• Energy Research
• 6. Clean water close
• Biomass and Bioenergy close

Abstract In this study, crude cellulose derived from cornstalk, after bleaching, was used as raw material for the synthesis of sodium carboxymethyl cellulose (CMC) by reacting with the cellulose with NaOH and chloroacetic acid at 75 °C for 1.5 h. Effects of alkali dosage, concentration of chloroacetic acid on the physical and chemical properties of the CMC products were investigated. It was revealed that the reactants alkali reagent/chloroacetic acid/cellulose at the molar ratio of 4.6:2.8:1and 4:2.5:1, or at the molar ratio of NaOH/ClCH 2 COOH ≈1.6–1.64, resulted in CMC products of relatively high water solubility. The viscosity-average molecular weight M v of these two CMC products obtained at molar ratios of 4.0:2.5:1 and 4.6:2.8:1 is in the range of 1.94 × 10 4 –2.48 × 10 4 g mol −1 , and the average DS of the two products are 0.57 and 0.85, respectively. As the solute concentration is above 2 wt%, the viscosity of the CMC-water solution exhibits nonlinear (exponential) increasing with increasing the solute concentration (typical of non-Newton fluids).

Among various bioreactors examined in anaerobic digestion and dark fermentation, UASB bioreactor has shown to be a promising alternative. However, mass transfer resistance and biomass washout have been the issues that reported as draw backs of the granular system in the literature. Another problem associated with such a system is its long start-up period as a result of biomass washout and long microbial granulation stage. In this paper, the results obtained from an UASFF bioreactor in methane (AD process) and hydrogen (DF process) production from POME, are presented to assess mass transfer of substrate into the granules and also study the role of internal packing used in the middle part of reactor in the process stability. The value of effectiveness factor, η, for AD and DF processes were calculated to be 0.96 and 0.94, respectively, indicating that there was no mass transfer resistance due to internal and/or external factors. The results showed that the packing material could retain biomass in the reactor and had outstanding contribution in the granulation enhancement. Its role as a supplementing treatment stage was more significant at low HRTs and up-flow velocities.

Molasses are a potential feedstock for ethanol production. The successful application of anaerobic fermentation for ethanol production from molasses is critically dependent to the development and the use of high rate bioreactors. In this study the fermentation of sugar cane molasses by Saccharomyces cerevisiae for the ethanol production in a continuously stirred tank reactor (CSTR), an immobilised cell reactor (ICR) and a membrane reactor (MBR) was investigated. Ethanol production and reactor productivities were compared under different dilution rates (D). When using the CSTR, a decent ethanol productivity (Qp) of 6.8 g L−1 h−1 was obtained at a dilution rate of 0.5 h−1. The Qp was improved by 48% and the residual sugar concentration was reduced by using the ICR. Intensifying the production of ethanol was investigated in the MBR to achieve a maximum ethanol concentration and a Qp of 46.5 g L−1 and 19.2 g L−1 h−1, respectively. The achieved results in the MBR worked with high substrate concentration are promising for the scale up operation.

Abstract Anaerobic digestion of animal by-products was investigated in batch and semi-continuously fed, reactor experiments at 55 °C and for some experiments also at 37 °C. Separate or mixed by-products from pigs were tested. The methane potential measured by batch assays for meat- and bone flour, fat, blood, hair, meat, ribs, raw waste were: 225, 497, 487, 561, 582, 575, 359, 619 dm 3 kg −1 respectively, corresponding to 50–100% of the calculated theoretical methane potential. Dilution of the by-products had a positive effect on the specific methane yield with the highest dilutions giving the best results. High concentrations of long-chain fatty acids and ammonia in the by-products were found to inhibit the biogas process at concentrations higher than 5 g lipids dm −3 and 7 g N dm −3 respectively. Pretreatment (pasteurization: 70 °C, sterilization: 133 °C, and alkali hydrolysis (NaOH) had no effect on achieved methane yields. Mesophilic digestion was more stable than thermophilic digestion, and higher methane yield was noticed at high waste concentrations. The lower yield at thermophilic temperature and high waste concentration was due to ammonia inhibition. Co-digestion of 5% pork by-products mixed with pig manure at 37 °C showed 40% higher methane production compared to digestion of manure alone.

Abstract Continuous bio-methanization of an energy crop, namely the beet silage, was investigated in this laboratory-scale work as mono-substrate, using a mesophilic biogas digester controlled by a fuzzy logic control (FLC) technique and without using any supplementing or buffering agent, despite the low pH of the substrate around 3.80. The temperature, pH, redox potential (ORP), daily biogas production and composition of digester biogas were continuously measured online. During the operation, the hydraulic retention time (HRT) varied between 24.8 and 9 days, as the organic loading rate (OLR) ranged from 2.6 to 4.7 g L −1 d −1 . The average pH, specific gas production rate (spec. GPR) and volumetric gas production rate (vol. GPR) were determined to be 7.12, 0.31 L g VS −1 d −1 and 1.084 L L −1 d −1 , respectively. The average methane (CH 4 ) content of digester biogas was about 56%. The FLC technique, which was developed at HAW Hamburg for anaerobic conversion of acidic energy crops to methane, determined the daily feeding volume (∼ OLR/HRT) for the biogas digester, depending on the feedback from online pH and methane measurements, and on the calculation of the spec. GPR. The spec. GPR was calculated by the corrected daily biogas production. Through online monitoring of pH, biogas production rate and composition, and by use of the FLC technique, the acidic beet silage could continuously be converted to biogas, without using manure or any other kind of buffering or supplementing agent(s). The lab-scale anaerobic biogas digester performed stable and safe, without encountering any problems of instability, as indicated by an adequate amount of buffering capacity, a VFA content below 0.5 g L −1 and a neutral pH range throughout the study.

