• Energy Research
• 2016-2025close
• 12. Responsible consumption close
• 14. Life underwater close

Abstract Activated carbon is commonly used as a material for contaminant-adsorption processes in aqueous systems. However, its use is more restricted to charcoal than to coal, for the most part, in view of the fact of the higher cost (~ 40%) if the mineral is a fossil fuel which needs to be extracted from the earth by mining. For this reason, the peach stone that comes from alimentary industrial tailings can be a good choice for the separation of pollutants from aqueous suspensions and other soluble substances. The purpose of this research was the development of a low-cost filter, using stones to remove atrazine from water. Appraisal and characterization studies were performed along with batch experiments to investigate dosing effects of the activated carbon, atrazine concentration, contact time, and adsorption pH on removal procedures. From the results of the experiment, an excellent removal of the analyte in question was observed under conditions that can be considered as close as possible to the environment, such as pH = 6.5, room temperature and 10 minutes of agitation time, always choosing the best alternative with the lowest cost of energy and time. Batch system application has been recommended as versatile for utilization in seasonal problems such as pesticide contamination.

The upload research data are including the fishery data of area coordinate, fishing effort (number of hooks), fishing date, number of catches and CPUE of immature and mature cohorts, and marien environmental date of SST, Chl-a, SSHD and MIL for 5° spatial grid from 2003 to 2012.

This realistic ocean simulation was run using the Coastal and Regional Ocean COmmunity model (CROCO), based on the Regional Ocean Modelling System (ROMS), which has 60 terrain-following vertical levels. This output (WOES 0.25) is the largest grid of a triply nested configuration: WOES I, WOES II and WOES III, with horizontal resolutions of ~22.5, 7.5 and 2.5 km respectively. Monthly ouputs of the 0.25 degree GLORYS ocean reanalysis is used to force the boundaries of WOES I. The surface forcing for this model is provided by a bulk formulation using daily ERA-Interim atmospheric reanalysis (with a resolution of ~80 km) and using a relative wind approach. The output is saved as daily averages, in monthly netcdf files spanning January 1993 - December 2014. WOES 0.25 spans 55.7degS to 3.18388 degS and 10degW to 102.25degE and covers most of the Southern Subtropical Indian Ocean and a part of the Southern Atlantic Ocean. Model output includes: averaged free-surface (zeta), averaged vertically integrated u-momentum component (ubar), averaged vertically integrated v-momentum component (vbar), averaged u-momentum component (u), averaged v-momentum component (v), averaged potential temperature (temp), averaged salinity (salt), averaged vertical momentum component (w). Numerical computations were performed on the IDRIS (Institut du Developpement et des Ressources en Informatique Scientifique) IBM "ADA" computer facility (under grant A0020107630)

The data comprise Climber3alpha+C simulations created by Matthias Hofmann (PIK) as part of the Work Package 2.1 of the COMFORT project as well as the PyFerret scripts (written by Ralf Liebermann and Matthias Hofmann) used for their evaluation. The simulation data consist of snap_*.nc files and history.nc files for ocean, atmosphere and mixed layer depth (hmxl) performed for different idealized scenarios: CONTROL, double and fourfold atmospheric CO2 (CO2X2 and CO2X4), also with additional Greenland freshwater influx (CO2X2_HOSING and CO2X4_HOSING). Furthermore, tracer simulations (CONTROL, CO2X4, CO2X4_HOSING) and simulations with constant scavenging (CO2X4) are also included. The aim was to analyse the simulations regarding climate change-induced changes in marine biogeochemistry and primary production, which will be published under the title "Shutdown of Atlantic overturning circulation could cause persistent increase of primary production in the Pacific" (see Related Work). Simulation data were generated with Climber3alpha+C (Earth system model of intermediate complexity) and evaluated with PyFerret v7.41. CDO was used to aggregate monthly simulation data into annual means.

Fashion products made from repurposed materials (e.g., backpacks made from pineapple leaves) have become more prevalent nowadays, and their environmental sustainability is one of the core advantages. Yet, it is currently unclear how consumers respond to products made from repurposed materials. We conducted three experiments to examine the effects of three material features, namely function, sustainability, and distinguishability, on consumer preferences for fashion products made from repurposed materials. The results indicate that, when the function of repurposed materials is as good as that of conventional materials, consumers prefer a product made from repurposed materials over the same product made from conventional materials. Also, consumers in general prefer repurposed materials to be less visually distinguishable. Finally, when the sustainability of the repurposed products is emphasized, consumers appear more likely to choose products made from repurposed materials, even when these products have an inferior function. In conclusion, to promote fashion products made from repurposed materials, marketers may emphasize the function and sustainability of repurposed materials, and producers may manufacture repurposed materials that visually resemble conventional materials.

