• Energy Research
• Restricted close
• Open Source close
• 12. Responsible consumption close
• PT close
• US close
• PK close

Sustainability assessment and rating systems are intended to foster more sustainable design, construction, operation, maintenance and disassembly/deconstruction promoting and making possible a better integration of environment, societal, and cost concerns with other traditional decision criteria. The use of improved and building technologies can contribute considerably to better environmental cycle and then to the sustainability of the constructions. It is widely recognised in the of Building Sustainability Assessment that Life Cycle Assessment (LCA) is a much preferable method for evaluating the environmental pressure caused by materials, Building assemblies and the whole life-cycle of a building. Nevertheless, LCA tools are not extensively used in building design and most of building sustainability assessment and systems are not comprehensive or consistently LCA-based. Reasons for this failure above all related to the huge variety and amount of material flows and processes of building’s Lifecycle and to the complexity of the stages of a LCA. This paper will present the difficulties and possible solutions to integrate more accurate environmental methods in rating systems. In this context, the paper will also present the work that is being carried out in the development of the Portuguese Building Sustainability Assessment system (SBTool PT)

Abstract This work assesses the impacts of aggressive driving behavior on pollutants emissions and energy consumption at a city level. Furthermore, it performs an economic analysis considering the potential avoided emissions and fuel savings and discusses potential policy measures to address this topic. The results showed that aggressive driving significantly impacts energy consumption and emissions, with energy consumption increasing by more than ∼200% and emissions by 330% for aggressive driving compared to non-aggressive driving (in MJ/km and in g/km, respectively). This increment was found to be even higher for diesel vehicles than for gasoline vehicles. On the contrary, gasoline vehicles showed higher percentages of increase for most emissions (CO, NOx and NO). Results also revealed that aggressive driving impacts are higher for local streets when examining the city level. Moreover, the economic analysis showed that significant cost reductions may be achieved by avoiding aggressive driving, reaching up to 52.5 k€ on a daily basis. In conclusion, this study is of particular relevance to policy makers and urban planners, enabling to obtain a comprehensive overview of the impacts of aggressive driving behaviors at a city level and providing new insights to perform further developments and to assess the feasibility of the implementation of policy measures.

Abstract Portugal’s performance concerning the Refuse Derived Fuel (RDF) strategy, with particular focus on perspectives for the Northern Region based on the current status of integrated municipal waste management systems in that region, was evaluated. Legal documents, official reports and the market were analyzed. The 2015 national installed capacity of waste treatment technologies, from which the high calorific value fraction (HCVF) for RDF production is obtained, is not far from what was predicted for 2013. However, only around 11% of the HCVF had such destiny and the amount of effectively produced RDF was only 30% of the material sent to RDF production (around 30 kt). In Northern Portugal, no RDF production plant was in operation in 2015; the amount of HCVF was estimated to range from 105 to 204 kt for 2015 and around 2.4 times more is expected in 2020. The strategy laydown for RDF failed so far, and thus, low diversion of waste from landfills is observed, mostly due to low landfill taxes and low HCVF quality, resulting in RDF being non-competitive with the imported higher quality product from countries with very high landfilling fees. Moreover, co-incineration and dedicated recovery solutions are scarce. In the Northern region, the HCVF may be treated in the existing municipal waste incinerator or the RDF might be recovered in new dedicated plants, receiving also non-hazardous waste fractions from other origin. Overall, to ensure a sustainable municipal waste management, the intensification of the reuse, preparation for reuse and recycling of waste components from source segregated collection must be significantly promoted.

The olive oil mill wastewater (OMW) is a by-product (with a high organic load) derived from the production of the olive oil. The OMW steam reforming (OMWSR) process was studied herein, aiming to decrease the environmental damage of such effluents; simultaneously, the waste is economically and energetically valorized with the H-2 production. Several Ni-containing catalysts were prepared and tested to compare their performances for the OMWSR using a synthetic OMW effluent; still, stability tests were also carried out. The materials were extensively characterized: thermogravimetric analysis, temperature programmed oxidation/reduction, temperature-programmed desorption of CO2/NH3, chemisorption of H-2, inductively coupled plasma optical emission spectrometry and physical adsorption-desorption of N-2 at-196 & DEG;C. Amongst the materials tested, the Ni-Ru/SiO2 sample stood out, exhibiting high catalytic performance: at 400 & DEG;C, the H-2 yield (> 8 mol(H2)& BULL;mol(OMW)(-1)) and conversion of total organic carbon (asymptotic to 75%) were high during all the 24 h of the long-term test, with only a small deactivation being noticed.

