• Energy Research
• Closed Access close
• 6. Clean water close
• 3. Good health close
• 4. Education close
• IN close
• CA close

Abstract In this study, crude cellulose derived from cornstalk, after bleaching, was used as raw material for the synthesis of sodium carboxymethyl cellulose (CMC) by reacting with the cellulose with NaOH and chloroacetic acid at 75 °C for 1.5 h. Effects of alkali dosage, concentration of chloroacetic acid on the physical and chemical properties of the CMC products were investigated. It was revealed that the reactants alkali reagent/chloroacetic acid/cellulose at the molar ratio of 4.6:2.8:1and 4:2.5:1, or at the molar ratio of NaOH/ClCH 2 COOH ≈1.6–1.64, resulted in CMC products of relatively high water solubility. The viscosity-average molecular weight M v of these two CMC products obtained at molar ratios of 4.0:2.5:1 and 4.6:2.8:1 is in the range of 1.94 × 10 4 –2.48 × 10 4 g mol −1 , and the average DS of the two products are 0.57 and 0.85, respectively. As the solute concentration is above 2 wt%, the viscosity of the CMC-water solution exhibits nonlinear (exponential) increasing with increasing the solute concentration (typical of non-Newton fluids).

Acidogenic anaerobic fermentation route was explored for the production of bioethanol and volatile fatty acids (VFA) from the press mud (PM) obtained from sugar mill. Slurry was prepared from PM having 10% of total solids and the same was hydrolyzed under acidic thermal conditions. Both press mud slurry (PMS) and pre-treated press mud slurry (PTPMS) was used as feedstock with mixed microbial consortia (MMC) and enriched mixed microbial consortia (EMMC). Mix of bioethanol and VFA were obtained in all the four cases (PMS-MMC, PMS-EMMC, PTPMS-EMC and PTPMS-EMMC), but, bioethanol and VFA yield of 0.04 g/g and 0.27 g/g, respectively obtained from PTPMS with EMMC was found to be comparatively higher. Control experiments carried out with glucose yielded bioethanol and VFA of 0.042 g/g and 0.28 g/g, respectively demonstrating that the organism was using reducible sugars in the feedstock for the generation of bioethanol by simultaneously producing the VFA from COD.

The influence of various solvents (H2O, CH3OH, and C2H5OH) on product distribution and nature of products during hydrothermal liquefaction of sargassum tenerrimum algae has been examined. Hydrothermal liquefaction was performed using H2O (260, 280 and 300°C) and organic solvents CH3OH and C2H5OH (280°C) for 15min. The use of organic solvents significantly increased the yield of bio-oil. In the case of liquefaction with CH3OH and C2H5OH, the bio-oil yield was 22.8 and 23.8wt.% respectively whereas the bio-oil yield was 16.33wt.% with H2O. GC-MS analysis of the liquid products indicated the presence of various organic compounds including aromatics, nitrogenated and oxygenated compounds and higher selectivity amount of ester compounds were observed in the presence of alcoholic solvents. NMR and FT-IR showed that present of solvents have an effect on the decomposition of sargassum tenerrimum algae.

Anode with good electrocatalytic capabilities is more specifically required to reduce the ohimic losses during microbial fuel cell (MFC) operation. Highly conductive polymers viz., Polyaniline (PANi) and Polyaniline/Carbon nanotube (PANi/CNT) composite were prepared by in situ oxidative chemical polymerization method. Anodes were fabricated independently by coating PANi and CNT/PANi composites on the surface of SSM. The fabricated electrodes were evaluated as anode against stainless steel mess (SSM) as cathode during MFC operation. Maximum bioelectricity generation was observed in SSM-PANi/CNT-anode with power density of 48 mW/m2 and COD removal efficiency of 80% compared with SSM-PANi-anode (38 mW/m2; 65%) and SSM-anode (28 mW/m2; 58%). Bioelectrochemical characterization of the electrode materials using cyclic voltammetry and electrochemical impedance spectroscopy showed high electrocatalytic activity of PANi/CNT composite electrode. The study concluded the efficiency of PANi/CNT composite electrodes as bioanode in operation of MFCs towards achieving increased bioelectricity production along with wastewater treatment.

This review presents recent advancements in high-voltage rechargeable aqueous batteries employing water-in-salt and modified water-in-salt electrolytes.

