• Energy Research
• engineering and technology close
• 6. Clean water close
• 9. Industry and infrastructure close
• IN close

Acidogenic anaerobic fermentation route was explored for the production of bioethanol and volatile fatty acids (VFA) from the press mud (PM) obtained from sugar mill. Slurry was prepared from PM having 10% of total solids and the same was hydrolyzed under acidic thermal conditions. Both press mud slurry (PMS) and pre-treated press mud slurry (PTPMS) was used as feedstock with mixed microbial consortia (MMC) and enriched mixed microbial consortia (EMMC). Mix of bioethanol and VFA were obtained in all the four cases (PMS-MMC, PMS-EMMC, PTPMS-EMC and PTPMS-EMMC), but, bioethanol and VFA yield of 0.04 g/g and 0.27 g/g, respectively obtained from PTPMS with EMMC was found to be comparatively higher. Control experiments carried out with glucose yielded bioethanol and VFA of 0.042 g/g and 0.28 g/g, respectively demonstrating that the organism was using reducible sugars in the feedstock for the generation of bioethanol by simultaneously producing the VFA from COD.

The influence of various solvents (H2O, CH3OH, and C2H5OH) on product distribution and nature of products during hydrothermal liquefaction of sargassum tenerrimum algae has been examined. Hydrothermal liquefaction was performed using H2O (260, 280 and 300°C) and organic solvents CH3OH and C2H5OH (280°C) for 15min. The use of organic solvents significantly increased the yield of bio-oil. In the case of liquefaction with CH3OH and C2H5OH, the bio-oil yield was 22.8 and 23.8wt.% respectively whereas the bio-oil yield was 16.33wt.% with H2O. GC-MS analysis of the liquid products indicated the presence of various organic compounds including aromatics, nitrogenated and oxygenated compounds and higher selectivity amount of ester compounds were observed in the presence of alcoholic solvents. NMR and FT-IR showed that present of solvents have an effect on the decomposition of sargassum tenerrimum algae.

The Western Rajasthan commonly known as the ‘Indian Thar Desert’ is characterised by harsh climatic conditions with active dunal activities. Precipitation (150–420 mm/yr) is far lower than evapotranspiration potentials (1500–2000 mm/yr). Ground water is limited and often brakish and high (75–100 m) water table. Solar intensity in the region varies from 5.85 to 6.44 kWh/m2/day. Further, peculiarity of the region is that sun is available for 345–355 days in a year, the area being highly scarce in rainfall. On an average, rains occur only for 10.4–20.5 days in a year in the Thar Desert. Therefore, there is high scope to harness solar energy for useful purposes. Considering these solar energy technologies for entrepreneurs, the detailed cost analysis has been worked out and presented. With initial investment of Rs (Indian Rupees) 3.50 lakhs for solar drying projects for handling 60,000 kg fresh vegetables annually (300 working days/yr), the payback period and average net annual returns come to 2.17 years and ...

Anode with good electrocatalytic capabilities is more specifically required to reduce the ohimic losses during microbial fuel cell (MFC) operation. Highly conductive polymers viz., Polyaniline (PANi) and Polyaniline/Carbon nanotube (PANi/CNT) composite were prepared by in situ oxidative chemical polymerization method. Anodes were fabricated independently by coating PANi and CNT/PANi composites on the surface of SSM. The fabricated electrodes were evaluated as anode against stainless steel mess (SSM) as cathode during MFC operation. Maximum bioelectricity generation was observed in SSM-PANi/CNT-anode with power density of 48 mW/m2 and COD removal efficiency of 80% compared with SSM-PANi-anode (38 mW/m2; 65%) and SSM-anode (28 mW/m2; 58%). Bioelectrochemical characterization of the electrode materials using cyclic voltammetry and electrochemical impedance spectroscopy showed high electrocatalytic activity of PANi/CNT composite electrode. The study concluded the efficiency of PANi/CNT composite electrodes as bioanode in operation of MFCs towards achieving increased bioelectricity production along with wastewater treatment.

Improving access to safe drinking water can result in multi-dimensional impacts on people's livelihood. This has been aptly reflected in the Millennium Development Goals (MDG) as one of the major objectives. Despite the availability of diverse and complex set of technologies for water purification, pragmatic and cost-effective use of the same is impeding the use of available sources of water. Hence, in country like India simple low-energy technologies such as solar still are likely to succeed. Solar stills would suffice the basic minimum drinking water requirements of man. Solar stills use sunlight, to kill or inactivate many, if not all, of the pathogens found in water. This paper provides an integrated assessment of the suitability of domestic solar still as a viable safe water technology for India. Also an attempt has been made to critically assess the operational feasibility and costs incurred for using this technology in rural India.