Alternative fuels and energy vectors are becoming increasingly important in terms of technical, geopolitical, economic, and environmental aspects. In particular, gaseous fuels and vectors, such as fossil or synthetic natural gas (NG) blended with hydrogen, commonly help provide optimal strategies to reduce global and toxic emissions of internal combustion engines, owing to their adaptability, anti-knock capacity, lower toxicity of pollutants, reduced CO2 emissions, and costeffectiveness. However, diesel engines still represent the reference category among internal combustion engines in terms of maximum thermodynamic efficiency. The possibility offered by dual-fuel (DF) systems to combine the efficiency and performance of diesel engines with the environmental advantages of gaseous fuels has been the subject of extensive investigations. However, the simple replacement of diesel fuel with gaseous fuel does not allow for optimising the engine performance, owing to the high percentage of unburned gaseous fuel, which compromises the potential reduction of CO2; therefore, more complex combustion strategies should be realised. In this study, with the aim of improving the DF combustion process, an experimental investigation was performed to analyse low-temperature combustion (LTC), using NG and two enriched hydrogen-compressed NG blends as primary fuels. The LTC mode was activated by means of a very early advanced pilot injection and carried out in two close steps. The double pilot injection was used to control the energy release rate in the first combustion stage, thereby minimizing the increase of the rate of pressure and allowing the extension of the operation range under LTC. The experimental activity was also focused on analysing the particle emissions, as it is well known that these emissions, together with those of nitrogen oxide, constitute the main pollutants resulting from diesel fuel combustion. The results demonstrated the potential to reduce the unburned fuel, NOx, and particle emissions simultaneously, while maintaining equivalent CO2 emissions to a diesel-only engine. Both the timing and pressure of the pilot injection proved to be critical parameters for optimising the emissions and performance

Stories play an exceptionally important role in how people assign value to a place. Taken together, all those stories essentially give a place an identity. The aim of placemaking is to ensure that the people using a place can appreciate that place. Placemaking approaches are focussed on strategic interventions in a place and aimed at changing the meaning and value of that place for local people, thus creating a qualitative place for enhanced storytelling. Using greenery is a common approach in place-making. Urban greenery has gone through a process of emancipation in the past 15 years. This emancipation has led to awareness that urban greenery is about more than just ecology and biodiversity, but also has social and economic consequences for a city’s fortunes. It is clear that green spaces do not stand alone: they are part of a complex urban system, and the use of green spaces in this complex system has immediate repercussions for how the city functions. With the changing role of green spaces within cities, the need to manage these spaces is emphasized. In this sense, the place-making approach, along with the storytelling approach could provide valuable insight on the planning and management of green spaces within the urban environment, with the aim to enhance quality of life by means of the social connection between people, the users of the space, and the qualitative place provided. This research illustrated that green space managers would need more social and organizational skills to manage modern urban green spaces in an attempt to create qualitative, usable spaces for citizens, spaces that are built upon stories and spaces that would further enable future stories of citizen life. The Story Behind the Place: Creating Urban Spaces That Enhance Quality of Life (PDF Download Available). Available from: https://www.researchgate.net/publication/271918395_The_Story_Behind_the_Place_Creating_Urban_Spaces_That_Enhance_Quality_of_Life [accessed Dec 21, 2015].

In themediumtolongterm,lowfossilfuelavailabilitywillmakeitnecessarytofindalternatives.Mass productionofbiofuelswillnotbeapracticalsolutionbecauseitrequiresstrongcompetitionforland that isusedforgrowingfood.Therefore,itwillbenecessarytorevisetheframeoftransportation energy sources.Thenumberofpurelight-andheavy-dutyelectricvehiclescouldincreaseinurban areas.Instead,itwillbehardtofindaviablealternativetotheinternalcombustionengineforextra- urban transportvehicles,thereforealternativesyntheticfuelscouldbeusedtocompensateforfossil fuel depletion.Asidefromasmallshareobtainablefrombiomass,mostsyntheticfuelsareexpectedto be obtainedfromcoal.Amongthese,syntheticnaturalgasrepresentsaverygoodsolution.Infact, syntheticnaturalgaswillbeadvantageouswithrespecttohydrogen,whoseon-boardstoragewillbean unsolvedprobleminthemediumterm,andwithrespecttosyntheticliquidfuels,whichrequiremore energy intheproductionphase.Moreover,thecarboncontentofliquidfuels,whichishigherthanthat of gaseousfuels,willberesponsibleforhigherCO2 emissionsfromvehicles.Currently,naturalgashas poor diffusioninthetransportsector,andthispaperhighlightsthemotivationsforfavouringapolicy aimedatincreasingtheshareofgaseousfuel-poweredvehicles.Inadditiontothelowenvironmental impact,syntheticnaturalgasalsooffersthepossibilityofoptimisingtheutilisationoffutureresources

The objective of the present work was: (i) to enable biodiesel production from acid waste lard; (ii) to study the esterification reaction as possible pre-treatment at different temperatures, catalyst amount and reaction times; (iii) to evaluate biodiesel quality according to EN 14214 after basic transesterification of the pre-treated fat; and (iv) to predict the impact of using such waste as raw material in mixture with soybean oil. Temperature and catalyst amount were the most important reaction conditions which mostly affected biodiesel quality, namely viscosity and purity. The selected pre-treatment conditions were 65 degrees C, 2.0 wt% H(2)SO(4) and 5 h, which allowed obtaining a product with a viscosity of 4.81 mm(2) s(-1) and a purity of 99.6 wt%. The proposed pre-treatment was effective to enable acid wastes as single raw materials for biodiesel production with acceptable quality; however, low yields were obtained (65 wt%). Alkali transesterification of a mixture of waste lard and soybean oil resulted in a product with a purity of 99.8 wt% and a yield of 77.8 wt%, showing that blending might be an interesting alternative to recycle such wastes. Also, because in addition to using conventional and relatively economical processes, some biodiesel properties depending on the raw material composition (such as the iodine value) might even be improved.