Abstract Globally, three-quarter of a billion people live without electricity. Besides, hundreds of million use a solar lantern for less than 4 h a day. Most of the access-deprived are in the Global South, predominantly in Sub-Saharan Africa and South Asia. The United Nations framed the seventh Sustainable Development Goal to improve access. Solar photovoltaic powered mini-grids are increasingly extending better service to deprived regions. However, poor load-factor and expensive storage adversely affect viability. Also, these mini-grids do not support infrequent large loads to avoid further loss of load-factor. Electric cooking is efficient and non-polluting; water treatment facilities can save millions from contaminant and pathogen by providing clean water. Besides, both electric cooking and water treatment are less expensive than alternatives. But mini-grids frequently do not support these. Indeed, the presence of sustained productive loads favourably influences the mini-grid economy. This study investigates the role of critical household loads to deliver similar bearing on the mini-grid economy. Results underscore realisation of desirable impact with household collaboration under a demand-response program. Collaborative consumption can lower initial investment by 62% and reduce the unit energy cost to $0.23. Also, cooperation improves the mini-grid load factor and promotes viability. Additionally, fast deployment needs during and after Covid-19 remains inherently supported while mitigating the pandemic induced financial stress of both consumer and mini-grid operator. This study of 88 nation-states underscores that demand response in a mini-grid can not only improve affordability for all consumers, but it can also bring 186 million people within affordable access.

Abstract Bitumen recovery by steam-solvent coinjection involves the coupled thermal/compositional mechanisms for reduction of bitumen viscosity. Reliable design of such processes requires reservoir flow simulation based on a proper phase-behavior model so that the oleic-phase viscosity near the steam-chamber edge can be modeled reliably. However, the effect of bitumen characterization (e.g., the number of pseudo components used) on steam-solvent coinjection simulation has not been studied in detail, and can be realized only after running multiple reservoir simulations, which is time consuming. There are two main objectives in this paper. One is to develop a reliable method for bitumen characterization by improving the fluid characterization method that was recently developed based on perturbation from n-alkanes (PnA). The other is to develop a novel analytical method for assessing the sensitivity of a particular coinjection simulation to bitumen characterization without having to perform reservoir simulations. A simulation case study is given to validate this analytical method. A proper number of pseudo components for bitumen characterization cannot be determined without considering the effect of phase behavior on the oleic-phase viscosity at chamber-edge conditions in steam-solvent coinjection simulation. Results show that the analytical method developed in this research can detect the sensitivity of recovery simulation to bitumen characterization without performing multiple flow simulations using different sets of fluid models. The PnA-based method developed for bitumen characterization gives reliable predictions of phase behavior for bitumen/solvent mixtures with a small amount of experimental data.

Abstract Natural resources exist independent of human intervention. Although these interventions can and do affect the balance between ecological and biological diversity conditions these resources support, and their use to promote economic development. Currently, the unsustainable use of these resources threatens this balance, calling for more sustainable patterns of natural resource use and conservation. The primary responsibility for ensuring the proper balance lies with governments, leading to various policies and programs to preserve natural resources. The ultimate goal is to make the masses aware of natural assets’ importance and encourage their sustainable use. To successfully implement, however, these government practices require public communication and participation, and the full consideration of public opinion at various levels of governance. A predictive analytics framework is proposed for understanding public opinion on government policies to improve sustainable water governance. An integrated policy initiative to balance water resources use and conservation launched by the Indian government served as a test case for applying the framework in an attempt to accurately classify the opinion polarity related to the policy. The conventional feature extraction is applied to pre-processed datasets to extract the relevant features. Subsequently, swarm-based feature selection is applied to filter out optimal features. Lastly, opinion mining and textual analysis are performed to determine the most relevant water management factors that need immediate attention. The proposed framework serves as a policy evaluation strategy in the water management domain. The paper closes with a discussion of the general applicability of the proposed framework.

A field study was conducted on two texturally different soils to determine the influences of biosolids application on selected soil chemical properties and carbon dioxide fluxes. Two sites, located in Manildra (clay loam) and Grenfell (sandy loam), in Australia, were treated at a single level of 70 Mg ha-1 biosolids. Soil samples were analyzed for SOC fractions, including total organic carbon (TOC), labile, and non-labile carbon contents. The natural abundances of soil δ13C and δ15N were measured as isotopic tracers to fingerprint carbon derived from biosolids. An automated soil respirometer was used to measure in-situ diurnal CO2 fluxes, soil moisture, and temperature. Application of biosolids increased the surface (0-15 cm) soil TOC by > 45% at both sites, which was attributed to the direct contribution from residual carbon in the biosolids and also from the increased biomass production. At both sites application of biosolids increased the non-labile carbon fraction that is stable against microbial decomposition, which indicated the soil carbon sequestration potential of biosolids. Soils amended with biosolids showed depleted δ13C, and enriched δ15N indicating the accumulation of biosolids residual carbon in soils. The in-situ respirometer data demonstrated enhanced CO2 fluxes at the sites treated with biosolids, indicating limited carbon sequestration potential. However, addition of biosolids on both the clay loam and sandy loam soils found to be effective in building SOC than reducing it. Soil temperature and CO2 fluxes, indicating that temperature was more important for microbial degradation of carbon in biosolids than soil moisture.