• Energy Research
• Closed Access close
• Open Source close
• 6. Clean water close
• IN close

Acidogenic anaerobic fermentation route was explored for the production of bioethanol and volatile fatty acids (VFA) from the press mud (PM) obtained from sugar mill. Slurry was prepared from PM having 10% of total solids and the same was hydrolyzed under acidic thermal conditions. Both press mud slurry (PMS) and pre-treated press mud slurry (PTPMS) was used as feedstock with mixed microbial consortia (MMC) and enriched mixed microbial consortia (EMMC). Mix of bioethanol and VFA were obtained in all the four cases (PMS-MMC, PMS-EMMC, PTPMS-EMC and PTPMS-EMMC), but, bioethanol and VFA yield of 0.04 g/g and 0.27 g/g, respectively obtained from PTPMS with EMMC was found to be comparatively higher. Control experiments carried out with glucose yielded bioethanol and VFA of 0.042 g/g and 0.28 g/g, respectively demonstrating that the organism was using reducible sugars in the feedstock for the generation of bioethanol by simultaneously producing the VFA from COD.

The influence of various solvents (H2O, CH3OH, and C2H5OH) on product distribution and nature of products during hydrothermal liquefaction of sargassum tenerrimum algae has been examined. Hydrothermal liquefaction was performed using H2O (260, 280 and 300°C) and organic solvents CH3OH and C2H5OH (280°C) for 15min. The use of organic solvents significantly increased the yield of bio-oil. In the case of liquefaction with CH3OH and C2H5OH, the bio-oil yield was 22.8 and 23.8wt.% respectively whereas the bio-oil yield was 16.33wt.% with H2O. GC-MS analysis of the liquid products indicated the presence of various organic compounds including aromatics, nitrogenated and oxygenated compounds and higher selectivity amount of ester compounds were observed in the presence of alcoholic solvents. NMR and FT-IR showed that present of solvents have an effect on the decomposition of sargassum tenerrimum algae.

Anode with good electrocatalytic capabilities is more specifically required to reduce the ohimic losses during microbial fuel cell (MFC) operation. Highly conductive polymers viz., Polyaniline (PANi) and Polyaniline/Carbon nanotube (PANi/CNT) composite were prepared by in situ oxidative chemical polymerization method. Anodes were fabricated independently by coating PANi and CNT/PANi composites on the surface of SSM. The fabricated electrodes were evaluated as anode against stainless steel mess (SSM) as cathode during MFC operation. Maximum bioelectricity generation was observed in SSM-PANi/CNT-anode with power density of 48 mW/m2 and COD removal efficiency of 80% compared with SSM-PANi-anode (38 mW/m2; 65%) and SSM-anode (28 mW/m2; 58%). Bioelectrochemical characterization of the electrode materials using cyclic voltammetry and electrochemical impedance spectroscopy showed high electrocatalytic activity of PANi/CNT composite electrode. The study concluded the efficiency of PANi/CNT composite electrodes as bioanode in operation of MFCs towards achieving increased bioelectricity production along with wastewater treatment.

Abstract Globally, three-quarter of a billion people live without electricity. Besides, hundreds of million use a solar lantern for less than 4 h a day. Most of the access-deprived are in the Global South, predominantly in Sub-Saharan Africa and South Asia. The United Nations framed the seventh Sustainable Development Goal to improve access. Solar photovoltaic powered mini-grids are increasingly extending better service to deprived regions. However, poor load-factor and expensive storage adversely affect viability. Also, these mini-grids do not support infrequent large loads to avoid further loss of load-factor. Electric cooking is efficient and non-polluting; water treatment facilities can save millions from contaminant and pathogen by providing clean water. Besides, both electric cooking and water treatment are less expensive than alternatives. But mini-grids frequently do not support these. Indeed, the presence of sustained productive loads favourably influences the mini-grid economy. This study investigates the role of critical household loads to deliver similar bearing on the mini-grid economy. Results underscore realisation of desirable impact with household collaboration under a demand-response program. Collaborative consumption can lower initial investment by 62% and reduce the unit energy cost to $0.23. Also, cooperation improves the mini-grid load factor and promotes viability. Additionally, fast deployment needs during and after Covid-19 remains inherently supported while mitigating the pandemic induced financial stress of both consumer and mini-grid operator. This study of 88 nation-states underscores that demand response in a mini-grid can not only improve affordability for all consumers, but it can also bring 186 million people within affordable access.

Abstract Natural resources exist independent of human intervention. Although these interventions can and do affect the balance between ecological and biological diversity conditions these resources support, and their use to promote economic development. Currently, the unsustainable use of these resources threatens this balance, calling for more sustainable patterns of natural resource use and conservation. The primary responsibility for ensuring the proper balance lies with governments, leading to various policies and programs to preserve natural resources. The ultimate goal is to make the masses aware of natural assets’ importance and encourage their sustainable use. To successfully implement, however, these government practices require public communication and participation, and the full consideration of public opinion at various levels of governance. A predictive analytics framework is proposed for understanding public opinion on government policies to improve sustainable water governance. An integrated policy initiative to balance water resources use and conservation launched by the Indian government served as a test case for applying the framework in an attempt to accurately classify the opinion polarity related to the policy. The conventional feature extraction is applied to pre-processed datasets to extract the relevant features. Subsequently, swarm-based feature selection is applied to filter out optimal features. Lastly, opinion mining and textual analysis are performed to determine the most relevant water management factors that need immediate attention. The proposed framework serves as a policy evaluation strategy in the water management domain. The paper closes with a discussion of the general applicability of the proposed framework.

