• Energy Research
• Restricted close
• Embargo close
• 7. Clean energy close
• 13. Climate action close
• 6. Clean water close
• 14. Life underwater close
• PT close
• EU close

Abstract High power pseudocapacitors are extremely relevant to answer specific needs in the current energy transition arena and to implement an efficient renewable energy society. However, literature shows that are still open gaps concerning improvement of their energy density at high power, conversion efficiency, cost and cycle life. Electrodes based on active transition metal compounds, and in particular metal sulphides, evidence high potential to meet these objectives. This work discusses the dependence on the synthesis route of the charge storage mechanism of manganese sulphide-based materials and relates the pseudocapacitive response of these electrodes with their polycrystalline nature. Results reveal that a manganese oxy-sulphide mixture can achieve a high specific capacitance of 231 F.g−1 at 0.5 A/g in a 0.65 V active window. These values represent a 31.5 % increase compared to pure rambergite, γ-MnS, and 436 % compared to pure hausmannite Mn3O4 prepared under the same conditions. Moreover, the results show that manganese oxy-sulphide electrodes are characterized by good charge retention (73%), and superior long term capacity retention (above 86%) after 5000 cycles, evidencing potential for high power energy storage applications.

Diesel engine exhausts from a common rail 3.0 L F1C diesel engine were analyzed at two different load conditions of the WLTC testing cycle downstream of both the diesel particulate filter (DPF) and selective catalytic reactor (SCR) to verify their effect on the characteristics of carbon particulate matter. An array of chemical, physical and spectroscopic techniques (gas chromatography coupled with mass spectrometry (GC-MS), mobility analyzer, UV-Visible absorption and fluorescence spectroscopy) was applied for characterizing polycyclic aromatic hydrocarbons (PAH), heavy aromatic compounds and soot, constituting the particulate matter (PM) sampled from the exhaust. The engine was operated in half load (HL) (188 Nm, representing the more common condition for engine in urban traffic) and full load (FL) (452 Nm, representing the best performance of the engine operation) conditions, at the same engine speed (2000 rpm). Soot formation was enhanced in HL condition, with respect to FL, but, just because of the much lower soot amount, the after-treatment systems in this last condition resulted to be less efficient in the soot abatement. Indeed, the abatement through DPF was about 40% lower in the FL condition with respect to HL condition, and any significant further concentration decrease was found after SCR, in both conditions. By contrast, PAH concentration after DPF abatement was found to be higher in the HL with respect to FL condition. A further PAH concentration decrease of about 30% was found after the SCR in the HL condition whereas in FL the reduction was only about 5-6%. Also the heavy aromatic compounds having molecular weight above the GC-MS detection limit (300 u), were mitigated by SCR. Therefore, SCR did not cause a further soot reduction, whereas it was effective in largely reducing PAH and heavy aromatics emissions, especially in the lower temperature condition featuring the half-load condition, when combustion efficiency is worse. Moreover, SCR system reduced the emission of small particles probably due to an enhanced agglomeration of particles, with beneficial effect on the harmfulness to human health.

Sustainability assessment and rating systems are intended to foster more sustainable design, construction, operation, maintenance and disassembly/deconstruction promoting and making possible a better integration of environment, societal, and cost concerns with other traditional decision criteria. The use of improved and building technologies can contribute considerably to better environmental cycle and then to the sustainability of the constructions. It is widely recognised in the of Building Sustainability Assessment that Life Cycle Assessment (LCA) is a much preferable method for evaluating the environmental pressure caused by materials, Building assemblies and the whole life-cycle of a building. Nevertheless, LCA tools are not extensively used in building design and most of building sustainability assessment and systems are not comprehensive or consistently LCA-based. Reasons for this failure above all related to the huge variety and amount of material flows and processes of building’s Lifecycle and to the complexity of the stages of a LCA. This paper will present the difficulties and possible solutions to integrate more accurate environmental methods in rating systems. In this context, the paper will also present the work that is being carried out in the development of the Portuguese Building Sustainability Assessment system (SBTool PT)

The search for affordable high performance electrode materials in photoelectrochemical hydrogen production by solar water splitting is an ongoing quest. Hematite is a photoanode material with an electronic band gap suitable for efficient absorption of visible light in a photoelectrochemical cell (PEC). Although its poor electronic structure makes hematite a controversial candidate for PEC, it remains promising because it is an earth abundant, chemically stable and low cost material – necessary prerequisites for PEC to become a competitive cost-efficient solar fuel economy. In addition to reviewing some recent PEC research on hematite and its relevant physical and chemical characteristics, we show how hematite obtained by a low cost synthesis can be refined by hydrothermal treatment and further functionalized by coating with phycocyanin, a light harvesting protein known for photosynthesis in blue-green algae.

