper presents a new method, based on the Smart Energy Systems concept. The aim is to increase the share of renewable energy penetration on islands. The method is applied to the island of Gran Canaria (Spain), considering the entire energy system of the island. Several smart renewable energy strategies are proposed following a cross-sectoral approach between the electricity, heating/cooling, desalination, transport and gas sectors. The different smart renewable energy strategies were applied in a series of steps, while looking for a transition from the current energy system to a nearly 100% renewable energy system. Based on the results, the study concludes that the suggested method is applicable for increasing renewable integration on islands and can potentially be used in helping energy planners to take decisions about priorities in development of the sector to improve such integration. The results indicate that, for the case of Gran Canaria, a 75.9% renewable energy system could be attained with technologies that can be implemented at present. Furthermore, it is shown that a nearly 100% renewable energy system in Gran Canaria is technically feasible and could be achieved if certain technologies acquire greater maturity. © 2018 Elsevier Ltd 443 421 2,048 5,537 Q1 Q1 SCIE

The increasing depletion of natural resources, combined with a wider set of pressures on the environment, has, in recent years, highlighted the need for a more efficient use of energy and a development process that involves alternative energy sources. Energy efficiency has received much attention as a solution, implying both monetary and emissions savings. However, the latter may be partially offset by the income and demand effects of the former, both in more efficient sectors and in spreading to the wider economy. This is the problem of rebound effects. Taking Spain as a case study, and introducing an energy-related CGE model that develops the inclusion of renewables, this paper evaluates a combination of efficiency initiatives to deliver both reduced energy use by households and a more sustainable supply of energy. Our findings suggest that a package aimed at improving efficiency in household electricity and petroleum use, combined with a more competitive supply of energy from renewable sources, may be the only way to get reductions in all energy use, and thus benefit the economy. Specifically, we consider how this package may lead to positive economic impacts and associated rebound effects, where the latter are focused on a greener energy supply.

With increasing interest in alternative energy resources and technologies, mass penetration of PHEVs (plug-in hybrid vehicles) into the electricity grid and widespread utilization of DERs (distributed energy resources) are anticipated in the near future. As an aggregation unit, the VPP (virtual power plant) is introduced for load management and resource scheduling. In this article, we develop an energy management model for VPPs and analyze the cost and emission impacts of VPP formation and PHEV penetration. We conduct a case study for the state of California using real-world data from official resources. An average of 29.5% cost reduction and 79% CO2 and 83% NOx emission reductions are attained as shared benefits of consumers in the case study. Results are illustrative of opportunities that VPP formation can provide for the community. Sensitivity of the results to the DER costs and capacities, battery and gasoline prices are also analyzed. In addition, we prove that charging and discharging do not simultaneously occur in the solutions, which leads to a simplification in traditional energy management models.

AbstractThe split cycle engine is a new reciprocating internal combustion engine with a potential of a radical efficiency improvement. In this engine, the compression and combustion–expansion processes occur in different cylinders. In the compression cylinder, the charge air is compressed through a quasi-isothermal process by direct cooling of the air. The high pressure air is then heated in a recuperator using the waste heat of exhaust gas before induction to the combustion cylinder. The combustion process occurs during the expansion stroke, in a quasi-isobaric process. In this paper, a fundamental theoretical cycle analysis and one-dimensional engine simulation of the split cycle engine was undertaken. The results show that the thermal efficiency (η) is mainly decided by the CR (compression ratio) and ER (expansion ratio), the regeneration effectiveness (σ), and the temperature rising ratio (N). Based on the above analysis, a system optimization of the engine was conducted. The results showed that by increasing CR from 23 to 25, the combustion and recuperation processes could be improved. By increasing the expansion ratio to 26, the heat losses during the gas exchange stroke were further reduced. Furthermore, the coolant temperatures of the compression and expansion chambers can be controlled separately to reduce the wall heat transfer losses. Compared to a conventional engine, a 21% total efficiency improvement was achieved when the split cycle was applied. It was concluded that through the system optimization, a total thermal efficiency of 53% can be achieved on split cycle engine.

Abstract Building energy consumption is vulnerable to climate change due to the direct relationship between outside temperature and space cooling/heating. This work quantifies how the relationship between climate change and building energy consumption varies across a range of building types at different spatiotemporal scales based on estimates in 925 U.S. locations. Large increases in building energy consumption are found in the summer (e.g., 39% increase in August for the secondary school building), especially during the daytime (e.g., >100% increase for the warehouse building, 5–6 p.m.), while decreases are found in the winter. At the spatial scale of climate-zones, annual energy consumption changes range from −17% to +21%, while at the local scale, changes range from −20% to +24%. Buildings in the warm-humid (Southeast) climate zones show larger changes than those in other regions. The variation of impact within climate zones can be larger than the variation between climate zones, suggesting a potential bias when estimating climate-zone scale changes with a small number of representative locations. The large variations found in the relationship between climate change and building energy consumption highlight the importance of assessing climate change impacts at local scales, and the need for adaptation/mitigation strategies tailored to different building types.