AbstractHigh Temperature Steam Electrolysis (HTSE) is one of the most promising ways for hydrogen production. If coupled to a CO2-free electricity and low cost heat sources, this process is liable to a high efficiency.The present study describes recent promising results obtained in terms of performance and durability in stack environment, thanks to the use of protective coatings on one hand, and of advanced cells on the other hand.As for Solid Oxide Fuel Cells, it has been demonstrated that the integration of protective coatings was mandatory to decrease the degradation rate in HTSE stacks, and that with optimized coatings, (CoMn)3O4 in the present case, the same durability as the one of the single cell tested in a ceramic housing could be reached. The type of cell was also shown to play a major role on the degradation rate. With advanced cells, degradations below 2%/kh could be reached. The higher is the current density, the higher is the degradation rate, with a mostly reversible effect. These degradation rates are close to the objectives, even if a bit higher than in SOFC mode.Finally a low-weight stack has been designed, targeting high performance and durability while reducing the cost by the use of thin interconnects. An electrochemical performance similar to the previous stack design has been obtained for a 3-cell stack (-1 A/cm2 at 1.3V at 800°C), with degradation rates below 3%/1000h in the testing conditions.The thermal cyclability of stacks has been demonstrated, from 800°C to 20°C, as well as electrical load cycling. The results showed that the HTSE stacks considered in the present study can cycle very rapidly, and that the cycles considered do not induce any degradation. Therefore it can be concluded that these results makes HTSE technology getting closer to the objectives of performance, durability, thermal and electrical cyclability and cost, and that HTSE is a candidate to produce hydrogen as a mean to store renewable intermittent energies.