• Energy Research
• engineering and technology close
• 11. Sustainability close
• 6. Clean water close
• 15. Life on land close
• US close
• AU close

Wind characteristics (e.g., mean wind speed, gust factor, turbulence intensity and integral scale, etc.) are quite scattered in different measurement conditions, especially during typhoon and/or hurricane processes, which results in the structural engineer ambiguously determining the wind parameters in wind-resistant design of buildings and structures in cyclone-prone regions. In tropical cyclones (including typhoons and hurricanes), the inconsistent wind characteristics may be in part ascribed to the complex flow structure with the coexistence of both mechanical and convective turbulence in the boundary layer of tropical cyclones. Another significant contribution to the scattered wind characteristics is due to various measurement conditions (e.g., terrain exposure and height) and data processing schemes (e.g., averaging time). The removal of the inconsistency in the field-measurement system may offer a more rational comparison of measured wind data from various observation platforms, and hence facilitates a better identification scheme of the wind characteristics to guide the urban planning design and wind-resistant design of buildings and structures. In this study, an analytical framework was firstly proposed to eliminate the potential observation-related effects in wind characteristics and then the wind characteristics of seven field measured tropical cyclones (four typhoons and three hurricanes) were comparatively investigated. Specifically, field measurements of wind characteristics were converted to a standard reference station with a roughness length of 0.03 m, observation duration of 10 min for mean wind and averaging time of 3 s for gusty wind at a 10 m height. The differences of the measured wind characteristics between the typhoons and hurricanes were highlighted. The standardized turbulent wind characteristics under the analytical framework for typhoons and hurricanes were compared with the corresponding recommendations in standard of American Society of Civil Engineers (ASCE 7-10) and Architectural Institute of Japan Recommendations for Loads on Buildings (AIJ-RLB-2004).

This paper presents an analysis of the problem of reorientation of a riser pipe from an initially horizontal configuration during subsurface tow to the vertical position for installation. Front and rear barges support the pipe through cables. The orientation into a vertical configuration is accomplished by paying out the front cable. The pipe is treated as a Bernoulli-Euler beam with significant tension undergoing large angle deflections. A finite element procedure used state transfer matrices and successive linearization and the results show that the stress critical phase occurs when the pipe is going through the 60-deg angle to the horizontal direction.

Abstract Microorganisms used in syngas fermentation require nutrients to grow and convert syngas (CO, H2 and CO2) into various products. Many of the essential nutrients can be provided by biochar. Poultry litter biochar (PLBC) contains minerals and trace metals and has a high pH buffering capacity, making it suitable as a nutrient supplement. The effects of PLBC loadings from 1 to 20 g L−1 on syngas fermentation were determined in 250 ml bottle assays. Results showed that 10 and 20 g L−1 PLBC significantly increased ethanol production compared to standard yeast extract (YE) medium. Fermentations in a 3L continuous stirred tank reactor (CSTR) with 10 g L−1 PLBC with and without 4-morpholineethanesulfonic acid (MES) showed 64% and 36% more ethanol production, respectively, than standard medium. The acetic acid accumulated at the beginning of fermentation was completely converted to ethanol in all media tested in the CSTR. These results demonstrate the feasibility of using PLBC medium without costly MES in the CSTR to enhance ethanol production from syngas for potential use at commercial scale.

Understanding the system of connections between societal contexts and policy outcomes in municipal governments provides important insights into how community sustainability happens, and why it happens differently in various communities. A growing body of research in recent years has focused on understanding the socio-economic characteristics of communities and cities that are recognized as policy leaders in sustainability. In this paper, we expand the focus beyond the leaders in sustainability as we apply a selection of socio-demographic influences of community sustainability to a large sample of U.S. communities using community classification analytics to identity a range of community types and levels of engagement with sustainability. Our typology presents an integrated and comprehensive perspective on the structure of community sustainability in the United States, highlighting key points of comparison between human capital factors such as population size and density, affluence, home ownership, and adoption of sustainability policy. The analysis provides new insights not only about community leaders in sustainability, but also communities with the civic and social capacity to do more, and the challenges that may inhibit sustainability efforts in others.

Energy is consumed at every stage of the cycle of water production, distribution, end use, and recycled water treatment. Understanding the nexus of energy and water may help to minimize energy and water consumption and reduce environmental emissions. However, the interlinkages between water and energy have not received adequate attention. To address this gap, this paper disaggregates and quantifies the energy consumption of the entire water cycle process in Beijing. The results of this study show that total energy consumption by water production, treatment and distribution, end use, and recycled water reuse amounts to 55.6 billion kWh of electricity in 2015, or about 33% of the total urban energy usage. While water supply amount increased by only 10% from 2005 to 2015, the related energy consumption increased by 215% due to water supply structural change. The Beijing municipal government plans to implement many water saving measures in the area from 2016 to 2020, however, these policies will increase energy consumption by 74 million kWh in Beijing. This study responds to the urgent need for research on the synergies between energy and water. In order to achieve the goal of low-energy water utilization in the future, water and energy should be integrated in planning and management.

