• Energy Research
• Closed Access close
• Open Source close
• 7. Clean energy close
• 6. Clean water close
• 2. Zero hunger close
• IN close
• DE close
• FR close

Abstract The reverse flat-plate collector is a non-concentrating collector. It can collect solar heat at high temperatures which cannot be achieved by conventional non-concentrating collectors. In this paper, the authors have proposed a number of modified versions of the originally proposed reverse flat-plate collector. The new designs are of single, as well as double, absorber type. The thermal performance of these modified reverse flat-plate collectors is compared with that of a single absorber reverse flat-plate collector, as well as with the corresponding normal flat-plate collector. It is found that the new design having two absorbers gives the best thermal performance as compared with other configurations. The analytical models presented in this paper very well describe the experimental results.

Abstract In this work addition of ethanol to high viscosity jatropha methyl ester (JME) through port injection is investigated in order to determine its effect fuel viscosity reduction on diesel engine performance. In addition to viscosity alteration, the impact of ethanol addition on combustion characteristics such as combustion duration, ignition delay and emissions levels from diesel engines fuelled with blends of ethanol, diesel and JME is studied in particular. It is found that blending of oxygenated fuels with diesel modifies the chemical structure and physical properties which again alter the engine operating conditions, combustion parameters and emissions levels. However, the injection of only 5% ethanol through port injection allows for a total of 25% blending of biofuels into diesel yet keeping the fuel characteristics close to that of conventional diesel. However, both experimental and numerical results show that ethanol addition in JME blended diesel results in a slight increase in fuel consumption and thermal efficiency for the same power outputs as that of conventional diesel fuel. Also, the combustion characteristics with ethanol addition include improved maximum in-cylinder peak pressure, cumulative heat release (CHR) rate of heat release (ROHR), in-cylinder peak temperature and combustion duration. Regarding emission characteristics the experimental results show significant reduction in smoke, carbon monoxide (CO) and total hydrocarbon (THC) emissions with extended oxygen mass percentage in the fuel at higher engine loads. However, oxides of nitrogen (NOx) emissions are found to increase at high loads although the common tradeoff between smoke and NOx is found to be more prominent for the oxygenated fuels.

In this study, levulinic acid (LA) was produced from rice straw biomass in co-solvent biphasic reactor system consisting of hydrochloric acid and dichloromethane organic solvent. The modified protocol achieved a 15% wt LA yield through the synergistic effect of acid and acidic products (auto-catalysis) and the designed system allowed facile recovery of LA to the organic phase. Further purification of the resulting extractant was achieved through traditional column chromatography, which yielded a high purity LA product while recovering ∼85% wt. Upon charcoal treatment of the resultant fraction generated an industrial grade target molecule of ∼99% purity with ∼95% wt recovery. The system allows the solvent to be easily recovered, in excess of 90%, which was shown to be able to be recycled up to 5 runs without significant loss of final product concentrations. Overall, this system points to a method to significantly reduce manufacturing cost during large-scale LA preparation.

Abstract This paper aims to present a feasibility study of the innovative plant for methanol synthesis from carbon dioxide-sequestered by fossil fuel power plant and hydrogen, which is produced by water electrolyzer employing the over-production on the electrical grid. The thermo-economic analysis is performed in the framework of the MefCO2 H2020 EU project and it is referred to the German economic scenario, properly taking into account the real market costs and cost functions for different components of the plant. Three different plant capacities for methanol production (4000 10,000 and 50,000 ton/year) have been investigated, assuming an average cost for electrical energy to feed electrolysers and analyzing the influence of the most significant parameters (oxygen selling option, methanol selling price and electrolysers’ capital cost) on the profitability of the plant. The analysis has been performed in W-ECoMP, software for the thermo-economic analysis and plant optimization developed by the University of Genoa.

Abstract The price effect of the rising share of renewable electricity, which is called ‘merit-order-effect’, leads to noticeable changes in the German power industry and debates about the electricity market design. This paper estimates the merit-order-effect induced by variable renewable energy in the German-Austrian electricity sector with a multivariate regression model. The research focus lies on the impact of the estimated effects on the marketability of variable renewable electricity generation. The results show a systematic decline of the average market revenues for wind and photovoltaic plants in the period from January 2011 to December 2013. Current market data shows a continuation of this trend into 2016. According to the German long term goals for the use of renewables, wind and solar power will play a crucial role in the future electricity generation mix. If investments in these technologies will be profitable without any regulatory remuneration mechanisms in addition to the market revenues, depends on the further cost degression and the development of the merit-order-effect.

