• Energy Research
• engineering and technology close
• 12. Responsible consumption close
• 11. Sustainability close
• 4. Education close
• IN close
• KR close

Second-generation bioethanol can be produced from various lignocellulosic biomasses such as wood, agricultural or forest residues. Lignocellulosic biomass is inexpensive, renewable and abundant source for bioethanol production. The conversion of lignocellulosic biomass to bioethanol could be a promising technology though the process has several challenges and limitations such as biomass transport and handling, and efficient pretreatment methods for total delignification of lignocellulosics. Proper pretreatment methods can increase concentrations of fermentable sugars after enzymatic saccharification, thereby improving the efficiency of the whole process. Conversion of glucose as well as xylose to bioethanol needs some new fermentation technologies to make the whole process inexpensive. The main goal of pretreatment is to increase the digestibility of maximum available sugars. Each pretreatment process has a specific effect on the cellulose, hemicellulose and lignin fraction; thus, different pretreatment methods and conditions should be chosen according to the process configuration selected for the subsequent hydrolysis and fermentation steps. The cost of ethanol production from lignocellulosic biomass in current technologies is relatively high. Additionally, low yield still remains as one of the main challenges. This paper reviews the various technologies for maximum conversion of cellulose and hemicelluloses fraction to ethanol, and it point outs several key properties that should be targeted for low cost and maximum yield.

Abstract Limiting the increase of global temperature requires electrification of the railway transport, which is relatively a distinct mode of transport in terms of economy, business and socialization of a country. However, battery complemented railway transport systems such as fuel cell hybrid railway propulsion systems are constrained by the high cost of the battery, and suboptimal performance of the fuel cell under varying loads. Optimized selection of battery can reduce its costs associated with sizing, life and utilization. Similarly, managing the load distribution between the battery and fuel cell can reduce the load variations concern for fuel cell. In this study, model-based selective characterization of the battery and fuel cell is done to identify the optimal features and constraints. Following characterization, the load allocation to battery and fuel cell is determined with the targets of collaborative utilization of optimal features and mitigation of constraints. Subsequently, considering this load allocation and results of characterization, conditions are proposed for reliable sizing and optimized selection of battery. The significance of the proposed conditions in reliable sizing is explored. Based on these conditions, certain commercially developed batteries are evaluated for optimized selection of battery. The results signify this study as a foundation for research on the reliable sizing and optimized selection of battery in fuel cell hybrid railway propulsion systems.

The distribution feeders often gets overload under peak power demands. This situation is generally countered by load shading, which leads to financial losses to utilities and individual users. This paper presents the new methodology to support the real and reactive power demand through energy storage (ES) to avoid the load shading situation. The compensation of real / reactive power not only provides the voltage profile improvement but also ensures the sustain power to the consumers. A control scheme incorporated also maintains the unity power factor on source side. This relieves the existing distribution network from the extra reactive loading hence the line is having extra capacity for real power transfer to its maximum thermal limit. This additional capacity availability adds more customer base to justify the energy storage investment. The operational features are presented through a simulation of a realistic urban feeder data. The financial analysis is also presented to justify the energy storages with the distribution networks.

The current status and challenges associated with the production and utilization of cellulosic ethanol in Korea are reviewed in this paper. Cellulosic ethanol has emerged as a promising option for mitigating Korea's CO(2) emissions and enhancing its energy security. Korea's limited biomass resources is the most critical barrier to achieving its implementation targets for cellulosic ethanol. Efforts to identify new suitable biomass resources for cellulosic ethanol production are ongoing and intensive. Aquatic biomasses including macroalgae and plantation wastes collected in the Southeast Asia region have been found to have great potential as feedstocks for the production of cellulosic ethanol. R&D explorations into the development of technologies that can convert biomass materials to ethanol more efficiently also are underway. It is expected that cellulosic ethanol will be in supply from 2020 and that, by 2030, its use will have effectively reduced Korea's total gasoline consumption by 10%.

