• Energy Research

This study aimed to examine the energy and exergy indices of the rosemary drying process in a hybrid-solar dryer (HSD) and the effects of air-drying parameters on these thermodynamic indices. Drying experiments were carried out at four levels of air temperature (40, 50, 60, and 70 ∘C) and three levels of air velocity (1, 1.5, and 2 m/s). Energy and exergy were calculated by application of the first and second laws of thermodynamics. Based on the principal laws, energy efficiency, exergy losses, and exergetic improvement potential rate, were evaluated. The results showed that the energy utilization ratio (EUR) ranged from 0.246 to 0.502, and energy utilization (EU) ranged from 0.017 to 0.060 (kJ/s). Exergy loss and efficiency varied from 0.009 to 0.028 (kJ/s) and from 35.08% to 78.5%, respectively, and increased with increased temperature and air velocity. It was found that the exergy loss rate was affected by temperature and air velocity because the overall heat transfer coefficient was different under these conditions. By comparison, with increasing temperature and air velocity, the exergy efficiency increased. Because most energy is used to evaporate moisture, this behavior may be explained by improved energy utilization. The drying chamber sustainability index ranged from 0.0129 to 0.0293. This study provides insights into the optimization process of drying operations and operational parameters in solar hybrid dryers that reduce energy losses and consumption.

Abstract The compression and compaction behaviour of bentonite, limestone and microcrystalline cellulose (MCC) — three cohesive powders widely used in industry were studied. Uniaxial compression was performed in a cylindrical die, 40 mm in diameter and 70 mm high, for three selected cohesive powder samples. The initial density, instantaneous density and tablet density were determined. The influence of maximum pressure and deformation rate was examined. The secant modulus of elasticity E sec was calculated as a function of deformation rate v, maximum pressure p and powder sample. After compaction experiments in hydraulic press at three pressures – p = 30, 45 and 60 MPa – and two different deformation rates, the strength of the produced tablets was examined in a material strength testing machine. From uniaxial compression tests performed on the universal testing machine for loading and unloading, the modulus of elasticity E was calculated on the basis of the first linear phase of unloading. The total elastic recovery of tablets was also obtained.