• Energy Research
• Restricted close
• 13. Climate action close
• 8. Economic growth close
• 1. No poverty close

The aim of this report is to demonstrate and evaluate the potential of tall wheatgrass (Elytrigia elongata) to avoid GHG emissions and obtain lower economic costs in marginal areas of Spain. Our research built scenarios based on experimental plots (2 and 3 years growth) in 3 locations of Spain with completely different climate conditions (provinces of Girona, Soria and Palencia). In our experiences, we achieved an adequate establishment and biomass production, and assumed a rank of biomass yields until the end of the life cycle that is usually accepted to be about 15 years in many other studies in United States, Argentina and Eastern Europe where tall wheatgrass is extensively cultivated in marginal areas for sheep livestock production. Using our experimental plots and statistical information for economic inputs costs, we built 5 different scenarios per region considering a large range of biomass yields of tall wheatgrass. The analysis included a comparison with annual grasses economic costs calculated for a wide range of biomass yields of a previous study. We estimated GHG emissions savings for tall wheatgrasses and used our previous study (which had GHG emissions savings as well). Savings were calculated replacing natural gas electricity with electricity from biomass combustion in real power plants in Spain. In a wide range of yields, the results suggest that marginal areas might present a better performance with tall wheatgrass compared to annual winter grasses (cereals whole plant cuttings), thus producing biomass yields with higher GHG savings and lower economic costs at the farm level. Proceedings of the 20th European Biomass Conference and Exhibition, 18-22 June 2012, Milan, Italy, pp. 217-229

Biomass is considered one of the most important options in the transition to a sustainable energy system with reduced greenhouse gas (GHG) emissions and increased security of enegry supply. In order to facilitate this transition with targeted policies and implementation strategies, it is of vital importance to understand the economic benefits, uncertainties and risks of this transition. This article presents a quantification of the economic impacts on value added, employment shares and the trade balance as well as required biomass and avoided primary energy and greenhouse gases related to large scale biomass deployment on a country level (the Netherlands) for different future scenarios to 2030. This is done by using the macro-economic computable general equilibrium (CGE) model LEITAP, capable of quantifying direct and indirect effects of a bio-based economy combined with a spread sheet tool to address underlying technological details. Although the combined approach has limitations, the results of the projections show that substitution of fossil energy carriers by biomass, could have positive economic effects, as well as reducing GHG emissions and fossil energy requirement. Key factors to achieve these targets are enhanced technological development and the import of sustainable biomass resources to the Netherlands. (C) 2013 Elsevier Ltd. All rights reserved.

In this study, air concentrations of BaP in two different seasons (winter 2015 and summer 2016) and BaP levels in ground vegetation from Tarragona County were used as control simulations performed with the WRF-CHIMERE air quality modelling system, in order to reproduce the incidence of that hazardous chemical in air and soils. The CTM was validated for the present climatology, showing a good ability to represent air and soil concentrations of BaP over the target domain (petrochemical, chemical, urban and background sites), particularly in the winter. Then, the variation of the BaP concentrations in air and soils were simulated for the time series 1996-2015 and for the climate change scenario RCP8.5 (2031-2050). While an increase is projected for the levels in air, particularly in chemical and remote sites where the variation can go up to 10%, in terms of soil deposition the findings are the opposite, with an evident decrease in soil BaP concentrations, particularly for background sites. Finally, a potential health effect of BaP for the local population (lung cancer) was assessed. Although according to the projections the EU threshold for BaP atmospheric incidence (1 ng m-3) will not be reached by 2050, there will be an increase in the life-time risk of lung cancer, particularly in the most populated areas within the simulation domain.

