• Energy Research
• Restricted close
• Open Source close
• Embargo close
• 13. Climate action close
• 7. Clean energy close
• European Marine Science close

This study highlights how Chinese economic development detrimentally impacted water quality in recent decades and how this has been improved by enormous investment in environmental remediation funded by the Chinese government. To our knowledge, this study is the first to describe the variability of surface water quality in inland waters in China, the affecting drivers behind the changes, and how the government-financed conservation actions have impacted water quality. Water quality was found to be poorest in the North and the Northeast China Plain where there is greater coverage of developed land (cities + cropland), a higher gross domestic product (GDP), and higher population density. There are significant positive relationships between the concentration of the annual mean chemical oxygen demand (COD) and the percentage of developed land use (cities + cropland), GDP, and population density in the individual watersheds (p < 0.001). During the past decade, following Chinese government-financed investments in environmental restoration and reforestation, the water quality of Chinese inland waters has improved markedly, which is particularly evident from the significant and exponentially decreasing GDP-normalized COD and ammonium (NH4+-N) concentrations. It is evident that the increasing GDP in China over the past decade did not occur at the continued expense of its inland water ecosystems. This offers hope for the future, also for other industrializing countries, that with appropriate environmental investments a high GDP can be reached and maintained, while simultaneously preserving inland aquatic ecosystems, particularly through management of sewage discharge.

Abstract The kinetics of methane hydrate decomposition was studied using a semibatch stirred-tank reactor. The decomposition was accomplished by reducing the pressure on a hydrate slurry in water to a value below the three-phase equilibrium pressure at the reactor temperature. The data were obtained at temperatures from 274 to 283 K and pressures from 0.17 to 6.97 MPa. The stirring rates were high enough to eliminate mass-transfer effects. Analysis of the data indicated that the decomposition rate was proportional to the particle surface area and to the difference in the fugacity of methane at the equilibrium pressure and the decomposition pressure. The proportionality constant showed an Arrhenius temperature dependence. An estimate of the hydrate particle diameters in the experiments permitted the development of an intrinsic model for the kinetics of hydrate decomposition.

AbstractExtreme weather events can have strong negative impacts on species survival and community structure when surpassing lethal thresholds. Extreme, short‐lived, winter warming events in the Arctic rapidly melt snow and expose ecosystems to unseasonably warm air (for instance, 2–10 °C for 2–14 days) but upon return to normal winter climate exposes the ecosystem to much colder temperatures due to the loss of insulating snow. Single events have been shown to reduce plant reproduction and increase shoot mortality, but impacts of multiple events are little understood as are the broader impacts on community structure, growth, carbon balance, and nutrient cycling. To address these issues, we simulated week‐long extreme winter warming events – using infrared heating lamps and soil warming cables – for 3 consecutive years in a sub‐Arctic heathland dominated by the dwarf shrubsEmpetrum hermaphroditum, Vaccinium vitis‐idaea(both evergreen) andVaccinium myrtillus(deciduous). During the growing seasons after the second and third winter event, spring bud burst was delayed by up to a week forE. hermaphroditumandV. myrtillus, and berry production reduced by 11–75% and 52–95% forE. hermaphroditumandV. myrtillus, respectively. Greater shoot mortality occurred inE. hermaphroditum(up to 52%),V. vitis‐idaea(51%), andV. myrtillus(80%). Root growth was reduced by more than 25% but soil nutrient availability remained unaffected. Gross primary productivity was reduced by more than 50% in the summer following the third simulation. Overall, the extent of damage was considerable, and critically plant responses were opposite in direction to the increased growth seen in long‐term summer warming simulations and the ‘greening’ seen for some arctic regions. Given the Arctic is warming more in winter than summer, and extreme events are predicted to become more frequent, this generates large uncertainty in our current understanding of arctic ecosystem responses to climate change.

As the largest renewable electricity source, hydropower represents an alternative to fossil fuels to achieve a low-carbon future. However, increasing evidence suggests that hydropower reservoirs are an important source of biogenic greenhouse gases (GHGs), albeit with large uncertainties. Combining spatially resolved assessments of GHG fluxes and hydroelectric capacity databases, we assessed that global GHG emissions from reservoirs is 0.38 Pg CO2 eq.yr−1, accounting for 1.0% of global anthropogenic emissions. The median carbon intensity for hydropower is ∼63.0 kg CO2eq. MWh−1, which is lower than that for fossil fuels, but higher than that for other renewable energy sources. High carbon intensity is mostly linked to shallow (water storage depth <20 m) and eutrophic reservoirs. Furthermore, we found that the reservoir carbon intensity (CI) value would be markedly increased to 131.5 kg CO2eq. MWh−1 when considering the dams under construction and planning. A low-carbon future will benefit from optimal dam planning and management measures, i.e., applying sludge removal treatments, thereby reducing the proportion of shallow reservoirs and anthropogenic pollution.

Sea spray aerosol (SSA) emission is a complex process affected by various controlling factors. This work seeks to deconvolute some of this complexity in a controlled laboratory setting using a plunging jet by varying three key parameters, one at a time: (1) air entrainment rate, (2) seawater temperature, and (3) biomass of phytoplankton. The production of SSA is found to vary linearly with air entrainment rate. By normalizing the production flux to air entrainment rate, we observe nonlinear variation of the production efficiency of SSA with seawater temperature with a minimum around 6-10 °C. For comparison, SSA was also generated by detraining air into artificial seawater using a diffuser demonstrating that the production efficiency of SSA generated using a diffuser decreases almost linearly with increasing seawater temperature, and the production efficiency is significantly higher than that for SSA generated using a plunging jet. Finally, by varying the amount of phytoplankton biomass we demonstrate that SSA particle production varies nonlinearly with the amount of biomass in seawater.

