• Energy Research
• Restricted close
• Open Source close
• CA close
• AT close
• IN close
• Aurora Universities Network close

The Indian Ocean Experiment (INDOEX) was an international, multiplatform field campaign to measure long-range transport of air pollution from South and Southeast Asia toward the Indian Ocean during the dry monsoon season in January to March 1999. Surprisingly high pollution levels were observed over the entire northern Indian Ocean toward the Intertropical Convergence Zone at about 6°S. We show that agricultural burning and especially biofuel use enhance carbon monoxide concentrations. Fossil fuel combustion and biomass burning cause a high aerosol loading. The growing pollution in this region gives rise to extensive air quality degradation with local, regional, and global implications, including a reduction of the oxidizing power of the atmosphere.

Using recycled rubber crumbs as drainage layer in extensive green roofs have high potential to reduce the heating and cooling loads in buildings over traditional materials used as drainage layer, such as pozzolana gravel. However, the environmental impact due to the life cycle should be analyzed to assess its environmental benefit. This paper evaluates the environmental performance of green roofs in which the drainage layer is made of rubber crumbs, a recycled material the use of which is still experimental for this purpose. In this paper Life Cycle Assessment (LCA) is applied to compare the environmental impact of four constructive systems, two extensive green roofs without insulation layer and with different drainage materials, e a recycled material, rubber crumbs, and a conventional one, pozzolana gravel -, in front of two conventional flat roofs, with and without thermal insulation (polyurethane), built in an experimental set-up consisting of four monitored house-like cubicles, located in Mediterranean continental climate (Lleida, Spain). The LCA considered the production, construction, operational, and disposal phases of the roofs, according to UNE-EN 15643-2. The operational phase was carried out using data measured in the experimental set-up, considering heating and cooling energy consumptions in the winter and summer period, respectively.

Abstract An exergy analysis, which only considers the unavoidable exergy destruction, is conducted for single, double, triple and half effect Water–Lithium bromide absorption cycles. Thus, the obtained performances represent the maximum achievable performance under the given operation conditions. The coefficient of performance (COP), the exergetic efficiencies and the exergy destruction rates are determined and the effect of the heat source temperature is evaluated. As expected, the COP increases significantly from double lift to triple effect cycles. The exergetic efficiency varies less among the different configurations. In all cycles the effect of the heat source temperature on the exergy destruction rates is similar for the same type of components, while the quantitative contributions depend on cycle type and flow configuration. Largest exergy destruction occurs in the absorbers and generators, especially at higher heat source temperatures.

Abstract Life Cycle Assessment (LCA) has been conducted for seven experimental cubicles located in Puigverd de Lleida (Spain). The objective of this experimental set-up is to test different constructive solutions in order to point out the most sustainable solution with lower energy demand during the operational phase. Therefore, different building, insulation and Phase Change Materials (PCMs) have been tested under controlled temperature conditions to examine the thermal performance of the whole system. Although some of these materials are able to reduce the energy demand and consequently the environmental impact during the operational phase, they still have high embodied energy that can cause high environmental impact during the manufacturing phase. Therefore the LCA study in this paper focuses on assessing the impact of the embodied energy needed during the manufacturing and disposal phase by highlighting and comparing the effect of using different building materials, insulating materials, and phase change materials.

Central solar heating plants with seasonal storage (CSHPSS) are among the most promising technologies to save energy in the industrial and residential-commercial building sectors. This work introduces a systematic approach to optimize these systems according to economic and environmental criteria. Our method, which combines the TRNSYS 17 simulation software with life cycle assessment and multi-objective optimization, identifies optimal CSHPSS designs for any climatic condition and heating demand profile considering economic and environmental criteria simultaneously. The capabilities of this approach are illustrated through its application to a case study of a CSHPSS located in Barcelona (Spain), which satisfies a heating demand for a neighborhood of 1120 dwellings. Numerical results show that the CSHPSS plant leads to significant environmental and economic improvements compared to the use of a conventional natural gas heating system. Our tool can guide engineers and architects in the transition towards a more sustainable residential sector.

