• Energy Research
• GB close
• IN close
• OM close
• Sustainability close

The growing population and increasing urbanization have led to a surge in domestic wastewater generation, posing significant challenges for effective and sustainable treatment. The present study demonstrates a novel and sustainable approach for the onsite treatment of domestic wastewater using an integrated settler-based biofilm reactor (ISBR) with efficient biogas generation. The ISBR provides an optimized environment for the growth of biofilm, facilitating the removal of organic pollutants and pathogens. Moreover, the ISBR enables the recovery of a valuable resource in the form of biogas, thus enhancing the overall utility of the treatment process. The performance of the ISBR was comprehensively evaluated at laboratory scale through treating the actual domestic wastewater generated from the hostel of Manipal University Jaipur. The ISBR system was operated under an ambient environment at a hydraulic retention time (HRT) of 24 h. The results demonstrated remarkable efficiency in terms of chemical oxygen demand (COD), total suspended solids (TSS), and coliforms removal, with average removal efficiency being more than 90%. According to the COD mass balance analysis, 48.2% of the influent COD was recovered as bioenergy. The chromatogram revealed a high percentage of methane gas in the collected biogas sample. The field emission scanning electron microscope (FESEM) analysis of the accumulated sludge in the ISBR system depicted the morphology of methanogenic bacteria. Both the experimental and theoretical results confirmed the feasibility and sustainability of the ISBR system at the onsite level.

Although it is widely assumed that business activity is dependent on flows of ecosystem services (ES), little evidence is available with which to evaluate this contention. To address this knowledge gap, we conducted a questionnaire survey of business dependencies on twenty-six different ES in the English county of Dorset, where the environment supports a significant component of the local economy. Responses were received from 212 businesses across twenty-eight sectors. While virtually all businesses (98%) were familiar with the concept of ES, dependency on ES was highly divided with 50% of businesses surveyed claiming no dependence on any ES flows. The highest businesses dependencies reported in this study were for regulating services with the ES of water quality and waste water treatment being of particular importance to businesses. The results however, advised that greater efforts are needed in highlighting the indirect benefits provided by Dorset’s ecosystems, with eight business sectors (58% of respondents) claiming no or little dependence on supporting and habitat services including the ES of biodiversity, habitats for species and maintenance of genetic diversity. Many businesses also indicated little or no dependence on the globally important ES of pollination and soil condition, which may reflect a lack of awareness of dependencies occurring upstream of their value chains. At the sector level, businesses directly involved in protecting, extracting, or manufacturing raw materials were found to be more dependent on provisioning, regulatory and supporting ES than those operating in the service sector who favored cultural ES. These results highlight the value of assessing business dependencies on ES flows, which could usefully inform environmental management and accounting systems and improve monitoring of business performance, and thereby contribute to achievement of sustainability goals.

Cassava utilisation in Malawi is negatively affected by rapid deterioration of fresh roots, primarily caused by postharvest physiological deterioration (PPD). A study was conducted to assess farmers’ knowledge and approaches used to minimize losses from PPD. Multi-stage sampling was used to identify districts, Extension Planning Areas (EPA’s) and farmers. Data were collected from 519 farmers using a structured questionnaire. Results revealed that PPD (74.0%) was the major post-harvest constraint followed by pests and diseases (62.1%). Farmers had varying knowledge levels on signs and causes of PPD. They were knowledgeable on PPD signs with 91.5% ably identifying PPD through change of pulp colour. The farmers also had moderate knowledge on causes of PPD, citing high temperature (57.6%) and over-staying of roots (56.2%) as main causes of PPD. Key methods for preventing PPD are: storage (43.0%) and piece-meal harvesting (40.4%). Only 2.6% of the farmers exploited varietal difference in dealing with PPD as some varieties (Sauti, Mpuma, Ching’amba, and Kalasa) take three to five days before showing PPD signs. Farmers’ knowledge levels and PPD preventive methods could be strengthened through: provision of training on post-harvest handling, improvement in storage and processing technologies; and application of advanced breeding techniques to exploit genetic variation in cassava germplasm.

