• Energy Research
• Closed Access close
• Open Source close
• Embargo close
• CN close
• US close
• DE close

Abstract Bio-based polyurethane (BPU) foams were successfully prepared using hydrothermally liquefied wheat straw (WS) to substitute a mass fraction of up to 50% of polyols. Response surface methodology (RSM) based on central composite design (CCD) was employed to optimize four process parameters: NCO/OH molar ratio, loading of crosslinking agent (glycerol), loading of catalyst (a mixture of triethylene diamine, stannous octoate, and triethanolamine), and loading of blowing agent (water) for the maximum compression strength of the rigid BPU foams. With the quadratic orthogonal regression model, verified by experimentation, the maximum compression strength of approximately 180 kPa was obtained at the following optimal conditions: NCO/OH molar ratio of 1.24:1, glycerol addition of 12.11%, catalyst loading of 0.76%, and blowing agent addition of 1.31% in relation to the total mass of polyols. The BPU foam prepared at the optimal conditions exhibits good thermal conductivity (0.045 Wm−1K−1) and thermal stability, comparable to those of a reference foam prepared with 100% PPG400.

Cold-start (subzero startup) capability of polymer electrolyte fuel cell (PEFC) is of great importance. In this paper, the effects of the micro-porous-layer (MPL), varying start-up temperatures, start-up current density variation on the cold-start operation are investigated. We found PEFC with anode micro-porous-layer (AMPL), compared with one with CMPL, has higher possibility of successful cold start. By analyzing the anode and cathode pressure revolution of PEFC, the effect of MPL on the super cooled water removal and ice formation at different temperatures (-7,-10,-15 and-20℃) are discussed . In addition, we investigate the ice distribution in MEA through the X-ray device, by comparing the initial image when fuel cells shut down (before the produce the water) and final image after failed cold-start. We also explore the negative voltage phenomenon in the initial process of cold-start operation.

We have investigated the microelectrical properties of CdTe thin films using scanning Kelvin probe force microscopy (SKPFM) and scanning spreading resistance microscopy (SSRM). Two films with the configurations of substrate and superstrate were subjected to the characterization studies. The electrical potential and resistance were properly mapped with the substrate film but not with the superstrate film because the underlying CdS/CdTe junction largely impacted the characterizations. The higher SKPFM potential on grain boundaries (GBs) of the substrate film than on the grain surface indicates positively charged GBs and upward band bending around the GB; therefore, the GBs are either depleted or inverted. The SSRM resistance mapping on this film shows nonuniformities and features that are associated with the grain structure and facets. However, the GBs do not exhibit distinct characteristic resistance. Comparing the low resistance channel along the GBs of high-performance CIGS films, the SSRM mapping of CdTe supports depletion of the GBs. In SSRM measurement, it is critical to adequately indent the probe to the film, and to apply a bias voltage larger than the onset voltage of the probe/film barrier, so that the contact resistance is minimized and that the local spreading resistance of CdTe film beneath the probe is measured.

Chromium (Cr) exposure during gestation causes malformations in animal experiments. In this multicenter case-control study, we initially involved 130 orofacial clefts (OFCs) and 260 controls to assess the association between Cr concentration and risk for OFCs. Then, umbilical cord serum (49 vs. 119) and cord tissue (84 vs. 142) were used to validate the association between Cr and OFCs. We found that maternal serum Cr concentrations in OFC cases were significantly higher than those in controls. Compared with the lowest tertile of maternal serum Cr concentration, the highest tertile of Cr increased the risk for OFCs [OR = 2.14 (1.14-4.05)]. In the validation cohort of umbilical cord serum and tissue, higher concentrations of Cr were associated with increased risks for OFCs in a dose-dependent manner (all Ps for trends <0.05). Cr concentrations in maternal serum and cord serum showed a positive correlation. The Cr concentration in cord serum was inversely correlated with egg and milk consumption frequencies, and the Cr concentration in cord tissue was positively associated with indoor coal burning. In conclusion, prenatal Cr exposure is a risk factor for OFCs, and indoor coal burning during pregnancy may be one of the sources of Cr exposure.

Abstract In this paper, the authors present a method for collecting data on household energy-use behavior. Open-ended interviewing is supplemented by the use of a self-recording system to compensate for a persistent problem in data-gathering on behavior, namely, the gap between what people say they do in interviews and what they actually do. The authors developed and field-tested a self- recording diary which is simple to both use and analyze. Results of that field test are discussed, together with an analysis of who in the household used (or controlled) each of the energy systems in the house. We also compare self-recorded data with interview data to point to differences between reported and recorded behavior. We believe that both the method and the insights into the separation of energy tasks within the household should be of paramount interest to energy planners.

