• Energy Research
• Closed Access close
• Embargo close
• CN close
• DE close
• Chinese Academy of Sciences close

Forest soil acidification caused by acid deposition is a serious threat to the forest ecosystem. To investigate the liming effects of biomass ash (BA) and alkaline slag (AS) on the acidic topsoil and subsoil, a three-year field experiment under artificial Masson pine was conducted at Langxi, Anhui province in Southern China. The surface application of BA and AS significantly increased the soil pH, and thus decreased exchangeable acidity and active Al in the topsoil. Soil exchangeable Ca2+ and Mg2+ in topsoil were significantly increased by the surface application of BA and AS, while an increase in soil exchangeable K+ was only observed in BA treatments. The soil acidity and active Al in subsoil were decreased by the surface application of AS. Compared with the control, soluble monomeric and exchangeable Al in the subsoil was decreased by 38.0% and 29.4% after 3 years of AS surface application. There was a minimal effect on soluble monomeric and exchangeable Al after the application of BA. The soil exchangeable Ca2+ and Mg2+ in the subsoil increased respectively by 54% and 141% after surface application of 10 t ha-1 AS. The decrease of soil active Al and increase of base cations in subsoil were mainly attributed to the high migration capacity of base cations in AS. In conclusion, the effect of surface application of AS was superior to BA in ameliorating soil acidity and alleviating soil Al toxicity in the subsoil of this Ultisol.

New zinc phthalocyanine (ZnPc-TDA), peripherally functionalized with donor-acceptor conjugates was synthesized, and its optical, thermal, electrochemical, and photovoltaic properties were studied. The black ZnPc-TDA exhibited both excellent solubility in common organic solvents, and broad absorption covering the range 300-900 nm. The photovoltaic devices with the configuration of ITO/PEDOT-PSS/ZnPc-TDA:PCBM/LiF/Al produced short circuit current densities of 2.26 mA/cm(2), the open circuit voltage of 0.68 V and power conversion efficiency of 0.4% under AM1.5G illumination. (C) 2010 Elsevier B.V. All rights reserved.

Bioenergy is considered a sustainable substitute to fossil-fuel resources and the development of a prudent combination of renewable and innovative conversion technologies are essential for the valorization and effective conversion of biowaste to value-added commodities. Here, a negative pressure-induced carbonization process was proposed for the valorization of lignin-enriched biowaste precursor to bio-oil and environmental materials (biochar) at various temperatures. The high heating values (HHV) of the as-prepared biochars from the lignin enriched precursor under negative pressure (low-medium vacuum) were within 25.9-31.5 MJ/kg, which matched satisfactorily to the commercial charcoal. Whereas, the bio-oils produced from the lignin enriched precursor under vacuum conditions was a blend of complex aromatic and straight-chain hydro-carbons, including aldehyde, ketone, phenol, and furans, exhibiting ability as potential heating-oil with HHV within 21.2-28.2 MJ/kg. Moreover, the biochars produced under vacuum environments at higher temperature showed greater stability (22.5-35.9%) than those produced under N2 atmosphere.

Abstract The Liquefied natural gas (LNG) cryogenic submerged pump, the core power equipment for the transportation of liquefied natural gas, is prone to cavitation. However, based on the traditional analysis of the pressure drop, the irreversible loss after cavitation can barely be displayed quantitatively. To solve this problem, an entropy production diagnostic model (EPDM) by the contribution of viscous entropy production (VEP), turbulent entropy production (TEP) and wall entropy production (WEP) for the cavitation flow was established to calculate the energy loss. The cryogenic cavitation model and proposed EPDM were proved to be reliable after comparing results with Hord’s experiment in an ogive and cavitation experiment in a centrifugal pump. Then, by studying the total entropy production, it was found that the EPDM could well predict the occurrence of the critical cavitation and the deterioration of cavitation. When compared with TEP and WEP, the effect of VEP is negligible. As the cavitation area expands from the suction surface of inducer (id) to the first-stage impeller (impA), the cavitation process can be divided into three stages and the total energy loss increases significantly from the first stage to the third one. Through the global distribution of energy loss, it was found that the faster growth of the loss in the second-stage impeller (impB) and the second-stage guide vane (gvB), not in id and impA, contributes more to the energy loss after cavitation. Finally, from the variation of ratio of TEP to WEP, it reveals that cavitation has a greater effect on the WEP rate for the impB, but the turbulent viscous dissipation is still dominant, while the eddy dissipation and resistance loss in gvB with the evolution of cavitation are both crucial.