Abstract The present work attempts to devise an efficient method utilizing an on-grid photovoltaic-thermal heat pump water heater (PV-THPWH) integrated with a real-time variable frequency controller to achieve the goal of energy-efficient buildings. The prime focus is to reduce the grid's dependence on the compressor's energy-intensive operation by employing a feedback-controlled variable frequency drive (VFD). Additionally, the possibilities involved with addressing the electrical and thermal energy requirements of an energy-efficient building was investigated utilizing the proposed system. R-32 refrigerant in the photovoltaic-thermal (PV-T) evaporator coils of the heat pump assembly help to cool the photovoltaic (PV) panel while delivering the absorbed heat in the condenser to heat water contained inside the storage tank. Outdoor experiments and theoretical investigations of the combined system were carried out to appraise the dynamic behavior under varying solar irradiation and ambient temperature conditions. The observations conveyed that the PV-THPWH system succeeded in reducing the PV panel operating temperature by 25%, which resulted in a 20% increment in PV power output. Also, the performance indicators, such as the instantaneous energy efficiency and instantaneous PV efficiency, were found to increase by 15% and 34%, respectively, resulting in an average coefficient of performance of 6.4. For a clear sky day, the recorded total PV energy output was 4.67 units, while the VFD compressor consumption was 3.42 units, and the surplus 1.25 units were sent to the grid. Furthermore, the economic analysis reported a payback period of 2.3 years for the developed PV-THPWH system.

Abstract Gold nanoparticles (Au-NPs) seeded plasmonic nanofluids (PNFs) have shown promising results in overall performance enhancement of direct absorption solar collector (DASC) due to localized surface plasmon resonance (LSPR) effect. For the work presented here, Au-NPs were synthesized by the wet chemical method and were utilized to prepare plasmonic nanofluid. The surface plasmon resonance peak of Au-NPs was observed at 531 nm using UV–Visible spectrophotometer study. The testing for performance enhancement of gold plasmonic nanofluid (GPNF) laden DASC so far is limited to laboratory scale setups or simulation studies. Considering the dearth of outdoor experimental studies, an attempt has been made in the present study to evaluate the thermal performance of Au-NPs (∼40 nm) based nanofluid (∼0.0002 wt%) in full scale DASC. The experiments have been performed at different flow rates under clear sky outdoor conditions in winter season at Jalandhar, India. The maximum collector outlet temperature was measured to be 55 °C with GPNF which is about 7 °C higher than the maximum outlet temperature obtained with de-ionized water as working fluid. Thermal efficiency with GPNF is about 33% higher than de-ionized water at the optimal flow rate of 0.030 kg/s.

Abstract Social acceptance of innovative technologies is a key element of an effective transition towards more sustainable energy economies. However, innovative technologies like genetic modification also tend to spark controversy and backlash. So far, efforts to inform the public about any risks and benefits of novel technologies not only have struggled to foster acceptance but also neglect the interdependent foundations of consumer decision-making. Through a controlled experiment with German consumers (N = 322), we examine whether consumer support and rejection of genetic modification in bioenergy crops is influenced by the statements and actions of actors throughout the supply chain. In specific, we show that the decision of energy companies to sell and support GM bioenergy positively impacts consumer decisions to support. To ensure that decision outcomes were specifically impacted by the expressions of corporate actors, we controlled for the content and valence of information by random assignment to one of three treatments in which participants received positive, negative, or balanced (risks and benefits) information. We find that negative messaging diminished support and increased rejection relative to the other treatments. Lastly, the statements and actions of corporate actors also exerted an indirect influence on consumer decisions through their interactions with social trust and labels, e.g. greater support by farmers had a positive influence only for those who are more generally trustworthy. Given these results, we anticipate more attention to the importance of actors such as farmers and energy companies for the social acceptance of novel technologies in the energy sphere.

Abstract— The odd nucleoside 4‐thiouridine, which is present in position 8 of 70% of E. coli tRNAs, possesses unusual spectroscopic properties which make it suitable for intramolecular energy transfer studies. Both its luminescence excitation spectrum and the action spectrum (230–380 nm) for the 8–13 link formation have been established in native E. coli tRNA at room temperature. The spectra are identical and present a new unexpected peak around 260 nm. At this wavelength, they are amplified by a factor of nine as compared with the absorption and excitation spectra of the free nucleoside in aqueous solution.The origin of this new peak is discussed and it is concluded that energy transfer does occur from the common nucleosides to the 4‐thiouridine residue. Using the values of the nucleosides to 4‐thiouridine distances inferred from the sets of atomic coordinates obtained on yeast tRNAphe crystals, a satisfactory account of our finding can be obtained assuming singlet‐singlet energy transfer. The efficiency of the mechanism is probably favoured by a good overlap between the emission spectra of the common nucleosides and the absorption spectrum of 4‐thiouridine.