This study aimed to investigate the effect of nitrogen addition on growth and water use of pot-grown Jatropha curcas (J. curcas) under three irrigation frequencies, i.e. 4d (W1), 8d (W2) and 12d (W3). Results show that compared to W1, W3 significantly reduced net plant growth, leaf area, basal shoot xylem cross-section area, total dry mass and whole water storage capacity and total evapotranspiration under saving irrigation water of 21.0%, but increased irrigation water-use efficiency (WUE1) and crop water-use efficiency (WUEET) by 9.7 and 13.1%, respectively. Meanwhile, W3 had higher Huber value, which may improve transfer water efficiency from roots to shoots. Compared to no nitrogen treatment, nitrogen addition increased total dry mass, whole plant water storage capacity, total evapotranspiration, WUE1 and WUEET by 13.4-38.1, 8.5-17.7, 14.9-17.5, 16.4-30.7 and 17.7-21.9%, respectively. Thus the optimal combination was the treatment with irrigation frequency of 12d and nitrogen supply, which can increase water-use efficiency. (C) 2013 Elsevier Ltd. All rights reserved.

Abstract Anaerobic treatment of palm oil mill effluent (POME) was studied using a 16-litre laboratory scale up-flow anaerobic sludge blanket reactor (UASB) run over a range of influent concentrations from 5.1 to 42.5 g Chemical Oxygen Demand (COD) per litre at a constant hydraulic retention time of four days. Methane production, volatile fatty acid conversion, net sludge growth and Chemical Oxygen Demand reduction were monitored. Over 96% Chemical Oxygen Demand was removed at loadings up to 10.6 g COD l −1 day −1 . At the highest influent concentration reactor instability was observed. Up to this point the results indicated that the UASB could treat POME more effectively than other systems reviewed.

Cassava pulp is a major by-product produced in a cassava starch factory, containing 50–60% of starch (dry basis). Therefore, in this study we are considering its potential as a raw material substrate for the production of methane. To ensure sufficient amounts of nutrients for the anaerobic digestion process, the potential of co-digestion of cassava pulp (CP) with pig manure (PM) was further examined. The effect of the co-substrate mixture ratio was carried out in a semi-continuously fed stirred tank reactor (CSTR) operated under mesophilic condition (37 °C) and at a constant OLR of 3.5 kg VS m−3 d−1 and a HRT of 15 days. The results showed that co-digestion resulted in higher methane production and reduction of volatile solids (VS) but lower buffering capacity. Compared to the digestion of PM alone, the specific methane yield increased 41% higher when co-digested with CP in concentrations up to 60% of the incoming VS. This was probably due to an increase in available easily degradable carbohydrates as the CP ratio in feedstock increased. The highest methane yield and VS removal of 306 mL g−1 VSadded and 61%, respectively, were achieved with good process stability (VFA:Alkalinity ratio < 0.1) when CP accounted for 60% of the feedstock VS. A further increase of CP of the feedstock led to a decrease in methane yield and solid reductions. This appeared to be caused by an extremely high C:N ratio of the feedstock resulting in a deficiency of ammonium nitrogen for microbial growth and buffering capacity.

Abstract For meeting the increasing demand of energy, biohydrogen production is to be considered in higher yield. Biohydrogen can be produced both by dark and photofermentative process. In this study, the photofermentative pathway is followed by using dl malic acid (IUPAC name: 2-hydroxybutanedioic acid, molecular weight: 134.08744 g mol −1 , molecular formula: C 4 H 6 O 5 ) as carbon source. Pure strain of purple non-sulfur (PNS) bacteria: Rhodobacter sphaeroides strain O.U.001 was studied to produce biohydrogen using the photobioreactor. The photobioreactor was constructed aiming the uniform light distribution. The objective of this study was to investigate the performance of 1 L annular photobioreactor operating in indoor conditions. The highest rate of hydrogen production was obtained at 92 h. In the designed photobioreactor, using Rhodobacter sphaeroides strain O.U.001 (initial dl malic acid concentration of 2.01 g L −1 ) at an initial pH of 6.8 ± 0.2, temperature 32 ± 2 °C, inoculum volume 10% (v/v), inoculum age of 48 h, 250 rpm (rotation per minute) stirring and light intensity of 15 ± 1.1 W m −2 , the average H 2 production rate was about 6.5 ± 0.1 mL H 2 h −1 L −1 media and yield 4.5 ± 0.05 mol of H 2 mol −1 of dl malic acid. Luedeking–Piret model was applied for the data fitting to determine the relationship between the cell growth and photofermentative hydrogen production. The photofermentative hydrogen production by this PNS bacterium was found to be microbial mixed growth associated function.