Electrical submersible pumps (ESPs) are widely used in upstream oil production. The presence of a low concentration solid phase, particle-laden flow, in the production fluid may cause severe damage in the internal sections of the pump which reduces its operating lifetime. To better understand the ESP pump's endurance, two different designs of commonly used mixed flow ESPs were studied numerically to determine the pump's flow behavior at its best efficiency point. Computational fluid dynamics (CFD) analysis was conducted on two stages of one design type of pump's primary flow path employing Eulerian–Granular scheme in ANSYS FLUENT. The key parameters affecting the erosion phenomena within the pump such as turbulence kinetic energy, local sand concentration, and near wall relative sand velocity were identified. The predictive erosion model applicable to pumps was developed by correlating the erosion key parameters with available experimental results. It is concluded that the use of an erosion model on the second design of ESP proves the model's versatility to predict the erosion on different designs of ESPs.

This paper develops a strategy for the continuing and improved supply of woodfuels to urban and industrial consumers in Sub-Sahara Africa. It argues that continued use of these fuels is not only a necessity, but is also in the best economic interest of most of the countries in this region. It shows that intensified and more orderly utilization of woodfuels can help to enhance, rather than impinge upon environmental parameters. Some examples are provided that illustrate how such strategies can be put into practice.

Sustainability has emerged, arguably, as the premiere mission of contemporary architecture. Green assessment tools abound, consultancy services flourish, buildings are marketed on the basis of sustainability performance, and government, media, and corporations seem preoccupied with assessing the quality of the built environment through a green lens. Yet for all the effort, and indeed for all the progress made, fundamental issues resistant to the structural change that is essential for genuine sustainability remain. This paper reviews the state of play of sustainability across the urban landscape. It considers the road travelled so far, and points out some of the major challenges that lie ahead.

We present Vehicle Energy Dataset (VED), a novel large-scale dataset of fuel and energy data collected from 383 personal cars in Ann Arbor, Michigan, USA. This open dataset captures GPS trajectories of vehicles along with their time-series data of fuel, energy, speed, and auxiliary power usage. A diverse fleet consisting of 264 gasoline vehicles, 92 HEVs, and 27 PHEV/EVs drove in real-world from Nov, 2017 to Nov, 2018, where the data were collected through onboard OBD-II loggers. Driving scenarios range from highways to traffic-dense downtown area in various driving conditions and seasons. In total, VED accumulates approximately 374,000 miles. We discuss participant privacy protection and develop a method to de-identify personally identifiable information while preserving the quality of the data. After the de-identification, we conducted case studies on the dataset to investigate the impacts of factors known to affect fuel economy and identify energy-saving opportunities that hybrid-electric vehicles and eco-driving techniques can provide. The case studies are supplemented with a number of examples to demonstrate how VED can be utilized for vehicle energy and behavior studies. Potential research opportunities include data-driven vehicle energy consumption modeling, driver behavior modeling, machine and deep learning, calibration of traffic simulators, optimal route choice modeling, prediction of human driver behaviors, and decision making of self-driving cars. We believe that VED can be an instrumental asset to the development of future automotive technologies. The dataset can be accessed at https://github.com/gsoh/VED. 11 pages, 15 figures

Abstract This paper formulates a model that assesses the economic and policy implications of the adoption and operation of microgrids. The recent climate agreement between the US and China as well as the historic Lima accord on climate change are prompting a massive demand in climate-friendly technologies. Given the increasing demand for electricity and the mounting costs of electricity supply associated with maximizing system performance through an optimal economic scheduling of microgrids, decision makers and policymakers are already facing the problem of sketching energy management strategies for localized operation and grid penetration. We employ a modified Benders' decomposition approach to explore the optimal scheduling of supply from different technology units in the microgrid in the face of supply and demand uncertainties. We guarantee that the power generated by the units meets systemic load while satisfying the primary operational and technological constraints. We implement our model in a quantitative numerical analysis where we investigate the operational regulation in the light of a public environmental policy. We extend prior research on this subject by uncovering a greater reliance on the grid under simultaneous uncertainties in demand and supply. We unlock a strategy for a proper mitigation of the effects of emissions. We find that carbon abatement policy can be used to motivate microgrids operators to invest in fuel cells and natural gas technologies when dealing with uncertainty.