Abstract Portugal’s performance concerning the Refuse Derived Fuel (RDF) strategy, with particular focus on perspectives for the Northern Region based on the current status of integrated municipal waste management systems in that region, was evaluated. Legal documents, official reports and the market were analyzed. The 2015 national installed capacity of waste treatment technologies, from which the high calorific value fraction (HCVF) for RDF production is obtained, is not far from what was predicted for 2013. However, only around 11% of the HCVF had such destiny and the amount of effectively produced RDF was only 30% of the material sent to RDF production (around 30 kt). In Northern Portugal, no RDF production plant was in operation in 2015; the amount of HCVF was estimated to range from 105 to 204 kt for 2015 and around 2.4 times more is expected in 2020. The strategy laydown for RDF failed so far, and thus, low diversion of waste from landfills is observed, mostly due to low landfill taxes and low HCVF quality, resulting in RDF being non-competitive with the imported higher quality product from countries with very high landfilling fees. Moreover, co-incineration and dedicated recovery solutions are scarce. In the Northern region, the HCVF may be treated in the existing municipal waste incinerator or the RDF might be recovered in new dedicated plants, receiving also non-hazardous waste fractions from other origin. Overall, to ensure a sustainable municipal waste management, the intensification of the reuse, preparation for reuse and recycling of waste components from source segregated collection must be significantly promoted.

Alternative fuels and energy vectors are becoming increasingly important in terms of technical, geopolitical, economic, and environmental aspects. In particular, gaseous fuels and vectors, such as fossil or synthetic natural gas (NG) blended with hydrogen, commonly help provide optimal strategies to reduce global and toxic emissions of internal combustion engines, owing to their adaptability, anti-knock capacity, lower toxicity of pollutants, reduced CO2 emissions, and costeffectiveness. However, diesel engines still represent the reference category among internal combustion engines in terms of maximum thermodynamic efficiency. The possibility offered by dual-fuel (DF) systems to combine the efficiency and performance of diesel engines with the environmental advantages of gaseous fuels has been the subject of extensive investigations. However, the simple replacement of diesel fuel with gaseous fuel does not allow for optimising the engine performance, owing to the high percentage of unburned gaseous fuel, which compromises the potential reduction of CO2; therefore, more complex combustion strategies should be realised. In this study, with the aim of improving the DF combustion process, an experimental investigation was performed to analyse low-temperature combustion (LTC), using NG and two enriched hydrogen-compressed NG blends as primary fuels. The LTC mode was activated by means of a very early advanced pilot injection and carried out in two close steps. The double pilot injection was used to control the energy release rate in the first combustion stage, thereby minimizing the increase of the rate of pressure and allowing the extension of the operation range under LTC. The experimental activity was also focused on analysing the particle emissions, as it is well known that these emissions, together with those of nitrogen oxide, constitute the main pollutants resulting from diesel fuel combustion. The results demonstrated the potential to reduce the unburned fuel, NOx, and particle emissions simultaneously, while maintaining equivalent CO2 emissions to a diesel-only engine. Both the timing and pressure of the pilot injection proved to be critical parameters for optimising the emissions and performance

Landfill gas (LFG) tends to escape from the landfill surface even when LFG collecting systems are installed. Since LFG leaks are generally a noticeable percentage of the total production of LFG, the optimisation of the collection system is a fundamental step for both energy recovery and environmental impact mitigation. In this work, we suggest to take into account the results of direct measurements of gas fluxes at the air-cover interface to achieve this goal.During the last 5 years (2004-2009), 11 soil gas emission surveys have been carried out at the Municipal Solid Waste landfill of Legoli (Peccioli municipality, Pisa Province, Italy) by means of the accumulation chamber method. Direct and simultaneous measurements of CH(4) and CO(2) fluxes from the landfill cover (about 140,000 m(2)) have been performed to estimate the total output of both gases discharged into the atmosphere. Three different data processing have been applied and compared: Arithmetic mean of raw data (AMRD), sequential Gaussian conditional simulations (SGCS) and turning bands conditional simulations (TBCS). The total amount of LFG (captured and not captured) obtained from processing of direct measurements has been compared with the corresponding outcomes of three different numerical models (LandGEM, IPCC waste model and GasSim).Measured fluxes vary from undetectable values (<0.05 mol m(-2) day(-1) for CH(4) and <0.02 mol m(-2) day(-1) for CO(2)) to 246 mol m(-2) day(-1) for CH(4) and 275 mol m(-2) day(-1) for CO(2). The specific CH(4) and CO(2) fluxes (flux per surface unit) vary from 1.8 to 7.9 mol m(-2) day(-1) and from 2.4 to 7.8 mol m(-2) day(-1), respectively.The three different estimation methodologies (AMRD, SGCS and TBCS) used to evaluate the total output of diffused CO(2) and CH(4) fluxes from soil provide similar estimations, whereas there are some mismatches between these results and those of numerical LFG production models. Isoflux maps show a non-uniform spatial distribution, with high-flux zones not always corresponding with high-temperature areas shown by thermographic images.The average value estimated over the 5-year period for the Legoli landfill is 245 mol min(-1) for CH(4) and 379 mol min(-1) for CO(2), whereas the volume percentage of CH(4) in the total gas discharged into the atmosphere varies from 29% to 51%, with a mean value of 39%. The estimated yearly emissions from the landfill cover is about 1.29 x 10(8) mol annum(-1) (2,100 t year(-1)) of CH(4) and 1.99 x 10(8) mol annum(-1) (8,800 t year(-1)) of CO(2). Considering that the CH(4) global warming potential is 63 times greater than that of CO(2) (20 a time horizon, Lashof and Ahuja 1990), the emission of methane corresponds to 130,000 t annum(-1) of CO(2).The importance of these studies is to provide data for the worldwide inventory of CH(4) and CO(2) emissions from landfills, with the ultimate aim of determining the contribution of waste disposal to global warming. This kind of studies could be extended to other gas species, like the volatile organic compounds.