Abstract Globally, three-quarter of a billion people live without electricity. Besides, hundreds of million use a solar lantern for less than 4 h a day. Most of the access-deprived are in the Global South, predominantly in Sub-Saharan Africa and South Asia. The United Nations framed the seventh Sustainable Development Goal to improve access. Solar photovoltaic powered mini-grids are increasingly extending better service to deprived regions. However, poor load-factor and expensive storage adversely affect viability. Also, these mini-grids do not support infrequent large loads to avoid further loss of load-factor. Electric cooking is efficient and non-polluting; water treatment facilities can save millions from contaminant and pathogen by providing clean water. Besides, both electric cooking and water treatment are less expensive than alternatives. But mini-grids frequently do not support these. Indeed, the presence of sustained productive loads favourably influences the mini-grid economy. This study investigates the role of critical household loads to deliver similar bearing on the mini-grid economy. Results underscore realisation of desirable impact with household collaboration under a demand-response program. Collaborative consumption can lower initial investment by 62% and reduce the unit energy cost to $0.23. Also, cooperation improves the mini-grid load factor and promotes viability. Additionally, fast deployment needs during and after Covid-19 remains inherently supported while mitigating the pandemic induced financial stress of both consumer and mini-grid operator. This study of 88 nation-states underscores that demand response in a mini-grid can not only improve affordability for all consumers, but it can also bring 186 million people within affordable access.

With the fast growth of the global economy, energy supply and demand have a strong impact on social, economic, and environmental aspects. As a consequence, this has pushed the decision-makers to formulate objectives, guiding economic policies toward sustainable goals. The process is known as Sustainable Development Goals (SDGs) that have been proposed by the United Nations. This being said, the energy sector is a vital domain with a vast potential for improvments in terms of technologies and ligistalations. Solar energy is among the most efficient solutions proposed to reduce the economic and environmental footprints of energy. In this frame, the current paper aims to localize solar energy within SDGs and analyze the contribution of the solar energy towards the achievement of the SDGs. Moreover, the current work highlights the contributions of Mohammed bin Rashid Al Maktoum (MBR) Solar Park in the United Arab Emirates to achieving the SDGs. Indeed, the MBR Solar Park concept offers valuable insights of environmental impacts by deploying clean and affordable energy sources in place of conventional fossil fuel power plants that are still heavily used in the region. The MBR Solar Park operation has already mitigated 6.5 million tonnes of carbon dioxide equivalent and this number will likely rise when all phases are installed and operational. Moreover, it has been shown that MBR Solar Park achieve several SDGs such SDG 8: decent work and economic growth, SDG 9: industry, innovation and infrastructure, SDG 11: sustainable cities and communities, and SDG 15: life on land.

Abstract Natural resources exist independent of human intervention. Although these interventions can and do affect the balance between ecological and biological diversity conditions these resources support, and their use to promote economic development. Currently, the unsustainable use of these resources threatens this balance, calling for more sustainable patterns of natural resource use and conservation. The primary responsibility for ensuring the proper balance lies with governments, leading to various policies and programs to preserve natural resources. The ultimate goal is to make the masses aware of natural assets’ importance and encourage their sustainable use. To successfully implement, however, these government practices require public communication and participation, and the full consideration of public opinion at various levels of governance. A predictive analytics framework is proposed for understanding public opinion on government policies to improve sustainable water governance. An integrated policy initiative to balance water resources use and conservation launched by the Indian government served as a test case for applying the framework in an attempt to accurately classify the opinion polarity related to the policy. The conventional feature extraction is applied to pre-processed datasets to extract the relevant features. Subsequently, swarm-based feature selection is applied to filter out optimal features. Lastly, opinion mining and textual analysis are performed to determine the most relevant water management factors that need immediate attention. The proposed framework serves as a policy evaluation strategy in the water management domain. The paper closes with a discussion of the general applicability of the proposed framework.

Abstract A vapour absorption refrigeration system (VARS) in which a transfer tank replaces the conventional solution pump is analysed. Six fluid pairs with R22 as the refrigerant and different absorbents: DMA; DMF; DMETEG; DMETrEG; DMEDEG; and NMP are considered. Variations in COP, circulation ratio, percent mass of generated vapour utilised for transfer-tank operation, and minimum generator temperature are compared over a wide range of operating conditions. In general, R22-DMA, R22-DMF, and R22-DMETrEG are preferable for a transfer-tank operated VARS. At high generator temperatures or low condenser temperatures, R22-DMA gives the best overall performance. When the temperatures of the evaporator, absorber, and condenser are high, one may prefer R22-DMF as the working fluid.