• Energy Research
• DE close
• IT close

The adenine nucleotide translocation in mitochondria has previously been established as an exchange between exogenous and endogenous adenine nucleotides across the inner membrane. The specificity and the control of the exchange are examined with the following major results: The adenine nucleotide translocation is relatively specific for exogenous ADP and ATP, AMP being nearly inactive. Among other nucleotides tested, only dADP and dATP exchange with a noticeable activity. In the controlled state ADP exchanges 2–4 times faster than ATP. If simultaneously added, ADP and ATP compete for the exchange, with ADP being about tenfold more active than ATP. The specificity of the exit of adenine nucleotides in the exchange is similar to the specificity of the entrance with the difference that ADP and ATP are released with equal activity in proportion to their intramitochondrial content. AMP is released only after a slow conversion to ADP. Therefore the short time exchange is limited by the endogenous content of ADP plus ATP. The exchange is influenced by the metabolic state of the mitochondria. The ATP exchange is more variable than the ADP exchange. Two effects are elucidated: (a) the influence of the metabolic state on the relative content of AMP which inhibits both the ADP and ATP exchange (b) the coupling of the energy transfer system which inhibits only the ATP exchange. An example for case (a) is the inhibition of the ADP and ATP exchange by arsenate and an example for case (b) is the strong increase of the ATP exchange on uncoupling. The following effects are relevant to the mechanism of the control of the exchange by ATP. The stimulation of the ATP exchange by uncoupler has the same concentration dependence as the uncoupling of oxidative phosphorylation (Km [CCP] = 0.08 μM, where CCP = carbonyl‐cyanide‐phenylhydrazone). Oligomycin does not abolish the uncoupler effect on the ATP exchange. “Endogenous uncoupling” on aging of mitochondria also stimulates the ATP exchange. Valinomycin plus K+ only slightly stimulate the ATP exchange. Anaerobiosis stimulates the ATP exchange to a smaller extent than uncoupling.In competition with ADP the effects of energy transfer on ATP exchange are more strongly revealed. On uncoupling the more than tenfold preference for ADP is fully abolished. It is concluded that basically the exchange for ADP and ATP has equal specificity in forward and reverse reaction. In the controlled state a superimposed force makes the specificity asymmetric and inhibits the entrance of ATP. This control of the ATP exchange is concluded to be based on the anionic character of the adenine nucleotides. Thus the ATP4‐ex–ADP3‐in exchange is inhibited unless the charge difference is compensated for by an uncoupler stimulated H+ movement across the membrane. Furthermore an electric potential gradient appears to be effective in the controlled state which is abolished on uncoupling.

Currently used analytical tools and indicators of macroeconomic development of the country do not adequately reflect environmental concerns. We need to improve the methodological basis of macroeconomic statistics of the natural environment and its relationships with agriculture to obtain more reliable information about the condition of a particular region. The paper proposes the formulation of macroeconomic accounts from the municipal level to aggregated information at the level of region and country. For example, the assets accounts for land cover and soil resources are developed according to cartographic survey of the Borovsk district of Kaluga region. In general, the developed base map is enough to make most accounts (balance sheet) assets land and soil resources. However, for a more complete and comprehensive reflection of soil resources in physical terms it is recommended to add indicators of soil properties that represent the physical, chemical and biological characteristics of soil, like porosity, structure, pH level and microbial biomass.

A complete surveillance strategy for wind turbines requires both the condition monitoring (CM) of their mechanical components and the structural health monitoring (SHM) of their load-bearing structural elements (foundations, tower, and blades). Therefore, it spans both the civil and mechanical engineering fields. Several traditional and advanced non-destructive techniques (NDTs) have been proposed for both areas of application throughout the last years. These include visual inspection (VI), acoustic emissions (AEs), ultrasonic testing (UT), infrared thermography (IRT), radiographic testing (RT), electromagnetic testing (ET), oil monitoring, and many other methods. These NDTs can be performed by human personnel, robots, or unmanned aerial vehicles (UAVs); they can also be applied both for isolated wind turbines or systematically for whole onshore or offshore wind farms. These non-destructive approaches have been extensively reviewed here; more than 300 scientific articles, technical reports, and other documents are included in this review, encompassing all the main aspects of these survey strategies. Particular attention was dedicated to the latest developments in the last two decades (2000–2021). Highly influential research works, which received major attention from the scientific community, are highlighted and commented upon. Furthermore, for each strategy, a selection of relevant applications is reported by way of example, including newer and less developed strategies as well.

Pool boiling in porous media has been applied in various thermal management systems by using latent heat and increasing the heat transfer area and thermal conduction path to improve the heat transfer performance. In mechanical equipment, vibration is an inevitable problem due to reasons such as engine operation and high-speed relative motion between transmission system components, which causes the system components to be affected by vibration forces or vibration accelerations. This study focuses on a review of published articles about the effects of mechanical vibration on the characteristics of boiling process in porous media by two aspects: heat transfer performance and bubble dynamics. Heat transfer coefficient (HTC) and critical heat flux are two main parameters used to measure the boiling heat transfer characteristics of porous media. For bubble dynamics investigations, properties such as migration, fragment, coalescence, departure diameter and frequency are the focus of research attention. Different mechanical vibration parameters, i.e., direction, frequency, and amplitude, will have different effects on the above characteristics. It is worth mentioning that the greatest influence occurs under resonance conditions, and this has been verified through experimental and simulation calculations. This review highlights the importance of considering mechanical vibrations in the design and optimization of porous media systems for efficient heat transfer applications. Further research is warranted to explore the detailed mechanisms and optimize the vibration parameters for enhanced heat transfer performance in thermal management systems using porous media.

