• Energy Research
• Closed Access close
• US close
• GB close
• RU close
• NL close
• UA close

A study was carried out to determine if electromagnetic fields of high voltage transmission lines can interfere with electromagnetically guided cornering systems associated with some center pivot irrigation units. Using electromagnetic susceptibility tests, it was found that 60 hertz magnetic fields of more than approximately 500 mG (milligauss) are required to cause interference with the operation of one system. This level is significantly higher than those found near most high voltage transmission lines. It was also found that the magnetic fields at harmonic frequencies and wideband fields due to corona on the transmission line studied were insufficient to cause interference with cornering guidance systems. Observations of center pivot cornering systems operating properly near 345 kV transmission lines in Nebraska, USA, confirmed these results.

Direct Load Control (DLC) is an effective instrument for achieving a guaranteed load curtailment. Unfortunately, if a customer considers that personal discomfort outweighs money savings after DLC shutting down of home appliances, DLC solution can be rejected. This paper proposes the way to remediate customer comfort concerns by pre-storing additional energy in electric loads before their disconnection from the grid. We take electric tank water heaters as an illustrative example of residential loads with storage. To illuminate our approach we first show how to balance electric consumption for pre-storing with user thermal discomfort for a single water heater. Then, we illustrate how the approach can be scaled-up to a multiple-boiler scenario, when ten remotely controlled boilers act next to fifty non-controlled boilers. The simulations for the latter case show that the expected user thermal discomfort can be significantly reduced at the cost of a reasonable increase of electricity demand preceding DLC event.

A cost efficient synergistic strategy combining mild alkaline pretreatment (0.5-5% NaOH at 70 °C for 60 min) and bovine serum albumin (BSA) blocking of lignin was evaluated for effective conversion of poplar. The highest glucose yield of 69.2% was obtained for 5% alkaline pretreated sample, which was 4.4 times that of untreated sample. The enhanced enzymatic hydrolysis was attributed to significant hemicelluloses removal with limited delignification. Delignification mainly occurred in secondary wall, leading to more open cell wall structure, thus facilitating better transport of enzyme. Hemicelluloses removal helped split adjacent microfibrils, thus increased the specific sites for cellulase binding. After BSA addition in enzymatic hydrolysis, cellulose conversion further improved to 78.4% with 33% reduction of cellulase dosage due to decreased non-specific adsorption of cellulase on residual lignin. The utilization of synergistic alkaline pretreatment - BSA strategy may improve the overall economics of biomass conversion and successful commercial implementation of biorefineries.

Paper mill sludge (PMS) is a residual biomass that is generated at paper mills in large quantities. Currently, PMS is commonly disposed in landfills, which causes environmental issues through chemical leaching and greenhouse gas production. In this research, we are exploring the potential of fast pyrolysis process for converting PMS into useful bio-oil and biochar products. We demonstrate that by subjecting PMS to a combination of acid hydrolysis and torrefaction pre-treatment processes it is possible to alter the physicochemical properties and composition of the feedstock material. Fast pyrolysis of pretreated PMS produced bio-oil with significantly higher selectivity to levoglucosenone and significantly reduced the amount of ketone, aldehyde, and organic acid components. Pretreatment of PMS with combined 4% mass fraction phosphoric acid hydrolysis and 220 °C torrefaction processed prior to fast pyrolysis resulted in a 17 times increase of relative selectivity towards levoglucosenone in bio-oil product along with a reduction of acids, ketones, and aldehydes combined from 21 % to 11 %. Biochar, produced in higher yield, has characteristics that potentially make the solid byproduct ideal for soil amendment agent or sorbent material. This work reveals a promising process system to convert PMS waste into useful bio-based products. More in-depth research is required to gather more data information for assessing the economic and sustainability aspects of the process.

Load modeling plays an important role in transmission planning studies to anticipate the response of a power system following fault. The composite load model is the latest and the state-of-the-art load model available for transmission planning studies. Many utilities in the US are already using the composite load model or transitioning to use the composite load model for their transmission planning studies. However, the usage of any aggregated load model can in some cases lead to unanticipated and suspect simulation results during certain grid conditions. This paper briefly introduces the composite load model and presents two scenarios where an informed sensitivity study can help transmission planners gain deeper insights into otherwise ambiguous results obtained while using the composite load model during simulations.

