• Energy Research
• Closed Access close
• 12. Responsible consumption close
• 1. No poverty close
• Netherlands Research Portal close

Plastic film mulching (FM) became a general practice to enhance crop productivity and its net primary production (NPP), but it can increase greenhouse gas (GHG) emissions. The proper addition of organic amendments might effectively decrease the impact of FM on global warming. To evaluate the feasibility of biomass addition on decreasing this negative influence, cover crop biomass as a green manure was incorporated with different recycling levels (0-100% of aboveground biomass) under FM and no-mulching. The net global warming potential (GWP) which integrated with soil C stock change and GHG (N2O and CH4) fluxes with CO2-equivalent was evaluated during maize cultivation. Under the same biomass incorporation, FM significantly enhanced the grain productivity and NPP of maize by 22-61 and 18-58% over no-mulching, respectively. In contrast, FM also highly increased the respired C loss, which was 11-95% higher than NPP increase, over no-mulching. Irrespective with biomass recycling ratio and mulching system, negative NECB which indicates the decrease of soil C stock was observed, mainly due to big harvest removal. FM decreased more soil C stock by 57-158% over no-mulching, but its C stock was clearly increased with increasing biomass addition. FM significantly increased total N2O and CH4 fluxes by 4-61 and 140-600% over no-mulching, respectively. Soil C stock changes mainly decided net GWP scale, but N2O and CH4 fluxes negligibly influenced. As a result, FM highly increased net GWP over no-mulching, while this net GWP was clearly decreased with increasing biomass application. However, cover cropping, and its biomass recycling was not enough to compensate the negative impact of FM on global warming. Therefore, more biomass incorporation might be essential to compensate this negative effect of FM.

Bioenergy is considered a sustainable substitute to fossil-fuel resources and the development of a prudent combination of renewable and innovative conversion technologies are essential for the valorization and effective conversion of biowaste to value-added commodities. Here, a negative pressure-induced carbonization process was proposed for the valorization of lignin-enriched biowaste precursor to bio-oil and environmental materials (biochar) at various temperatures. The high heating values (HHV) of the as-prepared biochars from the lignin enriched precursor under negative pressure (low-medium vacuum) were within 25.9-31.5 MJ/kg, which matched satisfactorily to the commercial charcoal. Whereas, the bio-oils produced from the lignin enriched precursor under vacuum conditions was a blend of complex aromatic and straight-chain hydro-carbons, including aldehyde, ketone, phenol, and furans, exhibiting ability as potential heating-oil with HHV within 21.2-28.2 MJ/kg. Moreover, the biochars produced under vacuum environments at higher temperature showed greater stability (22.5-35.9%) than those produced under N2 atmosphere.

Abstract Sugarcane is a major crop cultivated globally and the residue left over after the crop harvest and extraction of juice is a good biomass source that can be used for the production of several useful chemicals. The sugarcane bagasse is an excellent substrate for the production of various biochemicals and enzymes through fermentation. Now major interest is focused on the utilization of these residue for biofuel production. The sugarcane crop residue is rich in cellulose and hemicellulose, hence it can be used for the production of bioethanol and other liquid transportation fuels. The present review gives a detailed account of the availability of sugarcane residue and various commercially important products that can be produced from this residue. It also provides recent developments in R&D on the bioconversion of sugarcane crop residue for value added products.

Volatile organic compounds (VOCs) can lead to environmental pollution and threaten human health due to their toxic and carcinogenic nature. The emission of VOCs increases dramatically with the accelerated industrialization and economic growth. Adsorption is identified as one of the most promising recovery technologies owing to its cost-effectiveness, flexible operation, and low energy consumption. In particular, adsorption-based technologies have a high potential to recycle both adsorbents and adsorbates, typically to capture valuable aromatic VOCs from industrial exhaust. Porous materials such as carbon-based materials, zeolite-based materials, and organic polymers and their composites have been extensively developed for VOCs adsorption focusing in adsorption capacity, hydrophobic property, thermal stability and regenerability. Among them, porous carbons as VOCs adsorbents have attracted increasingly attention, because they can be regulated by tuning the pore structure for VOCs accessibility during the adsorption process. Moreover, porous carbons can adsorb target VOCs by controlling the pore structure and surface functional groups. Significantly, the pore size distribution of porous carbons mostly controls the VOCs sorption process. Micropores provide the main adsorption sites, while mesopores enhance the diffusion of VOCs. In this review, the adsorption mechanism of VOCs onto porous carbons was generally concluded. Porous carbons can be designed as a specific structure for adsorption of aromatic VOCs by controlling the pore structure, hydrophobic sites, π-electronic structure, and surface functional groups. Since there are limited review literatures on porous carbons derived from renewable resources for VOCs adsorption, this paper will provide an overview on the synthesis of porous carbons from biomass and other organic wastes for VOCs adsorption or integrated oxidation processes (e.g., photocatalysis, non-thermal plasma catalysis, chemical catalysis) under ambient conditions with the objective of guiding ...

