• Energy Research
• 7. Clean energy close
• 11. Sustainability close
• 15. Life on land close
• 2. Zero hunger close
• NL close
• FI close

Abstract In this study, intergeneric grafting was employed between Populus cathayana and Salix rehderiana to investigate the grafting compatibility of the two Salicaceae plants and to reveal whether grafting can improve their drought resistance. Under different grafting combinations (P. cathayana scion with P. cathayana rootstock, P/P; P. cathayana scion with S. rehderiana rootstock, P/S; S. rehderiana scion with S. rehderiana rootstock, S/S; and S. rehderiana scion with P. cathayana rootstock, S/P), the survival and growth rate, biomass accumulation and allocation, photosynthetic traits, carbon isotope composition (δ13C), relative water content (RWC) and non-structural carbohydrates (NSCs) were measured. The results showed that the grafting compatibility between P. cathayana and S. rehderiana was very high, as the survival rates ranged from 76% to 100% under different grafting combinations. Drought significantly decreased growth, biomass accumulation, photosynthetic pigment contents, net photosynthesis rates (Pn) and RWC, and increased δ13C in all grafting combinations. Under drought stress, biomass accumulation, total chlorophyll, transpiration rate (E) and Pn were higher in P/P and P/S than in S/S and S/P. Compared with P/P, the growth rate, biomass accumulation, root/aboveground ratio (R/A ratio), carotenoid, RWC, starch and total soluble sugar (TSS) of P/S were less affected by drought. The height growth rate (GRH), R/A ratio, carotenoid, chlorophyll a, total chlorophyll, WUEi and TSS of S/P were lower than those of S/S under water-limited conditions. Moreover, a principal component analysis indicated that P/S and S/S had higher drought resistance than P/P and S/P under water deficits. The used method allows combining specific advantageous traits from P. cathayana and S. rehderiana, which may be a highly useful tool to enhance drought resistance in the cultivation of Salicaceae plants.

The majority of local respondents in a large-scale survey were in favour of planned local wind farms on the Danish coast, despite these wind farm plans being the source of wider public and political contestation and opposition. Here we discuss results from the open-ended questions in the survey, specifically focusing on comments expressing how some respondents felt split in their views of these wind farms, accepting the need for renewable energy while at the same time being concerned about the potential local impact of the wind farms. Building on previous theoretical propositions relating to energy infrastructure opposition, here we apply the concept of cognitive polyphasia in some depth, providing a socio-cognitive account of the internal contradiction of being positively disposed to renewable energy in principle, but concerned about or opposed to specific de­velopments in localities. We distinguish a cognitive polyphasic account of such mixed feelings from cognitive dissonance accounts, and we identify several types of polyphasic representations, providing a basis for further work in other cases. The majority of local respondents in a large-scale survey were in favour of planned local wind farms on theDanish coast, despite these wind farm plans being the source of wider public and political contestation andopposition. Here we discuss results from the open-ended questions in the survey, specifically focusing oncommentsexpressinghowsomerespondentsfeltsplitintheirviewsofthesewindfarms,acceptingtheneedforrenewableenergywhileatthesametimebeingconcernedaboutthepotentiallocalimpactofthewindfarms.Building on previous theoretical propositions relating to energy infrastructure opposition, here we apply theconceptofcognitivepolyphasiainsomedepth,providingasocio-cognitiveaccountoftheinternalcontradictionof being positively disposed to renewable energy in principle, but concerned about or opposed to specific de-velopments in localities. We distinguish a cognitive polyphasic account of such mixed feelings from cognitivedissonanceaccounts,andweidentify severaltypesofpolyphasicrepresentations,providingabasisforfurtherworkinothercases

