• Energy Research
• 7. Clean energy close
• 12. Responsible consumption close
• 6. Clean water close
• 2. Zero hunger close
• US close

Characteristics of Tm:YAG ceramic for high efficient 2-μm lasers are analyzed. Efficient diode end-pumped continuous-wave and Q-switched Tm:YAG ceramic lasers are demonstrated. At the absorbed pump power of 53.2W, the maximum continuous wave (cw) output power of 17.2 W around 2016 nm was obtained with the output transmission of 5%. The optical conversion efficiency is 32.3%, corresponding to a slope efficiency of 36.5%. For Q-switched operation, the shortest width of 69 ns was achieved with the pulse repetition frequency of 500 Hz and single pulse energy of 20.4 mJ, which indicates excellent energy storage capability of the Tm:YAG ceramic.

Abstract Molten salt reactors (MSRs) are a class of next-generation nuclear reactors that have received recent industrial and research interest. A generalized species transport solver was implemented in the Virtual Environment for Reactor Applications (VERA) computing suite to extend this tool to analyze liquid-fueled MSRs. This core simulator has been extended to model the transport of fission product gases into a collection of circulating gas bubbles with the purpose of removing the gases. This paper presents the governing species transport equation, along with various nuclear source terms. Development of the source term for phase migration is discussed, along with a simplified interfacial area tracking method. Finally, a case study on a simplified MSR loop is presented in which modeling parameters were varied to assess their impact on gas removal. The steady state results show that parameters such as bubble diameter, gas injection rate and mass transfer coefficient have a low to moderate effect on the fraction of xenon in the core region. Removal efficiency has the greatest effect on the fraction in the core region. After the pump bowl, bubble diameter has a minor effect on the fraction of xenon in the gas void. These results point out that increasing parameters such as mass transfer coefficient, gas injection rate, and removal efficiency drives the xenon into the circulating gas void, while decreasing bubble diameter also drives xenon into the gas void by increasing interfacial area.

Abstract Thermal performance of three naturally ventilated public buildings in which the wind tower is an important architectural freature is studied. One of the three builidings as well as it's wind tower is instrumented for temperature, relative humidity and airflow velocity measurements, and the other two are instrumented for temperature measurement. The results have led to a discussion concerning the degree of wind tower effectiveness in achieving thermal comfort.

Energy is consumed at every stage of the cycle of water production, distribution, end use, and recycled water treatment. Understanding the nexus of energy and water may help to minimize energy and water consumption and reduce environmental emissions. However, the interlinkages between water and energy have not received adequate attention. To address this gap, this paper disaggregates and quantifies the energy consumption of the entire water cycle process in Beijing. The results of this study show that total energy consumption by water production, treatment and distribution, end use, and recycled water reuse amounts to 55.6 billion kWh of electricity in 2015, or about 33% of the total urban energy usage. While water supply amount increased by only 10% from 2005 to 2015, the related energy consumption increased by 215% due to water supply structural change. The Beijing municipal government plans to implement many water saving measures in the area from 2016 to 2020, however, these policies will increase energy consumption by 74 million kWh in Beijing. This study responds to the urgent need for research on the synergies between energy and water. In order to achieve the goal of low-energy water utilization in the future, water and energy should be integrated in planning and management.

As is the case with several other mechanical power takeoffs (PTOs), the mechanical-motion-rectifier-based PTO consists of components, such as one-way clutches, gears, a ball screw, mechanical couplings, and a generator. Equivalent circuit models have been created in this article to describe the dry frictions, viscous damping, and mechanical compliances in these components, so the nonideal efficiency and nonlinear force of the PTO can be predicted in electrical simulations by integrating these subcircuit models. The circuit model is simplified, and its parameters are categorized as dc and ac unknowns. The dc and ac tests on the PTO are performed sequentially to extract two sets of parameters through linear regression or nonlinear curve fitting. Then, the model is validated through its prediction capability over 25 test conditions on input forces, output voltages, and efficiencies, with correlation coefficients of 0.9, 0.98, and 0.981, respectively.

Forest soil acidification caused by acid deposition is a serious threat to the forest ecosystem. To investigate the liming effects of biomass ash (BA) and alkaline slag (AS) on the acidic topsoil and subsoil, a three-year field experiment under artificial Masson pine was conducted at Langxi, Anhui province in Southern China. The surface application of BA and AS significantly increased the soil pH, and thus decreased exchangeable acidity and active Al in the topsoil. Soil exchangeable Ca2+ and Mg2+ in topsoil were significantly increased by the surface application of BA and AS, while an increase in soil exchangeable K+ was only observed in BA treatments. The soil acidity and active Al in subsoil were decreased by the surface application of AS. Compared with the control, soluble monomeric and exchangeable Al in the subsoil was decreased by 38.0% and 29.4% after 3 years of AS surface application. There was a minimal effect on soluble monomeric and exchangeable Al after the application of BA. The soil exchangeable Ca2+ and Mg2+ in the subsoil increased respectively by 54% and 141% after surface application of 10 t ha-1 AS. The decrease of soil active Al and increase of base cations in subsoil were mainly attributed to the high migration capacity of base cations in AS. In conclusion, the effect of surface application of AS was superior to BA in ameliorating soil acidity and alleviating soil Al toxicity in the subsoil of this Ultisol.

AbstractObjective: The marked increase in the prevalence of obesity in the United States has recently been attributed to the increased fructose consumption. To determine if and how fructose might promote obesity in an animal model, we measured body composition, energy intake, energy expenditure, substrate oxidation, and several endocrine parameters related to energy homeostasis in mice consuming fructose.Research Methods and Procedures: We compared the effects of ad libitum access to fructose (15% solution in water), sucrose (10%, popular soft drink), and artificial sweetener (0% calories, popular diet soft drink) on adipogenesis and energy metabolism in mice.Results: Exposure to fructose water increased adiposity, whereas increased fat mass after consumption of soft drinks or diet soft drinks did not reach statistical significance (n = 9 each group). Total intake of energy was unaltered, because mice proportionally reduced their caloric intake from chow. There was a trend toward reduced energy expenditure and increased respiratory quotient, albeit not significant, in the fructose group. Furthermore, fructose produced a hepatic lipid accumulation with a characteristic pericentral pattern.Discussion: These data are compatible with the conclusion that a high intake of fructose selectively enhances adipogenesis, possibly through a shift of substrate use to lipogenesis.

AbstractBio-syngas from gasification of sugarcane bagasse is one of the most promising sources for renewable energy. As an agriculture-based biomass, sugarcane bagasse has a high content of moisture (46-52%), fibrous (43-52%) and low bulk density (80-120kg/m3). This quality of bagasse will tend to initiate agglomeration and cause de-fluidization. It will disturb the gasification process and finally will decrease yield and quality of syn-gas. Its chracteristics in low quality can be improved by pretreatment, i.e., torrefaction process, addressed by slow heating of biomass on wet or dry conditions on atmosphere pressure for 1hour before it is used as feedstock gasification.This preliminary work features an experimental investigation of torrefaction process of Indonesian sugarcane cane bagasse. Temperature of torrefaction varies from 150, 175, 200, 225, 250 and 300°C. For bagasse gasification process, the optimum temperature of dry torrefaction is 150°C. At this temperature, yield of syngas will higher than other torrefaction temperature. Temperature of dry torrefaction will give energy saving opportunities than that's of wet torrefaction (180°C, 1 hr).Analysis ultimate and proximate also indicate that sugarcane bagasse with temperature torrefaction 150°C give better result than other torrefaction's temperature in high content of hydrogen and low content of carbon.