As smart cities become a global topic, interest in smart mobility, the core of smart cities, is also growing. The technology that comes closest to general users is “autonomous driving”. In particular, the successful market entry and establishment of some private companies proved that “autonomous driving” is not technology of the future but imminent reality. However, safety in autonomous vehicles that rely on sensors instead of the driver’s five senses has been the focus of attention from the beginning and continues to be so. In this study, we attempted to counter this interest. Based on the actual data of thirty traffic accidents, assuming the AEBS (Autonomous Emergency Braking System) was installed to assist the driver in safe driving, it was reinterpreted through simulation to see what changes occurred in the accident. In the computer program, PC-Crash, the results were first analyzed through simulation using Euro NCAP (New Car Assessment Program)’s AEBS test standards. Subsequently, the other variables in the AEBS were controlled and the accident was reinterpreted by changing only the angle of the radar detection sensor. As a result, it was confirmed that a total of 27 accidents out of thirty accidents could have been prevented with the AEBS. In addition, it proved that the crash avoidance rate of vehicles gradually increased as the radar angle increased.

India's steadily expanding populace has made it important to create innovative methods of transportation with electric vehicles (EV's) being the most favoured alternative. The major impediment is the negative impact caused by the improper setup of charging stations on the utility distribution system. This paper takes up the issue of optimal planning (siting and sizing) of charging station (CS) infrastructure in the city of Allahabad, India. It has been labelled as a future smart city under a pilot transportation project started by Government of India. A hybrid algorithm comprising of Genetic Algorithm and improved version of conventional Particle Swarm Optimization (GAIPSO) is employed in this study. The aim is to find optimal location of proposed charging stations in the Allahabad distribution system. PSO further re-optimizes the received sub-optimal solution (site and size of station) which leads to an overall improvement in its functionality and solution. Simulation studies on a real time system of Allahabad city clearly exhibits the superior performance of the aforementioned technique with respect to GA and PSO in terms of improvement in voltage profile and quality of solution obtained for the objective function.

AbstractThe penetration of financialization into the biocultural geographies of islands builds upon processes of commodification and privatization of environments, entailing enclosures of resource commons, environmental destruction and displacement of people, their livelihoods, knowledge and practices, with implications for sustainability. Against this background I critique the growing literature on acronym models of island development, arguing for more careful consideration of issues concerning democracy, human rights and sustainability. Drawing on the ‘right to the city’ literature, I highlight the importance of the ‘right to the island’ in an effort to move beyond the policy imperatives of MIRAB, SITE and PROFIT. Exercising the right to the island involves cultivating radically pluralistic democracy through struggles for alternative island futures. In so doing it problematizes what it means to develop and achieve sustainability.

Yard waste is either dumped or is being openly burned to get rid of it, instead of using it as a valuable renewable energy source. In this study, hydrothermal carbonization of yard waste was conducted to valorize it as a solid bio fuel, using a batch reactor. The effect of process parameter on yield, energy and physicochemical properties of the valorized solid bio fuel (hydrochar) was examined in this study by varying reaction temperature (160-200 °C for 2 h) and reaction time (2-24 h at 200 °C). The calorific value of hydrochar was within a range of 17.72-24.59 MJ/kg as compared to 15.37 MJ/kg for untreated yard waste. Hydrochar mass yield decreased from 78.6% at operating temperature - time of 160 °C -2 h to 45.6% at 200 °C -24 h. The plot of atomic ratios (H/C and O/C) demonstrates improvement in the coalification process which was mainly governed by decarboxylation and dehydration reactions. The grindability of the prepared hydrochar was comparable to that of coal. Hydrochar produced at lower reaction condition (160-200 °C at 2 h) have better flowability as compared to that produced at higher reaction condition (4-24 h at 200 °C). The reaction time longer than 12 h has a minimal effect on the yield, energy and physicochemical properties of hydrochar. Increasing reaction time and temperature improved the ignition and burnt temperature of hydrochar. All reaction condition has an energy ratio (energy output to energy input) of more than one making HTC process a net energy producer.

Biogas is a viable alternative for supplying clean and sustainable energy. Despite all manner of policy measures introduced by the Government of India, biogas is not widely used in India. This article tries to identify factors that influence the decision to adopt biogas at household level. We examine a conceptual framework empirically in which a household wants to maximize utility from biogas by using the India Human Development Survey (IHDS) I, which is a nationally representative, multi-topic survey. By applying both maximum likelihood and penalized likelihood methods (Firthlogit) of logistic regression on a sample size of almost 10,384 households, it has been found that wealthy people are more likely to adopt biogas compared to the marginalized section of the society. We recommend more inclusive policy measures for the weaker section of the society to create an enabling environment to make it a self-promoting technology.