The process of photosynthesis is initiated by the capture of sunlight by a network of light-absorbing molecules (chromophores), which are also responsible for the subsequent funneling of the excitation energy to the reaction centers. Through evolution, genetic drift, and speciation, photosynthetic organisms have discovered many solutions for light harvesting. In this review, we describe the underlying photophysical principles by which this energy is absorbed, as well as the mechanisms of electronic excitation energy transfer (EET). First, optical properties of the individual pigment chromophores present in light-harvesting antenna complexes are introduced, and then we examine the collective behavior of pigment-pigment and pigment-protein interactions. The description of energy transfer, in particular multichromophoric antenna structures, is shown to vary depending on the spatial and energetic landscape, which dictates the relative coupling strength between constituent pigment molecules. In the latter half of the article, we focus on the light-harvesting complexes of purple bacteria as a model to illustrate the present understanding of the synergetic effects leading to EET optimization of light-harvesting antenna systems while exploring the structure and function of the integral chromophores. We end this review with a brief overview of the energy-transfer dynamics and pathways in the light-harvesting antennas of various photosynthetic organisms.

Disposal of FBC solid residues currently represents one of the major issues in FBC design and operation, and contributes significantly to FBC operating cost. This issue has triggered research activities on the enhancement of sorbent utilization for in-situ sulfur uptake. The present study addresses the effectiveness of the reactivation by liquid water hydration of FB spent sorbents. Two materials are considered in the study, namely bottom ash from the operation of a full-scale utility FB boiler and the raw commercial limestone used in the same boiler. Hydration-reactivation tests were carried out at temperatures of 40°C and 80°C and for curing times ranging from 15min to 2d, depending on the sample. The influence of hydration conditions on the enhancement of sulfur utilization has been assessed. A combination of methods has been used to characterize the properties of liquid water-hydrated materials.

The database presents the scenario results of an exploratory research, carried out at the International Institute for Applied Systems Analysis (IIASA): the Low Energy Demand (LED) study (Grubler et al. 2018). The LED scenario explored how far transformative changes that combine technological changes, end-use efficiency, and new business models for energy service provision can lead for lowering energy demand, and how these changes could drive deep decarbonisation in the long-term. The scenario development methodology included a bottom-up analysis of how currently existing, though often embryonic, social, institutional, and technological trends could become mainstream with resulting step-changes in efficiency and resulting lowered energy demand. The bottom-up demand estimations were then further explored for their supply side and emissions and climate implications with a top-down modeling framework drawing on the Shared Socioeconomic Pathways (SSP) framework (Riahi et al. 2017). The results show that global final energy demands can be drastically reduced in 2050, to around 245 EJ/yr, or 40% lower than today, whilst significantly expanding human welfare and reducing global development inequalities. According to the knowledge of the authors, LED is the lowest long-term global energy demand scenario ever published. The LED scenario meets the 1.5°C climate target in 2100 without overshoot and keeps the global mean temperature increase below 1.5°C with a probability of more than 60%, without requiring controversial negative emission technologies, such as bioenergy with carbon capture and storage (BECCS), that figure prominently in the emission scenario literature (Rogelj et al. 2015, Anderson and Peters 2016, Creutzig et al. 2016, Smith et al. 2016). Furthermore, the beneficial impacts of the LED scenario on a range of other sustainable development goals are also shown, demonstrating that efficiency of energy services provision plays a critical role in reaching low-energy futures without compromising increased living standards in the Global South, while at the same time reducing adverse social and environmental impacts of climate mitigation strategies that focus predominantly on large-scale supply-side transformations. The research is published in a peer-reviewed article in Nature Energy (Grubler et al. 2018) with ample supplementary information. Water consumption and withdrawal data are published in Parkinson et al. (2018). The data is available for download from the LED Database. The content of the LED database and any derived analysis may only be used for non-commercial scientific publications, articles, educational purposes, figures and data tables provided that the source reference pursuant to section 'Required citation' is included and all relevant publications are correctly cited. Partial reproductions of the database content may be stored in online repositories, if this is necessary to comply with a journal's data archiving and access requirements. Such reproductions must be limited to the scope of the manuscript in question, and must include a hyperlink to the source database hosted at https://db1.ene.iiasa.ac.at/LEDDB and the download date from the source database. However, any wholesale duplication, translation, reworking, processing, arrangement, transformation, or reproduction through the internet or any other channels, of the https://db1.ene.iiasa.ac.at/LEDDEB for commercial or non-commercial purposes is not permitted without the explicit written approval of IIASA.

