• Energy Research
• 6. Clean water close
• AU close

Multiple techniques for soil decontamination were combined to enhance the phytoremediation efficiency of Eucalyptus globulese and alleviate the corresponding environmental risks. The approach constituted of chelating agent using, electrokinetic remediation, plant hormone foliar application and phytoremediation was designed to remediate multi-metal contaminated soils from a notorious e-waste recycling town. The decontamination ability of E. globulese increased from 1.35, 58.47 and 119.18 mg per plant for Cd, Pb and Cu in planting controls to 7.57, 198.68 and 174.34 mg per plant in individual EDTA treatments, respectively, but simultaneously, 0.9-11.5 times more metals leached from chelator treatments relative to controls. Low (2 V) and moderate (4 V) voltage electric fields provoked the growth of the species while high voltage (10 V) had an opposite effect and metal concentrations of the plants elevated with the increment of voltage. Volumes of the leachate decreased from 1224 to 134 mL with voltage increasing from 0 to 10 V due to electroosmosis and electrolysis. Comparing with individual phytoremediation, foliar cytokinin treatments produced 56% more biomass and intercepted 2.5 times more leachate attributed to the enhanced transpiration rate. The synergistic combination of the individuals resulted in the most biomass production and metal accumulation of the species under the stress condition relative to other methods. Time required for the multi-technique approach to decontaminate Cd, Pb and Cu from soil was 2.1-10.4 times less than individual chelator addition, electric field application or plant hormone utilization. It's especially important that nearly no leachate (60 mL in total) was collected from the multi-technique system. This approach is a suitable method to remediate metal polluted site considering its decontamination efficiency and associated environmental negligible risk.

Shifts in rainfall patterns and increasing temperatures associated with climate change are likely to cause widespread forest decline in regions where droughts are predicted to increase in duration and severity. One primary cause of productivity loss and plant mortality during drought is hydraulic failure. Drought stress creates trapped gas emboli in the water transport system, which reduces the ability of plants to supply water to leaves for photosynthetic gas exchange and can ultimately result in desiccation and mortality. At present we lack a clear picture of how thresholds to hydraulic failure vary across a broad range of species and environments, despite many individual experiments. Here we draw together published and unpublished data on the vulnerability of the transport system to drought-induced embolism for a large number of woody species, with a view to examining the likely consequences of climate change for forest biomes. We show that 70% of 226 forest species from 81 sites worldwide operate with narrow (<1 megapascal) hydraulic safety margins against injurious levels of drought stress and therefore potentially face long-term reductions in productivity and survival if temperature and aridity increase as predicted for many regions across the globe. Safety margins are largely independent of mean annual precipitation, showing that there is global convergence in the vulnerability of forests to drought, with all forest biomes equally vulnerable to hydraulic failure regardless of their current rainfall environment. These findings provide insight into why drought-induced forest decline is occurring not only in arid regions but also in wet forests not normally considered at drought risk.

Recently, upflow microaerobic sludge blanket (UMSB) system has been developed to remove ammonium and organic matter simultaneously. This study aims to establish influent and operational conditions promoting anammox-based nitrogen removal process in the UMSB reactor by using a modified Activated Sludge Model. Experiments were performed on a laboratory-scale UMSB reactor treated piggery wastewater for over two years. With the experimentally determined model parameters, the established model well simulated the UMSB reactor performance. The maximum anammox growth rate was calibrated to be 0.41 d-1 at 35 °C. Further simulations showed that UMSB reactor operated with high influent organics or nitrogen loading rates at temperature above 15 °C can achieve efficient nitrogen removal (>70%). The nitrogen loading over 0.6 kg N/(m3·d)) significantly favors anammox activity. UMSB could also be a promising system for nitrogen removal from low-strength ammonium wastewater with fluctuated COD influence. These results provide support to UMSB design and operational optimization.

