• Energy Research
• agricultural and veterinary science... close
• PL close
• AT close

An experiment was conducted under laboratory conditions to investigate the effect of increasing concentrations of fenitrothion (2, 10 and 200 mg a.i./kg soil), diuron (1.5, 7.5 and 150 mg a.i./kg soil) and thiram (3.5, 17.5 and 350 mg a.i./kg soil) on soil respiration, bacterial counts and changes in culturable fraction of soil bacteria. To ascertain these changes, the community structure, bacterial biodiversity and process of colony formation, based on the r/K strategy concept, EP- and CD-indices and the FOR model, respectively, were determined. The results showed that the measured parameters were generally unaffected by the lowest dosages of pesticides, corresponding to the recommended field rates. The highest dosages of fenitrothion and thiram suppressed the peak SIR by 15-70% and 20-80%, respectively, while diuron increased respiration rate by 17-25% during the 28-day experiment. Also, the total numbers of bacteria increased in pesticide-treated soils. However, the reverse effect on day 1 and, in addition, in case of the highest dosages of insecticide on days 14 and 28, was observed. Analysis of the community structure revealed that in all soil treatments bacterial communities were generally dominated by K-strategists. Moreover, differences in the distribution of individual bacteria classes and the gradual domination of bacteria populations belonging to r-strategists during the experiment, as compared to control, was observed. However, on day 1, at the highest pesticide dosages, fast growing bacteria constituted only 1-10% of the total colonies number during 48 h of plate incubation, whereas in remaining samples they reached from 20 to 40% of total cfu. This effect, in case of fenitrothion, lasted till the end of the experiment. At the highest dosages of fenitrothion, diuron and at all dosages of thiram the decrease of biodiversity, as indicated by EP- and CD-indices on day 1, was found. At the next sampling time, no significant retarding or stimulating effect was detected. However, in case of CD values the higher differences were observed. The significant impact of pesticides on the physiological state of soil bacteria was not found. They were generally in dormant state (lambda < 0.5), but immediately after pesticides application, the additional reduction of frequency of bacterial cell proliferation (max. decrease of lambda value to 0.15 for thiram on day 14) and prolonged retardation time of colony appearance (max. increase of t(r) value to 1.39 for fenitrothion on day 1) on agar plates were found.

A technological solution was developed to process slaughter waste and farm manure and transform them into organic and mineral fertilizers. It has been shown that the formation of an enclosure on a goose farm from nitrogen-binding substances (brown coal, a mixture of brown coal with magnesite, used ash substrate) has a positive effect on reducing nitrogen emissions, even to about 80%. The presented solution is in line with ecological trends and ensures comprehensive management of agri-food waste. It reduces the loss of valuable nutrients from renewable sources, increases the efficiency of fertilizers and reduces the environmental nuisance of poultry farms. Organic-mineral fertilizers made from slaughterhouse waste and poultry manure were as effective as expensive commercial mineral fertilizers. New fertilizers helped to obtain a yield similar to the groups fertilized with mineral fertilizers: 11 t per ha for maize (grain), 0.8 t per ha for mustard (seed), 10 kg per 1 m2 of radish (all), and 18.5 kg per 1 m2 of beet (whole) while reducing production costs thanks to the use of waste materials.

