• Energy Research
• engineering and technology close
• 6. Clean water close
• 14. Life underwater close
• US close
• GB close
• ES close

This paper presents an analysis of the problem of reorientation of a riser pipe from an initially horizontal configuration during subsurface tow to the vertical position for installation. Front and rear barges support the pipe through cables. The orientation into a vertical configuration is accomplished by paying out the front cable. The pipe is treated as a Bernoulli-Euler beam with significant tension undergoing large angle deflections. A finite element procedure used state transfer matrices and successive linearization and the results show that the stress critical phase occurs when the pipe is going through the 60-deg angle to the horizontal direction.

Abstract Microorganisms used in syngas fermentation require nutrients to grow and convert syngas (CO, H2 and CO2) into various products. Many of the essential nutrients can be provided by biochar. Poultry litter biochar (PLBC) contains minerals and trace metals and has a high pH buffering capacity, making it suitable as a nutrient supplement. The effects of PLBC loadings from 1 to 20 g L−1 on syngas fermentation were determined in 250 ml bottle assays. Results showed that 10 and 20 g L−1 PLBC significantly increased ethanol production compared to standard yeast extract (YE) medium. Fermentations in a 3L continuous stirred tank reactor (CSTR) with 10 g L−1 PLBC with and without 4-morpholineethanesulfonic acid (MES) showed 64% and 36% more ethanol production, respectively, than standard medium. The acetic acid accumulated at the beginning of fermentation was completely converted to ethanol in all media tested in the CSTR. These results demonstrate the feasibility of using PLBC medium without costly MES in the CSTR to enhance ethanol production from syngas for potential use at commercial scale.

Recent geomorphic evidence from the inner shelf and shoreface to the east of Long Island's barrier island system indicates that reworking of glacial outwash deposits at the inner shelf-shoreface transition, as sea level rises, may be supplying much of the sediment needed to maintain barrier islands to the west. A conceptual model describing sediment dispersal from outwash source areas was developed from this hypothesis. It was reasoned that outwash sediments ranging from silts to coarse gravels would be subject to differential transport paths across and along the shoreface upon reworking. Coarser grain sizes would move onshore toward the intertidal beach, whereas finer sediments would move offshore. Sand of intermediate grain size would be concentrated in the surf zone an move alongshore in wave-generated longshore currents. To test this model, 400 samples from the beach and shoreface of Long Island were analyzed for grain-size frequency distribution and each grain-size class was examined for frequency of occurrence in the cross-shore and alongshore directions. On a spatially averaged basis, grain-size classes displayed peak abundance in specific zones across the shoreface as predicted by the model, but alongshore trends could not be recognized among the "noisy" data. Therefore, empirical orthogonal functions (EOF) were used to examine uncorrelated (orthogonal) modes of variability in the occurrence of each grain-size class in the alongshore direction. The first function, representing more than 60% of the variability among the data, showed that grain sizes subject to longshore transport in the surf zone i crease in frequency in the alongshore direction relative to coarser grain sizes. Results also show that peak concentrations of coarse sediments correspond to zones subject to frequent overwashing. It is concluded that EOF analysis of individual grain-size classes holds promise for extracting trends from noisy data sets. End_of_Article - Last_Page 318------------

[EN]A systematic approach is developed for the conceptual optimal design of biomethane production via carbon capture. A hybrid heuristic-mathematical procedure is proposed to determine the optimal technology and operating conditions. The heuristic step consists of a literature-based screening of the available technologies. After the prescreening stage, the technologies selected are amine absorption, pressure swing adsorption (PSA), and membrane separation. The mathematical stage is composed of two steps. First, different alternatives for each technology are modeled based on first principles and rules of thumb. These models are used to select the optimal configuration for each process considered. Second, a superstructure model for biomethane production is developed integrating the pre-selected upgrading technologies to select the optimal process, as well as to determine the optimal operating conditions. Four waste sources are analyzed: cattle manure, swine manure, municipal food waste, and sludge. The results suggest that the best amine is diethanolamine (DEA), the best membrane material is the polyimide, and the suggested zeolite is 13X among the ones studied. Finally, among the three technologies, the overall results show that carbon capture using a PSA system using zeolite 13X results in lower production and investment costs, but very close to the use of membranes. The results indicate that food waste shows the lowest production cost for biomethane 0.36 €/Nm3, due to the largest organic matter content, whereas the investment costs are 67 M€, considering a biogas production rate of 0.035 kg of biomethane per kg of waste and the processing of 311 kt/yr of food waste. Credits or incentives are still needed for biomethane to be competitive with fossil natural gas. Junta de Castilla y León y USAL

Hydraulic fracturing drilling technology can cause a high risk of surface spill accidents and thus water contamination. Climate change together with the high water demand and rapid increase in industrial and agricultural activities are valued reasons why we should all care about the availability of water resources and protect them from contamination. Hence, the purpose of this study is to estimate the risk associated with a site contaminated with benzene from oil spillage and its potential impact on groundwater. This study focused on investigating the impact of soil variability and water table depth on groundwater contamination. Temperature-dependent parameters, such as soil water content and the diffusion of pollutants, were considered as key input factors for the HYDRUS 1D numerical model to simulate benzene migration through three types of soil (loamy, sandy clay loam, and silt loam) and evaluate its concentration in the water aquifer. The results indicated that an anticipated increase in earth’s average surface temperature by 4 °C due to climate change could lead to a rise in the level of groundwater pollution in the study area by 0.017 mg/L in loamy soil, 0.00046 mg/L in sandy clay loam soil, and 0.00023 mg/L in silt loam soil. It was found that climate change can reduce the amount of benzene absorbed from 10 to 0.07% in loamy soil, 14 to 0.07% in sandy clay loam soil, and 60 to 53% in silt loam soil. The results showed that the soil properties and solute characteristics that depend on the temperature have a major and important role in determining the level of groundwater pollutants.

