• Energy Research
• IT close
• CA close
• Sapienza University of Rome close

The winter package to reform EU’s energy system Diritto dell'energia

The Salcheto winery has undertaken a process of reduction of its primary energy consumption and the implementation of green energy technologies. They adopted solar photovoltaic, wood biomass, and geothermal energy sources. A horizontal ground source heat exchanger (GSHE) plant is used to cool a part of the pressed grapes and control the wine production temperature. The goal of this work was to investigate some technical issues of the plant and to increase the efficiency of the whole system. The first step was the evaluation of the actual operating conditions of the GSHE plant, by performing a thermal response test. The results allowed us to find the thermal diffusivity of 3.5 × 10−7 m2/s, and the calculation with the IGSHPA standard indicated a cooling performance of about 6 kW. A survey during the harvest highlighted a peak power of 6 kW. Therefore, to improve the plant, some modifications were proposed and analyzed. In the new layout, the geothermal plant serves the condenser of the refrigeration unit, allowing cooling of the all production lines, instead of only one. The peak power was evaluated as 32 kW, and the GSHE can fulfil this, up to 18 kW. For higher power, the evaporative tower will supply the remainder, covering a maximum of 45%. Furthermore, the refrigeration unit may cover the cooling requirements of the entire residential and office building, without other plant improvements.

The paper presents a novel densely packed assembly for high concentrating photovoltaic applications, designed to fit 125x primary and 4x secondary reflective optics. This assembly can accommodate 144 multijunction cells and is one of the most populated modules presented so far. Based on the thermal simulation results, an aluminum-based insulated metal substrate has been used as baseplate; this technology is commonly exploited for Light Emitting Diode applications, due to its optimal thermal management. The original outline of the conductive copper layer has been developed to minimize Joule losses by reducing the number of interconnections among the cells in series. Oversized Schottky diodes have been employed for bypassing purposes. The whole design fits the IPC-2221 requirements. The plate has been manufactured using standard electronic processes and then characterized through an indoor test and the results are here presented and commented on. The assembly achieves a fill factor above 80% and an efficiency of 29.4% at 500x, less than 2% lower than that of a single cell commercial receiver. The novel design of the conductive pattern is conceived to decrease the power losses and the deployment of an insulated metal substrate represents an improvement towards the awaited cost-cutting for high concentrating photovoltaic technologies.

The ATLAS Inner Detector is a composite tracking system consisting of silicon pixels, silicon strips and straw tubes in a 2 T magnetic field. Its installation was completed in August 2008 and the detector took part in data- taking with single LHC beams and cosmic rays. The initial detector operation, hardware commissioning and in-situ calibrations are described. Tracking performance has been measured with 7.6 million cosmic-ray events, collected using a tracking trigger and reconstructed with modular pattern-recognition and fitting software. The intrinsic hit efficiency and tracking trigger efficiencies are close to 100%. Lorentz angle measurements for both electrons and holes, specific energy-loss calibration and transition radiation turn-on measurements have been performed. Different alignment techniques have been used to reconstruct the detector geometry. After the initial alignment, a transverse impact parameter resolution of 22.1+/-0.9 ��m and a relative momentum resolution ��p/p = (4.83+/-0.16) \times 10-4 GeV-1 \times pT have been measured for high momentum tracks. 34 pages, 25 figures