Summary Several decades of research on invasive marine species have yielded a broad understanding of the nature of species invasion mechanisms and associated threats globally. However, this is not true of the Arctic, a region where ongoing climatic changes may promote species invasion. Here, we evaluated risks associated with non‐indigenous propagule loads discharged with ships' ballast water to the high‐Arctic archipelago, Svalbard, as a case study for the wider Arctic. We sampled and identified transferred propagules using traditional and DNA barcoding techniques. We then assessed the suitability of the Svalbard coast for non‐indigenous species under contemporary and future climate scenarios using ecophysiological models based on critical temperature and salinity reproductive thresholds. Ships discharging ballast water in Svalbard carried high densities of zooplankton (mean 1522 ± 335 SE individuals m−3), predominately comprised of indigenous species. Ballast water exchange did not prevent non‐indigenous species introduction. Non‐indigenous coastal species were present in all except one of 16 ballast water samples (mean 144 ± 67 SE individuals m−3), despite five of the eight ships exchanging ballast water en route. Of a total of 73 taxa, 36 species including 23 non‐indigenous species were identified. Of those 23, sufficient data permitted evaluation of the current and future colonization potential for eight widely known invaders. With the exception of one of these species, modelled suitability indicated that the coast of Svalbard is unsuitable presently; under the 2100 Representative Concentration Pathway (RCP) 8·5 climate scenario, however, modelled suitability will favour colonization for six species. Synthesis and applications. We show that current ballast water management practices do not prevent non‐indigenous species from being transferred to the Arctic. Consequences of these shortcomings will be shipping‐route dependent, but will likely magnify over time: our models indicate future conditions will favour the colonization of non‐indigenous species Arctic‐wide. Invasion threats will be greatest where shipping transfers organisms across biogeographic realms, and for these shipping routes ballast water treatment technologies may be required to prevent impacts. Our results also highlight critical gaps in our understanding of ballast water management efficacy and prioritization. Thereby, our study provides an agenda for research and policy development.

Understanding how genetic-based traits of plants interact with climate to affect associated communities will help improve predictions of climate change impacts on biodiversity. However, few community-level studies have addressed such interactions. Pinyon pine (Pinus edulis) in the southwestern U.S. shows genetic-based resistance and susceptibility to pinyon needle scale (Matsucoccus acalyptus). We sought to determine if susceptibility to scale herbivory influenced the diversity and composition of the extended community of 250+ arthropod species, and if this influence would be consistent across consecutive years, an extreme drought year followed by a moderate drought year. Because scale insects alter the architecture of susceptible trees, it is difficult to separate the direct influences of susceptibility on arthropod communities from the indirect influences of scale-altered tree architecture. To separate these influences, scales were experimentally excluded from susceptible trees for 15 years creating susceptible trees with the architecture of resistant trees, hereafter referred to as scale-excluded trees. Five patterns emerged. (1) In both years, arthropod abundance was 3-4X lower on susceptible trees compared to resistant and scale-excluded trees. (2) Species accumulation curves show that alpha and gamma diversity were 2-3X lower on susceptible trees compared to resistant and scale-excluded trees. (3) Reaction norms of arthropod richness and abundance on individual tree genotypes across years showed genotypic variation in the community response to changes in climate. (4) The genetic-based influence of susceptibility on arthropod community composition is climate dependent. During extreme drought, community composition on scale-excluded trees resembled susceptible trees indicating composition was strongly influenced by tree genetics independent of tree architecture. However, under moderate drought, community composition on scale-excluded trees resembled resistant trees indicating traits associated with tree architecture became more important. (5) One year after extreme drought, the arthropod community rebounded sharply. However, there was a much greater rebound in richness and abundance on resistant compared to susceptible trees suggesting that reduced resiliency in the arthropod community is associated with susceptibility. These results argue that individual genetic-based plant-herbivore interactions can directly and indirectly impact community-level diversity, which is modulated by climate. Understanding such interactions is important for assessing the impacts of climate change on biodiversity.

The production of biobutanol is hindered by the product's toxicity to the bacteria, which limits the productivity of the process. In situ product recovery of butanol can improve the productivity by removing the source of inhibition. This paper reviews in situ product recovery techniques applied to the acetone butanol ethanol fermentation in a stirred tank reactor. Methods of in situ recovery include gas stripping, vacuum fermentation, pervaporation, liquid–liquid extraction, perstraction, and adsorption, all of which have been investigated for the acetone, butanol, and ethanol fermentation. All techniques have shown an improvement in substrate utilization, yield, productivity or both. Different fermentation modes favored different techniques. For batch processing gas stripping and pervaporation were most favorable, but in fed‐batch fermentations gas stripping and adsorption were most promising. During continuous processing perstraction appeared to offer the best improvement. The use of hybrid techniques can increase the final product concentration beyond that of single‐stage techniques. Therefore, the selection of an in situ product recovery technique would require comparable information on the energy demand and economics of the process. © 2017 American Institute of Chemical Engineers Biotechnol. Prog., 33:563–579, 2017