AbstractEarthworms may promote the biodegradation of polycyclic aromatic hydrocarbons (PAHs) in soil, but the mechanism through which they exert such influence is still unknown. To determine if the stimulation of PAH degradation by earthworms is related to changes in microbial communities, a microcosm experiment was conducted consisting of columns with natural uncontaminated soil covered with PAH‐contaminated dredge sediment. Columns without and with low and high Eisenia andrei densities were prepared. Organic matter and PAH content, microbial biomass, and dehydrogenase activity (DHA) were measured in soil and sediment over time. Biolog Ecoplate™ and polymerase chain reaction using denaturing gradient gel electrophoresis were used to evaluate changes in metabolic and structural diversity of the microbial community, respectively. Earthworm activity promoted PAH degradation in soil, which was significant for biphenyl, benzo[a]pyrene, and benzo[e]pyrene. Microbial biomass and DHA activity generally did not change over the experiment. Earthworm activity did change microbial community structure, but this did not affect its functioning in terms of carbon substrate consumption. Results suggest no relationship between changes in the microbial community by earthworm activity and increased PAH disappearance. The role of shifts in soil microbial community structure induced by earthworms in PAH removal needs further investigation. Environ. Toxicol. Chem. 2012;31:794–803. © 2011 SETAC

A methodology for the sizing of domestic hot water heating and storage systems is defined, by assuming an extreme operating condition cycle composed of only two parts, a water consumption period and a system repositioning period. In both parts to respond to the extreme hot water demanding conditions, the heating is always on. The subsequent exergy analysis of this domestic hot water production system compares the irreversibility and the exergy efficiency of the water storage and the tankless situation. To carry out such analysis, some basic assumptions were made: a constant temperature heat source, a short duration operating cycle and a constant thermal energy supply. Under these circumstances it is shown that the hot water storage system leads to lower exergy losses while the tankless system is more exergy efficient, but requiring a higher instantaneous thermal power input. The use of the joule effect electricity, as the system heat source, be it a water storage one or a tankless one, maximizes the system irreversibility losses and minimizes the system exergy efficiency. The tankless system, with the joule effect electricity heat source is the worst situation.

Abstract This work assesses the impacts of aggressive driving behavior on pollutants emissions and energy consumption at a city level. Furthermore, it performs an economic analysis considering the potential avoided emissions and fuel savings and discusses potential policy measures to address this topic. The results showed that aggressive driving significantly impacts energy consumption and emissions, with energy consumption increasing by more than ∼200% and emissions by 330% for aggressive driving compared to non-aggressive driving (in MJ/km and in g/km, respectively). This increment was found to be even higher for diesel vehicles than for gasoline vehicles. On the contrary, gasoline vehicles showed higher percentages of increase for most emissions (CO, NOx and NO). Results also revealed that aggressive driving impacts are higher for local streets when examining the city level. Moreover, the economic analysis showed that significant cost reductions may be achieved by avoiding aggressive driving, reaching up to 52.5 k€ on a daily basis. In conclusion, this study is of particular relevance to policy makers and urban planners, enabling to obtain a comprehensive overview of the impacts of aggressive driving behaviors at a city level and providing new insights to perform further developments and to assess the feasibility of the implementation of policy measures.

ScopeThis study was designed to evaluate the influence of ethanol on the bioavailability of blackberry anthocyanins.Methods and resultsA total of 18 participants were recruited to consume 250 mL of a blackberry puree (650 mg of anthocyanins) without (BBP) or with 12% ethanol (BBP 12%). Venous blood was collected from participants at baseline and at 15, 30, 60, and 120 min after puree ingestion. Urine samples were collected at baseline and at 120 min. Plasma and urine concentration of anthocyanins and anthocyanin conjugates were quantified by HPLC‐DAD. Methyl‐cyanidin‐glucuronide (Me‐Cy‐Glucr) and 3′‐methyl‐cyanidin‐3‐glucoside (3′‐Me‐Cy3glc) were the main anthocyanin conjugates detected in all plasma and urine samples. Urinary concentration of these anthocyanin conjugates were positively correlated with their plasma concentration. Ethanol increased plasma Cmax of Me‐Cy‐Glucr and 3′‐Me‐Cy3glc. Participants were then stratified according to their body mass index (BMI) and body fat mass. After BBP consumption, plasma Cmax of Me‐Cy‐Glucr and 3′‐Me‐Cy3glc tended to be decreased in overweight/obese participants, in comparison to normal weight participants. The increase on plasma Cmax of Me‐Cy‐Glucr and 3′‐Me‐Cy3glc induced by ethanol was more pronounced in the group of overweight/obese participants.ConclusionsEthanol seems to enhance Cy3glc metabolism that appears to be compromised in overweight and obese individuals.