• Energy Research

The paper deals with a single-phase photovoltaic (PV) inverter based on the Cascaded H-Bridge (CHB) topology for Low Voltage (LV) grid. A distributed architecture of PV sources integrated with battery energy storage systems (BESS) is proposed with the particularity of avoiding the use of dc-dc converters. A method of compensating for the short-term daily variability of PV energy is also presented. The control implements power scheduling to ensure that constant active power is fed into the grid at every predetermined time interval (e.g., every quarter of an hour). Furthermore, a dedicated hybrid modulation scheme based on a sorting algorithm for balancing the state of charge (SOC) of the single cells is proposed. Numerical investigations are carried out on a 19-level CHB inverter implemented in a PLECS®(i.e., the simulation platform for power electronic systems from Plexim) environment to validate the feasibility and effectiveness of the proposed control strategy.

Over-temperature occurring in silicon solar panels, subject to partial shadowing, are reduced by means of a series connected voltage divider which sustains part of the reverse voltage developing across the shaded solar cells. The circuit is based on a power MOSFET which is driven by the output voltage of the solar panel. When the solar panel is uniformly illuminated the MOSFET is in the ON state and does not affect the operation of the module, while, when the solar panel is partially shaded, and the output voltage decreases, the MOSFET enters in the pinch-off operation mode, thus subtracting its voltage from the reverse voltage across the shaded cell. Experiments performed on a commercial solar panel showed one third of reduction of the reverse voltage across shaded solar cells, with a reduction of the hot spot temperature of about 25°C.

Residual lifetime estimation has gained a key point among the techniques that improve the reliability and the efficiency of power converters. The main cause of failures are the junction temperature cycles exhibited by switching devices during their normal operation; therefore, reliable power converter lifetime estimation requires the knowledge of the junction temperature time profile. Since on-line dynamic temperature measurements are extremely difficult, in this work an innovative real-time monitoring strategy is proposed, which is capable of estimating the junction temperature profile from the measurement of the dissipated powers through an accurate and compact thermal model of the whole power module. The equations of this model can be easily implemented inside a FPGA, exploiting the control architecture already present in modern power converters. Experimental results on an IGBT power module demonstrate the reliability of the proposed method.

Nowadays, energy is becoming more electrical in each field of engineering application, thus power converters have assumed an increasingly relevant role for electrical machines, renewable energy and transportation systems [...]

In this paper a grid-tied photovoltaic (PV) cascaded H-bridge (CHB) inverter with embedded storage units is proposed. The multi-input single-output inverter architecture allows a distributed maximum power point tracking (DMPPT) approach, thus mitigating the mismatch effects. The energy storage units (ESUs) embedded at each dc-link provides more flexibility to the power circuit compensating for the inherent variability of the PV sources. The proposed power system ensures a continuous power supply to the grid also in case of PV power fluctuations due to irradiance conditions as well as to the MPPT. In particular, the presence of a storage element allows a voltage sweep on the PV source to be implemented, thus guaranteeing the maximization of PV energy harvesting, with no detrimental effect on the power delivery to the utility network. The numerical results, carried out on a single-phase nineteen-level PV CHB inverter, reveal the improved performance of the proposed design and control technique.

The paper deals with design and control of a fault tolerant and reconfigurable photovoltaic converter integrating a Battery Energy Storage System as a standby backup energy resource. When a failure occurs, an appropriate control method makes the energy conversion system capable of operating in open-delta configuration in parallel with the grid as well as in islanded mode. In case network voltage is lacking due to heavy anomalies or maintenance reasons, the proposed control system is able to quickly disconnect the inverter from the grid while ensuring the energy continuity to the local load and the emergency fixtures by means of the integrated battery packs. In particular, the paper proposes a fast islanding detection method essential for the correct operation of the control system. This specific technique is based on the Hilbert transform of the voltage of the point of common coupling, and it identifies the utility lack in a period of time equal to half a grid cycle in the best case (i.e., 10 ms), thus resulting in good speed performance fully meeting the standard requirements. A thorough numerical investigation is carried out with reference to a representative case study in order to demonstrate the feasibility and the effectiveness of the proposed control strategy.

In this paper, a photovoltaic (PV) module-level Cascaded H-Bridge (CHB) inverter with an integrated Battery Energy Storage System (BESS) is proposed. The advantages and drawbacks of the CHB circuit architecture in distributed PV generation systems are highlighted. The main benefits are related to the higher granularity of the PV power control, which mitigates mismatch effects, thus increasing the power harvesting. Nevertheless, heavy unbalanced configurations due to the intermittent nature of PV sources need to be properly addressed. In order to smooth the PV fluctuations, a Battery Energy Storage System is used to provide both an energy buffer and coordination of power supply and demand to obtain a flat profile of the output power. In particular, by exploiting the inherent modularity of the conversion circuit, a distributed storage system is also implemented by splitting the battery into smaller units each of which represents the backup module of a single power cell of the PV CHB. The proposed design and control strategy allows overcoming the operating limits of PV CHB inverter. Simulation results, carried out on a single-phase nineteen-level PV CHB inverter, evidence the effectiveness of the proposed design and control approach to minimize the adverse impact of deep mismatch conditions, thus enabling continuous power output by compensating PV power fluctuations.