Switchgrass (Panicum virgatum L.) has attracted attention as a promising second generation biofuel feedstock. Both existing grasslands and marginal croplands have been suggested as targets for conversion to switchgrass, but the resulting production potentials and hydrologic impacts are not clear. The objectives of this study were to model switchgrass production on existing grasslands (scenario-I) and on marginal croplands that have severe to very severe limitations for crop production (scenario-II) and to evaluate the effects on evapotranspiration (ET) and streamflow. The Soil and Water Assessment Tool (SWAT) was applied to the 1063 km2 Skeleton Creek watershed in north-central Oklahoma, a watershed dominated by grasslands (35%) and winter wheat cropland (47%). The simulated average annual yield (2002-2011) for rainfed Alamo switchgrass for both scenarios was 12 Mg ha-1. Yield varied spatially under scenario-I from 6.1 to 15.3 Mg ha-1, while under scenario-II the range was from 8.2 to 13.8 Mg ha-1. Comparison of average annual ET and streamflow between the baseline simulation (existing land use) and scenario-I showed that scenario-I had 5.6% (37 mm) higher average annual ET and 27.7% lower streamflow, representing a 40.7 million m3 yr-1 streamflow reduction. Compared to the baseline, scenario-II had only 0.5% higher ET and 3.2% lower streamflow, but some monthly impacts were larger. In this watershed, the water yield reduction per ton of biomass production (i.e. hydrologic cost-effectiveness ratio) was more than 5X greater under scenario-I than under scenario-II. These results suggest that, from a hydrologic perspective, it may be preferable to convert marginal cropland to switchgrass production rather than converting existing grasslands.

Abstract The paper presents a method for identifying and classifying local stakeholders involved in renewable energy development. The method is based on the expert assessment and comprises three main steps: (1) identification of the independent experts considering their expertise and knowledge of the local context; (2) identification of the local stakeholders based on expert assessment; and (3) analytical categorisation of stakeholders taking into account the professional relationship network. Using forest biomass (bioenergy) production as example, the stakeholder analysis is illustrated on the case study of Triglav National Park, which is characterised by a high potential of woody biomass production and a large number of stakeholders involved in land use and management. The first stage of stakeholder analysis identifies the key stakeholders to be involved in bioenergy development, through a survey with local experts. The results highlight eight key stakeholders and several primary and secondary stakeholders that should be involved to ensure socially acceptable decision-making about the renewable energy development in the Triglav National Park.

The automotive upholstery industry, which processes bovine leathers, has struggled with vast amounts of solid waste, of which the majority are fractions, such as shavings and splits and offcuts, both containing chromium (Cr) and free of Cr. In this work, a novel leather waste-to-fertiliser approach has been tested: four lightly processed (incubation with effective microorganisms) and three aggressively processed (using pyrolysis or hydrolysis processes) tanned leather waste fractions were used. They were applied as organic nitrogen-based fertilisers in two separate glasshouse experiments, consisting of four subsequent harvests, under spring–autumn conditions in northern Poland. The Cr stressing effect caused by bovine shavings containing Cr and splits and offcuts containing Cr stimulated an increase in ryegrass growth after 30 days, providing twice the dry matter yield than bovine shavings free of Cr and splits and offcuts free of Cr, then (after 90 and 120 days) it inhibited growth. The Monod kinetics model was developed using the best fitting procedure (R2 > 0.94) for the efficiency of internal N use in ryegrass for the lightly processed fractions of tanned leather-waste fractions and each harvest. In the case of the processed leather waste-fractions, the relation was quasi linear, evidencing less growth inhibition and no over-fertilisation effects. The acid hydrolysate of bovine shavings containing Cr showed the best performance, reaching a relative agronomic effectiveness (RAE, N utilization-based) equal to 89%, 95%, 19%, and 38% for 30, 60, 90, and 120 days, respectively, and 71% in total. For the lightly processed fractions, it was lower than 12%. The future perspective should focus on steps including scaling up the tests to field conditions; transportation, storage, and application methods; effectiveness for other crops; usage in crop rotation systems; environmental impact assessment; production carbon footprint; commercial potential; and optimizing the production processes.

