• Energy Research
• Closed Access close
• Restricted close
• BE close
• Bioresource Technology close

Production of microbial protein (MP) from recovered resources - e.g. CO2-sourced formate and acetate - could provide protein while enabling CO2 capture. To assess the protein quality obtained from this process, pure cultures and enriched communities were selected and characterized kinetically, stoichiometrically and nutritionally. Growth on acetate resulted in up to 5.3 times higher maximum specific growth rate (μmax) than formate (i.e. 0.15-0.41 h-1 for acetate compared to 0.061-0.29 h-1 for formate at pH = 7). The protein content was a function of the growth phase, with the highest values during stationary phase, ranging between 18 and 82%CDW protein depending on the organism and substrate. The negative correlation between biomass productivity and protein content indicated a trade-off between production rate and product quality. The final product (i.e. dried MP) quality was in most cases superior to soybean and all cultures were rich in threonine, phenylalanine and tyrosine, regardless of the carbon source.

One challenge in using microbial fuel cells (MFCs) for wastewater treatment is the reduction in performance over time due to cathode fouling. An in-situ technique was developed to clean air cathodes using magnets on either side of the electrode, with the air-side magnet moved to clean the water-side magnet by scraping off the biofilm. The power output of the magnet-cleaned cathodes after one month of operation was 132 ± 7 mW m-2, which was 42% higher than the controls with no magnet (93 ± 4 mW m-2) (no separator, NS), and 110% higher (116 ± 4 mW m-2) than controls with separators (Sp, 55 ± 7 mW m-2). Cleaning cathodes using magnets reduced the biofilm by 75% (NS) and 28% (Sp). The in-situ cleaning technique thus improved the performance of the MFC over time by reducing biofouling due to biofilm formation on the air cathodes.

Five different pre-treatments were investigated to enhance the solubilisation and anaerobic biodegradability of kitchen waste (KW) in thermophilic batch and continuous tests. In the batch solubilisation tests, the highest and the lowest solubilisation efficiency were achieved with the thermo-acid and the pressure-depressure pre-treatments, respectively. However, in the batch biodegradability tests, the highest cumulative biogas production was obtained with the pressure-depressure method. In the continuous tests, the best performance in terms of an acceptable biogas production efficiency of 60% and stable in-reactor CODs and VFA concentrations corresponded to the pressure-depressure reactor, followed by freeze-thaw, acid, thermo-acid, thermo and control. The maximum OLR (5 g COD L(-1) d(-1)) applied in the pressure-depressure and freeze-thaw reactors almost doubled the control reactor. From the overall analysis, the freeze-thaw pre-treatment was the most profitable process with a net potential profit of around 11.5 € ton(-1) KW.

Anaerobic digestion is generally considered to be an economic and environmentally friendly technology for treating waste activated sludge, but has some limitations, such as the time it takes for the sludge to be digested and also the ineffectiveness of degrading the solids. Various pre-treatment technologies have been suggested to overcome these limitations and to improve the biogas production rate by enhancing the hydrolysis of organic matter. This paper studies the use of peracetic acid for disintegrating sludge as a pre-treatment of anaerobic digestion. It has been proved that this treatment effectively leads to a solubilisation of organic material. A maximum increase in biogas production by 21% is achieved. High dosages of PAA lead to a decrease in biogas production. This is due to the inhibition of the anaerobic micro-organisms by the high VFA-concentrations. The evolution of the various VFAs during digestion is studied and the observed trends support this hypothesis.

Tall oil fractions obtained from Norwegian spruce pulping were hydrodeoxygenated (HDO) at pilot scale using a commercial NiMo hydrotreating catalyst. Comprehensive two dimensional gas chromatography (GC×GC) showed that HDO of both tall oil fatty acids (TOFA) and distilled tall oil (DTO) produced highly paraffinic hydrocarbon liquids. The hydrotreated fractions also contained fatty acid methyl esters and norabietane and norabietatriene isomers. Steam cracking of HDO-TOFA in a pilot plant revealed that high light olefin yields can be obtained, with 35.4 wt.% of ethene and 18.2 wt.% of propene at a coil outlet pressure (COP) of 1.7 bara, a dilution of 0.45 kg(steam)/kg(HDO-TOFA) and a coil outlet temperature (COT) of 820 °C. A pilot plant coking experiment indicated that cracking of HDO-TOFA at a COT of 850 °C results in limited fouling in the reactor. Co-cracking of HDO tall oil fractions with a typical fossil-based naphtha showed improved selectivity to desired light olefins, further demonstrating the potential of large scale olefin production from hydrotreated tall oil fractions in conventional crackers.

The organic fraction of municipal solid waste (OFMSW) is a widely-available promising feedstock for biofuel production. However, the presence of different inhibitors originating from fruit and food/beverage wastes as well as recalcitrant lignocellulosic fractions hampers its bioconversion. This necessitates a pretreatment to augment the biodigestibility and fermentability of OFMSW. Hence, this review aims to provide the in-vogue inhibitory compound removal and pretreatment techniques that have been employed for efficient OFMSW conversion into biofuels, i.e., hydrogen, biogas, ethanol, and butanol. The techniques are compared concerning their mode of action, chemical and energy consumption, inhibitor formation and removal, economic feasibility, and environmental sustainability. This critique also reviews the existing knowledge gap and future perspectives for efficient OFMSW valorization. The insights provided pave the way toward developing energy-resilient cities while addressing environmental crises related to generating OFMSW.

Anaerobic digestion is widely applied for the recovery of energy from waste activated sludge. Pre-treatment methods are of high interest to increase the biodegradability of the sludge and to enhance the digestion efficiency. This paper studies the application of a microwave pre-treatment. An experimental set-up of two pilot scale semi-continuous digesters was used. During a long term experiment, one of the reactors was fed with untreated sludge, while microwave pre-treated sludge (336 kJ/kg sludge) was introduced in the second one. A solid retention time of 20 days was kept during the experiments. (Organic) dry solids, carbohydrates, proteins and volatile fatty acids were monitored during digestion. It was seen that the microwave pre-treatment resulted in an effective solubilization of the organic matter in the sludge. The changes to the sludge composition resulted in an increase in biogas production by 50%, while the methane concentration in both reactors remained stable.