Demographic data for eight red coral (Corallium rubrum) populations in the NW Mediterranean Sea (Spain and France). This dataset includes colony size-based estimates of annual survival, shrinkage and fecundity rates of red coral populations subjected to different disturbances (fishing and warming) and a growth model based in coral colonies from two populations.

Local tide and wave conditions were recorded with a RBRduo TDǀwave sensor (RBR Ltd., Ontario/Canada). The sensor was bottom mounted in a shallow tidal creek (0.78 m NHN) through a steel girder (buried 0.3m deep in the sediment) and was positioned 10 cm above sediment surface, as was determined by using a portable differential GPS. This resulted in the sensor falling dry during low tide. For accurate depth calculations, raw pressure data were manually corrected for atmospheric pressure derived from a locally installed weather station. The sensor was pre-calibrated by the manufacturer and the sampling rate was 3 Hz with 1024 samples per burst at a sample interval of 10 min. Recorded data were internally logged until the readout with the Ruskin (V1.13.13) software. Date and time is given in UTC.Data handling was performed according to Zielinski et al. (2018): Post-processing of collected data was done using MATLAB (R2018a). Quality control was performed by (a) erasing data covering maintenance activities, (b) removing outliers, and (c) visually checks. Low-tide data is not removed, but were easily identified through the manually calculated water depth data, where all depths < 0.05m represented low tide data.

The atmosphere concentration of CO2 is steadily increasing and causing climate change. To achieve the Paris 1.5 or 2 oC target, negative emissions technologies must be deployed in addition to reducing carbon emissions. The ocean is a large carbon sink but the potential of marine primary producers to contribute to carbon neutrality remains unclear. Here we review the alterations to carbon capture and sequestration of marine primary producers (including traditional ‘blue carbon’ plants, microalgae, and macroalgae) in the Anthropocene, and, for the first time, assess and compare the potential of various marine primary producers to carbon neutrality and climate change mitigation via biogeoengineering approaches. The contributions of marine primary producers to carbon sequestration have been decreasing in the Anthropocene due to the decrease in biomass driven by direct anthropogenic activities and climate change. The potential of blue carbon plants (mangroves, saltmarshes, and seagrasses) is limited by the available areas for their revegetation. Microalgae appear to have a large potential due to their ubiquity but how to enhance their carbon sequestration efficiency is very complex and uncertain. On the other hand, macroalgae can play an essential role in mitigating climate change through extensive offshore cultivation due to higher carbon sequestration capacity and substantial available areas. This approach seems both technically and economically feasible due to the development of offshore aquaculture and a well-established market for macroalgal products. Synthesis and applications: This paper provides new insights and suggests promising directions for utilizing marine primary producers to achieve the Paris temperature target. We propose that macroalgae cultivation can play an essential role in attaining carbon neutrality and climate change mitigation, although its ecological impacts need to be assessed further. To calculate the parameters presented in Table 1, the relevant keywords "mangroves, salt marshes, macroalgae, microalgae, global area, net primary productivity, CO2 sequestration" were searched through the ISI Web of Science and Google Scholar in July 2021. Recent data published after 2010 were collected and used since area and productivity of plants change with decade. For data with limited availability, such as net primary productivity (NPP) of seagrasses and global area and NPP of wild macroalgae, data collection was extended back to 1980. Total NPP and CO2 sequestration for mangroves, salt marshes, seagrasses and wild macroalgae were obtained by the multiplication of area and NPP/CO2 sequestration density and subjected to error propagation analysis. Data were expressed as means ± standard error.