Abstract To alleviate the shortage of natural gas resource and ease carbon emissions, a novel solar-driven combined cooling, heating and power (CCHP) system is designed and optimized using the genetic algorithm in the work. Different from the process of direct combustion in a conventional CCHP system, natural gas is firstly converted into syngas by a solar-driven natural gas reforming step, which is consumed in an efficient tri-generation system. Energy, economic and environmental evaluations on five office buildings in different climate zones in China are implemented to validate the advantages of the proposed system. Results show that the annual maximum primary energy saving, total cost saving, and CO2 emission reduction are 69.76%, 49.80%, and 71.55%, respectively. The system located in severe cold zones, where solar energy is abundant and building requires more heat load in whole year, achieves the highest benefits in comparison with separate systems. Furthermore, the sensitivities on the price fluctuations of electricity, natural gas and solar field to the system profits are investigated, which indicates that the influence of electricity price on the system performance is the most significant. Thus, a promising method for reducing the natural gas consumption and improving the utilization efficiency of solar energy is provided.

Bioplastics are alternatives of conventional petroleum-based plastics. Bioplastics are polymers processed from renewable sources and are biodegradable. This study aims at conducting an environmental impact assessment of the bioprocessing of agricultural wastes into bioplastics compared to petro-plastics using an LCA approach. Bioplastics were produced from potato peels in laboratory. In a biochemical reaction under heating, starch was extracted from peels and glycerin, vinegar and water were added with a range of different ratios, which resulted in producing different samples of bio-based plastics. Nevertheless, the environmental impact of the bioplastics production process was evaluated and compared to petro-plastics. A life cycle analysis of bioplastics produced in laboratory and petro-plastics was conducted. The results are presented in the form of global warming potential, and other environmental impacts including acidification potential, eutrophication potential, freshwater ecotoxicity potential, human toxicity potential, and ozone layer depletion of producing bioplastics are compared to petro-plastics. The results show that the greenhouse gases (GHG) emissions, through the different experiments to produce bioplastics, range between 0.354 and 0.623 kg CO2 eq. per kg bioplastic compared to 2.37 kg CO2 eq. per kg polypropylene as a petro-plastic. The results also showed that there are no significant potential effects for the bioplastics produced from potato peels on different environmental impacts in comparison with poly-β-hydroxybutyric acid and polypropylene. Thus, the bioplastics produced from agricultural wastes can be manufactured in industrial scale to reduce the dependence on petroleum-based plastics. This in turn will mitigate GHG emissions and reduce the negative environmental impacts on climate change.

People’s attention of transformer condition assessment is increasing in recent year and data mining is applied in transformer condition assessment with its obvious superiority in dealing with complex data and finding potential problems. In this paper, the process of the research on applying data mining to transformer condition assessment is summarized. The research results of data processing methods such as rough set theory, principal component analysis and colony algorithm as well as the research result of transformer condition assessment such as vector machine, neural network, Bayes network, association rules and fuzzy theory are introduced, analyzed and compared in detail. The advise on the choice and quantification of figure, the employ of the pattern recognition method, the blend of multi-information and visualization display are given.

In this study, Myriophyllum elatinoides growth under different nitrogen (N) concentrations (2, 250, 300, 350 and 400 mg L-1) and changes in rhizosphere bacterial community structure were investigated. High N (>300 mg L-1) concentrations caused reduction in M. elatinoides biomass. Growth tended to stabilize at 49 days. N concentration in roots were higher than that in stems and leaves under high N conditions. TN and NH4+ removal efficiencies reached 84.0% and 87.2%, respectively, in M. elatinoides surface flow constructed wetlands (SFCWs). Rhizosphere bacterial diversity increased over time. Proteobacteria, Firmicutes, Cyanobacteria, and Bacteroidetes dominated at the phylum level. Genera Turicibacter, Allochromatium, and Methylocystis increased at low N (<300 mg L-1) concentrations, while Pseudomonas increased at high N concentrations over the experimental period. Redundancy analysis showed that pH was strongly correlated with changes in rhizosphere bacterial community structure. These findings helped to insight into N removal mechanism in M. elatinoides.