Seagrass systems of the Western Pacific region are biodiverse habitats, providing vital services to ecosystems and humans over a vast geographic range. SeagrassNet is a worldwide monitoring program that collects data on seagrass habitats, including the ten locations across the Western Pacific reported here where change at various scales was rapidly detected. Three sites remote from human influence were stable. Seagrasses declined largely due to increased nutrient loading (4 sites) and increased sedimentation (3 sites), the two most common stressors of seagrass worldwide. Two sites experienced near-total loss from of excess sedimentation, followed by partial recovery once sedimentation was reduced. Species shifts were observed at every site with recovering sites colonized by pioneer species. Regulation of watersheds is essential if marine protected areas are to preserve seagrass meadows. Seagrasses in the Western Pacific experience stress due to human impacts despite the vastness of the ocean area and low development pressures.

Abstract This paper presents a novel multi-time-stage input–output-based modeling framework for simulating the dynamics of bioenergy supply chains. One of the key assumptions used in the model is that the production level at the next time-stage of each segment of the energy supply chain adjusts to the output surplus or deficit relative to targets at the current time period. Furthermore, unlike conventional input–output models, the technology matrix in this approach need not be square, and thus can include coefficients denoting flows of environmental goods, such as natural resources or pollutants. Introducing a feedback control term enables the system to regulate the dynamics, thus extending the model further. This is an important feature since the uncontrolled dynamic model exhibits oscillatory or unstable behavior under some conditions; in principle, the control term allows such undesirable characteristics to be suppressed. Numerical simulations of a simple, two-sector case study are given to illustrate dynamic behavior under different scenarios. Although the case study uses only a hypothetical system, preliminary comparisons are made between the simulation results and some broad trends seen in real bioenergy systems. Finally, some of the main policy implications of the model are discussed based on the general dynamic characteristics seen in the case study. In particular, insights from control theory can be used to develop policy interventions to impart desirable dynamic characteristics to nascent or emerging biofuel supply chains. These interventions can be used to guide the growth of bioenergy supplies along final demand trajectories with minimal fluctuation and no instability.

Net primary production (NPP), the difference between CO2 fixed by photosynthesis and CO2 lost to autotrophic respiration, is one of the most important components of the carbon cycle. Our goal was to develop a simple regression model to estimate global NPP using climate and land cover data. Approximately 5600 global data points with observed mean annual NPP, land cover class, precipitation, and temperature were compiled. Precipitation was better correlated with NPP than temperature, and it explained much more of the variability in mean annual NPP for grass- or shrub-dominated systems (r2 = 0.68) than for tree-dominated systems (r2 = 0.39). For a given precipitation level, tree-dominated systems had significantly higher NPP (approximately 100-150 g C m(-2) yr(-1)) than non-tree-dominated systems. Consequently, previous empirical models developed to predict NPP based on precipitation and temperature (e.g., the Miami model) tended to overestimate NPP for non-tree-dominated systems. Our new model developed at the National Center for Ecological Analysis and Synthesis (the NCEAS model) predicts NPP for tree-dominated systems based on precipitation and temperature; but for non-tree-dominated systems NPP is solely a function of precipitation because including a temperature function increased model error for these systems. Lower NPP in non-tree-dominated systems is likely related to decreased water and nutrient use efficiency and higher nutrient loss rates from more frequent fire disturbances. Late 20th century aboveground and total NPP for global potential native vegetation using the NCEAS model are estimated to be approximately 28 Pg and approximately 46 Pg C/yr, respectively. The NCEAS model estimated an approximately 13% increase in global total NPP for potential vegetation from 1901 to 2000 based on changing precipitation and temperature patterns.

Abstract In many visions and roadmaps, there is a broad agreement that fuel cells – both for stationary and mobile applications – are the key technology to allow the development of a hydrogen infrastructure. Furthermore, this development is generally thought to be based on a gradual, decentralised evolution. Nevertheless, in this paper it is argued that, taking into account the entire hydrogen chain (production, transport, storage, distribution and end-use), this decentralised fuel-cell based philosophy shows some serious flaws. Therefore, a new hydrogen-transition approach was pushed forward: mixing in of hydrogen into the natural-gas bulk. Using Flanders – the Northern part of Belgium – as a case study, the development of a transitory hydrogen infrastructure has been studied, taking into account the entire hydrogen chain and its dynamics, from production to end use. In a next step, this transition is being quantified. An optimisation model has been developed using Matlab and the commercial solvers GAMS and CPLEX. Following a mixed-integer linear-programming approach, this model is able to determine the economically optimal hydrogen-production mix and operational behaviour of each hydrogen-production plant separately. The model then allows gaining valuable insights in the importance of storage and the influence of fuel prices and carbon taxes with regard to the development of an early hydrogen economy.