Biomass is a sustainable energy source which, through thermo-chemical processes of biomass gasification, is able to be converted from a solid biomass fuel into a gas mixture, known as syngas or biosyngas. A solid oxide fuel cell (SOFC) is a power generation device that directly converts the chemical energy of a fuel to electricity. Therefore, biomass-powered SOFCs could be highly efficient. Typically, in addition to carbon dioxide and water vapor, the major components of syngas produced from biomass gasification include hydrogen, carbon monoxide and methane which are potential fuels for SOFCs, which make integration possible between SOFCs and biomass gasifiers. However, the syngas is also comprised of trace species such as tars, H2S, HCl, and alkali compounds, among others, which could be detrimental to SOFCs if they are contained within the feeding syngas stream. Therefore, the syngas must be pretreated in order to reduce these trace species to a level that SOFCs are able to tolerate. With various gas treatments, the overall system performance would fluctuate, and therefore, the influence of the gas treatment methods on the system performance must be understood. The most prominent among the trace species is tar. The effect of tars on the performance of SOFCs has yet to be studied, however, it is known that, even though tar can possibly poison the fuel cell through carbon deposition, it may also become a fuel for SOFCs. Furthermore, SOFC systems are currently designed in general for employing natural gas. Due to the fact that SOFC systems are very sensitive to the fuel types, it is necessary to completely understand the system response when switching from natural gas to biosyngas to enable a better controllability for future experiments. The research scope of this thesis is limited to the aforementioned issues. The objective of this thesis is to provide a fundamental study to ensure a safe and efficient system integration. The study is limited to an existing downdraft fixed-bed gasifier and a 5 kWe SOFC CHP system due to these two units entering the commercial market. The approach utilized, however, could be further adopted for the large scale power plants based on biomass gasifiers and SOFCs. The research begins with the evaluation of technologies involved biomass-powered SOFCs in chapter 2. Technologies regarding biomass gasification, gas cleanup and fuel cells are discussed based on literature surveys. The review begins by briefly summarizing conventional gasifiers including fixed-bed and fluidized bed gasifiers, which are implented for biomass gasification. Following that, details are indicated for SOFC performance affected by the trace species such as particulates, H2S and available cleaning technologies. The combination of biomass gasifiers with fuel cells including proton exchange membrane fuel cells (PEMFC), molten carbonate fuel cells (MCFC), and SOFCs is then reviewed with an emphasis on the development of SOFC technology and the study of integration between biomass gaisifers and SOFCs. Chapter 3 presents a thermodynamic study of the influence of cleaning technology on the energetic and exergetic performance of the integrated gasifier–SOFC system with distinctive system configurations. Two gas cleaning systems, specifically, a combined high and low temperature gas cleaning system and a high temperature gas cleaning system are considered to connect the gasifier with the SOFC system. The influence of the steam addition for the suppression of carbon deposition and various heat sources for steam generation on the system performance is evaluated. The performance of the SOFC system operating with natural gas and biosyngas is also compared. The installed SOFC system, particularly the embedded pre-reformer and anode off-gas recirculation was initially designed for natural gas. This design is desirable as it effectively uses the steam in the anode off-gas and the heat generated in the stack. As SOFC performance is very sensitive to gas composition and operating conditions, both of which are affected by the anode recirculation, an evaluation of the recirculation behavior on safety issues regarding carbon deposition and nickel oxidation and system performance are presented in chapter 4. An important finding is that, by not implementing the recirculation, the biosyngas-fueled SOFC system effectuates a much higher net electrical efficiency, less initial investment and simpler system configuration in comparison to that when recirculation is implemented. Tolerance of SOFCs to the trace species from biomass gasification is not yet fully understood. The influence of biomass gasification tars on SOFC performance and mitigation of carbon deposition are experimentally evaluated in chapter 5&6. Well-controlled operational conditions assist in the suppression of carbon deposition. Chapter 5 presents the influence of operating conditions including steam levels, current density and time on stream on the performance of SOFCs with Ni–YSZ anodes fueled by tar-containing biosyngas at 800 °C. Changes in impedance spectra and polarization curves of SOFCs following tar exposure were analyzed to assess the cell performance. The biosyngas composition and the tar concentration employed in these measurements were identical to those measured from the commercial air-blown biomass gasifier that is to be connected to the studied SOFC system. Operating this type of SOFC with the tar concentrations could result in severe damage to the cell due to carbon formation on the anodes. Scanning Electron Microscopy (SEM) indicated carbon deposition which affected the performance of the SOFC, as is exhibited by the impedance spectra and anode polarization curves of the cells after exposure to tars. However, the risk of carbon deposition could be alleviated by increasing steam levels and current loads. Chapter 6 presents a similar study of the effects of tar on SOFC performance, but possesses a focus on Ni–GDC anodes and various operating temperatures levels (700, 800 and 900 °C) under both dry and wet conditions. Polarization behavior, electrochemical impedance spectroscopy, and cell voltage degradation were analyzed to evaluate the cell performance. It is most likely that the cells with Ni–GDC anodes did not suffer from carbon deposition under the wet conditions studied. Dry tar-containing syngas for SOFCs is unlikely to cause carbon formation under a mild current load; however, it may induce carbon formation at open circuit. The effect of carbon dioxide that is capable of suppressing carbon deposition was experimentally investigated, and an enhanced performance was observed under the conditions studied. Under carbon risk-free operating conditions, the cell voltage increases when raising the feeding tar concentration, indicating that tar performs as fuel for SOFCs. Numerical simulation is an efficient tool for the evaluation of SOFCs’ response when switching fuels. Chapter 7 presents such a numerical study with the focus on the evaluation of kinetic models for methane steam reforming for SOFCs operation with multiple fuels. Three frequently employed kinetic models were selected in order to examine their impacts on the performance of a tubular SOFC. The resulting thermo-electrochemical behaviors derived from these models were compared. It was discovered that all three kinetic models are reasonably accurate in terms of the polarization behavior, but they significantly affected the local thermo-electrochemical performance. A more rapid kinetic model was adopted based on the evaluation of these three kinetic models in order to evaluate the performance of the tubular SOFC in terms of local electrochemical performance, anode oxygen partial pressure and overall SOFC performance when performing with multiple fuels. Chapter 8 draws the conclusions regarding the work presented in this dissertation, and recommendations are suggested for future research activities.