Heavy trucks contribute significantly to climate change, and in 2020 were responsible for 7% of total Swedish GHG emissions and 5% of total global CO2 emissions. Here we study the full lifecycle of cargo trucks powered by different energy pathways, comparing their biomass feedstock use, primary energy use, net biogenic and fossil CO2 emission, and cumulative radiative forcing. We analyse battery electric trucks with bioelectricity from standalone or combined heat and power (CHP) plants, and pathways where bioelectricity is integrated with wind and solar electricity. We analyse trucks operated on fossil diesel fuel and on dimethyl ether (DME). All energy pathways are analysed with and without carbon capture and storage (CCS). Bioelectricity and DME are produced from forest harvest residues. Forest biomass is a limited resource, so in a scenario analysis we allocate a fixed amount of biomass to power Swedish truck transport. Battery lifespan and chemistry, the technology level of energy supply, and the biomass source and transport distance are all varied to understand how sensitive the results are to these parameters. The scenario spans 100 years into the future. We find that pathways using electricity to power battery electric trucks have much lower climate impacts and primary energy use, compared to diesel and DME based pathways. The pathways using bioelectricity with CCS result in negative emissions leading to global cooling of the earth. The pathways using diesel and DME have significant and very similar climate impact, even with CCS. The robust results show that truck electrification and increased renewable electricity production is a much better strategy to reduce the climate impact of cargo transport and much more primary energy efficient than the adoption of DME trucks. This climate impact analysis includes all fossil and net biogenic CO2 emissions as well as the timing of these emissions. Considering only fossil emissions is incomplete and could be misleading. This dataset contains data on 4 metrics (primary energy use, biomass feedstock use, cumulative CO2 emissions, and cumulative radiative forcing) resulting from scenario modeling of cargo truck use in Sweden powered by different energy pathways. The energy pathways include battery electric trucks powered by bioelectricity, solar photovoltaic electricity and wind electricity, and internal combustion trucks powered by fossil diesel and dimethyl ether. The scenario spans 100 years into the future. The Excel sheet "tables" contains input data for the scenario modeling, with sources listed where applicable. The remaining sheets contains the modeled results and generated figures that are also a published in the associated article Sathre & Gustavsson (2023). Refer to the method description and reference list in the included documentation files for details. Tunga lastbilar bidrar kraftigt till klimatförändringarna och stod 2020 för 7% av de totala svenska växthusgasutsläppen och 5% av de totala globala CO2-utsläppen. Här studerar vi hela livscykeln för lastbilar som drivs av olika energivägar, jämför deras användning av biomassaråvaror, primär energianvändning, biogena och fossila CO2-utsläpp netto och kumulativ strålningstvingning. Vi analyserar batterielektriska lastbilar med bioel från fristående eller kraftvärmeverk och vägar där bioel integreras med vind- och solkraft. Vi analyserar lastbilar som drivs med fossilt dieselbränsle och med dimetyleter (DME). Alla energivägar analyseras med och utan avskiljning och lagring av koldioxid (CCS). Bioelektricitet och DME produceras av skogsavverkningsrester. Skogsbiomassa är en begränsad resurs, så i en scenarioanalys avsätter vi en fast mängd biomassa för att driva svenska lastbilstransporter. Batteriets livslängd och kemi, tekniknivån för energiförsörjning och biomassakällan och transportavståndet varierar alla för att förstå hur känsliga resultaten är för dessa parametrar. Scenariot sträcker sig 100 år in i framtiden. Vi finner att vägar som använder el för att driva batterielektriska lastbilar har mycket lägre klimatpåverkan och primär energianvändning, jämfört med diesel- och DME-baserade vägar. De vägar som använder bioelektricitet med CCS resulterar i negativa utsläpp som leder till global kylning av jorden. Vägarna med diesel och DME har betydande och mycket liknande klimatpåverkan, även med CCS. De robusta resultaten visar att elektrifiering av lastbilar och ökad förnybar elproduktion är en mycket bättre strategi för att minska godstransporternas klimatpåverkan än införandet av DME-lastbilar, och mycket mer primärenergieffektiv. Denna klimatkonsekvensanalys omfattar alla fossila och biogena CO2-utsläpp samt tidpunkten för dessa utsläpp. Att bara ta hänsyn till fossila utsläpp är ofullständigt och kan vara missvisande. Detta dataset innehåller data om 4 mätvärden (primär energianvändning, biomassaråvara, kumulativa CO2-utsläpp och kumulativ strålkraftspåverkan) som härrör från scenariomodellering av lastbilsanvändning i Sverige som drivs av olika energivägar. Energivägarna inkluderar batterielektriska lastbilar som drivs av bioelektricitet, solcellselektricitet och vindkraft samt förbränningsbilar som drivs av fossil diesel och dimetyleter. Scenariot sträcker sig 100 år in i framtiden. På arket "tables" i Excelfilen återfinns den indata som använts i modelleringen med angivna källor där detta är tillämpligt. Övriga ark innehåller resultat samt figurer som också publiceras i den samhörande artikeln Sathre & Gustavsson (2023). Se metodbeskrivning samt referenslista i tillhörande dokumentationsfiler för detaljer.