A field study was conducted on two texturally different soils to determine the influences of biosolids application on selected soil chemical properties and carbon dioxide fluxes. Two sites, located in Manildra (clay loam) and Grenfell (sandy loam), in Australia, were treated at a single level of 70 Mg ha-1 biosolids. Soil samples were analyzed for SOC fractions, including total organic carbon (TOC), labile, and non-labile carbon contents. The natural abundances of soil δ13C and δ15N were measured as isotopic tracers to fingerprint carbon derived from biosolids. An automated soil respirometer was used to measure in-situ diurnal CO2 fluxes, soil moisture, and temperature. Application of biosolids increased the surface (0-15 cm) soil TOC by > 45% at both sites, which was attributed to the direct contribution from residual carbon in the biosolids and also from the increased biomass production. At both sites application of biosolids increased the non-labile carbon fraction that is stable against microbial decomposition, which indicated the soil carbon sequestration potential of biosolids. Soils amended with biosolids showed depleted δ13C, and enriched δ15N indicating the accumulation of biosolids residual carbon in soils. The in-situ respirometer data demonstrated enhanced CO2 fluxes at the sites treated with biosolids, indicating limited carbon sequestration potential. However, addition of biosolids on both the clay loam and sandy loam soils found to be effective in building SOC than reducing it. Soil temperature and CO2 fluxes, indicating that temperature was more important for microbial degradation of carbon in biosolids than soil moisture.

Abstract A vapour absorption refrigeration system (VARS) in which a transfer tank replaces the conventional solution pump is analysed. Six fluid pairs with R22 as the refrigerant and different absorbents: DMA; DMF; DMETEG; DMETrEG; DMEDEG; and NMP are considered. Variations in COP, circulation ratio, percent mass of generated vapour utilised for transfer-tank operation, and minimum generator temperature are compared over a wide range of operating conditions. In general, R22-DMA, R22-DMF, and R22-DMETrEG are preferable for a transfer-tank operated VARS. At high generator temperatures or low condenser temperatures, R22-DMA gives the best overall performance. When the temperatures of the evaporator, absorber, and condenser are high, one may prefer R22-DMF as the working fluid.

Fruit and vegetable marketplace waste (FVMW) is an appealing alternative for energy production and should be utilized as a single substrate in anaerobic digestion (AD)–based biogas plants at an industrial-scale level in subtropical climatic countries. India alone generates 961,000 tons of FVMW annually from the major fruit and vegetable markets (FVMs). Utilization of FVMW to produce useful energy by AD could be helpful in meeting the ever-increasing energy demands of these countries. AD of fruit and vegetable waste (FVW) by two-phase systems has revealed good results in terms of stability, performance, and biogas generation; however, innovative approaches like plug flow tank reactor (PFTR) with passive solar heating with no mixing and no energy heating coupled with heat balance models and resistance network–based heat balance models need to be researched for subtropical climatic conditions in order to optimize the economics and energy balance of an AD system. Food waste and slaughter house wastes could be utilized successfully as co-substrates with FVW. C/N ratio is a critical performance parameter in the AD systems involving co-substrates; however, the synergistic relationship among co-substrates and characteristics, viz., macro- and micronutrients of individual co-substrates, must be investigated to improve the AD process. The optimum proportions of co-substrates could be determined by individual substrate characterization, biomethanation potential (BMP), and biodegradation kinetic models, thereby saving time and money as compared with random experimentation. Thermal, ultrasonic, and electrical pre-treatment in addition to physical pre-treatment could be effectively used for pre-treating FVW; however, synergy between co-substrates and pre-treatment method must be researched in order to justify the increased cost in extra pre-treatment.

Pseudomonas sp. AKS2 isolated from soil degrades polyethylene succinate (PES) efficiently in the laboratory. However, this organism may not be able to degrade PES with similar efficiency in a natural habitat. Since in situ remediation is preferred for the effective removal of recalcitrant materials like plastic, in the current study, bioaugmentation potential of this organism was investigated. To investigate the potential of the AKS2 strain to bioaugment the PES-contaminated soil, a microcosm-based study was carried out wherein naturally attenuated, biostimulated, and AKS2-inoculated (bioaugmented) soil samples were examined for their ability to degrade PES. The results showed better degradation of PES by bioaugmented soil than other microcosms. Consistent with it, a higher number of PES-degrading organisms were found in the bioaugmented microcosm. The bioaugmented microcosm also exhibited a higher level of average well color development in BiOLOG ECO plate assay than the other two. The corresponding Shannon-Weaver index and Gini coefficient revealed a higher soil microbial diversity of bioaugmented microcosm than the others. This was further supported by community-level physiological profile of three different microcosms wherein we have observed better utilization of different carbon sources by bioaugmented microcosms. Collectively, these results demonstrate that bioaugmentation of PES-contaminated soil with AKS2 not only enhances polymer degradation but also increases microbial diversity. Bioaugmentation of soil with AKS2 enhances PES degradation without causing damage to soil ecology. Thus, Pseudomonas sp. AKS2 has the potential to be implemented as a useful tool for in situ bioremediation of PES.