Heat stress and cold stress have a negative influence on cattle welfare and productivity. There have been some studies investigating the influence of cold stress on cattle, however the emphasis within this review is the influence of heat stress on cattle. The impact of hot weather on cattle is of increasing importance due to the changing global environment. Heat stress is a worldwide phenomenon that is associated with reduced animal productivity and welfare, particularly during the summer months. Animal responses to their thermal environment are extremely varied, however, it is clear that the thermal environment influences the health, productivity, and welfare of cattle. Whilst knowledge continues to be developed, managing livestock to reduce the negative impact of hot climatic conditions remains somewhat challenging. This review provides an overview of the impact of heat stress on production and reproduction in bovines.

Funding Information: This work was supported Southeast University (SEU) project 3203002003A1 and National Natural Science Foundation of China (NSFC) under the grant 51772080 and 11604088 . Jiangsu Provincial Innovation and Entrepreneurship Talent program Project No. JSSCRC2021491 . Industry-University-Research Cooperation Project of Jiangsu Province in China , Grant No. BY2021057 . Dr. Asghar thanks the Hubei Talent 100 program and Academy of Finland ( 13329016 , 13322738 ) for their financial support. Publisher Copyright: © 2022 The Authors Electrolytes with high-proton conduction and low activation energy are attractive for reducing the high operating temperature of solid-oxide fuel cells to less than <600 °C. In this work, we have fabricated semiconducting electrolyte SrFeTiO3-δ (SFT) material exhibiting high ionic conduction and exceptionally high protonic conduction at low operating temperature but with low electronic conduction to evade the short-circuiting issue. The prepared fuel cell device exhibited high open-circuit voltage (OCV) and a high-power output of 534 mW/cm2, of which 474 mW/cm2 could be for sure be related to the protonic part. The current study suggests that usage of semiconductor SrFeTiO3-δ facilitates a high concentration of oxygen vacancies on the surface of SFT, which mainly benefits proton conduction. Moreover, lower grain boundary resistance leads to obtain higher performance. Also, the Schottky junction phenomena are proposed to inhibit the e-conduction and excel the ions transportation. The high performance and ionic conductivity suggest that SFT could be a promising electrolyte for protonic ceramic fuel cells. Peer reviewed

In this paper, a linear mathematical and numerical model for analysing the dynamic response of a flexible electroactive wave energy converter is described. The Wave Energy Converter (WEC) is a floating elastic tube filled with slightly pressurised sea water. It is made of Electroactive Polymers (EAPs).Under simplifying assumptions, a set of governing equations is formulated for the flow inside the tube, the flow outside the tube and the behaviour of the tube wall. By combining them, the evolution of the flow velocity in the tube can be written as a wave equation. The corresponding eigenmodes of vibration are calculated. Then, using spectral decomposition, the equation of motion for the response of the tube in waves is derived. Experiments were carried out on a scale model of the wave energy converter in the wave tank of Ecole Centrale de Nantes in 2011. Numerical results are compared with experimental results in regular waves, showing rather good agreement, which validates the model and the initial modelling assumptions. Finally, estimates are made for the energy performance of a possible prototype.

Owing to the complexity of the sector, industrial activities are often represented with limited technological resolution in integrated energy system models. In this study, we enriched the technological description of industrial activities in the integrated energy system analysis optimisation (IESA-Opt) model, a peer-reviewed energy system optimisation model that can simultaneously provide optimal capacity planning for the hourly operation of all integrated sectors. We used this enriched model to analyse the industrial decarbonisation of the Netherlands for four key activities: high-value chemicals, hydrocarbons, ammonia, and steel production. The analyses performed comprised 1) exploring optimality in a reference scenario; 2) exploring the feasibility and implications of four extreme industrial cases with different technological archetypes, namely a bio-based industry, a hydrogen-based industry, a fully electrified industry, and retrofitting of current assets into carbon capture utilisation and storage; and 3) performing sensitivity analyses on key topics such as imported biomass, hydrogen, and natural gas prices, carbon storage potentials, technological learning, and the demand for olefins. The results of this study show that it is feasible for the energy system to have a fully bio-based, hydrogen-based, fully electrified, and retrofitted industry to achieve full decarbonisation while allowing for an optimal technological mix to yield at least a 10% cheaper transition. We also show that owing to the high predominance of the fuel component in the levelled cost of industrial products, substantial reductions in overnight investment costs of green technologies have a limited effect on their adoption. Finally, we reveal that based on the current (2022) energy prices, the energy transition is cost-effective, and fossil fuels can be fully displaced from industry and the national mix by 2050.