• Energy Research
• Closed Access close

Abstract The amount of installed solar power in Finland is increasing as a result of decreasing photovoltaic (PV) system component prices. The growth is especially noticeable in residential systems, and ways to make PV electricity a more competitive choice for Finnish residents are studied. One of these ways is to decrease the solar PV electricity production costs by decreasing the investment costs by undersizing the inverter of the PV system. The objective of undersizing is to find the optimal array-to-inverter sizing ratio (AISR) where the ratio of the economic loss from the clipped energy to the economic gain from the decreased system investment achieved by an undersized inverter is lowest. In this paper, the economically most optimal AISRs are determined for different residential array sizes, orientations, and inclinations when operating in Finnish locations and conditions. Calculations for each inverter size are carried out by using recorded Finnish meteorological data and the current Finnish PV system cost distribution, and by analyzing existing 1-s resolution production measurement data of a Finnish PV system. It is concluded that it is necessary to use 1-s resolution data as the use of 1-h resolution production data would lead to more significant undersizing caused by the power clipping occurring within an hour. The optimal AISRs presented in this study are higher than the optimal ratios reported in previous studies for locations further south than Finland. This can be explained by the northern location of Finland, where the irradiance above Standard Test Conditions (STC) is lower than in central Europe, for example. This allows more significant undersizing as less energy is clipped even at higher ratios. In the case of south-oriented arrays in a 30° installation angle, the optimal AISRs for the 10 kW, 6 kW, and 3 kW inverters were 1.6, 1.8, and 2.08, respectively. Again, the AISRs for the southwest-southeast facade installations were 1.8, 1.9, and 2.17 for the inverters under study. They do not clip the produced energy as much as rooftop systems because their production is more evenly distributed throughout the day, yet they do not achieve as low production costs either. It is pointed out that if the PV self-consumption is optimized by using PV to heat water or batteries as a storage, limitation of the PV generation might not be the correct solution.

The effect of the combined application of nano-hydroxyapatite (NHAP) or nano-carbon black (NCB) on the phytoextraction of Pb by ryegrass was investigated as an enhanced remediation technique for soils by field-scale experiment. After the addition of 0.2% NHAP or NCB to the soil, temporal variation of the uptake of Pb in aboveground parts and roots were observed. Ryegrass shoot concentrations of Pb were lower with nano-materials application than without nano-materials for the first month. However, the shoot concentrations of Pb were significantly increased with nano-materials application, in particular NHAP groups. The ryegrass root concentrations of Pb were lower with nano-materials application for the first month. These results indicated that nano-materials had significant effects on stabilization of lead, especially at the beginning of the experiment. Along with the experimental proceeding, phytotoxicity was alleviated after the incorporation of nano-materials. The ryegrass biomass was significantly higher with nano-materials application. Consequently, the Pb phytoextraction potential of ryegrass significantly increased with nano-materials application compared to the gounps without nano-materials application. The total removal rates of soil Pb were higher after combined application of NHAP than NCB. NHAP is more suitable than NCB for in-situ remediation of Pb-contaminated soils. The ryegrass translocation factor exhibited a marked increase with time. It was thought that the major role of NHP and NBA might be to alleviate the Pb phytotoxicity and increase biomass of plants.

Abstract This study investigates the possibility of using and developing hydrokinetic power to supply reliable, affordable and sustainable electricity to rural, remote and isolated loads in rural South Africa where reasonable water resource is available. Simulations are performed using the Hybrid Optimization Model for Electric Renewable (HOMER) and the results are compared to those from other supply options such as standalone Photovoltaic system (PV), wind, diesel generator (DG) and grid extension. Finally the paper points out some major challenges that are facing the development of this technology in South Africa.

Abstract Day-ahead forecasts of direct normal irradiance (DNI) from the Integrated Forecasting System (IFS), the global model of the European Centre for Medium-Range Weather Forecasts (ECMWF), are used to simulate a concentrating solar power (CSP) plant through the System Advisor Model (SAM) to assess the potential value of the IFS in the electricity market. Although DNI forecasting from the IFS still demands advances towards cloud and aerosol representation, present results show substantial improvements with the new operational radiative scheme ecRad (cycle 43R3). A relative difference of approximately 0.12% for the total annual energy availability is found between forecasts and local measurements, while approximately 10.6% is obtained for the previous version. Results of electric energy injection to the grid from a simulated linear focus parabolic-trough system shows correlations coefficients of approximately 0.87 between hourly values of electric energy based on forecasted and measured DNI, while 0.92 are obtained for the daily values. In the context of control strategy, four operational strategies are given for different weather scenarios to handle the energy management of a CSP plant, including the effect of thermal energy storage capacity. Charge and discharge operational strategies are applied accordingly to the predicted energy availability.

