• Energy Research
• 13. Climate action close
• 6. Clean water close
• 4. Education close
• IN close
• CH close

Abstract A process engineering strategy was developed for cultivation of high density biomass of Chlorella sp. FC2 with improved productivity under photoautotrophic condition. The process engineering strategy involved a combinatorial approach of: (i) optimization of CO2 concentration in the inlet gas stream & aeration rate; (ii) growth kinetic driven feeding recipe for limiting nutrients; and (iii) dynamic increase in light intensity. The strategy was tested by growing the cells on laboratory grade BG11 medium. With an attempt to reduce the cultivation cost, the growth performance of the organism was then evaluated on commercial grade BG11 medium. Finally, hydrothermal liquefaction was carried out for direct conversion of microalgal slurry into bio-crude oil. Cultivation on laboratory grade BG11 medium resulted in biomass titer and overall productivity of 8.41 g L−1 and 575.9 mg L−1 day−1 respectively. Significant improvement in biomass titer (13.23 g L−1) and overall productivity (731.6 mg L−1 day−1) was observed when grown on commercial grade BG11 medium. Higher fraction of hydrocarbon in the bio-crude oil depicted better oil quality. Thermal gravimetric analysis revealed that maximum distillate fraction lies within the boiling point range of 200–300 °C which is suitable for conversion into diesel oil, jet fuel, and fuel for stoves.

Abstract Due to gradually diminution of fossil fuel, the cost-effective utilization of available fuel for power generation has turn out to be a vital concern of electric power utilities. Thermal power plants have to operate within their fuel confines and contractual constraints. This work suggests social group entropy optimization (SGEO) technique to solve short-term generation scheduling of a power system consisting of fuel constrained thermal generating units, cascaded hydro power plants, solar PV plants, wind turbine generators and pumped storage hydro (PSH) plants with demand side management (DSM). Simulation results of the test system have been compared with those acquired by self-organizing hierarchical particle swarm optimizer with time-varying acceleration coefficients (HPSO-TVAC), fast convergence evolutionary programming (FCEP) and differential evolution (DE). Numerical results show that fuel consumption can be adequately controlled for fulfilling constraints imposed by suppliers and total cost with fuel constraints is more than the cost without fuel constraints. It has been also observed from the comparison that the suggested SGEO has the ability to bestow with superior-quality solution.

The problem of acid gas exhaust emissions treatment has not been fully resolved at present. Dry adsorption of acid gases with alkaline sorbents is currently being investigated, to improve solid sorbents. In this study, 5 types of hydrated lime were characterised and tested. The sorption capacities were measured by means of a system consisting of a feed line (HCl/N2), a thermostatic reactor and a water absorber. The physical characteristics of sorbent samples were also compared. Analyses conducted with scanning electronic microscopy revealed that sample C1 showed uniform particle distribution. Samples C2 and C3 showed the co-presence of fine and coarse particles. Sample C4 showed very fine particles with agglomeration phenomena. In sample C5, fibrous elements were found. Energy dispersive spectrometry (EDS) analyses showed a similar composition of the samples, with the exception of the presence of Mg in some of them. After 30 min of testing, the following differences in sorption capacities with respect to C1 (3.59 mg g−1) were found: C2, −20%; C3, −13%; C4, −17%; C5, −3%. Higher sorption capacities were associated with more uniform particle size distributions. Conversely, agglomeration of fine particles may have adversely affected the performance of sorbents.

Participatory modeling has been widely recognized in recent years as a powerful tool for dealing with risk and uncertainty. By incorporating multiple perspectives into the structure of a model, we hypothesize that sources of risk can be identified and analyzed more comprehensively compared to traditional ‘expert-driven’ models. However, one of the weaknesses of a participatory modeling process is that it is typically not feasible to involve more than a few dozen people in model creation, and valuable perspectives on sources of risk may therefore be absent. We sought to address this weakness by conducting parallel participatory modeling processes in three countries in West Africa with similar climates and smallholder agricultural systems, but widely differing political and cultural contexts. Stakeholders involved in the agricultural sector in Ghana, Mali, and Nigeria participated in either a scenario planning process or a causal loop diagramming process, in which they were asked about drivers of agricultural productivity and food security, and sources of risk, including climate risk, between the present and mid-century (2035–2050). Participants in all three workshops identified both direct and indirect sources of climate risk, as they interact with other critical drivers of agricultural systems change, such as water availability, political investment in agriculture, and land availability. We conclude that participatory systems methods are a valuable addition to the suite of methodologies for analyzing climate risk and that scientists and policy-makers would do well to consider dynamic interactions between drivers of risk when assessing the resilience of agricultural systems to climate change.

Growing concerns over the use of limited fossil fuels and their negative impacts on the ecological niches have facilitated the exploration of alternative routes. The use of conventional plastic material also negatively impacts the environment. One such green alternative is polyhydroxyalkanoates, which are biodegradable, biocompatible, and environmentally friendly. Recently, researchers have focused on the utilization of waste gases particularly those belonging to C1 sources derived directly from industries and anthropogenic activities, such as carbon dioxide, methane, and methanol as the substrate for polyhydroxyalkanoates production. Consequently, several microorganisms have been exploited to utilize waste gases for their growth and biopolymer accumulation. Methylotrophs such as Methylobacterium organophilum produced highest amount of PHA up to 88% using CH4 as the sole carbon source and 52–56% with CH3OH. On the other hand Cupriavidus necator, produced 71–81% of PHA by utilizing CO and CO2 as a substrate. The present review shows the potential of waste gas valorization as a promising solution for the sustainable production of polyhydroxyalkanoates. Key bottlenecks towards the usage of gaseous substrates obstructing their realization on a large scale and the possible technological solutions were also highlighted. Several strategies for PHA production using C1 gases through fermentation and metabolic engineering approaches are discussed. Microbes such as autotrophs, acetogens, and methanotrophs can produce PHA from CO2, CO, and CH4. Therefore, this article presents a vision of C1 gas into bioplastics are prospective strategies with promising potential application, and aspects related to the sustainability of the system.