The establishment of phytoextraction crops on highly contaminated soils can be limited by metal toxicity. A recent proposal has suggested establishing support crops during the critical initial phase by metal immobilization through soil amendments followed by subsequent mobilization using elemental sulphur to enhance phytoextraction efficiency. This 'combined phytoremediation' approach is tested for the first time in a pot experiment with a highly contaminated soil. During a 14-week period, relatively metal-tolerant maize was grown in a greenhouse under immobilization (before sulphur (S) application) and mobilization (after S application) conditions with soil containing Cd, Pb and Zn contaminants. Apart from the control (C) sample, the soil was amended with activated carbon (AC), lignite (Lig) or vermicompost (VC) all in two different doses (dose 1~45 g additive kg-1 soil and dose 2~90 g additive kg-1 soil). Elemental S was added as a mobilization agent in these samples after 9 weeks. Biomass production, nutrient and metal bioavailability in the soil were determined, along with their uptake by plants and the resulting remediation factors. Before S application, Cd and Zn mobility was reduced in all the AC, Lig and VC treatments, while Pb mobility was increased only in the Lig1 and VC1 treatments. Upon sulphur application, Fe, Mn, Cd, Pb and Zn mobility was not significantly affected in the C, AC and VC treatments, nor total Cd, Pb and Zn contents in maize shoots. Increased sulphate, Mn, Cd, Pb and Zn mobilities in soil together with related higher total S, Mn, Pb and Zn contents in shoots were observed in investigated treatments in the last sampling period. The highest biomass production and the lowest metal toxicity were seen in the VC treatments. These results were associated with effective metal immobilization and showed the trend of steady release of some nutrients. The highest remediation factors and total elemental content in maize shoots were recorded in the VC treatments. This increased phytoremediation efficiency by 400% for Cd and by 100% for Zn compared to the control. Considering the extreme metal load of the soil, it might be interesting to use highly metal-tolerant plants in future research. Future investigations could also explore the effect of carbonaceous additives on S oxidation, focusing on the specific microorganisms and redox reactions in the soil. In addition, the homogeneous distribution of the S rate in the soil should be considered, as well as longer observation times.

Phytoremediation and its efficiency--influenced by several factors-is prime concern in reduction of environment contamination with heavy metals. The aim of the study was to estimate in controlled conditions--in relation to the natural Ca/Mg ratio 4:1--the influence of different Ca/Mg ratios (1:1/4, 20:1, 1:10) on selected heavy metals (Cd, Cu, Pb, and Zn) accumulation efficiency shown by three morphological parts of Salix viminalis 'Cinamomea' (cane bark, shoots and roots). Accumulation of heavy metals in experimental conditions was significantly Ca/Mg ratio dependent, and occurred in the following order: 1:10 > 4:1 > 20:1 > 1:1/4. The highest accumulation under 0.5 mM solutions (as compared to 0.1 mM) was noted for copper and zinc, and the lowest for cadmium. Biometric parameters of Salix viminalis cuttings revealed the highest biomass productivity under 20:1 and 4:1 Ca/Mg ratios. In the case of shoot length increase, both metal concentration and kind of metal present in the solution were important. The results indicate that higher calcium ion concentration in solution (Ca/Mg 20:1) stimulates Salix viminalis growth by 3 fold when compared to other Ca/Mg ratio. It can be an important factor in remediation of the environment with this plant.

This study investigates the effects of osmotic dehydration on garlic clove halves using a low-pH osmotic solution with ascorbic acid, concentrated tomato juice, and basil extract (45° Brix). Samples, both dehydrated and fresh, were subjected to various drying methods. Physical properties, such as CT scan analysis, texture profile analysis (TPA), porosity, and density, were examined. Additional parameters like energy consumption, specific energy consumption, moisture content, water activity, and color change were evaluated. Osmotic dehydration reduced moisture content by over 7.5%. The specific energy consumption for microwave vacuum drying (MVD) was 95 kJ/g for osmotically dehydrated samples compared to 118 kJ/g for non-dehydrated samples. Drying times decreased by 24 min for MVD and 15% for microwave convective drying (MCD). The Weibull model best fit the drying kinetics, with R2 values above 0.99 and RMSE below 0.03 for all methods. TPA tests showed no significant impact of osmotic dehydration on hardness, though drying methods significantly affected hardness, ranging from 49 N to 707 N. Color change was higher for osmotically dehydrated samples, reaching 37.09 for OD-CD compared to 29.78 for CD.