Crop cultivation in greenhouses under semi-arid climatic conditions is subject to various stresses, in particular during the winter season at night, when the interior air is poorly controlled, leading to prolonged periods of low temperature. The aim is then to evaluate and control the heat exchanges of the enclosure in order to prevent low indoor air temperatures and reduce the thermal load of the greenhouse. The objectives of this study are to investigate the convective and radiative heat exchanges at the cover in order to establish new correlations for the convective heat transfer coefficients in semi arid regions. The climatic parameters were measured inside and outside a closed empty glasshouse without crop, for three different nights during the winter season in the semi-arid land of Algeria. A physical model for analysing the convective heat transfers was implemented, and new correlations were established, parameterised, calibrated and validated thoroughly. A significant difference was observed between the correlations obtained by this study and the models obtained for other greenhouse designs under different climatic conditions. Results show that the convection mode along the inside wall of the cover is free turbulent. Conversely, the convection mode along the outside greenhouse cover remains forced turbulent. A consistent performance of the correlations was observed, both in the calibration and validation stages.

Poria cocos (Schw.) Wolf, an important medicinal and food fungus, is well known in East Asia. Due to growing market demand, long cultivation period, and consumption of pine trunk during cultivation, developing alternative methods for producing P. cocos and/or its active components is of interest. In the present study, the effects of different culture methods on biomass and accumulation of four triterpenoids were investigated. The ethanol extract of fermented mycelium (EFM) was orally administered to rats. Urine output and concentrations of electrolytes (Na+, K+, and Cl-) were measured. Our results showed that mycelia grew better under continuous shaking culture condition (7.5 g DW·L-1), and higher triterpenoid levels were accumulated in two-stage culture (112 mg·L-1, 2.03%). The optimal starting time of static culture for triterpenoid yield was 4th d after shaking culture. Single administration of middle and high dose of EFM significantly increased urine output, Na+ and Cl- excretion, and Na+/K+ ratio. These results suggested that ethanol extract of cultured mycelia showed significant diuretic activity in rats and two-stage culture of P. cocos could be an alternative way to produce mycelia and triterpenoids.

Abstract Egg yolk-derived P and N dual doped nano carbon capsules (PNCCs) have been synthesized and used as lithium ion battery anodes. The application of egg yolk as the carbon source is a new and environmental-friendly approach for biomass recycling. The reversible capacity of half cells made of PNCCs is as high as ~770 mA h g−1 at a current density of 0.5 A g−1 with considerable rate capacity and cycling stability. PNCCs show a capsule-like structure, which provide extra edges and active sites for lithium intercalation. The heteroatom doping also introduce defects and disorder, which increases the electrochemical activity and creates more active sites for lithium insertion.

This study aims to introduce, conceptualize, and design a novel biomass/gasification-driven hybrid energy configuration. The proposed hybrid configuration has four subsystems: reformer solid oxide fuel cell (RSOFC), biomass/gasification, homogeneous charge compression ignition engine (HCCIE) plus waste heat recovery system (WHRS). RSOFC and HCCIE systems are embedded to generate electric energy. The syngas required for these two subsystems is captured from the biomass/gasification subsystem. In addition to generating electrical energy, fuel cell is responsible for providing combustible fuel to the HCCIE subsystem. The embedded engine in the system can improve the proposed configuration efficiency by increasing the rate of electrical energy production. In addition, the dissipated heat of fuel cell and engine subsystems is recovered by WHRS. The proposed energy configuration is evaluated and discussed from energetically, exergetically and exergoeconomic and environmental aspects to obtain a comprehensive feasibility study of the plant. The offered hybrid design has new component's structure and relationships that have not been reported in the publications. The analysis indicated that the proposed hybrid configuration is capable of generating approximately 1100 kW and 366.3 W of electric and thermal power, respectively, with the overall energetic and exergetic efficiencies of 69.4% and 52.1%. Exergoeconomic analysis results revealed that the specific fuel cost of the total proposed configuration was approximately 1.96 USD per GJ. In addition, compared to a coal and petroleum oil-based power generation plants, the proposed hybrid configuration can have approximately 2.75-fold and 97.7% lower CO2 emissions, sequentially. Besides, the proposed system can rival other similar biomass-driven designs.