Sustainable aviation fuels (SAFs) can contribute reduce greenhouse gas emissions compared to conventional fuel. With the increasing SAFs demand, various generations of resources have been shifted from the 1st generation (oil crops), the 2nd generation (agricultural waste), to the 3rd generation (microalgae). Microalgae are the most suitable feedstock for jet biofuel production than other resources because of their productivity and capability to capture carbon dioxide. However, microalgae-based biofuel has a limitation of high freezing point. Recently, a jet biofuel derived from Euglena wax ester has been paying attention due to its low freezing point. Challenges still remain to enhance production yields in both upstream and downstream processes. Studies on downstream processes as well as techno-economic analysis on biofuel production using Euglena are highly limited to date. Economic aspects for the biofuel production will be ensured via valorization of industrial byproducts such as food wastes.

Implementing a circular economy aimed at reusing resources is becoming increasingly important for industry. Microalgae fit within a circular economy by being able to bioremediate nutrient waste and as a source of biomass for several commercial applications. Here, we report a novel validation of a circular economy concept using microalgae at a relevant industrial scale with a new two-phase process. During the first phase biomass was grown autotrophically, biomass was then concentrated using membrane technology for the second phase where mixotrophic conditions were applied to boost growth further. Microalgae cultures were able to grow (13.8 g/L), uptake and bioremediate nutrients (Nitrogen > 134 mg/L/day) from an anaerobic digestion side-stream (digestate), obtaining high quality microalgae biomass (>45% protein content) suitable for use as animal feed, closing the circular economy loop for industrial applications.

With the development of agriculture, a huge amount of vegetable waste (VW) is produced every year, posing a large considerable environmental problem that cannot be ignored. Anaerobic digestion (AD), as an eco-friendly, efficient, and sustainable biomass conversion technology, may be used to address the pollution caused by VW. The compositional components of various VWs are different, which will affect their biomethane potential and directly determine whether they are suitable substrates for AD. Thus, this study involved a systematic analysis of the composition and biomethane potential of 20 typical VWs. The results showed that the methane yields of the VWs were different (207.5-346.3 mL/g VS) owing to the differences in composition. More importantly, a correlation between the contents of organic components and methane production was established, and then used to predict methane production by VW rapidly. In addition, first-order model, modified Gompertz, and Cone models were used to describe the biochemical methanogenesis mechanism of these VWs. The results of this study can provide a reference for fundamental research on the AD of VW as well as serve a convenient and precise method to predict methane production by different VWs through analyzing compositional components, which will be beneficial for pollution prevention and the comprehensive utilization of VW in the future.

The macroalgal industry is expanding, and the quest for novel ingredients to improve and develop innovative products is crucial. Consumers are increasingly looking for natural-derived ingredients in cosmetic products that have been proven to be effective and safe. Macroalgae-derived compounds have growing popularity in skincare products as they are natural, abundant, biocompatible, and renewable. Due to their high biomass yields, rapid growth rates, and cultivation process, they are gaining widespread recognition as potentially sustainable resources better suited for biorefinery processes. This review demonstrates macroalgae metabolites and their industrial applications in moisturizers, anti-aging, skin whitening, hair, and oral care products. These chemicals can be obtained in combination with energy products to increase the value of macroalgae from an industrial perspective with a zero-waste approach by linking multiple refineries. The key challenges, bottlenecks, and future perspectives in the operation and outlook of macroalgal biorefineries were also discussed.

Abstract Biomass is an important renewable energy source that holds large potential as feedstock for the production of different energy carriers in a context of sustainable development, peak oil and climate change. In developing countries, biomass already supplies the bulk of energy services and future use is expected to increase with more efficient applications, such as the production of biogas and liquid biofuels for cooking, transportation and the generation of power. The aim of this study is to establish the amount of Ghana's energy demand that can be satisfied by using the country's crop residues, animal manure, logging residues and municipal waste. The study finds that the technical potential of bioenergy from these sources is 96 PJ in 2700 Mm3 of biogas or 52 PJ in 2300 ML of cellulosic ethanol. The biogas potential is sufficient to replace more than a quarter of Ghana's present woodfuel use. If instead converted to cellulosic ethanol, the estimated potential is seven times the estimated 336 ML of biofuels needed to achieve the projected 10% biofuels blends at the national level in 2020. Utilizing the calculated potentials involves a large challenge in terms of infrastructure requirements, quantified to hundreds of thousands of small-scale plants.