Modal shifts hold considerable potential to mitigate carbon emissions. Electric bikes (e-bikes) represent a promising energy- and carbon-efficient alternative to cars. However, as mobility behaviour is highly habitual, convincing people to switch from cars to e-bikes is challenging. One strategy to accomplish this is the disruption of existing habits - a key idea behind an annual e-bike promotion programme in Switzerland, in which car owners can try out an e-bike for free over a 2-week period in exchange for their car keys. By means of a longitudinal survey, we measured the long-term effects of this trial on mobility-related habitual associations. After one year, participants' habitual association with car use had weakened significantly. This finding was valid both for participants who bought an e-bike after the trial and those who did not. Our findings contrast the results of other studies who find that the effect of interventions to induce modal shifts wears off over time. We conclude that an e-bike trial has the potential to break mobility habits and motivate car owners to use more sustainable means of transport.

Abstract In case of a core melt-down accident in a light water nuclear reactor, hydrogen is produced during reactor core degradation and released into the reactor building. This subsequently creates a combustion hazard. A local ignition of the combustible mixture may generate standing flames or initially slow propagating flames. Depending on geometry, mixture composition and turbulence level, the flame can accelerate or be quenched after a certain distance. The loads generated by the combustion process (increase of the containment atmosphere pressure and temperature) may threaten the integrity of the containment building and of internal walls and equipment. Turbulent deflagration flames may generate high pressure pulses, temperature peaks, shock waves and large pressure gradients which could severely damage specific containment components, internal walls and/or safety equipment. The evaluation of such loads requires validated codes which can be used with a high level of confidence. Currently, turbulence and steam effect on flame acceleration, flame deceleration and flame quenching mechanisms are not well reproduced by combustion models usually implemented in safety tools and further model enhancement and validation are still needed. For this purpose, two hydrogen deflagration benchmark exercises have been organised in the framework of the SARNET network. The first benchmark was focused on turbulence effect on flame propagation. For this purpose, three tests performed in the ENACCEF facility were considered. They concern vertical flame propagation in an initially homogenous mixture with 13 vol.% hydrogen content and different geometrical configurations. Three blockage ratios of 0, 0.33 and 0.6 were considered to generate different levels of turbulence. The second benchmark objective was the investigation of the diluting effect on flame propagation. Thus, three tests performed in the ENACCEF facility using the same blockage ratio of 0.63 and three different initial gas compositions (with 10, 20 and 30 vol.% diluents) have been considered. Since ENACCEF runs at ambient temperature, a surrogate to steam was used consisting of a mixture of 0.6He + 0.4CO 2 on molar basis. This paper aims to present the benchmarks conclusions regarding the ability of LP and CFD combustion models to predict the effect of turbulence and diluent on flame propagation.

SummaryConservation agriculture (CA) practices such as zero tillage (ZT) and permanent raised beds (PB) accelerate deposition of soil organic matter and augment associated biological properties of soil through enhanced inputs of organic carbon. However, the potential benefit of CA under intensive cereal‐based systems for key soil health indicators (such as carbon pools and biological activities) is only partially known. Therefore, we analysed the effect of three medium‐term tillage practices and four intensive crop rotations on selected soil organic carbon pools and microbial properties. The tillage practices consist of ZT, PB and conventional tillage (CT) in main plots and four crop rotations (MWMb, maize–wheat–mungbean; MCS, maize–chickpea–Sesbania; MMuMb, maize–mustard–mungbean; MMS, maize–maize–Sesbania) in subplots. The experimental design was split‐plot with three replications. After 6 years, we observed a significant positive effect of CA practices on soil organic carbon (SOC) content, labile SOC fractions, soil microbial biomass carbon (MBC) and dehydrogenase activity (DHA). The total organic carbon (TOC) was greatly affected by medium‐term tillage and diversified cropping systems; it was larger for CA and MCS and MWMb systems. The interaction effect between tillage and cropping systems for SOC content was not significant at all soil depths. Significantly larger contributions (8.5–25.5%) of labile SOC pools to TOC at various soil depths were recorded in PB and ZT. There was a significant positive effect of CA practices and diversified crop rotations on MBC and DHA at all the soil depths and sampling times, but the interaction effect between tillage and cropping systems was not significant. Thus, our medium‐term (≥ 5‐years) study showed that the combination of CA (PB and ZT) practices and appropriate choice of rotations (MCS and MWMb) appears to be the most appropriate option for restoration and improvement of the soil health of light‐textured Inceptisols through the accumulation of soil organic matter (SOM) and improvement in soil biological properties.Highlights Effect of conservation agriculture (CA) on soil labile carbon inputs and biological properties. Observed changes in SOC stock and C‐pools at different soil depths after 6 years. Significant effects of tillage and crop rotations observed for labile‐C pools. Adoption of ZT and PB enhanced SOC stock, C‐pools and microbial activity compared to CT.