• Energy Research
• Restricted close
• Embargo close
• 13. Climate action close
• 12. Responsible consumption close
• IN close
• PK close

Wood biomass is turned into industrial fuel through chipping. The efficiency of chipping depends on many factors, including chipper knife wear. Chipper knife wear was determined through a long-term follow-up study, conducted at a waste wood recycling yard. Knife wear determined a sharp drop of productivity (>20%) and a severe decay in product quality. Dry sharpening with a grinder mitigated this effect, but it could not replace proper wet sharpening. Increasing the frequency of wet sharpening sessions determined a moderate increase of knife depreciation cost, but it could drastically enhance machine performance and reduce biomass processing cost. Since benefits largely exceed costs, increasing the frequency of wet sharpening sessions may be an effective measure for reducing overall chipping cost. If the main goal of a chipper operator is to increase productivity and/or decrease fuel consumption, then managing knife wear should be a primary target. (C) 2014 Elsevier Ltd. All rights reserved.

The Indian Ocean Experiment (INDOEX) was an international, multiplatform field campaign to measure long-range transport of air pollution from South and Southeast Asia toward the Indian Ocean during the dry monsoon season in January to March 1999. Surprisingly high pollution levels were observed over the entire northern Indian Ocean toward the Intertropical Convergence Zone at about 6°S. We show that agricultural burning and especially biofuel use enhance carbon monoxide concentrations. Fossil fuel combustion and biomass burning cause a high aerosol loading. The growing pollution in this region gives rise to extensive air quality degradation with local, regional, and global implications, including a reduction of the oxidizing power of the atmosphere.

Abstract This Special Section provides introduction to the 15th Conference Process Integration, Modelling and Optimisation for Energy Saving and Pollution Reduction (PRES 2012). In this editorial introduction, the editors are highlighting the individual articles included in this issue and discussing the main points. The main areas of this issue can be summarised as: Process Integration for Energy Saving, Integrating Renewable Energy Sources and Energy Optimisation issues.

Improper management of pig manure has resulted in environmental problems such as surface water eutrophication, ground water pollution, and greenhouse gas emissions. This study develops and compares 14 alternative manure management scenarios aiming at energy and nutrient extraction. The scenarios based on combinations of thermal pretreatment, anaerobic digestion, anaerobic co-digestion, liquid/solid separation, drying, incineration, and thermal gasification were compared with respect to their energy, nutrient and greenhouse gas balances. Both sole pig manure and pig manure mixed with other types of waste materials were considered. Data for the analyses were obtained from existing waste treatment facilities, experimental plants, laboratory measurements and literature. The assessment reveals that incineration combined with liquid/solid separation and drying of the solids is a promising management option yielding a high potential energy utilization rate and greenhouse gas savings. If maximum electricity production is desired, anaerobic digestion is advantageous as the biogas can be converted to electricity at high efficiency in a gas engine while allowing production of heat for operation of the digestion process. In conclusion, this study shows that the choice of technology has a strong influence on energy, nutrient and greenhouse gas balances. Thus, to get the most reliable results, it is important to consider the most representative (and up-to-date) technology combined with data representing the area or region in question.

Abstract Hydrothermal liquefaction (HTL) is a promising technology for converting organic-rich waste biomass such as swine manure (SM) and sewage sludge (SS) into energy-dense bio-crude. Until now, one of the major challenges associated with HTL is the pumpability of high dry-matter containing fibrous feedstocks for continuous processing. In this context, this batch scale study presents a suitable approach for enhancing the pumpability of the fibrous material, specifically SM, by co-processing with SS. Obtained results showed that SM was not pumpable itself due to its fibrous nature, but became pumpable by the addition of SS at overall 25 % dry matter content. It was highlighted that the sample mixture containing ~80 % of the SM was smoothly pumped with 20 % SS. Subsequently, HTL experiments were carried out on samples mixed under the ratios SM:SS (100:0, 0:100, 50:50, 80:20, and 20:80). The highest bio-crude yield (42.38 %) via maximum synergistic effect was obtained from the sample SM/SS (50:50) at ratio 1:1 with the best HHV of 36 MJ/kg. Almost 60–70 % mass of all bio-crudes contained volatiles at 350 °C. ICP-AES measurements revealed that the majority of the inorganic elements were concentrated into the solid phase, while 40–50 % of the potassium and sodium were transferred to the aqueous phase. In conclusion, using SS as a co-substrate with SM not only enhances the pumpability of SM, but its co-liquefaction has demonstrated beneficial synergistic effects on improving the energy recovery of the bio-crude.

