• Energy Research

Parallel heat flux calculations at the JET divertor have been based on the assumption that all incoming heat is due to the projection of the heat flux parallel to the magnetic line, q , plus a constant background. This simplification led to inconsistencies during the analysis of a series of dedicated tungsten melting experiments performed in 2013, for which infrared (IR) thermography surface measurements could not be recreated through simulations unless the parallel heat flux was reduced by 80% for L-mode and 60% for H-mode. We give an explanation for these differences using a new IR inverse analysis code, a set of geometrical corrections, and most importantly an additional term for the divertor heat flux accounting for non-parallel effects such as cross-field transport, recycled neutrals or charge exchange. This component has been evaluated comparing four different geometries with impinging angles varying from 2 to 90°. Its magnitude corresponds to 1.2%–1.9% of q , but because it is not affected by the magnetic projection, it accounts for up to 20%–30% of the tile surface heat flux. The geometrical corrections imply a further reduction of 24% of the measured heat flux. In addition, the application of the new inverse code increases the accuracy of the tile heat flux calculation, eliminating any previous discrepancy. The parallel heat flux computed with this new model is actually much lower than previously deduced by inverse analysis of IR temperatures—40% for L-mode and 50% for H-mode—while being independent of the geometry on which it is measured. This main result confirms the validity of the optical projection as long as a non-constant and non-parallel component is considered. For a given total heating power, the model predicts over 10% reduction of the maximum tile surface heat flux compared to strict optical modelling, as well as a 30% reduced sensitivity to manufacturing and assembling tolerances. These conclusions, along with the improvement in the predictability of the divertor thermal behaviour, are critical for JET future DT operations, and are also directly applicable to the design of the ITER divertor monoblocks. EURATOM 633053

Effects of the spatial chanelling (SC) of the energy of fusion-produced alpha particles - the spatial transfer of the energy of fast ions by destabilized eigenmodes and delivering this energy to bulk plasma particles (Kolesnichenko et al 2010 Phys. Rev. Lett. 104 075001) - on the plasma performance is studied. Analysis is carried out in the assumption that alpha particles located in the peripheral region of the plasma destabilize multiple fast magnetoacoustic modes (FMM) having global radial structure. The FMM with the frequencies close to cyclotron harmonics of alpha particles are considered. It is found that these FMM can be in resonance with the bulk plasma ions and electrons located in the central region of the plasma, delivering the alpha energy to this region. This improves the overall plasma confinement. In addition, it leads to anomalous ion heating when the ion damping of FMM exceeds the electron one. The damping rates of the considered waves are calculated. It is shown that reasonably small amplitude waves can receive and transfer across the flux surfaces as large power density as that required for spatial channelling of a considerable part of fusion energy. The developed theory of the inward spatial channelling is applied to JET experiments carried out during the deuterium-tritium-experiment campaign (DTE1), where presumably anomalous ion heating and improvement of the plasma confinement took place.

Tritium (T) distributions on tungsten (W)-coated plasma-facing tiles used in the third ITER-like wall campaign (2015–2016) of the Joint European Torus (JET) were examined by means of an imaging plate technique and β-ray induced x-ray spectrometry, and they were compared with the distributions after the second (2013–2014) campaign. Strong enrichment of T in beryllium (Be) deposition layers was observed after the second campaign. In contrast, T distributions after the third campaign was more uniform though Be deposition layers were visually recognized. The one of the possible explanations is enhanced desorption of T from Be deposition layers due to higher tile temperatures caused by higher energy input in the third campaign.