Energy is consumed at every stage of the cycle of water production, distribution, end use, and recycled water treatment. Understanding the nexus of energy and water may help to minimize energy and water consumption and reduce environmental emissions. However, the interlinkages between water and energy have not received adequate attention. To address this gap, this paper disaggregates and quantifies the energy consumption of the entire water cycle process in Beijing. The results of this study show that total energy consumption by water production, treatment and distribution, end use, and recycled water reuse amounts to 55.6 billion kWh of electricity in 2015, or about 33% of the total urban energy usage. While water supply amount increased by only 10% from 2005 to 2015, the related energy consumption increased by 215% due to water supply structural change. The Beijing municipal government plans to implement many water saving measures in the area from 2016 to 2020, however, these policies will increase energy consumption by 74 million kWh in Beijing. This study responds to the urgent need for research on the synergies between energy and water. In order to achieve the goal of low-energy water utilization in the future, water and energy should be integrated in planning and management.

Electrical submersible pumps (ESPs) are widely used in upstream oil production. The presence of a low concentration solid phase, particle-laden flow, in the production fluid may cause severe damage in the internal sections of the pump which reduces its operating lifetime. To better understand the ESP pump's endurance, two different designs of commonly used mixed flow ESPs were studied numerically to determine the pump's flow behavior at its best efficiency point. Computational fluid dynamics (CFD) analysis was conducted on two stages of one design type of pump's primary flow path employing Eulerian–Granular scheme in ANSYS FLUENT. The key parameters affecting the erosion phenomena within the pump such as turbulence kinetic energy, local sand concentration, and near wall relative sand velocity were identified. The predictive erosion model applicable to pumps was developed by correlating the erosion key parameters with available experimental results. It is concluded that the use of an erosion model on the second design of ESP proves the model's versatility to predict the erosion on different designs of ESPs.

A promising route to transition wastewater treatment facilities (WWTFs) from energy-consuming to net energy-positive is to retrofit existing facilities with process modifications, residual biosolid upcycling, and effluent thermal energy recovery. This study assesses the economics and life cycle environmental impacts of three proposed retrofits of WWTFs that consider thermochemical conversion technologies, namely, hydrothermal liquefaction, slow pyrolysis, and fast pyrolysis, along with advanced bioreactors. The results are in turn compared to the reference design, showing the retrofitting design with hydrothermal liquefaction, and an up-flow anaerobic sludge blanket has the highest net present value (NPV) of $177.36MM over a 20-year plant lifetime despite 15% higher annual production costs than the reference design. According to the ReCiPe method, chlorination is identified as the major contributor for most impact categories in all cases. There are several uncertainties embedded in the techno-economic analysis and life cycle assessment, including the discount rate, capital investment, sewer rate, and prices of main products; among which, the price of biochar presents the widest variation from $50 to $1900/t. Sensitivity analyses reveal that the variation of discount rates causes the most significant changes in NPVs. The impact of the biochar price is more pronounced in the slow pyrolysis-based pathway compared to the fast pyrolysis since biochar is the main product of slow pyrolysis.

Common to the Committee on Statistics of Drilling District 12 area are the recent exploration activities associated with the Central North American rift system or Mid-Continent geophysical anomaly (MGA), a major feature that runs from the Lake Superior area south into Kansas. For the last several years, much preliminary geologic and geophysical work has been undertaken, which usually proceeds a major play. The primary purpose is to test the Cambrian and Precambrian sediments know to have oil seeps in Wisconsin and Michigan. In 1984, Texaco USA drilled the first deep test, which was in Kansas. Although the well was apparently a dry hole, Texaco's findings have not been released. Kansas had a very active year with 7,451 completions, 45 more than those reported in 1983. The success rate of all wells drilled for oil or gas (7,307) was 57.5%, down slightly from 59.3% in 1983. Drilling for oil continued to predominate with 3,783 oil wells and 419 gas wells completed. Total footage was 22,486,535, up 4% from 1983. The average depth of a test drilled for oil or gas was 3,026 ft. In Missouri, the number of wells drilled for oil or gas declined 17% from 1983 levels. Most drilling continued to be in the western part of the state. A deep test in Vernon County penetrated 2,080 ft of Precambrian rocks. In Nebraska, 12 new discoveries were made in the western part of the state. Seven found new oil reserves, and 5 were tight holes; all were classified as new-field wildcats. The average depth was 5,465 ft in the 7 discoveries where the operator reported the total depth. In Mills County, Iowa, 4 wildcats were drilled to the Cambrian with depths from 3,000 to 3,300 ft. All were located approximately 35 mi north of the Tarkio field in northwestern Missouri. It is estimated that 2,000,000 ac are leased in Iowa along the MGA. In Minnesota, 400,000 ac were leased during 1984. The leases were concentrated mainly along the MGA from Duluth to the Iowa border. About 1,000 mi of Vibroseis was run across this feature. In Wisconsin, regional geophysical surveys along the MGA have been run. Companies are now doing more detailed seismic work. Acreage leased from October 1983 to January 1985 was estimated at 214,000 ac. A dry hole was drilled 1,000 ft into quartzite in Barron County.