In this study, the freshwater microalgae Selenastrum sp. was assessed for the effective degradation of pyrene and simultaneous production of biodiesel from pyrene-tolerant biomass. The growth of algae was determined based on the cell dry weight, cell density, chlorophyll content, and biomass productivity under different pyrene concentrations. Further, lipids from pyrene tolerant culture were converted into biodiesel by acid-catalyzed transesterification, which was characterized for the total fatty acid profile by gas chromatography. Increased pyrene concentration revealed less biomass yield and productivity after 20 days of treatment, indicating potent pyrene biodegradation by Selenastrum sp. Biomass yield was unaffected till the 20 mg/L pyrene. A 95% of pyrene bioremediation was observed at 20 days of culturing. Lipid accumulation of 22.14%, as evident from the estimation of the total lipid content, indicated a marginal increase in corroborating pyrene stress in the culture. Fatty acid methyl esters yield of 63.06% (% per 100 g lipids) was noticed from the pyrene tolerant culture. Moreover, fatty acid profile analysis of biodiesel produced under 10 mg/L and 20 mg/L pyrene condition showed escalated levels of desirable fatty acids in Selenastrum sp., compared to the control. Further, Selenastrum sp. and other freshwater microalgae are catalogued for sustainable development goals attainment by 2030, as per the UNSDG (United Nations Sustainable Development Goals) agenda. Critical applications for the Selenastrum sp. in bioremediation of pyrene, along with biodiesel production, are enumerated for sustainable and renewable energy production and resource management.

Abstract This paper presents a novel and environmentally friendly production of direct reduced iron (DRI) technology using biomass as an additive agent in iron ore pellets and simulated biomass-derived syngas as the reducing agent. The effects of biomass addition on iron ore pellets reduction and consequent reduction kinetics in simulated biomass-derived syngas atmosphere were investigated. The results demonstrated that the biomass addition improved the pellet porosity and specific surface area, thus increasing both the reducibility and reduction rate and decreasing the apparent activation energy for pellet reduction. Mathematical modelling of experimental data indicated an interfacial chemical reaction mechanism with FeO → Fe as the rate controlling step. The simulated biomass syngas is an alternative gas-based reductant to natural gas, coal gas, more than 99.5% reduction degree of the oxidized pellets was reduced at 1323 K within 20 min. The apparent activation energies were 86.05 kJ·mol −1 , 97.53 kJ·mol −1 for the pellets with and without biomass addition. The proposed iron ore reduction process therefore would be a potential to reduce iron directly using biomass with high efficiency and real environmental benefits.

AbstractA new glucoceramide named pellioniareside (1) was isolated from the aqueous ethanolic extract of whole plants of Pellionia repens, together with lupeol (2), uracil (3), (22E,20S,24R)‐5α,8α‐epidioxyergosta‐6,22‐dien‐3‐β‐ol (4), and daucosterol (5). The structure and relative configurations of pellioniareside were identified as (2S,3S,4R,6E,8E)‐1‐O‐β‐d‐glucopyranosyl‐2‐[(2R)‐2‐hydroxytetracosanoylamino]‐1,3,4‐octadecanetriol‐6,8‐diene by analysis of spectral data and by chemical evidence.

Atmospheric concentrations of the greenhouse gas nitrous oxide (N(2)O) have increased significantly since pre-industrial times owing to anthropogenic perturbation of the global nitrogen cycle, with animal production being one of the main contributors. Grasslands cover about 20 per cent of the temperate land surface of the Earth and are widely used as pasture. It has been suggested that high animal stocking rates and the resulting elevated nitrogen input increase N(2)O emissions. Internationally agreed methods to upscale the effect of increased livestock numbers on N(2)O emissions are based directly on per capita nitrogen inputs. However, measurements of grassland N(2)O fluxes are often performed over short time periods, with low time resolution and mostly during the growing season. In consequence, our understanding of the daily and seasonal dynamics of grassland N(2)O fluxes remains limited. Here we report year-round N(2)O flux measurements with high and low temporal resolution at ten steppe grassland sites in Inner Mongolia, China. We show that short-lived pulses of N(2)O emission during spring thaw dominate the annual N(2)O budget at our study sites. The N(2)O emission pulses are highest in ungrazed steppe and decrease with increasing stocking rate, suggesting that grazing decreases rather than increases N(2)O emissions. Our results show that the stimulatory effect of higher stocking rates on nitrogen cycling and, hence, on N(2)O emission is more than offset by the effects of a parallel reduction in microbial biomass, inorganic nitrogen production and wintertime water retention. By neglecting these freeze-thaw interactions, existing approaches may have systematically overestimated N(2)O emissions over the last century for semi-arid, cool temperate grasslands by up to 72 per cent.

Abstract A high-flux solar simulator is essential for evaluating solar thermal components under controlled and adjustable flux input conditions. This study presents a newly built high-flux solar simulator composed of 19 individual units. Each unit includes a xenon short-arc lamp (each consuming up to 6 kW electricity power) coupled with a truncated ellipsoidal reflector, a cooling blower, and a power module. The power module yields a current in the range of 50–160 A. The number of lamps in use is flexible, which allows for a wide range of radiation flux (10%–100%) on the focal plane. The radiation power, peak value, flux distribution on the circular target plane, and conversion efficiency are evaluated based on a flux mapping method. The results indicate that the proposed solar simulator is capable of achieving thermal power of 23.3 kW, peak flux in excess of 1.78 MW/m2, a stagnation temperature exceeding 2360 °C, and average irradiance of 773.4 kW/m2 on the focal plane (diameter of 260 mm). The electro-thermal conversion efficiency of the simulator is 35.7%. A ray-tracing method was employed, and the simulation results were found to be in good agreement with those in the experiments. An experimental test of a volumetric ceramic receiver was conducted, and the results indicate the availability and applicability of the high-flux solar simulator when carrying out studies about solar receivers.