Current policies of habitat conservation, recovery, and management are strongly biased in favour of terrestrial systems, being poorly applicable to marine environments. A sound habitat classification, leading to spatially explicit accounts on the distribution of marine habitats and communities, is a prerequisite to identify conservation priorities, based on appropriate methods for assessing habitat sensitivity to human disturbance, aimed at preventing habitat loss. The ten major European marine habitat classifications, recognizing a total of 1121 marine habitats, have been here revised, and their major differences have been formally tested in terms of multivariate dissimilarity. Mediterranean-based classifications resulted rather uniform, their habitats forming a separate cluster from the rest of European ones; these differences might be due to either distinct ecological features, or to divergences in the way habitats are classified. Either too vague or too detailed classifications, leading to cumbersome appreciations of biodiversity at habitat level, fail to provide proper tools for the conservation and management of marine environments. Different species assemblages can inhabit the same habitat type, representing the well-know natural variability that, at large scale, should not affect the appreciation of habitat distribution. Intra-habitat natural variability, in fact, causes a misleading qualitative interpretation of small-scale biodiversity distribution. Mediterranean classifications have been integrated and simplified by identifying habitats according to explicit criteria: level on the shore, type of primary substrate, presence of bioconstructors, presence of habitat formers, presence of ecosystem engineers. The motivating idea is to limit the current emphasis on spatial dominance as the only criteria for the introduction of species, assemblages, and habitats in the lists, towards a clearer recognition of the structural and functional role of biodiversity. The reduction of previous classifications to a list of 94 Mediterranean marine habitat types represents an initial attempt at providing a simple and flexible tool for the evaluation of biodiversity at habitat level, leading to more feasible conservation measures, potentially extendable at European scale. (C) 2008 Elsevier B.V. All rights reserved. Current policies of habitat conservation, recovery, and management are strongly biased in favour of terrestrial systems, being poorly applicable to marine environments. A sound habitat classification, leading to spatially explicit accounts on the distribution of marine habitats and communities, is a prerequisite to identify conservation priorities, based on appropriate methods for assessing habitat sensitivity to human disturbance, aimed at preventing habitat loss. The ten major European marine habitat classifications, recognizing a total of 1121 marine habitats, have been here revised, and their major differences have been formally tested in terms of multivariate dissimilarity. Mediterranean-based classifications resulted rather uniform, their habitats forming a separate cluster from the rest of European ones; these differences might be due to either distinct ecological features, or to divergences in the way habitats are classified. Either too vague or too detailed classifications, leading to cumbersome appreciations of biodiversity at habitat level, fail to provide proper tools for the conservation and management of marine environments. Different species assemblages can inhabit the same habitat type, representing the well-know natural variability that, at large scale, should not affect the appreciation of habitat distribution. Intra-habitat natural variability, in fact, causes a misleading qualitative interpretation of small-scale biodiversity distribution. Mediterranean classifications have been integrated and simplified by identifying habitats according to explicit criteria: level on the shore, type of primary substrate, presence of bioconstructors, presence of habitat formers, presence of ecosystem engineers. The motivating idea is to limit the current emphasis on spatial dominance as the only criteria for the introduction of species, assemblages, and habitats in the lists, towards a clearer recognition of the structural and functional role of biodiversity. The reduction of previous classifications to a list of 94 Mediterranean marine habitat types represents an initial attempt at providing a simple and flexible tool for the evaluation of biodiversity at habitat level, leading to more feasible conservation measures, potentially extendable at European scale.

In the present work, a facile method to prepare translucent anatase thin films on cellulose acetate monolithic (CAM) structures was developed. A simple sol-gel method was applied to synthesize photoactive TiO2 anatase nanoparticles using tetra-n-butyl titanium as precursor. The immobilization of the photocatalyst on CAM structures was performed by a simple dip-coating method. The translucent anatase thin films allow the UV light penetration through the CAM internal walls. The photocatalytic activity was tested on the degradation of n-decane (model volatile organic compound-VOC) in gas phase, using a tubular lab-scale (irradiated by simulated solar light) and pilot-scale (irradiated by natural solar light or UVA light) reactors packed with TiO2-CAM structures, both equipped with compound parabolic collectors (CPCs). The efficiency of the photocatalytic oxidation (PCO) process in the degradation of n-decane molecules was studied at different operating conditions at lab-scale, such as catalytic bed size (40-160 cm), TiO2 film thickness (0.435-0.869 μm), feed flow rate (75-300 cm3 min-1), n-decane feed concentration (44-194 ppm), humidity (3 and 40%), oxygen concentration (0 and 21%), and incident UV irradiance (18.9, 29.1, and 38.4 WUV m-2). The decontamination of a bioaerosol stream was also evaluated by the PCO process, using Pseudomonas aeruginosa (Gram-negative) and Staphylococcus aureus (Gram-positive) as model bacteria. A pilot-scale unit was operated day and night, using natural sunlight and artificial UV light, to show its performance in the mineralization of n-decane air streams under real outdoor conditions. Graphical abstract Normally graphics abstract are not presented with captions/legend. The diagram is a collection of images that resume the work.