Abstract Biogas production is one of the number of tools that may be used to alleviate the problems of global warming, energy security and waste management. Biogas plants can be difficult to sustain from a financial perspective. The facilities must be financially optimized through use of substrates with high biogas potential, low water content and low retention requirement. This research carried out in laboratory scale batch digesters assessed the biogas potential of energy crops (maize and grass silage) and solid manure fractions from manure separation units. The ultimate methane productivity in terms of volatile solids (VS) was determined as 330, 161, 230, 236, 361 L/kg VS from raw pig slurry, filter pressed manure fiber (FPMF), chemically precipitated manure fiber (CPMF), maize silage and grass silage respectively. Methane productivity based on mass (L/kg substrate) was significantly higher in FPMF (55 L/kg substrate), maize silage (68 L/kg substrate) and grass silage (45–124 L/kg substrate (depending on dry solids of feedstock)) as in comparison to raw pig slurry (10 L/kg substrate). The use of these materials as co-substrates with raw pig slurry will increase significantly the biomethane yield per unit feedstock in the biogas plant.

The Carpathian mountain region is one of the most significant natural refuges on the European continent. It is home to Europe’s most extensive tracts of montane forest, the largest remaining virgin forest and natural mountain beech-fir forest ecosystems. Adding to the biodiversity are semi-natural habitats such as hay meadows, which are the result of centuries of traditional land management. Like other mountain regions areas, the Carpathian mountain region provides important ecosystem goods and services such as water provision, food products, forest products and tourism. But these ecosystem services are feared to be under threat from climate change.This chapter reports on climate trends, impacts and adaptation options. Analysis of climate trends show an increase in annual mean temperature of 1.1–2.0 °C over the last 50 years (1961–2010), further increasing by 3.5–4.0 °C towards the end of the century. Precipitation changes are dispersed with an increase of 300–400 mm in the north and decrease of 100–150 mm in the south regions. Summer precipitation is projected to reduce by 20 %, whereas winter precipitation is projected to increase in most areas by 5–20 % by the year 2100. Both future scenarios and observations show high spatial variability and uncertainty. The same holds for the impacts on the investigated sectors water resources, forests, wetlands, grasslands, agriculture and tourism.The review of climate trends and adaptation options, inspired a strategic agenda on adaptation to be implemented under the regional Carpathian Convention. Planning for climate change adaptation benefits from transnational cooperation because many impacts relate to seasonal and geographical shifts across borders. This is true for the natural system (e.g. shifts in species distribution and snow cover) as well as for socio-economic activities like agriculture, forestry and tourism (e.g. shifting opportunities for growing crops and changes in the tourist season). Examples of adaptation exist, yet need to be communicated for wider adoption. Essential components of adaptation will be capacity building and information sharing, climate-proofing of infrastructure and investments, promotion of eco-system based adaptation measures and making biodiversity management more dynamic.

M.S.S. Santos is grateful to Portuguese Foundation for Science and Technology (FCT) for her PhD fellow (reference: SFRH/BD/104087/ 2014). Kashif Mushtaq is grateful to MIT Portugal Program for his doctoral grant (PD/BD/128041/2016) under the scope of the FCT. The authors would like to acknowledge to the FCT under the scope of the strategic funding of UID/BIO/04469 unit and COMPETE 2020 (POCI 01-0145-FEDER-006684) and BioTecNorte operation (NORTE-01-0145- FEDER-000004) funded by the European Regional Development Fund (ERDF), under the scope of Norte2020 - Programa Operacional Regional do Norte. The authors also acknowledge the Projects: i) POCI-01-0145- FEDER-006939 (LEPABE - Laboratory for Process Engineering, Environment, Biotechnology and Energy – UID/EQU/00511/2013), funded by the ERDF, through COMPETE2020 – Programa Operacional Competitividade e Internacionalizacao (POCI) and by nationals funds through FCT, ii) by the Project SunStorage - Harvesting and storage of solar energy”, with reference POCI-01-0145-FEDER-016387, funded by ERDF, through COMPETE 2020 –POCI), and by national funds, through FCT; (iii) Project PTDC/EQU-EQU/30510/2017 - POCI-01-0145- FEDER-030510 – Sunflow “Solar energy storage into redox flow batteries” funded by FEDER funds through COMPETE2020 - Programa Operacional Competitividade e Internacionalizacao (POCI) and by national funds (PIDDAC) through FCT/MCTES and iV) NORTE-01-0145- FEDER-000005 – LEPABE-2-ECO-INNOVATION, supported by North Portugal Regional Operational Programme (Norte 2020), under the Portugal 2020 Partnership Agreement, through the ERDF. The authors are indebted with all the colleagues who assisted in the laboratory work.