------------------------------------------------------------------------------------------------------------------------------------------- This version has been superseded. The latest version is at https://doi.org/10.5281/zenodo.5517550 ------------------------------------------------------------------------------------------------------------------------------------------- Eddy covariance flux tower datasets of all Urban-PLUMBER sites, associated with the manuscript: "Harmonized, gap-filled dataset from 20 urban flux tower sites" Use of any data must give credit through citation of the above manuscript and other sources as appropriate. We recommend data users consult with site contributing authors and/or the coordination team in the project planning stage. Relevant contacts are included in timeseries metadata. For site information and timeseries plots see https://urban-plumber.github.io/sites. For processing code see https://github.com/matlipson/urban-plumber_pipeline. Within each site folder: - `index.html`: A summary page with site characteristics and timeseries plots. - `SITENAME_sitedata_vX.csv`: comma seperated file for numerical site characteristics e.g. location, surface cover fraction etc. - `timeseries/` (following files available as netCDF and txt) - `SITENAME_raw_observations_vX`: site observed timeseries before project-wide quality control. - `SITENAME_clean_observations_vX`: site observed timeseries after project-wide quality control. - `SITENAME_metforcing_vX`: site observed timeseries after project-wide quality control and gap filling. - `SITENAME_era5_corrected_vX`: site ERA5 surface data (1990-2020) with bias corrections as applied in the final dataset. - `log_processing_SITENAME_vX.txt`: a log of the print statements through running the create_dataset_SITENAME scripts. Authors Mathew Lipson, Sue Grimmond, Martin Best, Andreas Christen, Andrew Coutts, Ben Crawford, Bert Heusinkveld, Erik Velasco, Helen Claire Ward, Hirofumi Sugawara, Je-Woo Hong, Jinkyu Hong, Jonathan Evans, Joseph McFadden, Keunmin Lee, Krzysztof Fortuniak, Leena Järvi, Matthias Roth, Nektarios Chrysoulakis, Nigel Tapper, Oliver Michels, Simone Kotthaus, Stevan Earl, Sungsoo Jo, Valéry Masson, Winston Chow, Wlodzimierz Pawlak, Yeon-Hee Kim. Corresponding author: Mathew Lipson <m.lipson@unsw.edu.au>

South Africa is likely to experience higher temperatures and less rainfall as a result of climate change. Resulting changes in regional water endowments and soil moisture will affect the productivity of cropland, leading to changes in food production and international trade patterns. High population growth elsewhere in Africa and Asia will put further pressure on natural resources and food security in South Africa. Based on four climate change scenarios from two general circulation models (CSIRO and MIROC) and two IPCC SRES emission scenarios (A1B, B1), this study assesses the potential impacts of climate change on global agriculture and explores two alternative adaptation scenarios for South Africa. The analysis uses an updated GTAP-W model, which distinguishes between rainfed and irrigated agriculture and implements water as an explicit factor of production for irrigated agriculture. For South Africa to adapt to the adverse consequences of global climate change, it would require yield improvements of more than 20 percent over baseline investments in agricultural research and development. A doubling of irrigation development, on the other hand, will not be sufficient to reverse adverse impacts from climate change in the country.