This study introduces novel phenothiazine-based organic dyes, 2-LBH-100, 2-LBH-44, and 2-Ryu-4, specifically designed for quasi-solid-state dye-sensitized solar cells (QsDSSCs). Employing a donor-π-acceptor architecture, these dyes incorporate varying electron-donating moieties, including bis(3-(hexyloxy)phenyl)amine and diphenylamino, coupled with a cyanoacrylic acid acceptor. Alkoxy substitutions in 2-LBH-100 and 2-LBH-44 enhanced solubility and dye loading on TiO2, leading to improved performance in QsDSSCs. 2-LBH-100 exhibited a power conversion efficiency (PCE) exceeding 5% with excellent stability, while 2-LBH-44 demonstrated a PCE of over 3%, increasing to 4% over time. 2-Ryu-4, with its diphenylamino donor, achieved an initial PCE of over 6%. This research highlights the crucial role of donor–acceptor interactions in optimizing organic dye design for high-performance QsDSSCs, paving the way for efficient and stable next-generation solar energy technologies.

According to the renewable energy directive 2009/28/EC, the European Union Member States should increase by 2020 the use of renewable energy to 20% of gross final energy consumption and to reach a mandatory share of 10% renewable energy in the transport sector. This study aims to quantify the impact of 2020 bioenergy targets on the land use in the EU, based on the projections of the National Renewable Action Plans in four scenarios: Scenario 1. Bioenergy targets according to NREAPs; Scenario 2. Bioenergy targets according to NREAPs, no second generation biofuels; Scenario 3. Bioenergy targets according to NREAPs, reduced import of biofuels and bioliquids; Scenario 4. Bioenergy targets according to NREAPs, high imports of biofuels and bioliquids. This study also considers the credit for co-products generated from biofuel production. The analysis reveals that the land used in the EU for bioenergy would range between 13.5 Mha and 25.2 Mha in 2020. This represent between 12.2% and 22.5% of the total arable land used and 7.3% and 13.5% of the Utilised Agricultural Area (UAA). In the NREAPS scenario, about 17.4 Mha would be used for bioenergy production, representing 15.7% of arable land and 9.4% of UAA. The increased demand from biofuels would lead to an increased generation of co-products, replacing conventional fodder for animal feed. Considering the co-products, the land used for bioenergy would range between 8.8 Mha and 15.0 Mha in 2020 in the various scenarios. This represent between 7.9% and 13.3% of the total arable land used in the EU and 4.7% and 8.0% of the UAA. In the NREAPS scenario, when co-products are considered, about 10.3 Mha would be used for biofuels, bioliquids and bioenergy production, representing 9.3% of arable land and 5.6% of agricultural land. This study further provides detailed data on the impact on land use in each Member State.

AbstractAn arc‐furnace model consisting of non‐linear, time‐varying resistance, realized by the Alternative Transients Program (ATP), is presented in this paper. It is shown that the model is appropriate for flicker investigation in electrical networks supplying arc furnaces, constituting a valid alternative to the linear arc modelling realized by amplitude modulation of voltage generators. Block diagram of the procedure for ATP modelling of the nonlinear, time‐varying arc resistance, dynamic voltage‐current characteristic of the furnace electric arc, voltage and current arc waveforms and characteristic curves of an arc furnace, obtained by ATP simulation, are presented, referring to circuit parameters taken from an actual plant and to a sinusoidal law for arc‐length time variation. Aflickermeter ATP simulation is realized to derive equivalent voltage‐variation values in agreement with the actual flicker measurements.

Abstract. Flooding in the Amazon basin is frequently attributed to modes of large-scale climate variability, but little attention is paid to how these modes influence the timing and duration of floods despite their importance to early warning systems and the significant impacts that these flood characteristics can have on communities. In this study, river discharge data from the Global Flood Awareness System (GloFAS 2.1) and observed data at 58 gauging stations are used to examine whether positive or negative phases of several Pacific and Atlantic indices significantly alter the characteristics of river flows throughout the Amazon basin (1979–2015). Results show significant changes in both flood magnitude and duration, particularly in the north-eastern Amazon for negative El Niño–Southern Oscillation (ENSO) phases when the sea surface temperature (SST) anomaly is positioned in the central tropical Pacific. This response is not identified for the eastern Pacific index, highlighting how the response can differ between ENSO types. Although flood magnitude and duration were found to be highly correlated, the impacts of large-scale climate variability on these characteristics are non-linear; some increases in annual flood maxima coincide with decreases in flood duration. The impact of flood timing, however, does not follow any notable pattern for all indices analysed. Finally, observed and simulated changes are found to be much more highly correlated for negative ENSO phases compared to the positive phase, meaning that GloFAS struggles to accurately simulate the differences in flood characteristics between El Niño and neutral years. These results have important implications for both the social and physical sectors working towards the improvement of early warning action systems for floods.