The drought prone North-West Bangladesh is vulnerable to the impacts of climate change, particularly because of less water availability in the dry period and high water requirement for crop production. Improved understanding of recent changes in crop water demand in the dry season is important for the water resources management in the region. A study was carried out to determine the potential impacts of recent climate change during last three decades on trends of water requirements of Boro rice. The reference crop evapotranspiration (ETo), potential crop water requirement (∑ETC), effective rainfall during the crop growing period (ER), potential irrigation requirement for crop evapotranspiration (∑ETC − ER) and net irrigation requirement of Boro rice were estimated using observed daily climate data in the CropWat model for the period of 1980 to 2013 for four North-West districts. Significant decreasing trends of ETo were observed in most of the dry months due to increasing relative humidity and decreasing wind-speed and sun-shine hours. The results showed decreasing trends of potential crop water requirement, i.e. the total crop evapotranspiration (∑ETC), of Boro rice due to decreasing reference crop evapotranspiration and shorter crop growing periods. The variations in trends of potential irrigation requirement for crop evapotranspiration (∑ETC − ER) found among different districts, are mainly linked to variations in trends of changes in effective rainfall. The net irrigation requirement of Boro rice has decreased, by 11% during the last three decades at an average rate of −4.4 mm year−1, instead of decreasing effective rainfall, mainly because of high rate of decrease of crop evapotranspiration (−5.9 mm year−1). Results indicate that a warming climate does not always result in higher agricultural water use and that climate change can also result in reduced water demands because of changes in humidity, wind-speed and sun-shine hours.

MILD combustion is a very attractive technology in energy production from diluted gas deriving from bio or thermochemical degradation of biomass for its intrinsic features. An effective use of such a technology for diluted fuel needs a thorough analysis of ignition and oxidation behavior to highlight the potential effects of the different fuel components on the basis of temperature and diluent/oxygen/fuel mixture composition. In this work ignition and oxidation of a model gas surrogating the gaseous fraction of biomass pyrolysis products containing C1-C2 species, CO and CO2 were experimentally and numerically studied in a wide range of temperature and overall composition in presence of large amount of CO2 or H2O. Experimental results showed that such species significantly alter the evolution of the ignition process in dependence on temperature range and mixture composition. Several kinetic models were tested to simulate experimental results. Significant discrepancies occur especially in case of steam dilution. Numerical analyses suggest that such diluents mainly act as third body species at low temperatures, conditioning both radicals production pathways and the relative weight of C1 oxidation/recombination routes, while strongly interact with the H2/O2 high temperature branching mechanisms at high temperatures. Further analyses are mandatory to improve the model ability to reduce the discrepancy between numerical and experimental data obtained in non standard conditions.