Low-temperature preheating, fast charging, and vehicle-to-grid (V2G) capabilities are important factors for the further development of electric vehicles (EVs). However, for conventional two-stage chargers, the EV charging/discharging instructions and grid instructions cannot be addressed simultaneously for specific requirements, pulse heating and variable-current charging can cause high-frequency power fluctuations at the grid side. Therefore, it is necessary to design a bidirectional grid-friendly charger for EVs operated under pulse-current heating and variable-current charging. The DC bus, which serves as the medium connecting the bidirectional DC–DC and bidirectional DC–AC, typically employs capacitors. This paper analyzes the reasons why the use of capacitors in the DC bus cannot satisfy the grid and EV requirements, and it proposes a new DC bus configuration that utilizes energy storage batteries instead of capacitors. Due to the voltage-source characteristics of the energy storage batteries, EV instructions and grid instructions can be flexibly and smoothly scheduled by using phase-shift control and adaptive virtual synchronous generator (VSG) control, respectively. In addition, the stability of the control strategy is demonstrated using small signal modeling. Finally, typical operating conditions (such as EV pulse preheating, fast charging with variable current, and grid peak shaving and valley filling) are selected for validation. The results show that in the proposed charger, the grid scheduling instructions and EV charging/discharging instructions do not interfere with each other, and different commands between EVs also do not interfere with each other under a charging pile with dual guns. Without affecting the requirements of EVs, the grid can change the proportion of energy supply based on actual scenarios and can also obtain energy from either EVs or energy storage batteries. For the novel charger, the pulse modulation time for EVs consistently achieves a steady state within 0.1 s; thus, the pulse modulation speed is as much as two times faster than that of conventional chargers with identical parameters.

In the United States, today’s ranches are engaging in small-scale nature-based endeavors to diversify their income base. But the geographic boundary of the land they own creates a relatively small area within which to operate, and fragmented ownership diminishes the ability of any single landowner to produce nature-based income. Collective action among nearby landowners can produce a set of resources from which all members of the group can profit. Such action can enhance the economic, social, and environmental sustainability of grasslands and the populations that use them. This article shows that common-interest communities can be used to provide and allocate wildlife and other resources on ranchlands, enabling individual landowners to generate more income from selling nature-based experiences to customers. Common-interest communities are familiar in urban settings but they have not yet been used in this setting. Thus, the article proposes a new approach to ranchland management based upon a familiar set of largely private legal arrangements. More broadly, the article illustrates the relevance of private law and private property to sustainable development by explaining how property owners can use private law to engage in environmentally beneficial and economically profitable enterprises on the vast privately owned landscape of the U.S. Great Plains.

The Internet of Things has recently been a popular topic of study for developing smart homes and smart cities. Most IoT applications are very sensitive to delays, and IoT sensors provide a constant stream of data. The cloud-based IoT services that were first employed suffer from increased latency and inefficient resource use. Fog computing is used to address these issues by moving cloud services closer to the edge in a small-scale, dispersed fashion. Fog computing is quickly gaining popularity as an effective paradigm for providing customers with real-time processing, platforms, and software services. Real-time applications may be supported at a reduced operating cost using an integrated fog-cloud environment that minimizes resources and reduces delays. Load balancing is a critical problem in fog computing because it ensures that the dynamic load is distributed evenly across all fog nodes, avoiding the situation where some nodes are overloaded while others are underloaded. Numerous algorithms have been proposed to accomplish this goal. In this paper, a framework was proposed that contains three subsystems named user subsystem, cloud subsystem, and fog subsystem. The goal of the proposed framework is to decrease bandwidth costs while providing load balancing at the same time. To optimize the use of all the resources in the fog sub-system, a Fog-Cluster-Based Load-Balancing approach along with a refresh period was proposed. The simulation results show that “Fog-Cluster-Based Load Balancing” decreases energy consumption, the number of Virtual Machines (VMs) migrations, and the number of shutdown hosts compared with existing algorithms for the proposed framework.

The supplier selection decision, within the scope of supply chain management (SCM), is one of the key decisions that plays an important role in the success of the business. The supplier selection problem, which aims to determine the most suitable suppliers in line with the demands of the enterprises, can be defined as a Multi-Criteria Decision Making (MCDM) problem that includes both quantitative and non-quantitative criteria. While there is a large body of literature on supplier selection studies using MCDM methods, the number of studies in the health sector is relatively low compared to other sectors. Although much research can be found regarding the application of MCDM techniques in clinical operations, less research has been conducted on the problem of supplier selection in healthcare services, which has a high complexity level. The main purpose of the study is to develop a holistic MCDM model as a decision support system for supplier selection in the health sector. The decision-making trial and evaluation laboratory (DEMATEL) and Analytical Network Process (ANP) methods were used together to analyze the model. The main criteria used in the study are price, quality, logistics, sustainability, and occupational health and safety (OHS). As sustainability and OHS rarely exist in supplier selection studies in the health sector, this holistic model can contribute to the literature in that aspect. According to the findings and the main criteria ranking, the most important criteria, emerged as price, quality, sustainability, OHS, technique, and logistics. The results indicate the importance of sustainability in supplier selection in the health sector. The method proposed in this study may help health managers as a support system for making purchasing decisions.